The airbag fault light came on for no apparent reason and has not gone off. Is this an electrical issue, airbag fault or something else that the dealer can take care of easily?
View 5 RepliesI've noticed on a few occasions (maybe 3 or 4 times total) on my 2005 V8 (about 2.5 months old and 2000 miles) that the brakes seem go into "ABS mode" for no apparent reason. No rain and no snow etc. As I depress the brake normally or even lightly it takes over and reacts like I slammed on the brakes. Then everything returns to normal.
View 5 RepliesGot in my car yesterday and the airbag light on the dash stays on and a airbag fault message pops up in screen next to the speedo. What could be the problem?
View 3 RepliesA month ago my check engine light came on so, after checking to ensure the gas cap was screwed on correctly, I did what the manual recommended and took my car directly to the dealership. After paying a diagnostics fee and losing my car for an entire day while they ran tests and contacted Toyota, my dealership told me they couldn't find a problem and just reset the indicator.
Within a few days the light came on again but before I had a chance to take it back to the dealership it went off. Now some 3 weeks later it is on again and I'm wondering what to do.
Recently "acquired" AB Fault that would not go away. Upon routine 10k service, here is what was found out. If you move the passenger front seat within the first few seconds, the self-tests (including determination of seat empty to automatically turn off passenger airbag) get confused and a fault code is thrown. Fault will not go away until reset by VW service (or presumably VAG-COM can do this).
The recommended "fix", at this point, is to not mess with the seat adjustment for 10sec after ON. There is no written information on Touaregs, apparently, but same problem is documented in a Technical Bulletin for New Beetle. A relevant quote from that document is: "Volkswagen Technical Service is investigating the following condition. After switching ignition ON, the Airbag Monitoring indicator light stays illuminated and DTC 02511 014 - Seat Occupied Recognition Control Module Fault - is stored in DTC memory.
Can you reset airbag fault with the KEYII-USB.....
View 2 RepliesI own a 2004 V8 Treg and the other day when I started the engine (and ever since) there is an error message displayed AIRBAG FAULT. I have arranged to take it to the dealer...
View 22 RepliesI recently received an airbag fault light so I figured that I would scan the module for error codes. This is what I came up with:
Control Module Part Number: 3D0 909 601 C
Component and/or Version: 05 Airbag 8.4E++H01 0352
Software Coding: 0012341
Work Shop Code: WSC 31414
Additional Info: 7L0959339B BF-Gewichtsens. 005 0006
Additional Info: Geraet 00000
2 Faults Found:
01217 - Side Airbag Igniter: Driver Side (N199)
001 - Upper Limit Exceeded - Intermittent
01316 - ABS Control Module
004 - No Signal/Communication - Intermittent
Has scanned the car while had the airbag fault present and if so, is this the usual harness that needs to be changed?
OK, I just got the airbag fult and am scheduled for service. I just noticed a clicking sound coming from the steering wheel Area... it does not occur with any specific movement and is fairly quite... definitely sounds like some kind of electrical switch tht is continually trying to do something (sensor??).
I am wondering if this is related to the airbag fault? Very annoying once you pick up on it... along with whatever is loose in my driver side pillar next to the seat belt strap that rattles with the bass!!
I have a 2008 Sonata. Yesterday the airbag light came on for no reason.
View 4 RepliesI have an 07 Camry and the alarm keeps going off for no apparent reason. Is there anyway to reset the alarm system itself? If so how and what do I need to do? How to do this.
View 2 RepliesMy 2009 managed to lose 4 quarts of oil over 200 miles today.
View 9 RepliesI tried starting my car today and it didn't want to go. I took out the air intake sensor blew at it and plugged it back in and started it, but it didn't sound the same, the muffler wasn't making as much noise as usual and just sounded like the engine wasn't working the same. After that it started normal and i've been driving for about a week, and today it didn't want to start again so i took out the censor did the same but still didn't start so i put down the clutch revved it a couple times and like magic it worked.
I think i need to change the censor but i'm not sure and i don't want to spend money if i don't have to.
I own a 2003 BMW 5301 with the sports ,premium and 'M' package. Of late the battery drains for no apparent reason. This happened a few times 2 months ago and I had the battery and alternator replaced. This has again started happening. The car starts promptly in the morning but refuses to start in the evening when I am ready to leave work. It has to be jump started. This does not happen everyday and the BMW service folks have not been able to figure this out.
