Touareg :: How To Remove The Front Plastic Plate
Mar 14, 2004
how can i take off the front plastic plate on the front of my touareg
View 4 Replieshow can i take off the front plastic plate on the front of my touareg
View 4 RepliesI took the plastic cover in front of the radiator off to clean the radiator and condenser. It directs air through the condenser before it gets to the radiator and I was wondering if it would cool the engine without it (if you don't need real cold ac air) . Without it the air can go over the top of the condenser and it is still blocked by the flap that stops airflow above the radiator. Also, I am wondering if the fact that the condenser has nothing in it affects the radiator cooling, and is it bad for the AC system to be empty. (My AC doesn't work)
View 7 RepliesFor those people who received a holeless grill in a 2 plate state how did you mount your front plate. I am supposed to have the holeless grill installed this Wednesday. I was thinking about using zip ties and mount it underneath it's original location but I am afraid that I will be blocking the radiator. I could do it by the side grill.
View 24 RepliesHow do I change my license plate bulbs? I can't seem to get the plastic covers to pop off without worrying about breaking something. Even reading about people saying the puddle lights were hard to change, i did mines in 10 minutes in the dark with a small flashlight lol.
This was a lot easier old my old g37/350z ....
Exactly how do you remove the cover (facia) below the front of the front seat so the battery can be removed. To my knowledge no one has spelled this out on this board.
View 7 RepliesI just got a Touareg with no manual. I have it and the Bentley CD ordered. In the meantime I need to charge the battery and cant figure out how to remove panel in front of seat. It was dead for a few months in the cold weather and I want to double check to be sure it didn't freeze and bust the sides.
Also I'm not sure this vehicle had the PDI done yet. What to look for in regards to a battery disconnect switch in the seat area. Supposedly the dealer removes these as part of the pre delivery inspection.
One last thing, with a jumpbox attached can I turn the key to a "on" position without danger of engine cranking to get it out of park? I guess what I am asking is when you insert the key and turn it to the right, is there a position past 12:00 that cranks engine, and then springs back to 12:00 when you let go of the key?
I need to roll it around my shop, but don't want it to accidentally activate the starter.
Was trying to remove the licenses plate screws today. One comes out easily, the other won't budge. I've sprayed a couple of times with WD40 but its still stuck.
View 14 RepliesI'm installing a double DIN head unit in my 2004 Santa Fe. It's a base model. I took out the old unit and noticed this silver metal bar. This plate takes up too much room and I can't install the new unit.
View 8 Replies02 Camry, how to I remove the burnt license plate bulb? Took off the underside trunk carpet and disconnected bulb harness, but I don't know how to remove the plastic piece that holds the bulb in place. Does it pull out, or twist out? I don't want to break it!
View 1 RepliesI got a piece of cable tie stuck in there.
View 6 RepliesHow to remove the plastic engine cover that covers the engine? I'm know some of them are just held in place with friction plugs and only require a good tug, but I've thought that about other things in the past which have resulted in expensive noises.
View 8 Repliesi need to get to the wires but cant do it looking through the small hole for the fuse box.
View 14 RepliesMy umbrella and few other items stowed in prius for some months now has a strong plastic/rubbery prius smell. How do I stop/reduce the smell at the source? There seems to be some discussion on its origin but no mention on how to reduce this.
View 8 RepliesHow is the red marker light lens, located on either side of the rear bumper, removed to allow the bulb on the inside to be replaced?
View 2 RepliesI have a 2010 prius with a misty gray interior. Accidentally when getting out I scuffed the door and on another occasion I scuffed the plastic molding by the gas tank lever.
The scuffs are black marks and they bother me every time I look at them. Is there a way to get them out? I tried rubbing them out with some cleaner on a paper towel but no luck.
What is the trick to removing the plastic pieces framing the lower door sills? i dont wanna just start yanking i need to run a wire from the trunk forward.
View 2 RepliesHow do I remove the plastic shelf that is blocking my path to access the cabin air filter? The left side is easily removed by pushing the shelf up but I cannot remove the right side of the shelf.
View 8 RepliesBulbs are fine, I turned the light switch from off to on (12 o'clock position) and they flicker for a split second. What can be wrong? I checked the harness on the rear hatch and it looks fine. Maybe the switch itself?
View 2 RepliesPlastic coupling between core and hose, is there a specialty to needed to remove from heater core?
View 1 RepliesHaving problem with moisture condensing on the plastic inside the headlight uniit? Discovered on one of mine after just sitting in the unheated garage for a few days.
View 5 RepliesMy Touareg developed a dash squeak last week. It seems like it's coming from where the dash and windshield come together. It sounds like plastic rubbing against glass.
View 2 Replies