So I've been searching and I could not find the answer to this. My car is sitting quite low on coil overs. I want to get this body kit but my question is:
How much lower does this body kit (more specifically the front lip) make the car? Does the kit go more outwards or downwards?
Recently, i realized the doors would automatically unlock after sitting in garage or parking lot for a night. In the beginning, i was thinking maybe that was my fault that i didn't lock it. However, I double double double checked every time when i left my car. the next day, it was unlocked.
View 14 RepliesI recently purchased my 2011 Camry XLE and have had the car alarm go off while the car was sitting in my driveway. This happened a few times and I thought I would push the plunger door switch in and out a couple of times to see if this would work. It did for a while like 2 weeks and then yesterday the car alarm went off again while it was sitting in my driveway again.
I grabbed my key and hit the door open button which turned off the alarm and locked the doors with the remote key fob. About an hour later the alarm went off again. I stopped the alarm again by hitting the open door button and then went out and pushed the door plunger button in and out again. So far the alarm hasn't gone off again.
When this first happened I took it back to the dealer and they said they tested the alarm system and found nothing wrong with it. Is it safe to assume that it is a bad door button? Is there any record in the car's computer that would tell when the alarm went off and why? Can the door plunger button be adjusted to correct this?
I have a 2011 premium and I just went out in the garage for something and happens to hear the compressor running. It turned off after about 10sec but I haven't driven the car for 8 hours. Does it level itself all the time even when not running? Do I have a leak or could it just be that it's now getting cold and was warmer today?
View 6 RepliesI have a 2011 Ranger with four wheel drive, a manual transmission and 34000 miles on it. The transmission gets very stiff after sitting for a while. At the worst I can't get it into first or reverse at all without hunting through all the other gears to find one it will shift into to get things moving. Is this normal for this vehicle or should I worry?
View 4 RepliesI am getting a terrible creaking noise when the car is cold after sitting all night . I've tried to isolate the area where the noise is coming from, but it varies from side to side. I have shot all movable parts with PB Blaster and it appears to work somewhat . I never noticed it until the cold weather. Where to look maybe engine cradle mount areas? 2010 Sonata 2.4 GLS
View 6 RepliesI hear a squeaking noise when I start my car. It is mostly in the mornings. Sometimes other parts of the day also. I believe it is on cold start because I usually hear it when the car has been sitting for a few hours.
My first thought was that it may be the belt so I popped the hood and looked at it. The belt seemed nice and tight and there were no cracks or extensive wear on it.
Second thought was brakes. My front brake pads are good but rear brake pads are close to needing replacement. Sometimes when I brake I hear the squeaking noise but it is hard to tell because at time it feels like it is coming from other cars.
Could the brakes be the cause of this sound? Even though it is at start up and not constant.
Car is 2007 Sonata with 100k+ miles on it.
I recently bought this CPO Azera that came with 100k mile powertrain warranty. I noticed startup rattle that occurs when the car has been sitting for 30mins and longer. It usually lasts 2 - 4 seconds.
I wanted to take it to the dealership but I want to make sure that I approach them the right way and won't be sent home with "this is normal behavior" as it happened in many cases when I was researching it. I suspect chain tensioner but I might be wrong.
2013 Azera Limited with 49k miles ....
I have a 2011 F-150 with the v-6 automatic. The truck has just under 45,000 miles on it. Couple of times I have started it up in the morning to head to work, and when I put it in gear(fwd or reverse) it seems to slip at first. It does it just the one time, then it will be fine. It only happens in the morning after sitting for the night and when it is cooler(Arizona here so hasn't gotten much cooler than the 50's at night so far). I need to take the truck in for another issue, but thought I would ask on here first.
View 14 RepliesMy 4 cylinder Sonata was so smooth at idle when I first got it that I couldn't tell the engine was running. Now there is some vibration noticable while sitting at stop lights (82,000 miles) .... Its gotten gradually worse but still isn't a big problem.
Is there anything typical that might cause this that I could fix? Its not extreme but there is a definite vibration that wasn't there when the car was new. My first thought was that one of the spark plugs is slightly fouled.
