Sonata I45 (YF - 2011+) :: Snapping / Brushing Noise When Turning The Wheel At Slow Speeds
May 5, 2015
2011 Hyundai sonata. My issues is that there seems to be a snapping/brushing noise when turn my wheel either left or right within under 5 MPH. Some people at work stated it could be the CV bolt? Not sure if that is correct, or something else. I am 117K miles, never have replaced anything suspension related.
View 11 Replies
Advertisement
During the past couple of months, I've noticed a moaning when I turn the steering wheel at slow speeds, mainly while driving in parking lots. When I turn the A/C off, the sound disappears. Is my compressor on its way out? The dealer replaced a leaky condenser in 2011. My fear is that they didn't replace it properly with adding oil back to the system.
View 1 Replies
A few weeks ago I noticed a 'clunk' noise when turning the steering wheel. It only did it the first turn on a trip. Over time it has gotten worse - the sound is the same, but it happens for several turns, maybe 10 or so, before it stops. After the car sits, turned off, for a while, the cycle starts again.
I replaced the rubber coupler on the MDPS, but my old one looked fine, and it made no change in the noise.
View 5 Replies
I have a 2003 Jetta Wagon with 49000 miles on it. I noticed that when turning at slow speeds (like taking turns in a parking lot) I hear a klunk coming from the area of the left front wheel, and I think I feel it through the steering wheel. Yesterday I was going around a hairpin turn at a shopping mall and heard two clunks. Driving straight it doesn't happen.
View 8 Replies
The car basically struggles to crank. Today it failed to completely start. It took multiple tries at turning the key to get it kick and each time the car would chug until it started.
About a month ago, the dealership said she needed a new battery when she took her car in for an oil change. They told her at that time that they found the car to take longer than normal to crank and wanted to charge $80 for a battery, sale price (normally $150 at dealership). She declined at the time.
When I used the car since then it cranked fine, about a good 3-4 seconds. We had the battery tested at discount auto and they found the battery to work fine and out-put more than enough cranking amps.
Last week she was away for a few days and had the car sit untouched. But when she came back she went on a small 100+mile road trip with the car and it ran fine. And when she came back from that, she took the car to do some errands around town. Today, the car took much longer than usual to fully start.
I don't think it's the battery. Possibly something with ignition. Engine turns over, so it is getting adequate power from the battery to the starter. Engine doesn't misfire. No engine-lights on the dashboard, nothing.
2011 Sonata 2.4L
View 10 Replies
I have a 2010 LS460 AWD with 42k miles and notice when I am making a medium to wide angle turn at parking lot speeds the front wheels make an intermittent metallic clicking/ticking noise that can be clearly heard when the windows are down and stereo is off. The noise can be heard when turning in either direction, driving forward or in reverse, and both accelerating and slowing down. Doesn't seem to happen when I'm turning the steering wheel while the car is stationary. Dealer suspects noise is due to dry contact areas between pads, calipers, and anti rattle springs and wants to perform a brake service for $330 before they're willing to investigate further (car still under warranty till end of the year). If noise is brake-related shouldn't it only occur when I'm applying the brakes? What should I do?
View 7 Replies
Noticed my 5 week old MK7 GTI is making squeaky noises on the driver's side when turning left at slow speeds. What this could be? Occurs intermittently, not all the time. This is a leased vehicle, would this be covered by warranty?
View 7 Replies
I am getting a click from the steering when rocking the wheel left or right. It is coming from the assembly the intermediate shaft is connected to. I see there is a large bearing on the end where the shaft comes out. I am not sure what this assembly is called. I have had it at the dealer and they said they re-torqued everything but they could not duplicate it.
I do not fall in the range for the recall and I have no problem with the car pulling left so I do not think it has anything to do with the intermediate shaft. It is clearly from the assembly the intermediate shaft is connected to on the steering wheel end of the intermediate shaft. 2011 limited
View 13 Replies
So... Took my car into a tire shop (tire pros) to get a screw pulled out of my front left tire... And after they finish the job - the guy comes up to me and says "your front brakes don't have much life left." I said, "I know I'm planning to change them in the next couple of weeks"...
He then said, "well I think your sensor just went off, when I pulled the car around.." I said "okay", got in the car and drove off - no brake light what so ever.
Anyways, A few hours later when pulling my car around the corner on the way home - I noticed that I am all of the sudden getting a random scraping sound from the front-right rotor anytime I turn the well all the way to the left at slow speeds...
I'm not too worried about it - just want to make sure these guys aren't trying to sabotage my car! The only thing that kills me, is that I didn't have the sound before and no all of the sudden I do? I'm assuming they somehow slightly moved the pad, causing it to somehow squeal - I'm just not exactly sure what they did...
