Touareg :: 2004 V8 - Low Speed Binding When Turning Left
Aug 5, 2007
I know from what I've read that this tsb should have been addressed on my vehical (04 V8 early vin). The car has had two previous owners and the 2nd purchased as vw certified. I bought the Treg when it had been certified again 18 months later, so why does this "binding" due to the stepper motor software still exist after all tsb's have been performed
Its happened twice in three weeks now........when you shut down and start again everything is ok.
View 3 Replies
Advertisement
I bought a 2004 F250 Crew Cab LB 4x4 with the 5.4 Motor and when I turn left it has some Tight Spots and I can't figure out why, I checked the Drive axles to make sure the locking hubs were unlocked and they spun freely, I Also have a lot of play in the steering wheel, Could this all be Related to the Steering Box? What else should I check for ?
View 3 Replies
I have a 01 Chrysler Sebring 4D Sedan. I have been working on cars many years, never done tie rods. This my first attempt, I messed something up I believe. I replaced both inner tie rods and outer ends. I followed what I thought was correct procedure., counted turns on ends coming off. Installed new ones the same amount of turns. Before I did this the steering was fine. Now when I turn sharp to the right or left, like turning in to a driveway, I get an awful binding grinding noise, and I can feel it shimmy in the wheel. It will even stop the car going hard right. I can see evidence of rubbing on the CV boot closest to the wheel on the pass side. I assume I messed up somewhere with setting the steering when I installed the Tie rod ends to the wheel hubs.
View 19 Replies
I just bought a used 2004 Touareg. I think I got a great deal.
I have noticed the noisy windshield wipers, the condensation on the windshield, minor binding problems when turning, and some hesitation/jumpiness in the throttle. I talked to a dealer today and they said if I had a list of things to fix, they could do it in a day.
View 24 Replies
My Toyota land cruiser 1993 dies at low speed only turning left....ONLY leftSo, it started last year while in low turning left off road she suddenly died and I just about rolled her, but was able to turn her back on and keep going albeit in higher RPM. Now, she dies all the time when making a slow speed left turn and ONLY left turn. Also, in low she bucks and starts to die....
View 3 Replies
Got the stabilizer bar recall done in February and have been on a couple of long trips since then. No real issues until about a week ago I noticed at low speed, when turning left, and usually if there was a small bump or incline........like turning into my driveway, there would be a popping/grinding sound. It could happen at speed, but never heard anything. I go last night to install some ECS cross drilled and slotted rotors and flush spacer kit and noticed this on the left front....
Well honestly I noticed first that I needed to wash my car, just got back from the beach and it has been raining here, but is this installed correctly. The bar is bent near the top, easier to see in person and I am fairly positive this is not correct. Called the dealership and they are going to check it out Monda. The picture below is of a left front on a MK7 and it appears to be the correct.
View 9 Replies
The Touareg is my wifes vehicle, so I do not drive it all the time, but I do all of the driving on our vacation. Let me start by saying it was quite hot and humid on vacation so this may be part of the cause. Like the topic says when parking and or turning from stop or at low speeds there was a very noticable groan/hum coming from the front of our 2009 V6 Touareg. Is this common/anything to worry about? Before vacation we had just had it in for the 10k service and everything checked out ok.
View 9 Replies
When turning left , I felt that there was a shock from front wheels. The service person told me that it was a differential problem and the controller unit is needed to reprogrmmed. Is it true? When my Touareg ran over the bump, I felt that the front suspensions were not adjusted well. Is it normal?
View 2 Replies
So, I just noticed this happening about a month ago and it's been occurring more frequently. Whenever I'm turning (left or right) and moving at a very slow speed (1 - 5mph), I feel a binding and sometimes I hear a slipping sound (that's the best that I can describe it). When I hear this sound, it feels like the Touareg's gears or center differential is slipping. What it is? If so, was the dealer able to resolve it quickly?
View 5 Replies
So yet I found out about another common issue but not that publicized. This is the grinding sound when turning at full lock (left or right) in slow speed. I've read several people in the forum who has encountered this. I read different remedies but the most common one is to have the CV boots lubricated.
I have a 2014 Wolfsburg with almost 5k miles. I am really now worrying about my water pump crapping out on me but I heard this grinding sound yesterday.
