When I accelerate (particularly during heavy throttle) I hear a sound that sounds like a diesel engine between 2000 and 2500 rpm's. It almost sounds raspy in nature.
View 24 RepliesI have a 2003 Camry 2.4 LE with 120k miles on it. It's been very well taken care of. As of now, here is the maintenance that has been completed at my dealership. By the way, I don't trust dealerships, but I do have one nearby that is actually beyond outstanding (and I know a little about cars):
- Regular oil changes, and always with 5W-30
- Radiator flush and thermostat replacement
- Tranny flush
- New front brakes, rear brakes cleaned, and lines flushed.
- Oil pan gasket replaced
- Valve cover gasket replaced
- Spark plugs replaced (at around 105k)
So, with this information being provided, here is my current problem. Lately, as I accelerate between 1500-2500 rpms, the engine has a louder than usual (but not too loud) groaning noise. Basically, the engine just sounds a tad louder than normal along with groaning noise. The engine also feels as though it is running kind of "dry" (if that makes any sense).
Now, above 2500 rpms, it's just fine. It's amazing on the highway, but I feel as though it has slightly lost acceleration in the city. The only issue with the car is the infamous greyish/blue smoke at startup, but that rarely happens and when it does, its a small amount of smoke, and it has never affected it's performance or gas mileage. Another thing is that I had to have that dreaded oil splash guard removed, because apparently the timing chain punctured it and it was about to fall off.
This problem has been recent within the last month. Just before this, the car has been on a roundtrip to Tucson from Tulsa, and Amarillo twice, complete with 32+mpg on the highway! So, what's wrong? Serptentine belt? PCV valve? Cam or something underneath the valve cover?
I have a 2003 excursion... it is a v 10and just yesterday there was a whistling noise. I parked the vehicle and idle it slowly but no noise. I drove it again n the noise was there again. So the noise is there at 2000-2500 rpm. I'm wondering if its my exhaust manifold?? Also I'm starting to loose power. When running and in parked it shut off.
View 10 RepliesI recently purchased a 2013 elantra.
I have noticed that there is engine vibration and noise felt in car and pedal when accelerating at around 2500-3000 rpm's before it shifts. Is this normal behavior? It just does not seem as smooth as it should be. I have only put about 600 miles on the car.
It has been very cold, but it does not go away after warming up.
I have this noise, and it has become very annoying as it occurs at the engine midrange rpms.
It is buzzing/howling noise that comes on above 2500-3000rpm, whether it is in gear/underload or in neutral/park. It is noticed most while in sport as it holds lower gears longer.
Electric aux water pump was replaced not so long ago. Have read about the wastegate rattle issue, but im not sure.
Took it to the dealer about two weeks ago for this and the tech said he could not even hear it on the test drive.
Here are some links of the said noise
Links: [URL] .....
2011 2.0TSI Tiptronic 4motion 170ps 55000km
2011 Sonata GDS. I previously purchased 19" Gen coupe wheels and never had a problem immediately. Approximately 2 months later of driving with the 19" wheels, when I got onto the highway one day, the car did a slight jerk with acceleration and the acceleration halted for a split second. Ever since that day, anytime I accelerate fast and/or reach highway speeds, the car has a delay when I hit the throttle. The car then has a "rattle" "groaning" sound that comes when the RPMs hit around 2000-2500 rpm. It will go away if I drive slow speeds/slow RPMs or shut the car off for a short amount of time. I have taken my car to the Hyundai dealer 3 times. I've had the adaptive values for the transmission and engine reset and that didn't do anything. I had a mechanic ride with me in the car to make sure they were hearing the sound and the delay in shifting and the mechanic was very shocked and had never even heard a sound like this before.
View 10 RepliesMechanics say they don’t know what wrong… I had some transmission work done on my truck – mostly an leak and replacing the harness – and ever since then after it rains or if we have a heavy dew my truck does the following:
Driving from O to 49 miles an hour truck is fine, as soon as I hit 50 the truck starts surging and you can see the tachometer jumping from 2000 RPM to 2500 RPMs. I drive around 17 miles to work where my truck will sit for seven hours. On the way home the truck is fine. I find this to be more of a problem when the truck has sat for a day or two over the weekend without driving it. Sometimes the “check engine” light will come on, sometimes not.
