So, I just returned home from a 7-day caribbean cruise to find my drivers side rear brake dragging...hard. I know it can happen to any car but it's aggravating none the less. I guess I'll limp the 2 miles to the dealer on Monday morning...
View 2 RepliesI have a 2004 xlt xtracab F150 and for the last week my drivers side brake has been dragging and the first time it happened it got REAL HOT and after I let it cool down it did release and then 2 days later it did it again but with a one mile slow drive to work did not get that hot. I am assuming that I will have to replace the caliper but is there anything else I may have to change?
View 5 RepliesWent and got new tires on the supercrew. Went going through parking lots or simply driving i hear a loud squeal like brake pad squeal. I put brand new wagner ceramics on the truck. Also if i turn to the left the driver side rear sounds like brakes are dragging against the rotor. Whats goin on with this. The squeal will happen between 10 mph to 20 mph and the grinding noise will happen if I am cruising or turning to the left. It goes away when i apply the brakes.
View 1 RepliesTruck is 2007 6.0L 4 door F-250 FX4
So this started after some High water encounters around my area. All freshwater. Went to the store and then i notice the truck pulling Left and got home and checked brake temps and the driver front and rear were over 400*F passenger side was 150* or less. No trailer no load in the bed. I decided to clean everything. Pads are worn but still have life.
Rotors showed some signs of where the pad is dragging Not bad though just a small area close to the top hat. I cleaned pads, carriage, and clips and reinstalled everything with some anti seize on the edges of the pads where the clips are and at the same spots on the carriage.
Thought it was ok but the after more water and a day or two sitting the same thing happened again. It is only the drivers side and it's both front and rear. I am stumped on this one. Two calipers going bad at once? I need to tow a boat on Monday So I have got to fix this.
I replaced my front axle pads but the driver's side brakes seem to be dragging on the rotor making a very loud squealing noise when im driving. When I parked it in my driveway it was really hot and smoking. It doesn't happen to the passenger side. I pushed back the Pistons easily to get the brake pads in there so that wasn't a problem. But I must admit I changed them when my brakes were grinding.
View 13 RepliesHaving issues in the T2 with driver side front and rear speakers going in and out. Comes back on when going over bumps or making left turns. right turns and they shut off again. also seams to happen more when listening to factory installed sirius than the iPod...
I've been doing car audio installs for years and this started shortly after i put an iPod adapter and amp/sub in. the head unit was never pulled out and i checked all the connections where i tied in with the rear speakers for the sub. I really don't think it's install related.
What would cause one side to go out front and rear?
I have a 2005 Highlander that had repeated rear brake noise problem after the dealership serviced the brake in May this year. The sound was like dragging or grinding. After that, I brought my car back but the noise came up every time in 3-7 days. Here is the of the service record from the dealership:
5/31/2011: initial maintenance. Rotor resurfaced, pad replaced
6/17/2011: Adjustment and lubrication.
7/13/2011: Replaced the pad.
8/20/2011: Technician could not hear the noise during drive test. Ticket withdrawn.
8/26/2011: Tighten e-brake, lubrication.
Tech told me the left and right brakes were not balanced. I recorded the noise in the following Youtube video: [URL] .....
Turn volume up and notice the last two stops. What I should say to the dealership service? I plan to take the car back in a few days.
The drivers side rear door on our 2004 T'reg is stuck shut. Neither the interior or exterior door handle will open the door. I tried locking/unlocking it a few times, both with the remote and with the interior button. Is this a simple fix, or is it off to the dealership with me?
View 2 Replies2011 f250 6.2. put it in the shop to have the rotors turned, and front brakes while they were under there. Now it pulls to the right whenever you apply the brakes. Can smell brakes on the left front after a short drive time. Replaced that caliper and it's still doing the same thing. I'm stumped at this point.
View 9 RepliesHazard triangle symbol on the edge of the drivers side rear seat facing the door. Noticed it yesterday when detailing the new gal. Thought maybe there was a first aid kit or triangle under the rear seat, but nothing. What it's there for??
View 2 RepliesMy 2009 Toyota Corolla LE is squeaking. The noise is coming from its rear break -- driver side. It happens only at a low speed when pressing the brake half way to slow down the car until it stops. Only 60-70% of the time though that it has the noise and only when going slow in the traffic and hit the brake. It doesn't seem to squeak on the highway.
The car has about 40k miles. I've heard that the rear brakes suppose to last ~100k miles. My questions and concerns are:
1. Is it too soon to replace rear drum breaks?
2. How to check the rear break pads to see if I really need to change them?
3. Are they just dirty? How to clean the rear breaks?
4. Finally, if I really need to replace them, how much does it cost in general?
I wish they were dish brakes -- so much easier to replace them.
