Bought new 2012 Tiguan SE 4Motion three weeks ago, today replaced water pump regarding high pitch noise issue. btw, how to make sure if the wastegate rattle issue has been fixed or not.
View 12 RepliesI have a 2009 Tiguan 2.0t 4 motion and recently has started having a very high pitched squealing noise coming from either the accessory belt area or the timing chain. The noise is constant until you are under acceleration and then it goes away. The CEL came on but when scanned it said no codes. and now sometimes the CEL will flash and the car has been idling rough. What it may be?
View 3 RepliesI lost boost, went from being chipped at 16psi to 7-8 with a check engine code and a high pitch noise. Now is the secondary air pump connected to the turbo in any way. It just happened and I'm working on getting the code read. Just curious if my pump is just bad, what im figuring.
View 1 RepliesThe car is a 2011 GTI 2dr w/6 speed, 12,000miles, cat back exhaust and that's it. Recently when I get into my car in the morning when it is cold (social not that cold) and either put it in reverse or just take off from first the clutch makes a really loud whining noise. Generally, it will go away after a few minutes but sometimes it doesn't go away even after the car is warmed up.
The thing that is weird to me is the clutch isn't slipping at all, even on a hard pull. I know that VW's clutches don't have reputation for lasting that long but I would be pissed if they said it was my fault seeing I drive it nice 9 times out of 10. On another note, I had my leaking water pump replaced a couple weeks ago, ever since then after the car warms up something is making a loud noise that sounds exactly like when your ears are ringing. I popped the hood and it sounds like it coming from the rear of the engine bay but its really to hard to pinpoint exactly where.
I just replaced the timing chain and water pump on my 1999 K1500 5.7L. After spending several evenings and a few early mornings working on it, I get everything back together and go to start it up. It starts then immediately dies. After double checking that the CKP sensor, two plugs on breather, and a/c and alternator wires (these are all that I unplugged) are connected I try in one more time before coming in to work today.
Timing chain was installed with No. 1 at TDC and mark on cam at 12 o'clock position as stated in the Haynes manual for the truck. I did not remove or even touch the distributor since replacing the intake gaskets ~3 years ago. Will check to see if any codes are showing in the morning when I have my laptop at home.
My brother has a '92 K1500 5.7L in which he had a leaking water pump. He replaced it with an Autozone unit. After replacing the pump, he now states he is experiencing fluctuating temperatures on the gauge. He has little heat at the heater, even after letting the truck idle and after driving it. This was not a problem prior to replacing the water pump. He has put approximately 200 miles on since the replacement and it has been about 2 weeks since he replaced it. He believes he has all the air out of the system, as he has checked the overflow container and radiator several times and the coolant level has not gone down.
This now "suddenly" appears after the pump replacement, we are thinking it is not the temperature gauge sensor or bad thermostat. We are thinking possibly still air in the system or water pump cavitation.
Four cylinder, 2004 Camry (2AZ-Fe), Auto with 98,000 miles.
I had to replace my water pump after driving with newly replaced Toyota Red antifreeze from the 8 year old Pink. I drove only two weeks and 1000 miles on it.
I believe that was just a coincidence. Some Camry's water pumps do not last even that long. Even if the coolant was not compatible with Toyota specification, it still could not destroy the pump seals in two weeks.
My water pump housing is leaking. My 09 is well out of warranty but that's not really my question. I would like to know what you did when you replaced your water pump. did you upgrade to a metal impeller pump such as the GEBA brand?
View 6 RepliesMy girlfriend has a jetta and I work at a DODGE dealership in service. I recently replaced the water pump and flushed the coolant twice and replaced the coolant with G13 coolant from the local VW dealership. After I finished burping the coolant system of air bubble. After I finished I took it for a spin and being the speed demon I am, I don't hold back on the throttle. I noticed immediately the engine lagging and being extremely sluggish. I ran my shops snap on code scanner on it and I came up with cylinder 1 fuel injector open circuit. Cylinder 6 fuel injector limited power. And last but not least o2 sensor 1 open circuit. If your facing the motor I undid the left motor mount from the frame, lifted the car on a hoist and took the bottom side motor mount off of the motor. I took the cv shaft off of the transmission and lowered the car and jacked the motor up by the oil pan to expose the water pump for removal and replacement. I'm wondering if possibly the o2 sensor could cause the ECU to seize power to two of the cylinders to ensure no engine damage or if its 3 separate problems.
