Suzuki - Esteem :: Engine Stalls Out After 3 Seconds At Idle When Car Reaches Operating Temp
Oct 21, 2015
I have a Suzuki Esteem on which I have recently had following work done from a suzuki dealer on their recommendation.
1) Throttle body repair and Cleaning.
2) Idle air control valve cleaning.
3) New fuel filter, air filter, spark plugs.
4) Engine tuning.
5) New battery.
6) New power steering belt.
PROBLEM: (Only when AC is OFF)
When my car reaches operating temperature the engine stalls out after three seconds at idle.
Suzuki dealer does not seem to know the reason behind this and they want to keep it for a few more days however i think they will just keep replacing parts one after another.
View 2 Replies
Advertisement
I have a 2000 Suzuki Esteem and I live in Minnesota (just in case the cold affects it). This morning my ignition won't turn at all. I have tried wiggling the wheels to unlock the ignition, but nothing is working.
View 5 Replies
When I start my van first thing in the morning it starts fine when it reaches t2he normal operating temp on my gauges, it begins to stall and dies. Then after Restarting it once or twice it runs great the rest of the day.
View 1 Replies
95 ford f250 with 5.8l. I have currently replaced the battery, alternator, distributor, cap, rotor, icm, coil, plugs, wires, act sensor, ect sensor, fuel pump, fuel press regulator. I got it to start today by messing with timing at distributor it ran to operating temp and died. Would crank but not start.. So I replaced the act tensor today.. Now it still won't start... koeo test gives code 327... I am stumped and about to tow it away...
View 11 Replies
It's happened since new, I figured maybe it would work itself out, but it hasn't. On the first start up of the morning, It will start fine, rev up and as it is reving down it will chugg, miss, and shake, for about 5 seconds or so until it reaches idle. If I put it in gear while it does it, the whole car will lurch and shake. It operates fine after that.
View 1 Replies
I have a 05 6.0l. Egr deleted. And my truck has a rough idle and power loss. Ive tested the ipr and the icp and they are reading at specs. I've also replaced the Hpop about 1500 miles ago. It has a real rough idle until it's at running temp. And it has power loss, I'll be driving down road and theres no where near has much power has there should be. And the idle will jump between 1500 rpm and 2000rpm.
View 9 Replies
Not sure if it's just timing chains or what...Maybe DMF? If it is the chains, is this excessive for chain noise? The noise starts once the car reaches operating temps. , video included.
View 9 Replies
How long would you say the engine reaches the full/normal operating temperature?
I have tandem parking at my place and in the morning my GF leaves for work before I do. So I drive at least about a mile before I shut off the engine to make sure everything is warmed up.
View 9 Replies
2006 Passat 2.0t. With the engine cold, the a/c will blow warm until the engine gets up to operating temp and the rad fan kicks on. After that, it will stay on and blow cold all day. I would think the rad fan should kick on as soon as I turn on the a/c to get air flow moving across the condenser as in every other car I have ever owned.
Does rad fan kick on as soon as you turn on the a/c? I'm thinking that i might have a problem with a relay that suppose to kick the rad fan on. I used my VAG.com software and its showing no faults.
View 3 Replies
Cold start ok . Problem arises after engine is at operating temp. After stopping for whatever and attempting to restart, dash no longer lights up with key in on position but starter cranks and engine won't start. Leave key in on position for about a min.dash lights back up and engine starts.
View 6 Replies
I've got a 1997 Nissan Altima (automatic, GXE). Recently it has started stalling. Usually this happens when the engine has warmed up to normal operating temperature (though last night it happened when the engine had just started).
Usually when it stalls it will start right back up, but sometimes it takes a few minutes. Sometimes it will start back up and die right away, other times it will turn over and over but not start. After a few minutes it will start back up. Sometimes it will stall momentarily and then restart right away, but not usually.
The rest of the time the car runs smooth as ever, no surging, no stalling, no erratic idling, no sputtering or anything. Usually the check engine light will come on after a stall, but I get a "no code" code when I check.
This started about two weeks ago, it did it once on a Saturday and then didn't do it again until Wednesday. Since then it has happened at least once a day, and yesterday it happened a lot while I was driving home, but not at all when I headed to work. Today it was fine for about 15 minutes and then started doing it a lot, but the last 3 or 4 miles it was fine again.
What may be the problem? I'm going to check the MAF and throttle position sensors, though I would assume if they were malfunctioning I'd either have more symptoms or I'd be getting a code.
View 10 Replies
I have a 2004 Grand Prix and it is displaying the symptoms of overheating but the temp gauge is not going above normal operating temp. I replaced the thermostat twice, and after driving for about 10-20 mins coolant comes out of the overflow. I'm at a loss, I'm thinking temp sensor(?) But I don't want to keep throwing unnecessary money into it. The fans work fine, the heater blows as it should.
