Touareg :: 2004 - Premature Tire Wear And Faulty Wheel Alignment On V8
Sep 24, 2004
Premature tire wear and faulty wheel alignment issues on 2004 Touareg V8 with 10,000 miles. My dealer informed me that my original tires, Continental 4X4 Contact 255/55R18s were about to need replacement and that there were known issues with the tire compound and alignment specifications. I have had the vehicle about 14 months. He said it was over twelve months but he would bring it up with the district representative. I told him that I thought this came under concealed defects and I expected VW to replace the tires and align all four wheels to whatever the current spec. Are there VW bulletins covering this I can obtain copies of?
View 1 Replies
Advertisement
24,000 miles, car is totally stock.
Both of my front tires have the cords hanging on on the extreme inside at a really odd angle.
View 13 Replies
I have 3 new tires and 1 with wave or cupping wear. It is a new tire not even a year used. I went in to get my alignment fixed because I was told the cupping is due to car being out of alignment. They told me I have to replace the tire with the cupping wear on it before they do the alignment. Is this true? or can i keep the tire and not have to shell out more money for a tire that is not even a year old. that being said, I am now doing more research and realizing that cupping is actually due to problems with the shocks. not alignment.
It's a 2009 toyota matrix xrs....
View 1 Replies
So due to a puncture I got earlier this week, I had to buy a new front passenger side right tire. Now the car pulls very slightly to the right. Is this due to having about 6k miles on the left tire and a brand new right tire or do I need an alignment again?
View 2 Replies
I have a 2006 SC 430 with 20,000 miles on it The (run flat) tires are wearing on the inside and the dealer says that they need replacing The local tire shop agrees, and will sell the tires to me for less, and also throw in an alignment He says that alignment is the reason for the uneven wear But the dealer says that the wheel on my 2006 SC 430 cannot be aligned, and that the new ones will probably wear the same way
View 12 Replies
I have a 2004 Toyota Camry that the steering wheel veers to the left while driving (not all the time) I have triedan alignment and a tire rotation and still have the problem.
View 12 Replies
I have a 2014 Supercab Ecoboost F150, which has 37k KM on it (23k miles). I work at sea for 4 weeks on / 4 weeks off so the truck sits a fair bit. I had it in the dealer for scheduled servicing and they noticed the inside pads on both front brakes were wearing significantly more than the outside (4mm vs 7mm). The lube guy at the time had suggested sticking calipers and that they'd be warranty.
A few days later I brought the truck back in to have the brakes looked at and an unrelated warranty item done. They looked and said the calipers aren't sticking and the rotors are grooved and rusted, particularly the inside surface. They wanted to put new pads on and turn the rotors for 400 bucks.
I had a hard time believing it wasn't the calipers, and I was having a hard time getting a good explanation from the service writer of what was going on. So I took the truck back and pulled the pass side tire off in the driveway to take a good look.
As far as I can tell, the calipers are free. The slide pins are nicely lubed and are free, and the pads are free to move in the anti-rattle clips. I squeezed the piston back with a set of C clamps and it seemed to be good. Also, the pads are wearing more or less evenly (not tapered or anything), just the inside is worn significantly more than the outside.
So, rotors wearing out in 23k miles? They aren't really warped, just heavily grooved. My theory at this point is that the weeks the truck spends sitting allows too much corrosion to build up on the rotor, which is getting caught up and wearing down the pads and rotor. Maybe the outside of the rotor isn't nearly as bad because it gets hosed down and washed more frequently?
Inside rotor surface
Outside rotor surface
Inside pad surface.
I still have 7 months of bumper to bumper warranty. Ford says the only cover brakes if the damage is caused by a caliper, so I think I'm out of luck on that front.
View 8 Replies
Previous owner of my truck installed a front leveling kit (2" aluminum shims under the coil spring seats) and was told by a dealer that it definitely lead to the wear and tear on the front end, specifically the track bar and track bar ball joints. They also stated it causing the truck to still pull to the left even when aligned because the geometry was off. My truck has 56k miles on it.
I was informed of this after months of trying to correct the death wobble. After 4 alignments at NTB, I took it to the dealer for diagnoses. I paid them to do the labor of replacing the track bar, but elected to remove the leveling spacers myself. Came out in about 45 mins, but had to purchase the shorter stock seat bolt from the dealer which was only available as a package with the coil spring seat...
Truck now rides better and seems perfectly aligned, before it pulled hard to the left. Wish I would have known about this earlier...
View 7 Replies
So I had a flat a couple weeks ago, finally got around to patching it (professionally) and decided to get a wheel alignment and tire rotation at the same time. No prior problems whatsoever (drove straight as an arrow) but roads in Hawaii suck so I decided to have it done while my car was in. Got my Camry back and it pulled to the right, with the steering wheel a little crooked to the right too. Talk about leaving something well enough alone, which is what I should have done!
Tried to take it back the next day, but they were super busy so I went to another location (same chain) and they said they suspect it could be my tires, but if not, they'll realign. They ended up doing the alignment again. My car pulls less but the steering wheel is crooked to the LEFT instead of right now when driving straight.
Question: Do you think it could be the patched tire? The nail was 1-.1.5" from the sidewall. This tire is on the right rear. Looks fine, and was fine up until I got a nail in it. Right front tire looks fine too.
I asked my mechanic, along with my cousin who worked with cars and did alignments himself in a past life, and they both told me they don't think it's my tire(s). They both told me to take it back and have the alignment redone.
Is it possible to just have two bad alignments at two different locations with two different techs?? The chain I'm going to is locally owned and has been around forever, and my last alignment was from them so I don't know what's going on this time.
* I have Michelin Pilot Exalto A/S tires all around, with about 20K miles on them.
View 14 Replies
I had my right front tire replaced due to a road nail. Now when I went for my 10,000 mile service they told me that I need a wheel alignment. My friend told me that whenever you replace a tire you always have to do a wheel alignment. Is t true?
View 11 Replies
How can I locate a faulty wheel sensor with VAG? Should I replace one sensor or all 4?
View 2 Replies
I had my tires rotated about 2,500 miles ago with tire balancing and wheel alignment done. After this the car developed strong vibrations at between 55 and 65 mph. When the speed goes up or down from that range the shaking stops. If I am going at a speed higher than 65 mph and brake the car shudders until the speed is below the 55 to 65 range.
I had the VW dealer do another tire balance, but the problem persisted. I then went to a Goodyear tire outlet and had them do a tire balance and then another one about two weeks later. The problem is still there. The Goodyear people suggested running the car for a while and see if it improves. It has not about 2,000 miles later
The VW tech rode with me and said that it was warped rotors that caused the vibration, but if the rotors are warped, should this vibration also be felt for other speeds?
View 14 Replies
I decided to get an alignment (for the first time since I took delivery of the car). I noticed some unusual wear on the inner and outer tire. I will post a before and after pic of the alignment. As you can see they were unable to correct everything.
The shop says that the prius does not have any way to correct camber in the front nor was there any way to correct the toe in the rear.
I cannot think of anything that would have messed up the rear left. The shop was saying these repairs will need either a new control arm or strut.
View 11 Replies
I have a 2005 Prius with 128,000 miles. At the last service the mechanic pointed out that the front tires were wearing significantly on the outside. I had them do an alignment but the before numbers were hardly out of spec. Everything was in spec except the front right camber - it was right at the limit (negative). Everything else was perfect. I would have expected only significant positive camber on both sides would cause both front tires to wear on the outside, when everything else was in spec?
View 8 Replies
Met with my dealer today to discuss my alignment problems and take a test drive. My car drifts seriously to the right when I take my hand off the wheel. I basically have to countersteer the car down the road.
I took a test drive with their alignment tech, a really nice guy who seems to know his stuff, and he concluded it's a 'drift' not a 'pull' and that the car is within spec now. The only thing they can do is move it slightly more left or do a 'custom alignment', which means they would align it left outside of spec to offset the drift. However, if they do this, they don't warrant tire wear, etc. While I'm never in favor of a band aid fix like this, I'm inclined to try it before I give up and sell the truck. I think it's something more than just the alignment.
Needed to do this, i.e., align the car out of spec slightly left to get it to track straight? Based on his markings, I can see where I am in spec, but I also know what the car's doing and it's pulling right. I'm not imagining it and I've never had this problem with another vehicle. I showed him over and over how it drifts hard right and said this is not normal, but they go back to the spec sheet. As an aside, they told me they have done 50 Treg alignments so far. 50! On a two year old model. That's ridiculous.
View 24 Replies
My 2004 Honda Accord Coupe has around 80,000 miles on it. Right now i am experiencing "chomping" or irregular wear on my tires. The inside quarter seems to be wearing at a significantly higher rate than the rest of the tire. However the outer edges have a very "wavy" wear to them as well. The right side of the car is much worse than the left side on both the front and rear tires. I do have direcitonal tires so i only rotate them front to back not side to side.
Research says that it is struts but when i asked my Honda technician he said to push down on the front and rear bumpers and if the car levels off within one and a half bounces it’s not the struts. I did that and it leveled off both on the front and rear. They don’t' appear to be leaking or have anything wrong with them.
So that left me thinking it was a balancing issue. I then went and got my tires balanced and the issue hasn't gone away.
View 9 Replies
Why are My Tires Wearing Unevenly?
View 2 Replies
So on my wives Prius which is an 2007 the rear tires are wearing more greatly on the insides that the outsides and they are wearing evenly on both the rear left and rear right inside. So not one is more worn than the other..
The tires are heavily worn, with that said the car rides extremely bumpy to the point the entire car is shaking on the freeway at 75 mph or higher. So much so it induces motion sickness which is odd for me. So also besides the alignment question, what else could be causing the insane amount of bumpiness? I balanced and rotated them yesterday but that didn't solve the issue.
View 6 Replies
My front driver's side Bridgestone Turanza EL400 (225/40R18) has premature wear such that the steel belt is beginning to show through the center of the tread. The front passenger side tire has no such wear and the alignment is good.
View 14 Replies
Lexus: GX 470 2003
I went to go get a wheel alignment (when driving my car starts drifting to the left hard/ also when my hands aren't on wheel) and they discovered that my front left tie rod is wobbly (also said lower ball joint is suspect). I was told they couldn't perform a complete wheel alignment until fixing the front left tie rod first.
Overall to fix/part/wheel alignment, the quote is
Labor: 223.97
Parts: 71.13 (I seen online for about 50 dollars cheaper??)
ENVIRO/DISPO: 23.61
Sales Tax: 5.68
Total: 324.39 (After 40.00 coupon)
View 5 Replies
2004 Ford Taurus - transmission was going out last Aug - had it rebuilt (new seals and torque converter) got it back steering wheel was slightly off (1/2 inch) of being the center when driving straight. Took a while to get it back to the shop - life happens - took back today - said they did everything they could and really needs an alignment which they do not do - drove it home after hanging out at the shop for 5 hours. The steering wheel is now off 2 inches from center and the car is pulling noticeably to the right. Going back tomorrow - but they are saying that it was not them and that I need to pay for an alignment.
View 3 Replies
