Subaru - Forester :: 2005 - CEL Came On - Cruise Control Started Blinking?
Dec 11, 2014
I bought a 2005 subaru forester xt a cohple months ago and then the CEL went on and the cruise control started blinking. The car also shook horribly. Long story short, and $2,300 later, i got the "head gasket set, water pump, timing kit, oil&filter change, " etc... Fixed. Question is, I am driving to Colorado from Maine in about two weeks. How long do subarus last after such repairs? Think ill get a few years out of it? Or should I sell it and buy a more reliable car before the trip out there.
View 11 Replies
Advertisement
I just bought a 2006 Subaru forester with 130K miles. Recently, the check engine light came and at the same time the cruise control started flashing. I brought it to the mechanic who said I had a bad catalytic converter. The car seems to be running just fine and now a day later the engine light is off.
View 3 Replies
My 2005 Subaru Legacy 2.5i - the engine light is on and the cruise control light is blinking. This happened once before and it went away after I recapped the fuel cap. However, this time it did not work. The car is running ok.
View 4 Replies
At a bit over 43K miles the check engine light came on with a blinking cruise light. Dealer has confirmed that both secondary injection pumps have failed for reasons unknown. I think this is part of the pollution control system.
View 3 Replies
On my 2007 Subaru Forester (100k miles) the CEL light is on and my cruise control light is blinking (cruise control does not work in this condition). Computer scan indicated front O2 sensor failed and my mechanic replaced it. No joy. Computer scan reported 0 data from EGR valve--replaced it. No joy.
View 2 Replies
My 2005 Subaru Forester just passed Rhode Island inspection last week. I didn't use for 6 days. Last night when we got home I moved the car and noticed a strong gas smell. This morning on I drove it cold on way to work right away I noticed lack of power at low gear (its automatic trans), a jumpy idle, and some smoke out back (not too much and looked whitish). Check engine light flashed a couple of times but didn't stay on nor flashed continuously. I know flashing CEL is BAD, so I went right back home and parked, didnt even drive a mile.
I'm thinking some sort of cylinder misfire.
View 2 Replies
So I'm driving along with everything fine till I pull into a neighbors driveway to drop off some stuff. As I pull in, the check engine light suddenly comes on and the cruise control light starts blinking. As I have a scangauge II always connected, I put the car in park and check the code. It comes up as P0000. I get on my Droid III and google it - all I see is "null code" so I clear the codes and everything is fine. I figure "that's odd, but whatever". I drive home (about 1000 feet) and park and shut the car off and go inside to mull this over.
I go back out to check out the scangauge again and it requires starting the car to read out the codes. The car won't start. The battery is fine, and in fact it does the "rurrr rurrr rurr" strongly for 10 times before I figure it's not starting. I wait about 30 seconds and try again - same thing. I wait about an hour or two and try again and it starts this time right away, but then stalls right away. Start again and manually give it some gas and it keeps idling weakly. I'm able to back out and drive a short distance and come back without a stall. I let it sit for the weekend (no shops open anyway) and start it monday morning with my AAA card out... and it starts fine and runs fine all day. I basically forget about it.
About a week and a half later, I'm driving along a country highway at 55 Mph, and the same thing happens. Check engine light, cruise control light blinking and the cruise actually cuts out so I'm losing speed suddenly. I run the scangauge again and same code. The car keeps running fine though, I'm able to drive it back (w/out cruise control) the 5 miles home. Nothing out of the ordinary.
I go inside and google this some more, and there's some posts about the Scangauge causing this - but I've been using it for about 4 years w/out this happening. That said, about 2 months ago, there was a recall, and they flashed the ECU with some update so maybe that changed something, but still - worked for months before this happened. I had to get to work etc so I just cleared the code again, and so far 3 days without a recurrence. Currently I'm thinking about waiting to see if it happens again and going to Autozone and have them read the code to see if it really is the Scangauge not reading the code right or whatever...
View 3 Replies
I have a 2007 subaru outback ll bean addition with 67,000 miles. For the past year and a half my gas pedal has intermittently become unresponsive. The engine is running just fine but the check engine light and cruise control light start blinking and boom-no gas. After turning off the engine, the car won't start until the gas pedal has magically started working again. The dash lights continue to blink for several starts but then stop.
