Having issue with these wiper blades? My wife's touareg has less than 15k, but the wiper blades are streaking and otherwise less than useless. I have had the same wiper blades on my jetta for over 2 years with no issue. I have tried cleaning the wipers several times, but to no avail. Before I shell out $60+ on some wiper blades. I know I am gonna probably gonna have to get the new wipers.
View 1 RepliesMine do. Its really weird especially if I haven't been using the wipers at all and I arrive somewhere, shut the car off, and the wiper blades twitch. Just curious to see if this is normal.
View 9 RepliesI am on my 3rd set of wiper blades trying to get rid of the skipping motion. I did not notice this problem with original. I bought one set at Autozone that skipped, went back and bought an expensive pair of blades, they skipped.
I bought the best wipers t, they skipped.
I just went to the dealer and got a pair of blades, they skip just as bad as all the others I've tried.
I have tried cleaning the windshield, This last time I used clay bar on the windshield but that made it worst. It would skip after each swipe after I used clay bar.
The last thing I done was use some waterless wash on windshield that has it temporally stopped skipping. The wipers run smooth so there is not a problem with any jerking or motion or anything like that.
I have 115K on 2011 Prius, not had a minute trouble out of it except for this skipping. I also have about 65K mile on this set of Michelin Energy saver A/S tires, they will go another 10K. I'm averaging 51 mpg Summer and Winter.
I was wondering if the wiper blades are controlled by two separate motors because the other day, I cut off my engine while the blades were half-way through their cycle leaving the blades exposed across the windshield. When turning the ignition back on, one of the blades starting moving slightly sooner than the other one. This may just be slack in the mechanism but it did raise a question for me. If this is the case, it might be a pretty neat safety feature.
View 12 RepliesSince when I bought the car (used) if the windshield isn't really wet, the wiper blades skip across the surface of the windshield and make a lot of noise. This occurred before and after I replaced just the wiper rubber.
View 17 Replies1971 cadillac wiper control lever will not turn on the wiper blades at any speed selected on the control lever but if you push forward on the chrome button on the lever the washer and intermittent wiper blades will work.
View 1 RepliesStill using the ones that came on my truck new in April 2014. We've had some miserable mix of weather lately. Snow/sleet/rain/freezing rain. The blades are definitely on the way out. What are the best year round wiper blades for northern climate?
View 14 RepliesAfter I changed to blade on the left wiper of my 2005 GC the blades hang up at the bottom of the return stroke. This pulls the end of the rubber from the holder on the end of the blade. Wrecks the blade and requires a new one. Happens with new blades so it must be the arm. I may have bent the arm a bit the first time I replaced the blade. Could this be the cause. Need a new arm?
View 1 RepliesI just took in my 2007 RX350 to the Lexus dealer for a "once over" as I recently purchased it, as well as a squeak that was coming from the passenger side wiper blades.
After several replacements (including the high end Rainx and Michelin from Home Depot) the squeak would not go away.
Lexus indicated that the "aftermarket" blades were causing the problem and I needed Lexus blades.
I pushed back as they were about $120 for both, but, much to my surprise no squeak.
Not sure what the OEM blades are and I guess I could have researched it more, but, was at my witts end with the squeak.
Anyway, that fixed the problem.
When I turn off the wiper blades on my 1997 Toyota Camry they do not return to the home or lowest position. They stop at whatever spot they happen to be. The wipers work OK on both slow speed and fast speed. Also the intermittent function is no longer working. In this position the wiper blades operate cintinually in the slow speed. What could be the causing this problem? Could it be the wiper switch on the steering column, the wiper motor, or some other component such as a fuse or relay?
View 5 RepliesLast night while driving in the ice and snow storm we had in the north east my passenger side wiper started acting funny was hitting the driver side wiper and not going full cycle. I think there is something wrong with the linkage,the driver side works fine bringing it in for service Monday.