I usually change plugs at 75K miles so I need to do the plugs anyway. My thoughts are if its an engine mount the vibration would be much worse. Maybe its a vacuum leak somewhere ... don't know.
I have a 2007 3.3L Sonata.
The car has been sitting for around 8 hours. Wh en I start it, the idle moves up and down about 100rmps. When I drive off there is a slight hesitation until I have driven for about 10-15 minutes. The idle is nice and steady after the too.
If I use a fuel system cleaner, it appears the car is fine for awhile and then the issue comes back.
So I have a little weird issue. My car has been sputtering a little when sitting idle at lights and such. But once I fill it up with gas the sputtering is even more noticeable. What this is?
View 3 RepliesI just replaced my OEM battery with a duralast from autozone. The battery had 138,000 miles. Shortly after, the check engine light came on and code says P0106. Map Sensor. Seems like to much of coincidence that this happened. Have read that disconnecting battery cables for 3 hours may do the trick.
View 8 RepliesSo I just got new ST's last week. My rear drop ended up less than 2" at the lowest setting. I know KW's go low. Here are some pictures of the drop and coils. How to get lower?
View 12 RepliesSo, I am starting to look at coilover kits. I really want to have as close to stock ride height in the winter. Deep snow and chunks of snow/ice on the road are common here and I don't want to break bumpers. At least I don't want to break bumpers any more than a stock car would.
In the summer however, I want to lose the gap. Really given the last couple of winters, it would be really nice to be able to change the ride height in just a few minutes, without removing wheels or jacking the car up.
It seems that the coilover kits I have seen so far start at about 1" lower than stock. Are there any kits out there that start at, or close to, stock height? I know 1" isn't much lower than stock, but again I am trying to get as close to stock for winter driving. Is there something that can be added to these kits to push the max height up some?
Oh yeah, ride quality and cornering performance are important too!
I'm reaching out to see if any other MQB platform owners who had DCC/Magride are experiencing suspension errors after upgrading to coilovers while employing a delete kit. Some of us S3 owners have been running into this issue after such an upgrade and using this kit by KW. I can throw a suspension error on demand in my S3 by taking a turn/curve at 40mph+ (highway on/off ramps work perfectly for this). A bumpy road or hard braking can also cause an error to be thrown.
Aside from the error being annoying sounding and looking it also re-enabled traction control. You cannot turn traction control back off until you've power cycled the car. This is a pretty annoying side effect that could also be pretty dangerous under the right circumstances. KW seems to think their kit is operating correctly and that the height sensors are out of range due to lowering the car. Currently there's no way to adjust where the height sensors sit so in my personal opinion this seems like a massive oversight on KWs part and their product is not working correctly.
I am adjusting my coilovers this weekend (Bilstein PSS10). Bringing them up a bit as the ride continues to be too rough for a daily driver. Would like to compare the height to stock.
Stock suspension height and wheels, looking for a quick measurement from the ground to the bottom of the fender edge (Across the center of the wheel) for front and rear?.
I have a 20th ae, and I figured how to lower the fronts a bit...but the backs, I tried searching but didn't find much......
View 3 RepliesI picked up some Megan coil overs with plans to install them today, but can't figure out where one part goes. It looks like a spring spacer. The instructions are terrible and make no mention of what it is. My guess is it goes with the rear springs but...? [URL]....
View 24 RepliesHow do you adjust the rear height on coilovers? I have the ST coilovers which are comparable to the KW. Do I have to compress the spring and then adjust? I tried to do it with the wrenches given but the whole thing just turns with it. I'm going to lower the front some more and I want to do the rear as well. It is my first set of coilovers on a car and I had someone else do the install.
View 3 RepliesInstalled the coilovers , took it for a drive , the rear end is just way to stiff. It seems like there was no rebound at all. We have the setting to softest. When installing the coilovers, the whole spring and shock assy was about 3 inches shorter than the OEM parts. We have to jack up the lower control arm to get it to mount. Is something adjusted wrong?
View 14 Replies