Sonata I45 (LF 2015+) :: Oil Burning Smell After Driving - Leaking Valve Cover Gasket?
Nov 21, 2015
I've been noticing an oil burning smell after driving recently, it's been going on for a few days now. My oil level is good, I have 8,500 miles on the car. Today I finally had a chance to look under the hood for any visible leaks, and I noticed some oil stains on what I think is the valve cover gasket.
2015 Sonata 2.0T ...
View 5 Replies
Advertisement
After reading some posts I think my passat could have the cam seal and valve cover gasket leaking. I smell burning oil when stopped. How much should this repair cost if I go to an indy repair shop?
View 3 Replies
My son-in-law came by tonight and showed me his ticket from his oil change at the dealer on his '08 Azera, 108k miles. Tech remarked that both valve cover gaskets AND the oil pan gasket were leaking. I've walked through his garage many times when my daughter has the car at work and I've never noticed any oil on the floor. Should have I seen any? I told dealer I would just drive it and monitor the oil level and any other signs of oil leakage. Since he bought the car with 101k miles and a fresh oil change ticket and never checked the level over the next 7k miles I don't think it's leaking bad.
View 2 Replies
A couple of days ago, I was driving my car around when the oil pressure light came on. Having recently changed the oil myself, I figured I had neglected to tighten something down there and it had become loose and was leaking oil. I stopped at two different shops. Both shops told me the leak was coming from the valve cover gasket. Instead of paying $200 for them to replace it, I did it myself. I didn't use any sealant or silicone, or anything like that. The old gasket was hard as a rock and had some sort of red cement around it.
After I had everything back together, I had a partner start the car for me. The oil leak has become much worse--probably a quart a minute. The thing is... I can't see any oil leaking from the valve cover gasket. You would think that an oil leak of that volume would be visible if it were coming from the top of the engine, no? We're going to take the gasket off again to inspect and perhaps use some gasket sealant in select spots, per some YouTube videos we watched.
View 3 Replies
I'm thinking of purchasing a 2001 GLX VR6 Jetta with lots of deferred maintenance (shocks/struts, brakes, exhaust). Most worryingly, the valve cover gasket is leaking oil. The price is pretty low, but is such a beast worthwhile at any price or is it better parted out? And the interior is about as beat up as the mechanical--screeching passenger window motor, broken glove compartment ... Is this thing worth being brought back to life?
View 6 Replies
I have a 2002 toyota camry xle 6 cyl i believe i have a valve cover gasket leaking vehicle has 112,000 miles. is there a step by step removal proccess i can access. I have done one on a 1995 honda passport 6 cyl how difficult is it
View 2 Replies
Changing the valve cover gasket on the 4 cylinder 2.4l. I was going to change mine's. Didn't know if there are any special tips like sealant to be used, loosening bolt sequence or tightening sequence, torque values.
View 9 Replies
I have a 2002 F250 5.4with Air Conditioning. The valve covers are leaking and the gaskets need to be replaced. I am attempting the valve cover gaskets. I was able to get the drivers side cover off with some difficulty. For the passenger side valve cover. There is very little " no" room to get at the bolts. I read somewhere that I may have to drop the engine on that side. I will do that if I have to.
View 5 Replies
I'm suspecting a small valve cover gasket leak. I've noticed dirt starting to accumulate near the alternator side of the front valve cover, there is dirt on there stuck to oil, I don't see any wet oil but its so minor the dirt just sticks to it. 107k miles here. Seems to be a common problem. I think Downhiller had a large oil leak, source unknown around his crank pulley area. You wouldn't think a car this young would leak oil. It's not bad, I havn't had to top any off I just like a mildly clean engine.
View 38 Replies
I have a 2007 Sonata V6 with 198,000km (123,000 miles) and when I was driving yesterday I smelt a burning smell like burning rubber or plastic. The smell seemed to go away after a while and I was wondering what could have caused it?
View 2 Replies
when replacing valve cover gasket, using the cork based one. Do you use any gasket sealant or any kind of silicone or just put it in by its self.
View 5 Replies
so I have a 2azfe engine
So there's an oil leak coming from the valve cover gasket (just purchased vehicle dirt cheap with 220k)
found this
Notice all the oil sitting on top of the exhaust mani gasket
In the left(lower) part of the picture it appears to be scraped.
the gasket appears to be newer, I did NOT use a screw driver to remove the valve cover, which is what this appears to have been done..
Can this be sanded down then filled with jb weld, and then regasketed?
View 7 Replies
So I'll be taking on a project to replace the valve cover gasket on my 2002 Camry V6. There's a bit of leakage through the gasket. And while I'm at it, I'll replace the spark plugs as well. I'm looking for a write up on this project. did a lot of searching but couldn't find anything.
View 14 Replies
I've got a coolant leak here (I wiped away some of it before taking the picture):
Close up
This is the only place I can find coolant leaking and it's running down all the way to the water pump:
When I wiped away from just below the valve cover gasket it flaked right off and it doesn't appear there is any oil mixed in. I changed the oil today and it didn't appear to have any coolant mixed in either.
The coolant doesn't appear to have any oil in it's nice and pink as it should be. I started the car from a cold start and sat and watched the area waiting for it to leak but nothing ever came out, of course.
I know there shouldn't be coolant leaking from this area anyways but I don't know how else to explain the trail pictured. I definitely have a small leak somewhere as I've found coolant on the floor of the garage before.
Do I just replace the valve cover gasket and move on or is there something else I should be concerned with here?
View 11 Replies
I have a 99 passat 2.8 v6, that closing on 200k miles, and its a car i'd really like to keep, lately i've had a few leaks coming from valve cover gasket, which i replaced, and now from the front drivers cam, and the rear passenger cam, the smell is terrible and the smoke is worse, i clean out the pcv but its still happening, i talked to a mechanic he says with that many miles i should just do the timing belt and get the seals done.
View 19 Replies
How difficult is it to replace the valve cover gasket on a 2001 Santa Fe with a 2.7? Can I just do the 'front' valve cover? Are there any tutorials with plenty of pictures while doing this?
View 4 Replies
A few days ago I noticed some oil leaking from the left (front) valve cover area and I suspect it's the gasket. Fortunately, I didn't see any leaks from the back cover. It seemed like an easy job to replace the gasket, but as I started to disconnect the wiring, e.g., cam sensor, spark plugs, etc., I can't seem to find a way to remove the black plastic wiring harness 'housing' out of the way.
View 1 Replies
I had a very slow oil leak that dripped onto the garage floor and i brought it into the dealership. They said it was a leaking left valve cover gasket; I searched and came up with nothing? The engine has just over 30K miles on it.
View 20 Replies
I just noticed what appeared to be an oil leak around the valve cover gasket, which the VW dealer has determined to be a defective cam sensor. Apparently the VW parts distribution center in Wisconsin has 530 of these in stock, so it may be a common failure. This is on a 2010 GTI with 28,xxx miles. Thought the community would like to know.
View 2 Replies
How to replace valve cover gaskets on 2002 430sc???
View 14 Replies
I did a valve cover gasket replacement. Changed all spark plugs and coilpacks. The car is still misfiring. I also just did the timing belt and water pump. Why it's still misfiring?? I'm new to this whole forum thing so bear with me lol. I'm wondering if it would be my cat, fuel pump, fuel filter. Or could it be a sensor?
View 2 Replies