I have a 2000 suburban with a 1500 motor and 300000 miles. Last year I replace the water pump and the thermostat. The heater would blow warm but not hot . But only when I start to drive. Yesterday I decide to change thermostat again thinking the new one from last year was faulty. Now the heater only blows cold air .
View 3 RepliesI am having a problem with the heater on my 98 2.7 Intrepid. Will not blow hot air when idling (just warm). After several minutes of driving with heat on air temp goes from hot to warm. It might just be me, but it seems like the air flow is cooler coming out of the defrost vents than from the dash/floor vents. Thermostat has been replaced (proper operation verified before installing). Had to replace gooseneck and heater coil supply tubing due to a leaking bleed valve. There appears to be NO air in the system.
Heater core was backflushed, there appears to be no restriction. Hose temp on exit line is approx. 15 deg. cooler than supply line when fan is running. Blend door actuator was replaced last spring (motor shorted). When temp control is moved from hot to cold temp changes drastically and door can be heard moving. On-board ATC diagnostics indicate all is good. Engine is running at normal operating temperature, not overheating or running cold. Is there a cabin filter or inlet supply for the air that could possibly be obstructed? Air flow seems adequate, not restricted. AC works fine.
My heater quit blowing hot or warm air all of the sudden. I took my mechanic and they said it showed no codes and were afraid to mess with it so I took it to a dealership. They worked on it most of a day. Said nothing showed a code as bad, they got into it and found the air going into the heater core was hot, but it was cool coming out. They spent some time flushing the coolant and said they found some sediment in the coolant fluid. They were hoping to flush out anything clogging the heater core.
View 8 RepliesI just replaced the radiator in my 2001 Elantra and now the heater will not blow warm air. Also the temp gauge on the dash stays at cold.
I have replaced all radiator hoses ...
New thermostat
New thermostat sensor
I have a 2004 gmc sierra and it is having heater issues. For a while now when starting it up cold it would not blow any warm air until the vehicle is moving. The other day while driving it would go back and forth between hot and cold.
View 3 RepliesIt blows luke warm air, no hot or no AC just luke warm... what could it be?
View 1 RepliesSunday I bought a 2001 f250/5.4 to replace my 91 f250. I didnt drive it yesterday, but this morning on my drive to work the heater was very weak, it seemed to blow warm for the most part, but was barely pushing air even on high. I flipped it over to A/C to see if it blew any harder and it did. Does the blower motor need replace? if so why does the AC blow harder than the heater?
View 14 Replies2000 f150 heater only got warm.
Flushed system, new thermostat, new coolant. Then NO warm air. A/C blows cold. Checked heater blend door and actuator both intact and working. Heater core not leaking, system holds pressure and doesn't leak.
Is there another automatic valve that could be shutting off flow to heater core?????
I have a 2000 Isuzu Rodeo with 230,000 miles. The A/C is cold when first turned on after start up, warm or cold engine. After about 5-8 minutes running on a sunny day, driving or at a stop, it starts blowing warm. If I shut the A/C off and leave it off for 30-45 seconds, it will blow cold again. On an overcast day it will blow cold for 15 minutes or more.
View 1 RepliesI can't seem to get the engine temp to middle range on the marker, but yet my heater blows "to me" hot air. Even while sitting in idle for extended amounts of time I cannot get it to "operating" temperature. I would think if my thermostat was stuck open my heater would blow either cold or slightly warm air. I have the 5.4L engine with knn air filter and no cats.
View 14 RepliesI own a 2000 Nissan Frontier. Just recently while I was driving (in 15 degree icy conditions!) my heater, which was blowing on setting 2, stopping blowing air. I tried messing around with it, and found out that it won't blow any air on settings 1,2,or 3. It does, however, blow air on setting 4, but that is accompanied by a slight strange noise/vibrating of the dash. The coolant level looks fine and I haven't spotted any leaks anywhere that might indicate that it's the heating core. I thought it might be the resistor.
View 4 RepliesThis problem is on my son's 2000 F-250 5.4. It's into October and my son tells me he has no heat coming out of his vents. I figure it has to be the control valve that should be in the heater hose lines. Could be jammed closed or a vacuum line has come off the pot that controls the open close cycle. We open the hood and nowhere can we see a coolant control flow valve. It is so tight and dark under all that mess of wires, intake, air conditioner lines and whatever.
Just where should we be looking for the valve. Also it could be the vacuum line is unplugged on the dash, behind the warm/cool selector. And even there is a possibility that some doofus has removed something. He bought the truck this summer. So to get us on the right path, where we start looking for the flow control valve?
We got our first taste of fall weather in Houston this weekend, and with it I've discovered a new problem with my truck. After the engine was up to temp, I noticed that the heater would blow cold air any time I sat at idle. If you rev up the rpm's to 1500-2000, you can feel the air start to get warm again. I'm guessing this means my heater core needs to be backflushed.
View 4 RepliesI have a 94 ford Taurus all of a sudden my ac doesn't blow cold and my heat doesn't blow hot. Also every now and again I hear a sound like an alarm clock coming from passenger side??
View 3 RepliesEvery couple of days, my 20 amp cigarette lighter fuse (#13) will blow. It is connected to the lumbar seats, the cigarette lighter, the interior door lock switches (not the key FOB - that is separate). I've tried using a 25 amp and that didn't work.
View 8 RepliesAt idle my heater kinda blows hot, at highway speeds i'M a human pop sicle.
View 1 Replies1995 Suburban loses power when its warm and backfires through the throttle body when floored..
View 6 RepliesI've only had the car about a month, and love everything about it. . . . but with the onset of cold mornings, I'm not very excited about the luke-warm air coming out of my heater.
It's reminding me of my old B5.5 Passat VR6 wagon and the annual heater-core flush that it required. Of course, the Passat was 13 years old and had 200k on it.
2001 Ford Escape.
Blend door seems to be moving properly...(or at least the control arm is...) Truck gets up to operating temperature quickly enough.
It does blow warm air, but never gets hot...can't keep up with single digit temps. Every thing looks to be operating properly...
My Burb starts right up when the engine compartment is cold. Can barely touch the key and the thing fires right up.
Once engine compartment is hot (operating temp), I shut off the motor, let it sit for a few minutes and I get about 3-5 seconds of dry start each time I start it. It fires right up, runs great after that dry start period.
The dry-start behaves as if it's starved for fuel for those 3-5 seconds.
It's a K1500 with a stock 5.7l (350 ci). 180,000 miles and the entire drivetrain runs like a top. Only mod I've made is a K&N cold air intake.
Here's what I've done/changed recently (i.e. within the past 5k miles):
Fuel pump, OEM installed by dealer.Fuel filter.Ignition control module, BWD.Ignition coil, BWD.Crankshaft position sensor, GM OEM.Engine coolant temp sensor, BWD.Oxygen sensors (all four), GM OEM.Catalytic converter, replaced one of the two.Plug wires, BWD.Plugs, Delco OEM.Distributor cap and rotor, BWD.Cleaned ground connection (bolts to frame) for fuel pump.Alternator, new not reman.PCV valve.Battery.
Full diagnostics by a very qualified shop two weeks ago, no bleedback from injector spider, fuel pressure solid and holds perfectly. After 90 minutes of troubleshooting, the mechanics finally gave up.
One last thing with potential that I can think of is that I started running ethanol-free gas around the same time this issue surfaced. Not at the exact time, but at a relatively similar time. Gas mileage has increased by 40% and power increased, hard to blame "bad gas."
Having issues with the AC system turning on to blow cold air? The problem seems to be intermittent so I don't know how I would be able to replicate the problem if/when I take the car in for service. My problem typically occurs when I start the vehicle. The AC will be on but will blow warm air. I seem to have to continually play with the HVAC controls for it to finally kick on and blow cold air.
When I searched, I read that the malfunction may be caused by a bad solder in the system but wasn't able to find a concrete resolution to the problem. Should I call a few dealerships to see if the service writers are aware of the issue? Being in AZ, not having AC for the first 5-10 minutes in the car can be brutal. The car in question is a 2014 3.6 SEL ...