Tiguan :: TPMS On MFD Stay Displayed Until Press Down On Brake Pedal


Mar 23, 2012

I have 2010 Tig, for the last 2 days, the TPMS on the MFD will stay displayed until I press down on the brake pedal, then it goes out, is this the sign on some problem?

View 5 Replies

Advertisement

Park Avenue :: Engine Bucking - RPMs Stay At Zero Or When Lightly Press Gas Pedal

92 PA Base, 141,000 mls

Whenever I have to drive for more than 50 - 75 miles or for one hour at a constant speed, the engine causes the car to buck and loose acceleration. When I press the gas pedal down to the floor, the rpm's stay at zero or when I lightly press the gas pedal, it would accelerate but with noticeable hesitation and difficulty. I go from maintaining speeds of 70 miles down to 40 miles. It also feels like no fuel is getting to the engine. This causes me to pull over for a few minutes, shut the engine off, and then its okay to drive for a few more miles.

I replaced the fuel filter and the MAF sensor. When I changed the MAF, I noticed that the bottom portion of the old one where the little wires are, was broken. I really thought that was the issue but when I replaced it, it started doing the same thing. What should I check or replace next?

View 12 Replies

Passat (B5) :: 1998 - When Press Brake Pedal Goes All The Way Down

I have just replaced the ABS Module, and replaced the brake fluid in my 1998 VW Passat 1.8T GLI. Now my brakes don't work at all, when I press the brake It goes all the way down. All the pipes are connected correctly and everything was put back the way it was, so I don't get why the brakes aren't working at all. Passat 1998 1.8T GLI...

View 1 Replies

Camry :: 07 - Have To Press Brake Pedal Hard To Come To A Complete Stop

I noticed that the car take a very long time to come to a complete stop and I have to press the pedal hard to stop. The brakes have approximately 11,000 miles on them in city driving conditions. Also the slightest bit I relax my foot, the car begins to creek and move. I have to have a very firm foot on it so it won't move. Is it time for new brakes or should I first begin to look at other potential problems? Also I noticed the car pulls to right slightly could that be related?

View 14 Replies

Camry :: 2009 - Brake Lights Don't Illuminate When Press Pedal

I have a 2009 Camry and both brake lights don't illuminate when I press the brake pedal but during night time driving, the red tailights are on indicating the bulbs aren't burnt. The third brake light on the top behind the rear seats does illuminate. By the way my tailights aren't the fancy LED ones just the normal stock bulbs. So what's the problem here? Is it a electrical issue?

View 2 Replies

Prius (2010-12) :: Swoosh Noise When Press The Brake Pedal

I am looking to buy a 2012 Prius and I test drove it. Everything seems ok except each time I press the brake pedal there is a swoosh noise its as if air is being released from somewhere and I can easily hear it. Is this normal? the car is 95000 km on it. The dealer says it might be a normal hybrid noise. I currently have a 2007 Prius but that does not make this noise.

View 5 Replies

Sonata I45 (YF - 2011+) :: Brake Pedal Is Rock Hard To Press

My brake pedal is rock hard to press and when I do press it while pushing the push to start, it does not turn on.

View 8 Replies

Prius (2004-09) :: Quirky Sound When Press On Brake Pedal

I can press on the brake pedal when car is off or on and there is a kind of quirky sound made. I can hear a pump sound and then a squeaking or quirky sound. It happens every time I press the pedal when it is stopped, either on or off.

View 2 Replies

Ford Super Duty (1999-2016) :: Clicking Noise In Park Or Brake Pedal Press Down - Brake Switch Noise?

The truck in my sig. makes a clicking noise when it's in the park and I press the brake pedal down. The click is coming from somewhere up high in the steering column. It doesn't make the clicking noise in any other gear only in park. Might be normal but I don't remember hearing it before?

View 9 Replies

Prius (2004-09) :: Loud Creaking Noise When Press Down Brake Pedal

I've a UK 2004 gen ii with 69000 miles on the clock. When coming to a stop and also when at a stand still if I press down the brake pedal I get a rather loud creaking sort of noise. I guess that's friction brake related as no noise with using brakes when driving. Also a high pitch squeal when driving and turning steering wheel slightly to the left that stops when you press the brake pedal.

View 19 Replies

Hyundai - Santafe :: Brake Pedal Making Audible Click When Press Down On It

I have a 2002 Hyundai Santa Fe with 152,000 miles on it. Last night, when I got in my car after work, I noticed that the brake pedal is now making an audible click when I press down on it. This has never occurred before (including on my way to work yesterday), but is still doing it today.

No lights are present on the dashboard, and I have not noticed any difference in the performance of my brakes. What could cause this, and should I be concerned?