My '03 3.5 has the driver side rear brake piston stuck. Tried the C clamp but no movement. Short of replacing the entire caliper...
View 9 RepliesAny recommendations on brake calipers and hose?
View 14 RepliesLast weekend I did a rear brake job on my 1997 F350 4wd diesel. I replaced the shoes, replaced all the hardware, replaced the cylinders and had the drums turned. I have driven the truck all week and everything has been fine. Tonight while out of town I set the parking brake to see if it was any better since the rebuild, and it was. Shortly after releasing the parking brake I drove about an hour to get home. When I arrived home by driver side rear brake, wheel, etc. was very hot. I threw water on it and it turned to steam instantly.
I suspect that setting my parking braked hard like I did (like you're suppose to) somehow caused it to drag. What is causing this and what needs to be done so that it doesn't happen again?
After reading some other posts I went out and checked my parking brake cable and found that it is not bound up that I can tell. Perhaps it did not completely release although it seems to release just like the other side. I checked it from front to equalizing bar and it is in great shape. The plastic coating is still on the wire and there isn't any corrosion the entire length. The only thing I did differently on this trip vs the one I made two days ago was try out the parking brake before I left. The last trip I could barely feel any heat on the rear wheels when I got home, this time the driver side was scorching hot.
As the says I have a 1999 Yukon Denali that the Rear Brake and Turn signal on Drivers side are not working. Also brake light on trailer DOES work but not the turn signal on that side.
I tested the Tail light circuit by plugging it into the passenger side and it works so that rules out that. What wires to test under the dash to test the combo / multi switch?
Also the tail lights or park light do work (both top and middle bulb lights up when the vehicle is running) its just brighter filament does not light up when breaks are pressed or turn signal is on.
This is my second time posting for the same issue on a 2003 3.5L with 120,000+ miles. Rear driver side brake caliper is stuck again. I have replaced both rear calipers after the driver side stuck a few months back. So most likely the first time was caused by something else.
What else could be causing this? Brake line, master cylinder, or other? I did not replace any brake lines the last time this happened. Just calipers and pads.
Recently I took my 2006 Subaru Outback wagon on a trip in the mountains. I parked my car in the driveway overnight and noticed oily fluid on all of the tiresand on the ground in the morning. The fluid spill was worse on the driver's side front and rear tires, but was noticeable on the passenger side as well. I did not notice an odor to it. I used the brakes alot on the way back down from the mountains..... I have taken this car places where I have used the brakes a whole lot but have not noticed this before. How bad is this? Is it possibly "normal?
View 5 RepliesI had a brake line crack on my way home yesterday(that was interesting..) It was the drivers side rear metal line from the splitter to the rubber hose. I went to autozone and was like ok easy enough this line is the same length and appeared to be the same diameter. bend to fit and all was well or not.. the fitting on the end was a different thread pitch and size. 1999 f250 4wd if it matters....
View 4 RepliesI sent my T in last week because I was not getting "cold" air out of the passenger side vents, at least not as cold as the drivers side. The Dealer has acknowledged the problem but is having a hard time (with wvoa) finding a solution. They've returned the T to me until they can find a fix, hoping to keep from removing the entire dash.
I ran some tests of my own this weekend. When in ECON mode, both sides put out the same temp; only when the compressor is on do the temps vary. I have heard gurgling in the dash since I bought the T and when in ECON the gurgle goes away (compressor is off).
Question: Could the system be low on frion (or whatever coolant)? Are there two separate evaporators for dual zone? I'm thinking (hoping) yes on both. Maybe one evaporator is getting a full mix of coolant and the other is not......could this be the gurgling I keep hearing?
I'll bring the T in tomorrow and ask them to recharge the system if any of you agree with this theory. I hate to think the dealer will have to rip the entire dash apart to fix this situation.
I have a 1962 ford falcon ranchero. The driver side brake light, goes out when brake pressure is applied, but is on when lights are fully on, but even then brake pressure is applied and goes out. Right brake light is fine. And turn signal on right works. But driver side back light goes out when brake pressure is put on and when turn signal is put for left side. Right makes a turn noise left side doesn't. I recently replaced the turn signal switch. So its brand new. But older wires every where else. No cuts anywhere on wires. Fine. And replaced the bulb also.
View 8 RepliesJust got my 2012 Prius from the body shop. Got hit in the rear where the starting battery is.
Had window control problems since battery was replaced.
Problem is that the driver-side rear window can't be controlled by the driver. It works fine with its own control but not from up front. The light on that windows button is not lit like the others. When pressed it lights and when released it blinks a few times and goes out. I unhooked the starting batter to try and reset things with no luck.