Prior to this problem, I have noticed that sometimes the console lights for the radio and AC blink and sometimes go dark at which point the controls are ineffective. As if this wasn't enough, just yesterday when trying to start the car, the engine was having trouble turning over with a rapid clicking noise. It eventually started but now the seat belt buckle alarm is out of whack and the speedometer displays "ER U1."
View 10 Replies
Sometimes when the AC is on automatic control it will kick out of auto control into manual control and the fan will speed up. All this happens without touching anything. Dealer said it's working fine.
View 1 Replies
I have a 09 Subaru Forester (automatic) with 56,300 miles on it. Within the last 100 miles, the transmission has started 'hiccuping' as it changes gears. Also, when the car is cold and first started up, as I drive the rpms rise to around 3k when switching gears; sometimes holding there for anywhere from 3 seconds to 12 seconds before finally changing gears. As the car warms up, this problem disappears, but the 'hiccuping' continues. I took it to the dealer and they flushed out the transmission fluid, but problem still persists. I called the dealership asking for a new transmission because it is still under warranty, but they refused. They are going to check pan for metal shavings, and if they're present then they'll replace trans. If not, then they will replace other parts until problem is fixed.
Also, another important question: If I had the transmission fluid replaced, would it be possible that they may have cleaned out any metal shavings, and when they check 100 miles later, there wouldn't be any? I'm worried that I'm going to get screwed because they eliminated any metal shavings and when they go to look again none will be there because there hasn't been enough mileage put on the car to make them appear again. I do not know enough about cars to know if this is even a possibility. They refuse to honor the warranty until they go through a checklist of possible repairs, and I'm nervous that list will run out when I hit 61,000 miles and warranty runs out.
View 3 Replies
My 2010 Subaru Outback recently surprised the hell out of me by simultaneously turning on the brake warning light, the traction control light, the check engine light and (just for a bonus!) disabled my cruise control while flashing the cruise control light. I pulled over, quickly surmising that all of those systems could not have failed at 70 MPH without instantaneous death to either me or the vehicle. Both apparently still being alive, I tried turning the car on an off to reset the lights. No go. Subaru was not going to miss this chance to get me to the dealership! (who I had avoided to this point!) As I was far away from home and the car being very healthy, it seemed, I decided to drive on. I proceeded to put a couple of hundred more miles on the car before I got back to town.
My car had 39,000 miles on it, 3,000 miles beyond the warranty end. I learned that I have an error code of P0171, "Fuel Trim Malfunction (Air/Fuel too lean)". So I guess I'm wondering about a few things...why would this sensor set off every light on my dashboard and disable my cruise control? Seems a bit overblown for running a bit lean. My gut tells me Subaru has a sensor/software problem they are not owning up to. I'm a big fan of conspiracy theories and this really smells like one...
Second, jeez, I'm only 3K miles over warranty, don't you think they'd cut me some slack. I mean I love my Subaru, or did anyway, until this happened. Now it's just another POS car that breaks for no apparent reason...
View 10 Replies
My 2000 Forester recently started shaking while driving at highway speeds or while under engine load (hills, accelerating, etc). My first thought was that it was a problem with the alignment so I took it to my local tire shop. The car has 164K on it and has been without a Subaru specific mechanic since my last guy got fired a year ago, though I am trying to get an appointment with the only other Subaru mechanic in the area, outside of the dealership.
The tire shop found an issue with cupped tires (naturally they'd want to sell me tires) and told me that my passenger side rear CV joint was bad and they'd have to replace the axle. Since this sounded credible for the symptoms it was showing and they found me an axle, I told them to go ahead and replace it.
When I got it back the first time, I didn't see any great improvement in the shaking. I also noticed that they'd forgotten to put the bolt back into the bottom of my shock absorber. o_O When I brought it back to them, they fixed the missing bolt and agreed to keep it for a week to troubleshoot where else the shaking might be coming from. In the process, they replaced spark plugs and wires (which it probably needed anyway) and did an oil change, but the shaking is still there after all their tinkering. They suggested the problem may be in the timing and that I should have that checked out.
