Sonata I45 (YF - 2011+) :: Engine Shaking At 1250 RPMs?
May 9, 2011
A few days ago I started my car, and as the idle was slowly dropping down from ~1500rpm, the whole thing started shaking a bit at 1250rpm. Enough to where I could feel it and my soda was vibrating like Godzilla was walking down the street. I can easily reproduce it by pushing the pedal just enough to get it to 1250 rpms.
The car has just over 3k miles on it, I did the intake filter mod on mine, and I'm wondering if that has something to do with it. Can a few of you who have the 2.4L engine, try to test it out for me? If you bring the engine to 1250rpms, is there a noticeable shake? If not, it must be the intake filter, and I will replace the factory airbox.
View 2 Replies
Advertisement
This is a intermittent issue. While either parked but mostly at stop lights I'll notice the engine shudder and shake very hard. It's done it about a handful of times and sometimes the AC is on and sometimes it isn't.
I have a 2011 SE ...
View 5 Replies
Been trying to save my miles on my 2011 GLS because I'm right at 100k (99.2K to be exact) and had a feeling something would be going wrong soon. Already had short block replacement, both CV axles replaced, steering columns, seized calipers, transmission sensors, and other repairs all done under warranty work for this stinker.
Driving to work today hear a clunk as I am driving uphill, tachometer immediately goes to zero, engine begins violently shaking, and traction control light comes on for some reason. Had my OBD scanner already plugged in and it pulls P0336 code for a crankshaft position sensor. Fortunately was close enough to home so that I drove it back and took the train to work. Probably going to take it to dealership tonight. The clunk and violent idle leads me to believe its more than a sensor problem. Car has had issues shifting over past month, but was so sporadic and not able to ever be replicated. Would maybe have a hard shift once every 2 weeks. That's about it.
View 6 Replies
2013 Sonata. What are the engine idling RPM's is when sitting at a red light? My engine seems to be a rough when sitting still.
View 8 Replies
Okay so I haven't driven my car in a couple of days, and when I started it today it started sputtering and shaking like it wasn't getting gas. I let it do this for about ten seconds to see if it would set a check engine light but it didn't. I shut off the car and restarted it, then it ran perfect.
I have had this happen to other cars if I let off the key too fast, but I don't think I did that today, I turned the key the normal amount of time. It only has 20k miles on it.
View 1 Replies
Having problem when driving on the highway? Today I noticed the side view mirror glass shakes and moves quite a bit, while the passenger mirror appears to be rock solid. Any easy fix? I have 15k on the car - would this be something covered by warranty? 2013
View 2 Replies
I've recently noticed that my 2013 hyundai sonata would start vibrating/shaking, if I were to release my brakes slowly (It doesn't shake if I release it fast). I was wondering if there are any problems with that?
I do not feel any vibration in the car when I press /slam the brake. The only time I feel the car shaking is when I would slowly release the brake.
View 4 Replies
So on my new 2.0T Sonata I noticed a brief metallic rattle in the 2K-3K RPM range when you rev the throttle. I was very concerned.
The sales rep said it may be the heat shielding that is coming lose. He was concerned and said to bring it back when Service is open.
I just got back from the dealer: The service manager didn't know what it was but his tech said it was part of the turbo system, it's a 1/4 inch bar (parallel with the bumper) you can plainly see between the firewall and engine. He said what it did but I forgot to take notes.
I listened to another 2.0 Turbo Sonata on the lot and it has the exact same rattle when rev'd.
View 6 Replies
2011 Sonata GLS, 95,000 miles.
This just started yesterday. While driving, the RPMS suddenly drop off. Depressing the gas pedal doesn't command any power output, even if I floor it, the RPMS continue decreasing and there is absolutely no power. The only way to keep moving is to completely release the pedal and then depress it again.
The transmission has been serviced twice by me and shifts smoothly. Should I plug a scan tool in ?
View 25 Replies
I have a 2011 GLS with about 47K.
There seems to be an issue with acceleration around 50-65MPH as the RPMs will jump as if to hesitate between gears (just my assumption). Maybe driving style/conditions as I live in West-Central Florida?
I'm the original owner and we have two of the same vehicles.
View 13 Replies
2012 Limited 2.0T. Bought it CPO (certified pre-owned with 12k miles). Current mileage 37,400.
Background ... Wednesday night, transmission started shifting funny. It felt like a delayed shift. RPMs increased by a few hundred before a harder engagement into the next gear. More noticeable between 2-3, 3-4. Also harder engagements in down shifting. Thursday, same shifting problem and CEL came on. I couldn't find my scan tool, so stopped by Autozone. Registered a P0711 (Transmission Fluid Temp sensor circuit). Called the dealership yesterday and dropped vehicle off. Picked up last night. According to the paperwork, the code that was present was a P0705 (Switch Assy-Transmission Range). Supposedly, the sensor was replaced and code cleared.
Driving home, the CEL was / is currently off. However, the transmission still isn't shifting properly. I am fully expecting the CEL to come back on. Never had an issue with the transmission indicator lights next to the shift selector (which I believe the P0705 symptoms were). On the printout I got from the dealership, it states "PLEASE NOTE GDS PRINTER NOT WORKING BEING REPAIR NO PRINTOUT AVAILABLE". I think dealership is just looking to milk some money from Hyundai.
Side note.... OE battery, which was replaced with another OEM when I bought the car 1 year ago, was replaced with a Die Hard yesterday.
