Looks like I am off to the dealer again after the fuse box died on me now the cabin fan control doesn't work. On position 1-2-3, I get nothing and on number 4 its working at max. For the past few weeks when its cold the fan used to make a whining noise until it heated up...
View 1 RepliesI bought the car with it a bit over 3 months ago, that was the only problem and simply couldn't pass the deal. Even used car dealer didn't know what it was.
You can only hear it when you go over 50-55+ mph and it comes from cabin air filter area.
I already changed cabin air filter, the other day I replaced filter tray as well due to broken clips. Cleaned the whole area real good and still can't get it to stop whining.
I'm new here to the F-150's forum although I've owned a few since 2001. I bought this F-150 '05 5.4L Lariat. Really nice truck. But when I purchased it, it had this weird noise inside the cabin. I thought because it had a camper on it that some tranny noise was coming up thru the camper and the rear cab. After taking camper off, the noise was still there. From everything I've read online, it could be rear pinion seal, differential bearing, tranny, front hubs, etc. I have left a video. Pay close attention to the little whine. Kinda hard to hear if your not listening for it.
Note- when i drive it is most definitely coming from the middle to rear of the truck. But I'm not ruling out anything. I have looked underneath the truck and the differential is dry and the driveshaft area near diff is dry. No leaks. I have not checked fluid in diff. Is there an easy way for these trucks? I have read and heard about adding an additive? The noise starts at about 10-15 mph all the way up to 80. I've never taken it past 80 but I'm sure it's still there.
[URL] .....
My wife has a 2015 Tiguan, 4 months old, and unfortunately a few early gremlins. The battery died after about a month - it was defective and we replaced it with an aftermarket to save a trip to the dealer (I know how to measure and detect electrical issues).
The Tiguan has also had intermittent gas odors in the cabin. Happens after it is started and is fairly strong but last for about a minute. Unfortunately it does not always happen and my wife has not detected a pattern such as cold starts, cold weather, full tank of gas, etc.
My wife is sensitive to the odor and I'm concerned about a potential gas leak (albeit a small one).
VW can't figure out why there is a gas smell inside the cabin after start up. My Tiguan has been in the shop going on 4 times now. All seals have been checked and fuel pump replaced.
View 1 RepliesOver the last several days I've noticed a faint whining noise coming from the engine when I pull into the garage. Sounds similar to the noise you hear when you keep an elevator door open for too long.
This is the first turbo engine that I've had so I'm not really familiar with the sounds it may or may not produce, and whether this is normal behavior.
Our 46K mile 2012 Tiguan starting making some pretty loud whining/growling/rattling engine noises recently so I took it to the dealer shop and they diagnosed a bad accessory belt tensioner. However, they didn't have one in stock and would have to order it. Well, that's fine but it's a 300 mile round trip to the dealer so I came home and ordered one from ECS Tuning.
I found a copy of an official VW (ETKA?) procedure on the web for replacing the tensioner for the TSI in a Golf so I suspect the procedure for a Tiguan is similar: remove the bolt for the secondary water pump and move the pump out of the way, remove the end bolt on the tensioner mounting shaft, remove the three bolts from the pendulum/dogbone, support the engine, remove the top two bolts from the passenger side engine mount, drop the engine about 2 inches and pull the tensioner out.
To be honest, I was very surprised that the dealership didn't have a tensioner in stock. This was a rather large and pretty good dealership shop (three service advisors). I guess accessory tensioner failure is really rare on the TSI.
This morning, the driver's heated seat in my 2012 Lariat did not seem to operate properly. (It worked fine approx 14 hours earlier.) Note that my seats have both the heat and cool options.
I started the truck (its NOT garaged and the air temp was -5 F, which has been kinda typical lately) and turned on the driver's heated seat to high (level 3). I noticed that the seat's 'air noise' was more than normal (I've always noticed a more air noise with the 'cool' setting .........
No, I was not using 'cool' instead of 'heat' !) and that the seat never warmed up during the 10 minute drive. (Normally it would be noticeably warm in less than 5 minutes.) The 'air noise' seemed to cycle off/on toward the end of the drive. I did not have a passenger, so I did not have a chance to try that seat.
I've owned the truck about 2 years and had never run into this before.
I've been working on my car for a few weeks now and I've been doing my best to figure out. The source of this sort of 'metallic grinding' that I'm hearing within the cabin. I cant seem to pinpoint where it's coming from within the engine bay with the hood open (maybe due to the magnaflow exhaust diffusing the sound from the outside of my car). I can easily hear noise when I'm inside however with indications its coming from the lower central area of the engine bay. I drive an '04 Volkwagen GTI 1.8T
In the days I've been working on it I've replaced the:
1. Timing Belt (and tensioner pulley/tensioner dampener)
2. Water Pump
3. Serpentine Belt
4. Thermostat (and housing)
5. Clutch disk and flywheel (from a SMF to a LUK DMF clutch)
6. CV Axles (both drivers and passengers)
7. Clutch Cylinder Slave
8. Wheel Bearings (front left and right)
9. Rotors (Front Left and Right)
Diagnosis**
The car starts without any problems just as it use to prior to the replacements done. BUT it's once I get the car moving where I begin accelerating I start to hear a dull grinding noise/rumble that becomes more and more apparent the faster I go. It seems the sound is directly correspondent to wheel movement upon accelerating. Nevertheless I could be wrong.
I had a friend tag along to diagnose the sound and to him it sounded similar to the "tunneling of air not being properly sealed" but to me it sounds like a metallic grind. My friend also mentioned that he felt it was louder towards the passenger side in contrast to the drivers. As mentioned before the sound is reproduced anytime wheel movement occurs. I've checked torque spec for every replacement job done to the car so there are no loose bolts/nuts/brackets. (but there are exceptions, which I will get to).