View 2 RepliesThe other day, in sub zero weather I left my radio and lights on as I ran into the store to grab washer fluid. The engine was turned off, but I did leave the radio on for my buddy.... I was in the store for a max of 5 mins. I get back into the car, go to turn it back on...... and nothing.... ZERO juice.... now I've had the radio on before for a much longer period of time without the engine running and have had no problem.
We ended up jumping the car and it started up with no problem. I let it idle for a bit but then all of the light on my dash came on..... I reved the engine a bit and they all went away.
A few days pass and the car starts up with no problem. Then I get stuck sitting in underground parking, so I turn the car off while I wait for the cars to exit the garage... again listening to music with the car off... go to start and nooooo juice! Being that the car is manual I was able to get it rolling and then popped the clutch..
224,000kms and counting.... all OEM
My aunt came to me the other day about her car not starting and I found that the battery was shot and would not accept a jump start so i replaced that and then yesterday it died again with the new battery so naturally, I replaced the alternator. After swapping the alternator I jumped the car ran it for about 20 mins and told her to follow me to grab some food. When she proceeded to back out the car died again!!!
So I tightened the belt on the alternator a little more, jumped it and let it run a little bit. This time I went through all the basic electronics lights blinkers brakes ect except ac and radio. then i back out and pull back in the parking spot and I was thinking pow it's fixed.
So I turn on the A/C and i notice the sound of the RPMs go down which doesn't concern me too much but when I looked at the RPM gauge it was erratic but the engine wasn't fluctuating with it. So I turned the ac off checked the A/C fuses they were fine. Tried turning the A/C on one more time and this time, RPM gauge stops reading all together and the A/C light was flickering very quickly.
I'm not good with the electronic side of the car but I am leaning towards a very bad grounding issue or short. I have no multi-meter so I haven't read any voltages but I am going to see if I can borrow one from my cousin.
I Have A 2001 Ram 1500 With The 318 5.2 Engine , Oil Pressure Jumps From 40 To 0 For No Apparent Reason, And Then Lifters Began To Tick. Turn Off Truck And Recrank Oil Pressure Returns To 40 Lbs, Rev Up Engine To 2000 Rpm Or Better And Pressure Goes To 0 Instantly. I Have Replaced Sending Unit, Replaced Oil Pump And Pickup, Changed Oil And Filter Using Dodge Filter, Removed Valve Covers And Intake Cleaned Out All Sludge, Tried 3 Different weights Of Oil, Cleaned Oil Passages, Inspected Oil pump Drive Shaft, Pulled Rear Main Cap And Inspected Bearing , Looked Good, Changed Oil And Filter 3 Times , Engine Is Very Clean. Engine Never Has Low Oil Pressure Either 0 Or 40 Lbs Never 10 Or 20. I Have Heard Others Describe This But Never Heard The Answer . Truck Has 70,000 Miles ,runs And Sounds Perfect When Oil Pressure Is At40. It Can Idle At 40 Lbs Hot, Which Leads Me To Believe Bearing Clearances Are Fine.
View 14 RepliesCar wouldn't start on Wednesday so wife had neighbor jump start the car and she took it to the auto store and had the original battery replaced. On Friday, while driving the car, the battery light came on so she took it to the auto store to have the battery checked. When they went out to check it the car wouldn't start, only click. The battery has a full charge and doesn't drop when the key is turned. I pulled the starter and had it checked...it's good. I've checked relays and fuses and am coming up with nothing.
View 1 Repliesmy '02 Durango is losing oil pressure for no apparent reason. A little background here. The truck has 143,XXX miles on it, I just had the top end apart for the l/s head gasket. Everything went well, and the truck was running fine for about 3 days. Then, for no apparent reason, the oil pressure dropped off. But the weird part is, is it's not staying at zero pressure. It's actually fluctuating. Now before anyone chimes in with a bad oil sensor, you can hear the lifters start to make noise till the pressure comes back up again. Up until the head gasket, the truck had been trouble free for the past 8 years. We bought it with 55,XXX in 2005, and I've always held to 3 mo./3,000 mile oil changes, and bi-annual cooling flushes, as we go EVERYWHERE with this thing.
View 2 RepliesI have a 2004 Alero that I just bought used about a week ago. Everything has been running fine until 2 days ago..it would not start. I waited a few minutes then it started right up. Today as I am coming up the highway everything dies...ALL power to the car is gone and I coasted into a parking lot. Approximately 15 minutes my husband gets into it and it starts. The code reading machine at O'reilly says I have an evap leak but that it would not cause the car to immediately stall like that.
View 3 Replies