View 14 Replies
My transmission is having issues switching from 1st to 2nd gear and same issue from 5th to 6th. What happens, (when attempting to switch from 1st to 2nd) RPMs rev up high (as though it is in Neutral) then after 2-3 sec it shifts, car jumps crazy and in like 1 sec it shifts down (to 1st - RPMs jump) then shifts to 2nd gear and from there it is fine. 3rd to 4th, to 5th is great, but 5th to 6th same issue, not as extreme, but similar. If i let go of gas when it should shift to 2nd gear, and wait like 2 sec, it will be in 2nd gear without jerking - Normal.
Sometimes in Park there is this noise as though something metal is hitting another metal part, and I can feel it in car - but it goes away and only happens from time to time. Also Neutral on rare occasion works as Reverse - super rare. I did Stall test (per Hyundai procedure Bulletin 13-AT-007) - no issues. Dealer ran diagnostic - no Codes in transmission. Flushed fluid - didn't work. I drained fluid again, put new fluid in and checked ATF level per 13-AT-006 - no difference. Tested Solenoids - no problem there. What could be an issue with my transmission?? 2012 Sonata GLS 2.4L with 7k miles.
View 30 Replies
I've got up two weekends in a row to this : 20130922_064713_zpsd7701bd3.jpg
All of the warning lights on my dash are lit up. I cannot put the car in gear due to the drive not showing up. The RPM's show 0, then after a few seconds they bump and start working. After restarting car a few times it finally goes away. Everything but the check engine lights. Anything to try before I put it in the shop tomorrow?
View 6 Replies
2011 Sonata GDS. I previously purchased 19" Gen coupe wheels and never had a problem immediately. Approximately 2 months later of driving with the 19" wheels, when I got onto the highway one day, the car did a slight jerk with acceleration and the acceleration halted for a split second. Ever since that day, anytime I accelerate fast and/or reach highway speeds, the car has a delay when I hit the throttle. The car then has a "rattle" "groaning" sound that comes when the RPMs hit around 2000-2500 rpm. It will go away if I drive slow speeds/slow RPMs or shut the car off for a short amount of time. I have taken my car to the Hyundai dealer 3 times. I've had the adaptive values for the transmission and engine reset and that didn't do anything. I had a mechanic ride with me in the car to make sure they were hearing the sound and the delay in shifting and the mechanic was very shocked and had never even heard a sound like this before.
View 10 Replies
I have a rattle coming from the muffler when I reach 2000-3000 rpms. I thought it may be the heat shied, so I got underneath the car and it was nice a snug. Had my wife get in the driver seat and rev the engine. It seems as though all sound came from the outlet of the muffler. Do I have an internal failure in the muffler? Over the past month it has become louder.
View 2 Replies
I just replaced my OEM battery with a duralast from autozone. The battery had 138,000 miles. Shortly after, the check engine light came on and code says P0106. Map Sensor. Seems like to much of coincidence that this happened. Have read that disconnecting battery cables for 3 hours may do the trick.
View 8 Replies
Bought a 2012 Azera a couple of weeks ago. When the engine is cold and I shift into reverse there's a loud bang and the whole car shakes. Feels as if I've been run into, or the transmission is going to fall out. I have also noticed some delayed upshifting (doesn't accelerate for a second but then really takes off). My 2007 Sonata did that a little, so I thought maybe it was a Hyundai thing, but maybe not.
My main concern is the BANG into reverse. The dealer said they can't get me in for several days, and that they don't have loaners, but they "might" be able to get me something to drive while they look at it. Honestly, the service guy sounded skeptical, and I guess I imagined a little better/faster response for such a new car. I'm almost afraid to drive it right now, the bang is so violent.
I'm pretty upset about this, it's my first really nice car. Has some sort of transmission issue with a new Hyundai? Anything in particular I should look for, say, etc.?
View 32 Replies
I had driven my car over 13 miles when it went into an idle mode and would not go above 1250 rpm. After dealership did approved tests they stated #4 piston had 25 lbs pressure and needed to be replaced. After breaking down the motor, they dealership stated that my car was vandalized and I have attached picture of the wood chips sitting on the piston. Dealer stated that someone placed the wood chips down my spark plug chamber. First door always locked and 2nd no damage to the hood and 3td how was I able to drive 13 miles before the car shut down, 4th chips look like brand new with no damage and not discolored and there was no smell of fuel on the chips.
View 19 Replies
I have a 2010 Sonata V6 that I bought new. It has a little less than 50K on it. I tried to start it today and it made a terrible noise then died seconds later. I popped the hood and then started it again and the engine was shaking violently in the engine compartment and making a terrible knocking noise. I had driven it 12 hours earlier and it ran fine. I called a tow truck and had it taken to the dealer but if I know my dealer, since it is Sunday they probably wont get to it until Tuesday. Also, this car has had the signature V6 valve cover leak that has been fixed 3 times. I noticed it was leaking again about a month ago and I have just been checking the oil and adding it as it needs it. I dont think the engine ran out of oil because I checked it before the tow truck came and it was between low and full.
View 2 Replies
When I use my automatic transmission to slow my vehicle on steep downhills, the RPMs are much higher than when the engine idles because I use my brakes. The pistons are firing many more times per minute - so am i using more gas? Is the answer different for a standard transmission?
My "mystery vehicle" is a 2011..... outback...
View 16 Replies
After I fill my 6 cyl 2004 Hyundai Sonata (280,000 km), the engines starts, then stalls. I can only get it to work by keeping the accelerator pushed to ensure sufficient rpm's. If I remove my foot from the accelerator, the rpm's drop to zero.With the engine revving, I put the car in drive and 'lurch' away from the pump. After that, everything is fine. It starts up properly … until the next fill. My mechanic is mystified and I am frustrated.
View 6 Replies
