Touareg :: Brake Pads Sensors Location / TPMS Light On
May 11, 2010
I have a 2004 vw toureg 3.2l v6 and i have two questions. first is where are the brake pad sensors located in the pad or outside of the break pad? Second question is TPMS light is on due to a dead battery in one of the tires how do i kill the whole system?
View 1 Replies
Advertisement
Ever since I bought my 04 V8, the TPMS warning light has been on due to dead sensors and a disconnected controller (G model controller), and I had just learned to live with the alert and the icon on the display for the time being. Last weekend I installed a 6 button cruise control switch and recoded per Michael's instructions. The switch works fine and everything was good. After a couple of drives with the new switch I noticed that the TPMS was not giving me the usual failure message or the fault icon anymore. If I hit the Vehicle button I still get the same fault message in the J523 screen but no warning in the cluster, and no warning upon startup. Ran a VCDS scan and the errors for the TPMS module not being there are still present as they always were.
View 4 Replies
About four days ago my TPMS warning light started blinking. Same tires and sensors have been on there for quite some time. The service book says to take it to the dealer, but I instead stopped by Discount Tire (where I purchased the tires) to see if they could look and figure out which sensor was acting up.
When he ran his sensor, none of my four sensors showed up as broadcasting at all! Now I know that all four of my sensors did not just randomly go out at the same time.
View 14 Replies
This will be my first winter using a dedicated set of winter tires and wheels on my 09 Camry. The set doesn't have TPMS sensors. Will the TPMS light constantly flash or just stay lit when the system doesn't detect the sensors? I could live with the light always lit but if it flashes it will be annoying.
View 14 Replies
What is the tire pressure that will trigger the TPMS to activate the warning light on the dash? I had 31psi in my left front and got no warning?
View 4 Replies
Just went to the dealership for 40k miles service and they told me my rear brake pads were low, around 20%. And they quote me $430 for replacement (Parts + labor). Should i go with it? or i better go buy parts from internet store and find some local mechanic install it for me?
View 9 Replies
I recently installed takeoff 2017 factory 18" wheel/tire combo on my 2008 F250 to replace the 17" steelies. Didn't even know it had a TPMS system. Light never came on in 10 years of driving. After installing and airing up to 70psi, the TPMS warning light came on. Checked pressures, all good. I'm guessing that the new 18's have different sensors than the 2008 17's. 08 has the rim mounted green rectangular style. Don't know what the 2017's are as the tires were never taken off the rims. What do I have to do to get the new sensors to work?
View 8 Replies
The brake pads worn symbol has lit up in the instrument cluster on my wife's 2008 Touareg V8. The car has 33K. Per Tom Bush VW in Jacksonville, both pads and rotors must be replaced. This is without even looking at it.
Per Osteen VW also in JAX, I might not have to replace the rotors. They stated that what they have seen is that usually the rotors don't get replaced until the second visit to replace pads.
View 5 Replies
I have a 2004 V6 with 20s and close to 32K miles, never driven off road. Last Friday this warning "Check brake pads" started to show sometimes. I believe the dealer changed them before, but if he did not, how much should it cost me to replace them?
View 11 Replies
I just picked up my 2015 Gx460 last month. The TPMS light stays on after I changed the snow tires. where the reset button for TPMS is located?
View 14 Replies
No luck using the search option. Can I reset (get the faulty wheel onboard light to turn off ) the system myself through the learn sequence? Haven't been able to achieve that result yet.
View 4 Replies
Car is year old, 20k. Replacing tires because of bubbles. I expect to run new tires for about 3-4 years. Do I need to replace the TPMS sensors?
View 2 Replies
Got my OZ wheels on, with a new set of TPMS sensors. The old sensors stayed with the OEM wheels for winter tires. How do I reset the system to recognize the new sensors? I have a VAG-COM kit, is this required or is there a method to do this through the MFD?
View 2 Replies
I purchased a set of Scion FRS wheels. I assume these have TPMS sensors installed. I found the reset button under the dash and followed the directions in the manual. The light still hasn't gone off.
Is there a different method to get the TPMS sensors to relearn? Or did I make the wrong assumption that stock FRS wheels have sensors.
View 19 Replies
If my check brake pads light came on a few days ago, how long do I have to get it to the dealer? Can it wait a few weeks? Months? Or, do I need to drive it straight there?
View 1 Replies
So my brake pads worn light came on recently on my 03 jetta...low and behold all 4 brake pads needed changing...funny though because upon buying pads with the sensor when I went to put new pads on the old ones didnt even have a sensor it was already cut at the harness and spliced together to keep the light off....so upon inspection one of the wires was black and the other copper....idk if one was supposed to be black or if its because its fried? Anyways i went as far up the wires as I could till they are harnessed in with the abs sensor wires...still one wire black....spliced together crimped and still the light comes and goes....I dont have access to the vcds or vagcom so can't turn it off that way..
View 2 Replies
So a few days ago the warning light that my break pads are getting low came on. My friend needs a ride this weekend that would bring the round trip to about 300 miles. How soon are my break pads on my 20th going to be shot? I don't know if this is an early warning to let you plan to get break pads in the near future, or if it's the same thing as seeing the gas light(Oh crap, gotta head to the gas station and fix this NOW).
View 7 Replies
I have an '05 GLI @ 45,000/mi. The sensor light came on for my brake pads about a week ago. So obviously I need new brake pads (front & rear? not sure...I know the sensor is only for the front). But I was also wondering if I need to replace the rotors.
I understand there is a measurement for the OEM rotors to tell when they need to be replaced. There is a little lip on the them, more so on the front than back. And they feel slightly grooved.
View 17 Replies
The dealer tells me my batteries in my low tire sensors are bad. The low tire light on the dash won't go out. So I need to replace the TPMS sensors in my '06 type 5 Prius. I know I can pick them online much cheaper than at the dealer. My question is, is there some reprogramming that will need to be done. I'm assuming it will be some convoluted sequence with buttons on the dash similar to turning off the backup alarm, etc.
View 3 Replies
My 2007 ES350 had a problem with the TPMS where it would flash for the first minute and then stay solid. After checking all 5 tire pressures and resetting the system by using the button under the drivers side dash, I determined that it was probably a bad sensor. Seeing as how they are 7 years old, this seemed reasonable. (I also checked to make sure the passenger side button for the second set of tires was not pushed).
I just had new tires installed at Costco, and brought 5 new sensors for them to install. They supposedly did whatever sensor registration magic is required, but I am still having the same issue. The light blinks for the first minute then goes solid.
What is interesting is that when I try to reset using the button, the light flashes slower (about 1 per second) 3 times, then goes faster (about every half second or so) for the rest of the minute. Is this some code that the system is trying to display?
Also, is there any trick to getting this system re-initialized that I can pass on to the Costco techs when I take it back up there?
View 14 Replies
I just changed brake pads front and rear. My light was on indicating need for such. After changing i figured light would reset and turn off. Not the case. How do i reset the light? Was there something i needed to do to sensor when pads changed?
View 5 Replies