Knowing that I've replaced both of the wheel bearings (and hub assembly) I can only assume the sources isn't from there. But I do admit a few mistakes while I had the car on jacks.
1. During the timing belt replacement I thought I would need to remove the exhaust (because I felt it would interfere with the lowering of the engine) so I, (without success), tried to remove the connection between the "bend of the exhaust" to the manifold which were 4 'turbo studs'. I had the worst time with the removal of studs but I was able to impact one them off, and as I tried another the strength of the impact broke one them half way through (meaning that I was able to unthread it a few threads but it snapped in the process, so I would need to somehow drill it out in order to replace it). This is where I gave up and did my best to install the one I had removed. Which I could only get threaded half of the way in.
-All in all I have 1 broken stud that still making a connection, and 1 protruding stud out of the 4 that connects the exhaust to the manifold.
Question: Can this be the cause of the sound? Without the full connection of 4 studs bolting exhaust to the manifold? Can this be the sound That my friend was referring to as the "tunneling air not being properly sealed"?
2. The second "mistake" isn't necessarily a mistake but a fault I found later that has to do with the Passenger CV Axle. I read a few forums here and read that it could be a problem with the axles, so I put the front end on jacks once again and found that there was a bit of movement of play on the axle shaft itself. In detail, the 2 connection points for the axle both at the Output differential flange and Hub assembly are secure and torqued to spec without any loose bolts.
BUT the rod itself seems to shift about a 1/2" between these two connecting points.
Question: Could THIS be the problem? With this type of 1/2" shift in the rod is it possible it can recreate the dull metallic grinding I'm hearing so much?
I have had my car at the dealership once before for fixing some rattling noise in the cabin. That was a couple of months or so ago. The rattling is back again, this time from the front doors area and from the front speakers or dash area near the speakers.
View 5 RepliesLooking at a V10 that I thought I might buy.... but it has an odd noise from the steering column. Noise is present when the engine is running - and is there whilst driving. However if, when stationary, you hold either side of the wheel and just move it fractionally, the noise goes away completely.
The noise sounds a bit like gas escaping from a pipe, or more accurately reminds me of the noise of gas being throttled like in a regrigeration circuit. Although I don't think it's anything to do with the air con. The car has the electrically adjustable column... but playing with this has now effect either.
Was wondering if take out the carpet and added dyno mat or fat mat yet. Does this make a big difference in road noise? Or very little? My C2 seems pretty loud on the freeway.
View 9 RepliesI have 06 passat 2.0L. When I turn on my cabin fan its making a noise like when a piece of paper is hitting a fan or something but a heavier sound. How do I get to the blower motor to see if something is stuck in there or something came loose?
View 2 RepliesI have noticed for some time, over bumps that the cabin makes lots of noise. It doesn't sound solid, it almost gives a hollow noise when going over a bump or pot hole in the road. I hate that it doesn't sound solid. The noise resonates from the rear. Almost like a plunk, plunk noise.
View 5 RepliesI installed a new cabin air filter and I am getting some fan vibration noise. Gets really noticeable around speed 3 or 4. What could be causing it? It is the TY brand filter.
View 4 RepliesAfter about a 40 minute drive I notice this noise from the cabin when I parked. I popped the hood and took a short video. What this is? It's a Golf SE 1.8T. (Video)
View 16 RepliesI'm trying to figure out what is wrong with my Prius. A few weeks ago, there was a big rainstorm in California, and I accidentally backed into what I think was a storm drain under very deep water. I heard a big thunk, but there was no visible damage to the car. A few days later, I noticed a low groaning noise that comes from inside the cabin, somewhere around the center console/front passenger side. I usually only hear it when I am moving at low/moderate speeds and turning the wheel to the left, although occasionally if the road is bumpy I hear it with my wheels straight ahead. For a couple weeks, I thought the noise only happened when moving-- however, last Friday, I was sitting in the car, which was parked on a hill with the wheels curbed (steering wheel all the way to the left). I turned the car on, and immediately the car started groaning (even though the car was in park). Then, after about 30 seconds, the gas engine turned off (I think that's what happens when the car gets much quieter after idling for a bit) and the noise stopped. SO, it happened when the car was in park as well.
View 6 Repliesmy 2002 chevy s-10 started making an air/hissing noise inside the cab. It seems to be coming from around the air conditioner controls (center front). It hisses while running, whether moving or not, does not change when the air conditioner or fan is running or not, but does improve when accelerating quickly. What could this be and would it be an easy fix or a professional job (my husband restores old cars, but doesn't do a lot with the newer ones)?
View 1 RepliesAfter replacing the cabin air filter I heard a loud noise from the fan area in the car. I rechecked the installation which was ok. I then reached down into the fan assembly, and there was the problem, some leaves had fallen into the fan when I removed the old filter. Took out the leaves , and all is well.
I replaced the OEM filter with a Fram Fresh Breeze filter which interesting enough only had half as many folds. I figure a big company like Fram must know what they are doing?
If the windows are closed you can hear it much better. The best way I can hear it is when I am stopped and i step on the gas just enough to get the rpms up. Another way to hear it is when I am at a red light on a hill and I am using the clutch. It's a rubbing sound but not as fast as the engine if that makes sense. Would that be the clutch? It doesn't matter whether the clutch is in or not, you can do it in neutral as well. Vw seems to think its the clutch but i have no slipping or anything. 65K miles no engine mods except intake.
View 2 RepliesAny way to make my Accent quieter whilst driving. It is not overly noisy in any way, but it is certainly louder than most cars in the cabin. Is there any sort of solution to this?
View 1 Replies