Got these codes after my check engine light came on.Cleared the light with my OBD2 scanner several time but it kept coming back on. One week at the dealer who replaced a 'sensor' after vegging it and talking to the VW Tech line! Light came back on the same day I picked up the Touareg from the dealer :confused. Dealer thinking about what to do next.
2007 FSI V8 Touareg...
The check engine light has been coming on and off over the last month...SO, I replaced the MAF which I thought was the code 17550. After a couple hundred miles the check engine light came on again. SAME code, 17550 again...my tech is baffled.
View 10 RepliesI bought a 2005 Volvo V70 with 75,500 miles on Nov. 13. On Nov. 15, the check engine light went on, and I returned to the dealership for a solenoid replacement. The check engine light went on again on Nov. 17, oil pan replaced. On Nov. 19, the light went on again, timing belt replaced. On Nov. 22, the light went on again. Each time the code was the same--sometimes in conjunction with other codes--but one code was consistent. We returned the car on Nov. 22 and asked for a refund in keeping with the Massachusetts lemon law (an attempt at repair 3+ times). The dealer refused, saying the check engine light and computer code were not the same as an attempted repair. He took the car and said he was going to call Volvo Tech in. However, he says the light "went off" and never came back on even though his staff has test driven it 170 miles in the past three days. He's "releasing our car" to us, even though he has made no repair. Tell me--is trying to address the same computer code considered a "repair"?
View 13 RepliesMy wife's car has 83000 miles on it. We bought it as a factory certified pre-owned vehicle with about 1800 miles on it and it came with the warranty. For the last two years the check engine light comes on with code 441 I don't worry about it till time to get inspection sticker here in Texas. I have been about to reset the computer and drive it till the computer is ready to be inspected and it has passed for two years. Now it won't reset and I have tried to test the vacuum switch and it seems to click when I apply voltage but light won't go off. This code can cost up to about 2000.00 to try and detect. I am not interested in having the dealership keep guessing on my dime.
View 2 RepliesI have an '09 LS SWB AWD with 86k miles on it. A few days ago the check engine light came on with a message on the dash for me to check the VSC system. The next day the check engine light and VSC warning went away on their own. A day after that they came back on. I pulled the ODB codes and got the following:
P0012 - "A" Camshaft Position - Timing Over-Retarded Bank 1
I took it to my local Lexus dealership and they determined that my VVT-i motor assembly needed replacing. Total cost would be $1,222. Apparently this part regulate the camshaft for variable valve timing. I asked if I should notice a performance dropoff since it's related to valve timing but they said no. They said I wouldn't make it worse by driving it so I took my car back and they would order the part for me.
The next day the check engine light and VSC warning went away on their own again and have not come back on for 3 days now. I don't understand why the warning and check engine lights keep going off on their own if this motor assembly needs replacing. Once again it has been 3 days now and no lights have come on.
I am the proud owner of a 2008 LS600hl with 141,000 miles. The check engine light is now on permanently and the estimated repair charge from my lexus dealership is outrageously expensive. Here is the official diagnosis and recommendation.
"Code P1083 - HCAC Valve Stuck Open in Bank 2 .
Recommend Replacing Y- Pipe With HC Adsorber .
Possibly May Need Exhaust 2 Sensors.
At roughly 140,000 miles, my wife's '07 Santa Fe GLS has thrown a P0456 code. Does this code on a Santa Fe common?
It is "evaporative emission system leak detected (very small leak)." The good news, I guess, is that it is 'very small.' However, being small may make it more difficult to detect.
I've recently bought used Hyundai SantaFe 2007 and the engine check light lit up. I've bought EML327 OBD2 scanner, it showed P1405 meaning "EGR tempereature sensor incorrect". Some of my friends says it has something to do with CPF filter and EGR valve. They think, i should clean both CPF and EGR. Car service told me that DPF (not CPF) filter cleaning costs arround 350eu and one service told me to simply take it out and reprogram car computer. As far as EGR valve cleaning goes, no service wants to do this. I don't really know much about cars, so my main question is what would be my next step in trying to fix this error.
View 3 RepliesMy 2010 Santa Fe is only 2 month old and has 2000km now the check engine light is on. Went to the dealer and found out the code is P200A -Intake manifold runner performance. And they just clear the code. What does this code mean?
View 22 RepliesMy dad has a 2007 dodge ram 5.7 hemi and recently the check engine light has been staying on at first it was fuel door open now that's gone but the check engine is there went to get the code read and was told something about a fuel leak evaporator leak the cap or a vacuum line the cap was tested it was good?
View 1 RepliesFrom time to time, the engine lights comes on with error code P0365, it usually disappears within two days (it disappears by itself), but it appears once per month and stays for two days.
The code scanner says :P0365 Camshaft Position Sensor B Circuit Malfunction (Bank 1)
Do I need to change the sensor? and where is it located?
my Sonata is 2009, 2.0L (Korean imported) 4 cylinder ...
My car's an 04 Mitsubishi Lancer ES, 4-cyl, 2.0L. So long story short, my check-engine light has been coming up every now and again for the last couple months with the code P0421, which a shop has confirmed I need a new manifold catalytic converter for (they ruled out any problems with O2 sensors).
View 2 RepliesI have a 99 Ford Explorer - w/217k miles. (2nd owner) .. I got an oil change 3 weeks ago, tune up 2 mos ago, and new brakes/tires within the last 6 mos, oh, and Brother-In-Law just recharged my a/c last week.
Runs well, and I hope to keep it for another few years, but having problem lately.
Check Engine light keeps coming on - I've taken it in, and they read the code, and it comes up with a misfire. Mechanic resets it, and it will stay off for a few days/weeks, and then comes back on.
Now, I just bought a 07 Yukon which seems to be in a great condition. The check engine light just popped up so I went to a mechanic and he said the code is p0455.
He did a smoke test and showed me that smoke is coming out of the rear of the vehicle at the gas tank area and the car needs the vent valve solenoid changed, but it's only sold at dealer.
So u went to dealer and got this part and decided to change it myself which was quite easy and fun.
I went back to clear the light, then a week later the light came back on, so I went back to him thinking maybe I didn't do it right, so he did another smoke test and sure enough we see smoke coming out of the rear again, so I looked under the car and saw it was coming out of the end of the vent valve assembly which I think is a small air filter. Is that normal? Or is the part defective?
I got a 2007 Hyundai Sonata Limited (Platinum Edition), 6 cylinder, 3.3L at 110,000 miles. Got a Check Engine light a month ago, checked it at Autozone and it showed P0171 and P0174 codes (Fuel System Too Lean). The code was cleared and I drew the car for about a month, and the light came back on again recently. Checked it again and now it is showing PO133 code (slow response (heated oxygen sensor bank 1)). What could it be if not the O2 sensor or bad wiring or cracks/leaks in the exhaust?
View 3 RepliesI own a 2007 hyundai accent currently around 123,000 KM's I've got my check engine light on and it has been on for a few weeks now. The Code its giving me for it is P0446, ( Evaporative Emission System Vent Control Circuit) Is what it is saying. I also notice when I put fuel in my car it does not want to start unless i turn the key over a few times or pump the gas pedal..? What to replace for this code?
View 9 RepliesI have 07 350 and my check engine light is on, i had it scanned and they told me that the code is BP0013 and bank 1 Cam position sensor is bad. What that code means and where is that sensor located???
View 9 RepliesWas cruising on the highway when the check engine light up. Scanned with a Techstream cable and got 2 codes: P0549 and P1083 (Engine and ETC). Just got a blown fuse yesterday, could it be related to a short ? Checked all fuses driver and passenger, didn't find another blown fuse (didn't checked in the trunk yet). LS600hl
View 14 RepliesToday my check engine light came on and the code is P0712. When I drove off from the parts store, the check engine light suddenly went off. What should I do at this point? What are the most likely problems/solutions.
View 1 RepliesI have a 2003 Prius, I had an accident and after it was fixed the check engine light started coming on. It would go off after a couple of days. The first time I took it to Autozone and the codes were P3150 & P3130, but the next day the check engine light went off. A couple of days later the light came back on....went back off....next week it stalled on the highway, but it started back up, now the codes it's reading are P1636 and P3002. It still starts up and will drive, but I'm afraid to drive it.
View 2 RepliesI have a 2007 Yaris, 180,000 miles, The check engine light comes on. With a P0011 code. I know that that could mean either:
blocked oil passage
Mechanical timing fault
Camshaft position a timing over advance
Failed OCV
Or VVT controller assembly fault
Since it's been really cold out I figured maybe it was a blocked oil passage, but after an oil change and quick check - I no longer think that's the problem.
The car runs great and it doesn't seem anything is wrong at all ...