View 8 Replies
I have a 04 f350 6.0 with about 195xxx miles on it. The other day my truck started acting up. It starts and idles without a problem and drives fine till the engine gets to operating temp once there I cannot accelerate quickly like getting onto the highway to get up to speed it just the motor just goes quiet and won't accelerate. It usually does this a little after 2000 rpm. I can let off the throttle and slowly get to speed as long as I don't go past 2000 rpm. No check engine light was not on scanned it and got p0611 for the ficm. I tested the ficm and it read 48v with key on. While truck was running I got 46.xx v then Started to climb to almost 48v. The truck was warm but not at operating temp where the problems starts(didn't have time to let it warm up all the way) could these symptoms be the ficm still? What else should I test?
View 5 Replies
Here's what is going on with my 2000 Dakota V6 3.9L V6:
After sitting for at least a couple of hours, the truck will crank but not start. After 3-5 tries, the truck does start but idles roughly at a very low RPM for 10 seconds or so and then stalls. I turn the key one more time and it starts up great and idles and drives normally. This behavior is very consistent. I have only driven it about 5 miles after it started doing this, because on that trip, the engine stalled while I was driving. Occasionally the MIL comes on and gives P0443 as the code. Question is, can the evap purge solenoid cause this behavior if it is going bad? I have inspected the vacuum lines, and they seem ok.
One more note: When this first started, I was pretty sure it was the fuel pump. Replacing that has not fixed the problem, and the fuel pump relay is good.
View 1 Replies
seems a bit rather loud. Can hear part of it while in car idling and the hood closed.
Is this normal or indicates potential problem to fix?
[URL]
View 2 Replies
So today I was driving to work and it was pretty cold out. It was about -22/-30 C with the wind. The drive is about 20 minutes in traffic. I to through drivethru and as I am leaving I notice that the temp dropped from about 90 to around 75/80. I then drive accross the street to work and the temp goes back up to 90. So I decided to sit there and let the car idle for a few minutes. Then the temp dropped again by about 10.
So I called the dealer and stopped by. All they did is take it for a test drive and do a scan to tell me everything is fine. By then the temp had warmed up outside and the issue was no longer present.
Having issues with fluctuating temp once your car reaches 90?
I know with my MK4 Golf 1.8T when I used to be in stop and go traffic the gauge would go down. So I replaced my thermostat and all was fine after that.
Do a modern car can a scan detect temp going below 90? Or could be a sticky thermostat?
It's a 2015 Golf 1.8 TSI
View 7 Replies
I have rpm stalls then comes back every 2 seconds at idle After one hour driving . Whitout any error code and no check engine . I checked all the sensors and even changed alternator and throttle body completely. No I suspect to crankshaft position sensor .
View 4 Replies
I have a 6th Gen 2007 Toyota Camry with the 4 cylinder engine with 150,000 miles, original owner.
After changing the car battery, the engine idle when at operating temperature went from the stock 650 to 450 RPMs. The engine does not stall and runs amazingly smooth at 450, but the drive ability from start is jerky and the car will roll backwards in drive on a small grade while in drive.
Another tip, before this issue, when cold on start up the engine would rev to about 2,000 RPM's then slowly drop which I understood to be normal and part of the emissions system. Now it revs to about a 1,000 and quickly drops to 450.
View 8 Replies
My F-150 ac shuts down when air temp reaches above 80 degrees. The freon has been checked, the compressor clutch cycling switch & high pressure switch have been replaced with no effect.
View 9 Replies
2.5 months ago I had a coolant flush in my 2007 explorer Eddie Bauer. The last 3 days last week the temp gauge went from the middle where it usually sits, to maxed out in the red. Stays there for about 45 secs and then drops back down.
Is it coincidence that I had a flush and maybe they didn't fill it all the way back up or is it somthing else ?
One other thing- even when it sits in the middle of the gauge I can sometimes hear the engine sucking in air like a vacuum so I guess at certain times its running hot but just doesn't raise the gauge just yet.
View 1 Replies
My 2001 1.5l works fine when cold however once it reaches temperature it will hiccup and then stall! It WILL NOT fire up until it gets cold again. Usually happens when we are coasting to a stop. I'm not a mechanic but can am mechanically inclined. I brought it to Autozone and had the computer codes sent (yes check engine lt was on) One code was a fuel lean code. Cannot recall the exact number. When it act up it sounds like there is either no fuel or no fire. I cleaned the mass air sensor and put fuel treatment in it and I replaced the fuel gas cap.
View 1 Replies