I don't think they're right about that. The vibration feels (to me) even more like a CV joint problem now than it did before. It shakes more violently and at slower speeds the longer it runs so by the time I get to work (40+ miles) it's almost constant. It stops shaking when you pop it into neutral and let it coast suggesting it's not timing or alignment - and making me think even more that it's something to do with the drive train.
View 6 Replies
I have a 2012 Subaru Forester with 27,000 miles on it. It has a rattle that started out in the glovebox area, and has migrated to areas around the dash, center console, liner by the sunroof control etc...I have had the car in the shop 5+ times, the last time being a week and a half. Everyone is baffled by this rattle. It seems to come and go. The glovebox liner was replaced, and other areas insulated, yet it still rattles, although it is not consistent.
View 3 Replies
My Keyless remote control is "DEAD" however my system is somehow engaged. In order to start my 99 Subaru Forester I need to reach under my dashand hold in the emergency override button. Car starts fine every time. Is it difficult to unwire this keyless system? I'm not going to keep this car much longer. Will probably replace car before end of 2013. Easy fix or keep driving as is? Any possible problems if I keep starting car with button release?
View 2 Replies
When my 06 Forester was still under warrantee I brought it to the dealer to diagnose a "stutter" in the transmission after I had slowed down to about 10mph to turn onto a street and started to accelerate. They could not find anything wrong and so I have lived with it until recently when I decided to try the local tranny shop that has a good reputation. They could not find any problem although at first they thought it might be engine related (mass air flow sensor), but that was ok.
View 2 Replies
My 08 altima cruise control comes on and the set light keeps blinking the service book says take it to my dealer is there anything I can do to fix it myself could it be a air leak or something?
View 1 Replies
I have a 2007 L.L. Bean Edition Forester. The cruise light is flashing and check engine light is solid. I am well into my retirement age and nearest dealer is about 2 hours away. Is this something that local mechanic can fix? He is very good, but not Subaru schooled. I'm afraid to drive it now.
View 2 Replies
This is my first Subaru, and I absolutely love the vehicle; however, because of it, I'm very new to its mechanics. I bought it used from a friend, and I've been driving it for three weeks now, now this noise has come up and I want to verify what needs to be fixed before I start taking things apart. Perhaps you all know what noise this is coming from the compressor/ac idler pulley area?Here are a couple of videos.
[URL] ...
[URL] ...
In case it does somehow matter, one of my knowledgeable friends asked me if it makes more noise when I turn, and the answer is no. Also, the noise does not come through the speakers, and from what I understand, that eliminates an alternator problem.
View 4 Replies
I have a 2005 Subaru Forester with about 124,000 miles. I've had her since 2012. This year has been rough for her and every month or so there seems to be something that I need to fix.
This time, the check engine light is on, and the cruise light is flashing. Two codes came up:P0442 - Small Evap LeakP0457 - Large Evap Leak
I brought it to a local auto service shop, and they replaced the gas cap, and also cleaned the filler neck with several grits of emery cloth. They cleared the codes, and told me to drive it for a few days.
Well the check engine light came on again the other day.
View 9 Replies
I have a 2005 Subaru Outback with 179,000 miles on it. My engine and cruise control lights flash on and off....have been doing this for 6 months now....intermittently. My mechanic said the he cleared the computer and to wait and see if it happens again. He said that it might be the catalytic converter. The car runs fine whether or not the lights are flashing.
View 3 Replies
I took our '99 Mazda Protege in for a clutch replacement. The mileage is over 150k. The car was returned with the air bag light blinking and the cruise control and horn deactivated. All were fine beforehand. The shop eventually admitted that they could have broken the clockspring during the repair. They are going to get back to me tomorrow with a quote for the repair and they told me they are going to "work with me" on the cost. I don't understand why I should pay for anything associated with the clock spring repair. Another mechanic told me they had to secure the steering during the clutch replacement and probably forgot to do it, furthermore they should cover 100% of the repair.
View 19 Replies
