Sonata I45 (YF - 2011+) :: Driver Seat Makes Creaking Noise When Lean Forward
Sep 6, 2012
In the drivers seat, when I lean forward, the seat makes a creaking noise. Not when I go backward and rest, but when I come forward. I just got this problem and I've barely put more than 7,000 miles on it
View 29 Replies
Advertisement
I have a 2007 Azera . About a week ago when I was going to sit in the car I noticed that driver seat leaned completely forward , I didn't pay attention to it and put it back but today When I was driving the the highway the driver seat suddenly started to leaning forward and push me in to the steering wheel, and the switch didn't work to put it back until It reach forward dead end . when I stopped the car and turn it off I could put it back with it's switch , also the seat memory's were erased . I happen 2 times in the highway then I decided to remove the seats fuse.
View 9 Replies
Annoying and embarrassing squeak in driver's seatback when I lean forward and then sit back. Car has only 46000 km. on it, and is only 2 1/2 years old. Will point out to the dealer at next visit.
View 4 Replies
I am not liking this seat. Not sure if something wrong with control lately or I'm just noticing from sitting there more but I want it to lean more forward. I have messed with controls to get it to as forward as it will lean but still feel like it's only touching the very bottom of my back. Is there a spec on seat angle so I could check if it's proper? I'd like to avoid getting a grandma pillow..
View 14 Replies
I have noticed new drivers seat squeak. It only happens with weight transfer side to side at lower speeds ( hard right and hard left below 30 mph, or entering a driveway). I have looked at several posts and it seems like people have had luck with simply tightening the bolts for the seat.
Well I did that and it still making the noise. I have isolated the noise to the lower part of the seat right behind the molding. Behind the molding and behind the seat control switches there is a white box for the switches. It seems like the noise is coming from there. I noticed that if I pop off the control switches and I loosen the screws for the control switches the noise gets a touch better.
I took it to the dealership and they told me they tried to add some oil between the leather and the molding but it did nothing since the source seems to be behind the molding.
View 11 Replies
2008 Sonata 4Cyl
My Driver Seat Does not move Forward any more. It will go back, up & Down Just not Forward.
Is there a Seat Reset Switch somewhere I don't know about ? How do I troubleshoot this?
View 7 Replies
I am able to operate my power drivers seat in all position except for reverse. My wife was the last one to drive and the seat is stuck in almost the full forward position. I can move the seat forward but not in reverse.
I've already looked under the seat for blockages along the railing and didn't see anything. I would try to remove the seat, but its positioned too far forward to access where I think the bolts would be. I did notice one unconnected wiring harness coming up from the floor under the seat, but it looks like it doesn't go to anything. Maybe its for models with heated seats or something because I don't have heated seats. My car by the way is a 2009 sonata GLS.
View 1 Replies
Well I had the rear lower control arms replaced for the recall. My car creaks and pops when i go over uneven places like from to road to driveway or up a steep incline since the swap. the noise is loud and comes from the back of the car.
View 1 Replies
Sometime back I had posted that I was getting a minor creaking noise which occurred mainly when I was slowly making right hand turns. At that time the conjecture was it was caused by the mounting tabs (used when the car is assembled) on the rear suspension. The solution was to drop the suspension and file off the tabs. But then I saw at least one other post that said the cause was something else.
Well the minor annoyance has become a major annoyance since it has gotten progressively worse. Before I resort in taking ot to the dealer I'd like to see if I can figure it out and fix it myself. But before I tackle that job I thought I would ask others who had this problem what it turned out to be.
View 28 Replies
I just bought used 2011 sonata 2.0T ltd. three weeks ago and i just figured that out when i turn the steering wheels both sides while car stops and pressing the brake pedal there is sound comes out from front and rear suspension.
View 2 Replies
On mine a few months back I started getting a creaking noise on the right side when I pull into my drive way, The dealer looked at it and said it would have to go to their body shop to re do some welds...
View 21 Replies
I have this noticeable creaking noise that pops up every now and then on the front passenger side of the car. Problem is it is hard to replicate to the dealer. I usually notice it going over dips at some times, and most when I make a right turn into a raised road. Otherwise, not a peep out of the car.
View 19 Replies
2011 GLS 2.4L auto, 40K, out of warranty
There is a loud groaning/creaking noise coming from the front suspension area. At low speeds, this noise dominates all other noises and is directly related to hitting the gas or pressing the brakes, which produces a forward or backward force on the front suspension and chassis. I can sometimes hear it briefly just by pushing against the parked car.
My hope is that I can just tighten up some bolts and make this go away, but other posts suggest it may be struts, stabilizer links or other non-obvious sources.
View 4 Replies
I got my Sonata at 27k, its now at 76k and the cars been great although I had the following issues.
I've noticed sometimes when I startup and shift into reverse the car jerks a bit and its not a smooth transition. However other times the car is very fluid in switching gears. Should I take it in to have a look at it?
Also when I am turning onto a unleveled road (usually a higher road), I notice a creaking/knocking noise coming from the front of the car, also notice it when I reverse into a parking space sometimes.
View 4 Replies
It's getting worse - I've looked all over the place and can't find the source. None of the other seats do it.
View 24 Replies
I have a 2012 Azera and when I enter and exit the vehicle, the driver seat will automatically move forward and backward. I have noticed that it just started making a loud clicking noise when moving forward and backward. Is this a motor issue, something under the seat, or maybe just a lubricant issue?
View 21 Replies
My drivers seat won't disengage from the track on the right side rail next to the console.
Looking for a shot from the manual before I take it apart?
View 5 Replies
I have 2011 GX 460 with 28000 miles. Just recently I started to notice the noise of the engine. You can only hear it only from a driver's seat, and it happens when you drop the pedal and engine goes into idling, at stop signs or stop lights etc. It comes as grinding noise and goes away when you accelerate. If the vehicle in parking or at full stop, you can hear this humming light grinding noise. I go outside, lay under the car and hear no noise. The dealer says it is a normal sound for this vehicle. I tried a few of them, and it is not the sound I hear.
View 14 Replies
I have a 2002 Chevy Impala with power driver's seat. The seat has three motors which move the seat forward/back, front of the seat up/down, rear of the seat up/down.
The seat will no longer go up/down in the rear of the seat. More importantly, it will no longer go forward or back. The left side jack screw spins and wants to move the seat forward or back but eventually stops when it can no longer go any further because the right side jack screw will not turn at all.
All of the motors are working properly and turning the flexible drive shafts. The drive shafts do not appear to be stripped at the ends. After removing the drive shaft covers and reinstalling the drive shaft, I can see that they are turning when the motors are activated.
I then removed the drive shafts and inserted a square bit into the end where the drive shaft gets inserted into the gearing attached to the jack screw. The bit just spins and spins and doesn’t turn the jack screw.
I cannot removed the seat because it is in a position where the rear bolts are covered by the seat. I have tried to remove the four bolts under the seat that attach the seat to the frame. I am unable to break these bolts free (they appear to be welded or loc-tited down).
View 5 Replies
Driver seat tilts forward all by itself sometimes when I park the car. I thought I read a thread in the past that someone else has this issue. 2007 Azera Limited and she has 90,000 mile on her. I have never held a car this long. That means I like it.
View 2 Replies
For years my wife has complained about the front passenger seat in my 06 Sonata. She says the seat bottom feels like it is tipped forward and too low.
Have you found a remedy for this?
View 10 Replies