I have taken it to two different places and neither one says they can find anything wrong with the truck. I have driven this truck for over 11 years and know it very well. There is something wrong, but what? 1993 Chevy Silverado 3500 Diesel....
Started a few days ago, There is a faint whistle noise when I am open throttle around 2500rpms. It lasts for about a second and does not occur at any other time. It does not occur under gradual acceleration, or when the car is parked/in neutral and just revving. I tried searching the forums *a little* bit, but my keywords just may have not been right.
My first inkling is that it may be related to flapper, since the rpms seem right and sounds vacuum related to me. But, the unit is completely disconnected (have borla cat-back) and the hose is ziptied, so is this possible? I will try to get a video of the noise later today.
My F150 with 175,000 miles on gave me a the ol' P0305 code indicating misfiring in cylinder #5. I changed the plugs and wires using Motorcraft wires and Motorcraft AGS34FM plugs.
Now the truck idles fine, does not give a OBD code but runs rough at 2,000-2,500 rpm. Tried it out on the highway and it started "bucking" a bit. Not sure what to try next.
My 2008 Accent started to stutter between 1500 and 2500 rpms. Now the check engine light has come on, and the engine is idling rough.
View 3 RepliesI have a Chrysler Sebring 2005Engine cuts out at 2500 spurts stutters can't go above 35 mph...But still runs... No cruise available will not come on.. Engine light on... Which I guess from what I read is normal In "limp mode" Got it home.. Shut it off.. Starts back up.. I'm thinking cam/crank shaft sensor? Both of those are new.. And an ECM all from a prior problem.. Or fuel pump.?? Not enough pressure to keep up with demand..
View 4 RepliesHad a first-time issue with my car today. Background, 2010 II bought in June, just short of 15K miles, never had any kind of mechanical issue.
While en route to work this morning, I was about halfway into my 15 minute drive to work, when I noticed my engine was idling very high, I would guess 2500 rpms. It started doing it while I was driving around 35 MPH, then continued doing it while I stopped at a traffic light, and continued when I continued driving to a speed around 50 MPH. The high idle while stopped was not transferred to the wheels, so it was not a safety issue as it would be in other cars.
When I got back up to 50, curious to try something, I hit the ECO mode button and the car returned to normal. I took ECO back off and the car was still fine. I had no further problems.
I would point out that this morning was about the coldest temp that the car has experienced. Outside temp ranged from 7 to 10 degrees.
I have an 03 Camry LE with 80,000 miles I do all the maintenance myself it has had the alternator replaced once at around 40,000 miles. The problem that just started is a whistling sound that ONLY is audible after 2500 rpm at acceleration. When the car is in park no matter how much I revive the engine I can not get it to make the whistle sound it ONLY can be heard at acceleration after 2500 rpms.
Also once I cease to accelerate it goes away while I'm driving there is NO Whistling. I've read that it could be the alternator so I had it checked twice on the car and it checked out good it passed all tests. I've removed the belt and spun the pulley to listen for bad bearing but to me sounded fine. I've removed the throttle body boot and checked for cracks an found nothing also cleaned throttle body (not that it needed it) while I had it off.
Also checked air box and nothing. The only thing I've done recently was take out cabin air filter to clean and replaced it but there was no problem with that. What's puzzling is that it ONLY occurs at acceleration after 2500 rpms then stops after acceleration.
I've been getting a blinking engine check light.. I pulled all the codes:
P0050: H02S Bank 2 Sen 1 Heater Circuit
P0155: O2 Sensor Heater Circuit Malfunction Bank 2 Sen 1
P0304: cylinder 4 Misfire detected
P0688: ECM/PCM Power relay sensor circuit
I've had the car sitting for awhile because I lost my job and didn't have any money to roll it around much.
I just changed out the spark plugs and two of these had a white coating on them.. I was hoping this would take care of the misfire after I replaced them. I also bought a new battery because mine had lost charge a few times.
The Car will run with an engine check light, but if I go past 2500-3000 rpms then it will start blinking (which means don't drive it )
The oil has been sitting in it for about 2 months, so I'm about to go change that and I'm hoping this will allow me to drive it without issues.