View 12 Replies
I have a 2004 Santa Fe GLS 3.5L AWD. Months ago I occasionally started noticing a strange sensation when backing up like the wheels were binding. Since it was intermittent I really didn't think too much about it and I don't drive the SF much except during bad weather or on vacation trips. The issue has gotten much worse and happens every time I drive it. This past week it bound up while turning into a tight parking place.
It binds to the point that the vehicle will just stop under normal acceleration. Backing up it does the same thing. When I finally got pulled into the parking place it felt like someone bumped me (I don't remember if this was before or after placing in park). I also feel it when taking very tight switchbacks in the mountains.
So doing research on this I came across the TSB about the Transfer Case Control Module, however after visually inspecting my module I determined it was made in May 2004 so it does not apply to the TSB.
Is it possible my module just went bad? So I am wondering what I should try? Replace the module with a used one (if I can find one) or foot the $300+ bill for a new one. Either way does anything need to be done to program it?
View 11 Replies
I have a binding and clicking-ish noise at low speed. Is that a sign of a bad axle?
View 3 Replies
I have some big time slop in my steering wheel, and what started as a type of binding when turning sometimes, is now really sloppy - almost dangerous
Is this the intermediate steering shaft? I just want to be 100% sure that I get the right thing before I buy it, as it's a dealer only part.
View 2 Replies
My 2009 Impreza 2.5i manual transmission makes a clunking binding when I turn. What the issue is it goes away and comes back.
View 1 Replies
I have a 2008 Elantra with 59,000 miles. When it is warm out (70 F+), the sterering wheel makes a binding noise (squeeking noise - it is hard to describe) when turning. It doesn't do this all the time and it is much more noticeable when it is warm out. The temps are usually mild. This is a recent problem as I haven't noticed it before.
Should I be concerned about this? I want to get it checked before the 60,000 mile mark in case this is a serious issue such as rack and pinion steering problems.
View 4 Replies
I have an 05 V8. When backing out of a parking spot at close to full lock I feel it binding a bit. Also, occasionally when pulling forward (at or close to full lock) it will bind for a few seconds, then it feels like it releases. I recently drove a long (10 hours) trip and when I parked it when hot it seemed to bind/chatter even worse.
I also noticed that on slow hard turn (i.e parking lot) there seems to be a low pitched moaning sound from the rear end area. It it possible it a dreaded stepper motor, even on a 05? It is an early 05. What this might be before doing this so they don't jerk me around and say there's nothing wrong.
View 1 Replies
Just replaced a badly worn Hub on my 98 AWD Explorer. The grinding noise is gone but now the steering is binding/shaking during stopped or low speed turns. What is going on or what I might have done wrong?
View 3 Replies
I have a 2008 F-450 Lariat 6.4 4x4. I recently started noticing the front driver side wheel (best I can tell) wheel makes a noise as though it's binding uo when turning either direction, and I can feel it as well. 4wd is not activated and the hubs are in auto. When the front end is off the ground, I rotated the wheels and they spun independently unless the hubs were locked. I noticed what appear to be seals on both the driver and passenger side hanging loose (see pics). What this might be? I recently used the 4wd when we visited White Sands National Monument while pulling a 5th wheel RV.
View 9 Replies
My 2005 has the ESOF system which has worked flawlessly. Recently I had upper and lower ball joints done and after that repair I had no auto locking hubs. ( independent shop messed up seal install ) they redid the job and it now seems like my front hubs are locking automatically because I am getting binding while turning. So this is the problem.. the front wheels do not "pull" only the rear wheels spin. If I manually lock the hubs I have 4x4 and can get out of being nearly stuck and everything works normally. What is wrong here? Does the shop need to redo the job again?
View 2 Replies
I have an 04 Saturn Ion redline that just recently started sweeping from the front driver side when I turn left. It doesn't happen all the time normally in warm to cool weather, and when I'm turning slower ( around 10-20 mph ). I know it's not the brakes or the rotors as I have just replaced them this week. And my drive axle boot looks okay. What the problem might be? I'm not a master mechanic but I have done some things just as need be so technical advice won't confuse me.
View 5 Replies
2006 RX400h AWD. I've been experiencing a new and irritating creaking sound that happens when I'm turning left and/or right
The odd thing is that it sounds like it is coming from the center console. I've moved it all the way forward, all the way back and removed the contents of the console...no luck.
My searches didn't find anything close to my scenario. I know that there's a TSB for the front seat pins, but my sound isn't coming from the front seat.
View 5 Replies