View 13 Replies
I'm a 2nd owner of a 2011 Sonata, and am currently at 99,800 miles. I have an extended warranty (so I've been told) that covers powertrain I believe until 100,000? When turning the wheel to the right then left, or vice versa, theres a clunk/thud sound produced from the steering column.
I am assuming this is not normal. Will my hyundai dealer cover this since it seems to be a common annoyance on these cars. Is it dangerous to not get it fixed?
View 11 Replies
Crossing 90K soon and noticing some vibration in the steering wheel. Have also been trying (in vain) to locate a clicking suspension noise in the rear.
Decided to pop the Red Sled up on stands and tighten stuff up. Few loose nuts in the rear (sway bar end links and the trailing arm bolts) so retorqued those. However, noise has only decreased, not gone away.
In the front, things are even worse. Tie rods are due for replacement (boots broken and right one had water in it) as well as ball joints. But the worse part is that the steering rack is whining when turning in either direction.
Thinking of tackling the front end work aside from alignment. Doesn't look hard so I do not fear that. But the steering rack is another beast entirely.
View 17 Replies
Vehicle: 2013 Hyundai GLS @ 36k miles.
When my vehicle is stopped or in motion at low speed, if I turn the steering wheel, I hear a knocking out at the sound towards the front of the vehicle. How concern should I be?
View 3 Replies
I have a 2015 Limited with the pano glass. Have an occasional cracking/snapping noise coming from the rear of the glass (not the moveable piece, but the fixed piece)? Were you able to get it fixed? The tech says it's because of body flex, and that there's no fix for now. I'm tempted to drop the headliner and drive it for a few days to try to pinpoint it.
I'm not quite sure what would be making that type of noise with body flex. Everything I can imagine would be fixable with maybe a nylon washer or some felt. Now that the temp is in the 50s, it's happening a lot, and it's starting to annoy me.
View 17 Replies
97 F150 4x4 around 200k miles on it, Drove the truck to town today and it started making a screeching noise when I turn the wheel and moving at slow speed's It is not the typical Ball joint squeak, and they were replaced about 6 months ago. I also get a clicking squeak going down the road, everyone in a while from take of ill get a slide grinding or crunching noise. Also noticed that when taking a curve to the right i feel and hear a slight Bump but I don't when turning to the left/
Also it doesn't have the typical grinding noise of a bad unit bearing, there is a slight roar but Pretty sure that it is just the aggressive tire's... I am about to go out and Jack it up and have a look at it to see what it was. Also if I loosen the Cv nut on at the Hub that would show me if there was any play in the bearing correct? since the cv should keep the bearing's fairly tight even if they are worn?
View 3 Replies
105K miles, developing a groaning noise when turning steering wheel during low speeds and stopped. Can feel slightly through steering column. No other problems, no clunking or any grinding noises, just "groaning" sound on initial movement. Fluid is full. While searching fix, I found this article on the C70 model, sounds like I might have same thing on my XC90. [URL] ....
View 6 Replies
One my F350 with 175,000 miles on it, at low speeds when turning the steering wheel it seems as if it has two places during use that it rubs or has an oblong spot in it. I have 285 tires on it and have for years.
Kind of like if you were turning a shaft in a seal and it rubbed or was rough. It makes a faint, muffled, barely audible grinding noise or feel. I have a lift and level of about 4" and 285s for years. This just started in the last 5 months or so.
View 1 Replies
Layely with my 2011 SE I've been getting a low pitch humming noise while traveling at low speeds, mainly going into a stop sign or light and searching for a parking spot. It happens with the AC off as well, not so much a vibration just a low pitch hum, also does it with foot off brake too as I just let it coast. Kind of annoying and want to make sure its good.
View 5 Replies
Noticed here lately that my 2011 Sonata LTD started making the thud noise when turning. Dealer says this is under the basic warranty but NHTSA states Power train. This was the service manager telling me this.
View 4 Replies
Have a cycling type mechanical noise coming from rear driver side wheel after I turn car off. Doesn't happen all the time...
See video : [URL] ....
View 27 Replies
I have a 2005 Subaru forester. It's got 127k and when I turn at slow speeds (like from a stop sign onto a main road) it shakes/vibrates. I called into Vox Pop when a mechanic was on the air last week and he said to check the serpentine belt. We did and it isn't loose/rotting, etc. What this might be?
View 6 Replies
I have a 90 Celica GTS thats a 5 speed, and the last month or so when going at slow speeds and turning, it almost sounds like tires rubbing bad on the fenders. But they are clearly not. There is also some resistance too when turning. I've checked the PS fluid and its full and not leaking.
View 2 Replies