View 3 RepliesToyota dealer said computer indicated the water pump and belt needed replacing. We decided to do the replacement ourself. Now the light comes on which indicates car is running hot. We did replace the coolant. The 2005 Toyota Prius never ran hot before the replacement, What did we do wrong?
View 3 RepliesI have a 2008 Camry SE with about 118K miles
I have replaced the Water pump and the temp sensor recently.
The problem is when you turn the thermostat control to hot on the HVAC dial only warm air blows and it is only warm when the engine is revved or going down the road.
My question is: Is the door on these electronically controlled or vacuum controlled? it is like the blend door gets stuck and is not closing fully or something.
On my 05 Prius (65K miles) I recently had my local Toyota dealer replace both the inverter water pump (for free per recall) and main engine water pump (~$500 based on their recommendation because of some coolant leakage). 1 week later, I got the P1121 code coming off and on intermittently.
My dealer says that the work they did is not related to P1121.
I have a 2007 Accent with 119K on it.
I wanted to replace the water pump and I was wondering if this can be replaced without removing the timing belt or the lower timing belt cover?
My son has a Mustang GT 5.0 that is overheating. I replaced the radiator with a heavy duty 3 core radiator. It had underdrive pulleys so I replaced them with stock pulleys. I put dual electric fans on it. I flushed the block and put a new thermostat and replaced all the hoses (made sure the bottom radiator hose had wire in it so it wouldn't collapse). I put a new water pump and drive belt but it still overheats when sitting in traffic and overheats when driving with the A/C on.
View 14 RepliesI was driving on the highway at about 80 mph when my car made a thunk noise and then the mph dropped to 40 mph. The car was hesitating but I continued to drive it to gas station. At this point steam was coming from passenger side engine front. The coolant was coming out now my car was overheating to the extreme. I drove it to shop. Next day he changed the thermostat and water pump. But he said it took him a while to get air out / bleeding it?! The day I drive off with my repaired car it still sounds loud eventually it sounds like a helicopter!!! Next day take it to Infiniti dealer they say I need a new engine. Internal engine failure! Could this have happened because the water pump wasn't replaced correctly? My car is a 2006 Infiniti G35x, 96k miles.
View 19 RepliesMy son has a 2002 Jetta, we just changed the water pump and the thermostat. The car will sit at idle and the temperature will stay around 190. When you drive down the road the temerature will rise and when you let off teh gas the temperature goes back down. What this could be, I have tried everything I can think of to fix this car.
View 13 RepliesWe had my son's water pump replaced in his 97 F150. It is now occasionally jumping to completely hot. If you turn it off and back on it returns to normal. The power to the engine is cut when it shows to be overheating. The check engine light has now come on.
View 9 RepliesI bought a 2003 Pontiac Grand Am a month ago, I have already replaced the power steering pump, the water pump, plugs and wires, new battery. It was running fine I drove it last night, but the radio has said loc since I bought it. Then today I got in it and tried to start it and it won't start. It turns over like it is going to start but doesn't. I tried the 10 minute reset thing. That didn't work.
View 1 RepliesA mechanic has my car and replaced my timing belt and water pump....he said he had it running and then it sputtered out and wont start..i have never had a problem with this car. Just replacing before it went out.. he is missing something.
View 19 RepliesI had my hybrid water pump replaced (free, under recall) about a month ago. Now the check engine light comes on intermittently, and it's with error code 1121 (Coolant flow control valve sensor stuck). I've seen other people on this forum hypothesize that the work could cause this error (if not bled properly, leaving air in the system). But my dealer said the work had nothing to do with this error and I need to replace the control valve. How to suggest to my dealer that it could, in fact, be due to their work and that I think they should fix it for free?
View 15 RepliesI had water pump and belt changed by a Toyota Dealer on 2006 4 cyl Camry LE. Now the car idles a little rougher, gas mileage is down by around 20%, and there is some subtle chatter noise.
Before the car would idle quiet (could not hear it from inside car), now it is noisier with a little vibration- both in park and drive. Gas mileage is worse, and I am compensating for winter temps (no snow around). I fill the tank and reset mileage to check. The needle also confirms lower mileage too.
A little noise around belt or pump area but another mechanic said belt tentioner is fine, no need to replace. So what could the dealer have done to cause this? What parts/systems do they operate on? Dealer said car sounds o.k., can't hear anything unusual (of course).Is there anything I can check myself or fix myself? I may try an auto stethoscope when I get one. Just want the old car back. Car has timing chain, no belt.