View 1 Replies

Sonata I45 (YF - 2011+) :: Car Won't Start - Cannot Press Brake Pedal / Hard As Rock

I have 2011 SE, it won't start at all. The car won't start all thou all electrical are working (radio, NAV, Dashboard) but when trying to press the break pedal is hard as a rock. Dashboard computer at times tells me to press the break pedal - but it wont start, it actually turns off when i press the break and hit the start button. It happen twice before was able to start it within couple minutes.

View 24 Replies

Diesel - Ford - F250 :: Hard To Press Brake Pedal While Driving

My truck is experiencing a hard to press brake pedal. It comes and goes and does not seem to happen at any one time while driving. I know that my truck uses a vacuum pump and instantly replaced this as I figured that with the age of the truck it should be done. However even with a new vacuum pump it did nothing to correct my problem with a hard to press brake pedal. I inspected all the lines to ensure that they are holding pressure and replaced two of the three with new lines. Again it still did nothing to correct the issue. I do not have any leakage coming from the master cylinder and no hiding noise from the brake booster.

1996 F250 7.3l Diesel Turbo 270,000 miles Manual Transmission

View 3 Replies

Passat (B6) :: 2010 - Disable Press Brake Pedal To Start Message?

Is there anyway to disable this annoying "press brake pedal to start" on the 2010 with Vag Com or some other magic tricks? I searched and found a thread but no solution if there is any.

View 8 Replies

Accent LC (2000-05) :: Auto Door Lock Is Not Functioning Even When Press The Brake Pedal

I'm having Hyundai Accent GLS Model 2005. Since yesterday, My tail lamp and Third Brake light is still switched on even I turn off the light & I notice that my Auto door lock is not functioning even I press the Brake Pedal. I tried to disconnect the battery & the Fuse and place it back but it doesn't works. Currently, I just pull out the fuse.

View 6 Replies

Toyota - Corolla :: 2010 - Vibration Sound When Driving And Press Brake Pedal

I have a Toyota Corolla 2010 LE. When I'm driving, no matter how fast I drive, I feel a vibration sound. When I press brake pedal, it's worse than driving. I recently replaced front rotors and brake pads. I also replaced whole tires a month ago.

View 9 Replies

Lexus RX 2010-15 :: Hissing Noise When Press And Release Brake Pedal On RX350 2013

Is it all the lexus rx350 had that noise? From the day I noticed hissing noise when I gentally press the brake pedal down and release it . And same noise can be heard when drive slowly and release gas pedal.

View 10 Replies

Prius (2010-12) :: Dashboard Lights Up Only When Push The Start Button And Press Brake Pedal

I have a 2010 Prius Hybrid and lately, on an intermittent basis, I will press the brake pedal and push the start button and the dashboard lights up as normal but when I go to put it in gear nothing happens. The last time it happened the fan was running and I couldn't turn it off. It's like the car is all set to go but all the interior controls don't function. I then shut it off and restart it and everything works.

View 1 Replies

Prius (2004-09) :: 2007 - Engine Not Turning Over When Press Brake Pedal And Start Button

I have a 2007 Toyota Prius. When I press the brake pedal and press the start button the engine does not start or the wheels are not powered by the battery. It gives me the following errors:

The indicator in the Start button lights in Amber Color.
0 kmph mark is not activated in the dash board pannel.
When I shift the gears it only shifts to neutral ("N") gear.

I cant move the car forward or backward. An error message is displayed in the MFD in Japanese language. It is in Japanese and I cant read the error message.

View 2 Replies

Camry 2012+ :: 2015 SE 4K Miles - Brake Pedal Stiff And Have To Press Hard For A Complete Stop

I own a 2015 camry SE - 4k miles on it. Right from the second month I felt like the brake was stiffer and I always felt like I am going to rear end the vehicle in the front. Last one month it became really worst. The pedal feels lot stiff and I have to press hard to bring to a complete stop. Brake is not very responsive. I feel like its still rolling even after applying the brakes and I have to apply the brake very hard to come to a stop. It looks to me like there is a response delay between applying brake pedal and actual stop. I used to drive a Civic and this is my first Toyota so I am not sure whether this issue is common in camry.

View 6 Replies

Ranger :: 1994 - Pedal Won't Stay Down At Emergency Brake?

1994 Ranger XLT 4.0 5spd 4WD 168,000 miles

the emergency brake will hold vehicle but pedal won't stay down. figured it would do the normal "ratchet" feel and sound.

also, i did a really dumb thing with 4wd. i will try to make a long story short. a few months ago when we had that snow storm and then another shortly after, i decided to lock my hubs but DID NOT engage the 4wd. my top speed was 55 in the weather going to work. i came home one night for a brief moment, shut truck off and went inside. i came right back out to go to my mom's house (not a focal point in story but she lives only three blocks away)

when i started my truck i noticed the 4wd light was on (4H, not "low range") could NOT get light to go out and 4wd does not work, engage or "disengage". (i know it's not engaged by the little bit of a test wheel slip on snow packed street)

not sure what to do. was told to check vacuum hoses but it's an electronic shift. what should my next plan of action be?

View 8 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved