Subaru - Forester :: Intermittent Stalling And Will Only Keep Running If Gas Pedal Gets Pumped
May 24, 2015
I have a 2003 Subaru Forester, bought it this past January. Got 163,000 miles on it, and we've driven it mostly around town. Over the last month, it has developed an intermittent problem with stalling and rough "putt-putt" running, and will only keep running if the gas pedal gets pumped. This seems to happen about every other time we turn it on, but without a pattern. It can be running fine, and then switch mode, as it were, to running rough and tending to stall. I've gotten ignition codes (check engine light came on and I had my guy check it out on the computer) twice. My mechanic (a long-term Subaru mechanic) has checked out the injectors, and replaced the head gasket, but the problem has not changed. I'm thinking that this may be an electronics issue or possibly something in the gas tank/line.
View 1 Replies
Advertisement
2003 Subaru Forester automatic non-turbo. Vehicle stalls out at long red lights. No sputter, shudder, or warning. Idle just drops to zero. May happen twice in one day or once in two or three months. No rhyme or reason. Runs great otherwise. No drivability issues until I am stopped. I replaced the idle air control (IAC) solenoid valve last week and thought I cured the problem. But the vehicle cut out on my wife while she was stopped, waiting to yield into traffic this evening.
View 13 Replies
I have a 2002 subaru forester that will stutter and backfire without throwing a code, but not all the time. i have had it hooked up to a computer to check the O2 sensors and they are fine, it has a new Throttle position sensor, knock sensor, plugs, and catalytic converters (all put on in the last month). I have called a dealership and they have not heard of this happening, so this is my last resort.
View 15 Replies
I have a 2003 Subaru Forester. It will cool just fine while not moving. It will also cool just fine if I'm coasting down a hill with my foot off the gas. However, on the highway I have intermittent cooling. It cools for 10-15 seconds and then it blows what feels like straight vent for 10-15 seconds. It has a new compressor, receiver/dryer, and expansion valve and is fully charged.
View 3 Replies
I recently had the clutch replaced on my 2001 Subaru, now the clutch pedal is sticking, could this be related to the clutch replacement or is this something else? I didn't have such a great experience with the mechanic that did the work so I don't trust him to tell me truthfully whether it's possibly a warranty issue or not. The problem happens intermittently. I'll push down on the pedal and when I release it it will only come back up half way. If you tap it with you toe it pops right up. Doesn't seem to impact the functioning on the vehicle.
View 3 Replies
Recently, my car had started having cooling issues. It was running hot, into the danger zone, and it would not blow hot air. I took action and replaced the thermostat myself, drained the coolant, and bled out any air bubbles, filled it up with coolant and the problems still persisted.
View 14 Replies
I just took my 2009 Subaru Forester (80,000 miles) in to a mechanic because it was having an intermittent power steering assist failure during low speed maneuvering (i.e., parking lot). This is always accompanied by a loud rhythmic whining form under the hood (kind of like a whaawhaawhaawhaa). By intermittent, I mean maybe 50% chance of it happening when I am maneuvering in a parking lot. By failure, I mean I can still turn the wheel but it's much harder. The mechanic diagnosed it as the following:
dry rot in drive belts, recommended replacement
leaky rack and pinion, recommended replacement
2 leaky front struts
I checked my power steering fluid before I brought it in and the level/color looks great. The mechanic said in addition to the leak that there's a little bit of a catch in the steering at a certain steering position when going faster, but I haven't noticed it myself. I have trusted this shop in the past and had good experiences, but there has been a lot of turnover lately, so I'm unsure of what to do. I went ahead and had them change the belts, but decided to wait on the rack/struts until I did more research/got a second opinion.
View 3 Replies
will it hurt my 98' forester to drive it when one cylinder has no compression? They tell me it needs a valve job for 2,500. They already put a mass air flow sensor in, and replaced plugs and wires. Still got the miss, but I need the vehicle.
View 2 Replies
1998 Forester, 233,000 miles.. Two years ago it started running hot after 15 minutes of either driving or idling. Coolant seemed to vanish into thin air. The Subaru Dealership said that I either had a bad head gasket or a cracked cylinder wall. They said if the head gasket was bad then need to replace the head gaskets. They said if the cylinder wall was cracked, then we would need a new engine.
View 4 Replies
I have an 06 subaru forester with a little over 130k miles on it. The AC has now become intermittent and when running doesn't blow super cold air. I had it recharged but that didn't fix the problem. What happens is that it will run fine for like 15-20 minutes or if not hot. The clutch will start by attaching very firmly but then suddenly for no reason will disengage. It is not slipping the belt at all. I dont think that it is a matter of too much air gap because when it grabs it does so very firmly. Also when they were charging it i noticed that the for a moment it was kicking on and off rapidly and then he did something that looked as though he might have released some and it stayed more constant?
View 1 Replies
I took my car to my previous shop for a P0325, Knock Sensor Circuit Malfunction. They wanted nearly $500 to fix it. My new shop said that I just needed some engine treatment and the code went away for a week and a half, but it came back yesterday, and my engine ran a little rough.
I heard what sounded like a very rough engine and it was my car. The technician came in saying that I was only running on two cylinders, but that sounds like far worse of a problem than I had been experiencing. They say that I need a $266.80 valve adjustment, which is all labor, but the total is $300 more than that:
Engine Light diagnostic: $44.99 Shop Fee: 35.00 Tune up package Remove and replace spark plugs: 60.03 Additional access time - remove: 64.20 and replace spark plugs: NGK Spark Plugx4: 9.96 Adjust Valve Clearance: 266.80 Pepguard Limited Extended Labor: 58.65 Warranty BWD Custom fit ignition set: 36.39
Parts: 46.35 Labor: 436.02 Other: 93.65 Tax: 6.55 Total: 582.57
Of course, my roommate, who is upset that I am not continually pouring fluids into leaky power steering and AC systems butted in and said the entire thing is preposterous. Problems with cylinder firing are invariably the result of bad spark plugs andor wires.
Well, they say that I need to replace those, which cost $46.35, the least expensive entry in the entire estimate. They just want to charge $124.23 to replace them.
Why don't I replace them myself and see if that fixes my problems?
They say that if the valve clearance adjustment does not fix the problem then I need new cylinders and valves.
Regretfully, I have a "service plan:""Engine: All internally lubricated parts contained within the engine block, cylinder head(s) or rotary engine housing(s); oil pump; timing belt or chain, timing gears and timing tensioners; water pump; engine block, cylinder barrels, engine head(s), rotor housing(s) if damaged by the failure of an internally lubricated part. Dipstick and tube; harmonic balancer; oil pan; timing chain cover."
I cannot imagine that it would cover a valve clearance adjustment and they would only cover cylinders and valves "if damaged by the failure of an internally lubricated part."
So, ride my bike eight miles tomorrow, replace the spark plugs and wires, and hope that it is enough?
View 19 Replies
Last week I started having problems with my 05 Accent, hatchback, 1.6L engine, automatic transmission. Filled the tank up with gas and the car stalled pulling out of the station and wouldn't start unless I pumped the gas while cranking the engine. Ran and started fine after that and I thought it may have just been an air bubble in the fuel line, since there wasn't a check engine light or any other symptoms after that. Fast forward to this morning and the check engine light comes on during my commute and when I checked it, it gave an EVAP code (P0441). I also stopped to refill the gas and it stalled again as I was leaving the station. Also after I measured the gas mileage I found that I'd lost around 7 mpg (from around 30 to around 23).
I've never heard of EVAP problems causing stalling and loss of gas mileage but I'm not all that familiar with these systems so I don't really know. I'm going to test if it's the gas cap going bad since on the list of things that could cause a P0441 that seems to be the easiest place to start, but other than that where to start looking?
View 8 Replies
Right before Xmas our 09 Forester was hit while parked on the street. The whole front end of our car got wrecked. Was still driveable but we needed a new radiator, AC compressor, fenders, bumper, hood, lights, etc...over 5K worth of work.
As soon as we picked it up we noticed that when you press on the gas the car makes a high pitched whistling noise, almost like the noise when you'd try to tune in an old transistor radio. It only happens when the car is driving and the gas is pressed, not when parked or in neutral.
I know we should have probably brought it right back to the shop that day but I really did not like the shop at all and they are not at all convenient to where I live. I've read it could be a loose cat converter. I checked the air intake housing and that is secure.
View 2 Replies
I have a 94 buick lesabre custom that is stalling intermittently and runs rough intermittently. We have had it for diagnostics and it could not read the codes. We changed the computer and it still can't read the codes. The diagnostic tool says it cannot connect when it is plugged in or it displays white flecks like snow flakes on the tool screen. It is an OBDII. The pin structure of the data connector port is two pins top row and bottom row two pins some blanks and one pin. We don't know how to fix it with no diagnostic codes and we don't know what to do to get the codes because we have changed the computer.
View 8 Replies
I have a 2004 Subaru Forester xs and the a/c goes out intermittently. I was told I need a new compressor clutch and that the whole compressor assembly will have to be replaced. I contacted another mechanic and he said that he would fix just the clutch but I should replace the whole thing. So, what do I HAVE to do? Are these prices in line? Can I get used parts or discounted parts?
View 2 Replies
I have an '06 Forester XT 2.5 turbo that has, what I can only describe as a stumble around 2500 rpm. The car's maintenance is always up-to-date, and never has anything under 91 octane run in it.This started out when you had the cruise set and now does it all the time whether or not the cruise is used. I've had it to 2 shops including a Subaru dealer that had it for a month and couldn't find the issue. We've been through injectors, coils, maf sensor, etc. to no avail. The trouble code that we're given is a misfire in cylinder 1. We discovered, while trying to find the issue, that there was only 30psi in that #1 cylinder and the valve guides were the issue. So the motor was pulled, heads planed, etc. and new guides installed. Also, put in a new timing belt, and so on, that is usually done when the motor is out.They have done a leak down test and compression tests as well. This is my wife's car and she absolutely love it, so I need to get this figured out.
View 2 Replies
I just bought this car for my daughter. It's in very good shape; runs like a top. But the gas mileage is a lousy 20 mpg. All of my trips are local (no stop and go stuff as we live in the country). A buddy of mine with the same car and similar driving habits says she gets 25-28 mpg. So far I have changed the oil, oil filter and air filter.This can't be the best I can expect, can it?!
View 10 Replies
At 56,000+ miles on my 2006 Forester, I was horribly shocked to learn while having 60,000 maintenance done that my head gasket was leaking. inclusive of timing belt replacement required. I have read some discussions in this vein, but none regarding a car with this few miles on it. It does not seem right. I have had other issues with this car, my 2nd forester. I do not know what I should do.
View 12 Replies
I have a 2015 forester & the seats are not wide enough so my right leg rests on the front corner of the seat & after driving 70 miles my legs & back are hurting. I think the outback has seats 2 inches wider , that could work.
View 2 Replies
Sometimes when the AC is on automatic control it will kick out of auto control into manual control and the fan will speed up. All this happens without touching anything. Dealer said it's working fine.
View 1 Replies
I have a 2003 Forester that has low air flow thru the vents if you try to use the AC or heater.
If you turn the speed from 1-4 you can hear the blower fan turning faster but the air coming out of the vents is very low. YOu can hardly feel it. I checked to see if there was a cabin filter and there was none.
Even though you can barely feel the air coming out, when on AC the air feels cold and when on heat it feels hot.
View 1 Replies