Any of these codes thrown and know what they could be? Which O2 sensor (like a link to a website that sells them). Trying to get this thing running again.
Yesterday as I crawled my way through heavy traffic on my drive home from work, my car started lurching unexpectedly. When I let up on the gas, the lurching subsided. I was able to recreate the behavior multiple times on my drive home, as well as while parked in my driveway. As the RPM exceeded 2500 the engine would lose oomph/power and the RPM would start stuttering/oscillating between ~2500 and ~2800 RPM. The behavior was identical regardless of which gear I was in (D1, D2, D3, D, or N), regardless of my speed, and regardless of how aggressively I was pressing the accelerator pedal. Every time the RPM hit 2500, the engine freaked out.
This morning, it did NOT happen when I tested it briefly. I was able to rev up to 3500-4000 RPM without any issues. I did read a case online in which someone experienced a similar issue that only manifested after the engine had been running a while. My car has ~173k miles on it, and this is its first engine issue. What might be causing this?
Video attached; also located here: [URL] ....
1984 prelude...1.8l .... I have posted previously on this vehicle and I have had some "success". The car will run with the support of starting fluid but will only stay running if the engine is kept at 2500 rpms or higher. If you let off the gas, it will bog out and die. Starting it requires another shot of starting fluid and a foot on the gas.
View 14 Replies!995 honda accord, 5 speed. Idle is fine until the engine warms up, then fluctuates between 1500 to 2500 rpms. The idle control valve was cleaned- no change. Valve was also replaced -also with no change. Put old valve back on. Computer was disconnected after cleaning and also after each valve change.Would the next step be to remove and clean the fast idle thermo sensor? Also how do you check the coolant lines coming in. Anything else I would need to check, clean or replace.
View 2 RepliesI have recently had some problems with my 2001 Yukon, it a 5.3L and has 4x4. when I accelerate I get about 2000 RPMs maybe and can barely get above 35mph. I brought it to a local dealer for a diagnosis and was told I had a bad catalytic converter, four bad O2 sensors and bad injector connectors. I've replaced the injector connectors but its still acting up. I don't want to spend the 700-1000 on a new catalytic converter when I can just replace the sensors.
View 4 RepliesTruck: 2001Ford F350 5.4 auto 4x4
Issue: Engine seems to free rev over 2500 RPMs. Barely hits 50 MPH. Revs fine in park, no power in gear. At 1/4 throttle it will move, but sluggish at best. Once you get around 2500 RPMs it stops accelerating and just revs. Does this in every gear, and gets worse the faster you go. feels like its stuck inbetween gears almost. No CEL's
Replaced: MAF, TPS, Trans fluid and filter, fuel filter, cleaned intake system, fuel system treatment, O2 sensors. Trans fluid was dark, but no burnt smell.
I'm about to pull the exhaust and look for a clogged cat.
I drive a 2000 Celica GT 5 speed. I am having an issue with my 1ZZ-FE.
I am hearing a ticking/rattling noise from my engine around 2k-3k RPMS. Anything before or after that, the noise dies down. I could hear it from the interior of the car as well. I at first thought it was valve chatter. Someone said It could be a piston or rod. What parts will be needed? Worst case, ill just swap in a 03+ 1ZZ or go with a 2ZZ.
[URL] ....
I have a 2002 Chevy Impala driving it in the city of Chicago. It's recently had the oil changed, and the transmission fluid flushed and filter replaced. This car was mine before I went off to school, and I meticulously maintained it for three years, and then my step sister inherited it. She drove it for two years, and then it sat in the driveway for a year and a half. It's got about 175,000 miles on it.
Problem: Every time I start to accelerate past 25mph and get around 2000rpms, the car starts to give out, sputter and jerk. It starts to drop off right when it should be shifting to second gear. When on the highway, even if I floor the gas peddle, it won't accelerate normally, but instead just crawls slowly to higher speeds.
It will eventually reach the higher speeds, but it takes about 5-10 minutes for it climb up from 25mph. I don't know enough about this level of car trouble to make a diagnosis myself, and would like an estimate of the cost for repairs. Also the car is getting around 19mpg on the highway, which I need to improve if I'm going to survive the $4.50/gal of Chicago gas. I'm hoping that fixing this problem will take care of that as well.