2006 V10
How far does the rear wiper go? Full half circle; 180 degrees? Or is it less? It seems to me the couple times I used it, it made a full 180 degree sweep. After having the rear window replaced, it now only goes about 140-150 degrees. Stops at 10 o'clock position and returns.
View 3 RepliesI can activate the rear wiper spray, but cannot seem to activate the wiper itself. I am hoping that this is user error (misunderstanding owner's manual) rather than a broken rear wiper assembly.
View 2 RepliesI took delivery of a new 2004 Touareg V8 with nav system radio, yesterday. On the way home, in the rain, the front windshield wipers stopped working as well as sound from the radio (controls, menus, etc... were still illuminated) This is not very comforting. Windshield wipers are quite necessary in the rain. The general technology behind windshield wipers and radios would seem to be mature to the point that reliability need not be questioned. As a new owner having just been through an hour of instruction on operating this piece of machinery, I felt somewhat inadequate that I could not operate the windshield wipers and radio. I said to myself, it can't be this hard! My wife and I became frustrated at each other to the point of my speculation on who would get the vehicle in the divorce.
When I finally made my way into my driveway, I decided to check the wiper fuse because it was most necessary, rain being forecast for the next several days.
I pulled the 30A fuse for the wipers and found it to be OK. I then replaced it. Behold, both the wipers and radio began to work. (The manual does not say anything about the radio being connected to the wiper fuse) Case closed, I thought. 5 minutes later they went out again. I pulled the fuse, replaced it and eureka, they began to work again. I drove the vehicle today for about 30 minutes at which time they ceased to function once more.
[IMG] ....
I have an 05 Touareg and the passenger side windshield wiper is not wiping a small section of the screen, approximately behind the rear view mirror. It's not a problem with the blade (I replaced those) so I suspect the wiper arm needs adjustment. Raising the car's bonnet reveals the wiper arm attachment (see picture) but there's a plastic cover that it looks like I need to remove. Usually I use brute force and break things like this. How to
(1) remove the plastic cover and
(2) adjust the wiper arm
The clips on the cover broke so I bought a new one. Since they redesigned the 04 base, I have to remove the base. I remove the nut on the outside and the 3 on the on the inside after removing the cover. However I can't figure out how to pull the wiper off and replace the base. There is something holding it together. There is a pin that is connected to the inside that has a round hole but it is not a torx, allen, or any type of other tool I tried.
View 5 RepliesI was unable to find a related thread for this topic. I thought there was an old one.
Anyways, having issue of the drivers side wiper leaving an area unwiped at eye level?
New wipers fixes this problem, but for only two days
So the day after getting my 5000 mile service (an entirely different story for that) I tried to clean off my rear window and found that the sprayer worked but the wiper didn't. Leaving even more of a mess.
Both the sprayer and the button on the wiper head to open just the glass work perfectly. With the stalk on just rear wipe there isn't even any sound coming from the wiper motor like it's trying to move but jammed. I have made sure the little prong is in the groove in the circular plate it goes into. I have checked the fuse box and fuse 52 isn't burned out (although oddly it only has a 5 amp fuse in it, not the 30 amp as the manual describes).
The only thing i'd like to check is the wiring under the dash. I can't remember if I have used the wiper since I installed my hands free kit, but I had both the a pillar trim and the under dash panel off. I assume it travels in the bundle down the a pillar, but then where does it go. I was very careful wiring the hands free but I suppose I could have pulled a wire loose inadvertantly re-installing the panel trim or something.
For some reason the wipers only work while moving. At a complete stop, slow, fast, intermittent and the wipe mode do not work. If moving forward all functions operate per the owners manual. The rear works perfect.
View 6 RepliesOur rain sensing wiper has been working flawlessly since new. However, it decided to stop working two days ago. It just goes constant speed now.
View 17 RepliesHow do I turn on the rear wiper without it spraying the window with washer fluid? I've followed the instructions in the manual for using the rear wiper, but very time I turn the wiper on it sprays the window with washing fluid. I don't need washer fluid sprayed on the window if the window is already wet from rain.
View 11 Replies