Sonata NF (2006-10) :: Clutch Noise In Neutral
Jul 18, 2016
So I was visiting my brother yesterday and he was standing beside the car when I started it (in first gear, clutch disengaged). When I put the car in neutral and let the clutch out he asked if I had heard the noise it made. Makes it when the clutch is engaged (ie, pedal up) but not when engaged, so I can safely say it's not the throw-out, which would be noisy when clutch disengaged. Kind of a rattling noise, nothing really loud but is noticeable. Could this be something to do with the dreaded dual mass flywheel? Wouldn't imagine it has anything to do with the clutch disc as it would be held tight when the clutch is engaged.
View 2 Replies
Advertisement
I have a 2009 Hyundai sonata, 2.4, 5 speed manual, gls, when I press down on clutch whether from a stop or when shifting, I get a loud grinding noise and the radio goes dead at same time!, I know it is the starter attempting to "engage", at least that's what I believe it to be, it also "'starts "from, the "on " position when I press on clutch.
View 8 Replies
Long story..couple months ago while coming home my 08 Sonata 2.4L manual 84,000 miles...started making this grinding noise and would stop when I pressed the clutch in and then sounded like something was grinding near the passenger front wheel.. well I get it home and the next morning my husband and I ride up the road so he can hear it.. was going to take it to the shop but it stopped and ran just fine till the other day.. crank the car and its fine.. once it gets warmed up and a few miles down the road it makes a knocking noise...but only when I let off the gas or idling .. even pressing on the gas just a tiny bit made it stop (even tried in while parked in the driveway with the hood up to make sure the engine wasn't just drowning it out) well I took it to the local dealership today and they said it was the flywheel and that it and the clutch and bearing needed to be replaced..
View 3 Replies
I'm at my place in Florida 1,000 miles from home, and when I started the car in a mall parking lot, there was some grinding metallic noise for a few seconds and I couldn't get it into first or reverse and the clutch pedal was way down. I was able to get going in 2nd and eventually the clutch was back to normal and I could get 1st and R. What happened? Broke some fingers in the pressure plate? Seems to run fine now but have a 1,000 mile ride ahead in the morning.
View 1 Replies
I was driving down the street and i noticed i couldnt get it in first gear, almost like a wall blocking it. and then i put it into 2nd gear and i started rolling... i turned my car off and when i started it back up, it had a slight grinding noise (in neutral). i put it in first gear, took out the clutch and i wasnt going anywhere... same with 2nd gear...
so i towed my car to the shop, they said my clutch went out and i "lost first and REVERSE gear".... is that possible?!
View 9 Replies
Now with the new clutch installed, it makes a terrible noise with my foot off of the clutch in neutral. I can't get into any gears; it'll just grind gears.
Here is a video of the noise. Again the noise only occurs with my foot off of the clutch pedal. Quiet with my foot on the clutch. I can't get into any gears.
1996 Honda Civic
View 19 Replies
2012 Golf 2.5 5 speed.
To keep it short: car has been making this noise since day one. Only happens once things have warmed up (20-30 minute drive). Push the clutch in and the noise goes away. This video was taken with the phone placed on the driver side front wheel.
Trans makes a "marbles in a can" noise with clutch out in neutral and when pushed in everything gets quiet. It's driving me nuts and I just have to know if its normal. The dealer told me its "play in the bearings of the trans because they aren't engineered with the tightest tolerances"
Here's the link to the video.....
View 7 Replies
I just recently picked up a 87 F250 with a 6.9 and a ZF5 trans. The PO replaced the clutch, and mentioned that he replaced the clutch fork too
Since I bought the truck, I've had some nasty rattling noises. It rattles when in neutral, and stops when I put the clutch in. The noise also comes back on occasion when decelerating at highway speeds, in 2nd as soon as I stop accelerating, and at low speeds in 3rd.
What is causing this?
View 4 Replies
My 06 sonata drop into neutral while driving. Any clues as to why this would happen?
View 2 Replies
My 2009 Sonata, 2. 4 L engine, base model with automatic transmission started up and ran OK, but 20 minutes later when I parked the car and shifted towards Park the gears grinded in neutral, stopped grinding in Reverse, and then grinded again when I made it to Park, and I quickly turned off the engine.
When I restarted, it grinded in Park, OK past Reverse, Grinded in Neutral, and then OK in Drive. How serious this is, or if there is anything I can check out on my own?
View 19 Replies
I've got an unknown issue with my 07 Accent (1.6L):
There is a low tone noise coming from near the upper area of the engine. It sounds like air or fluid traveling through a hose. The tone of the noise has recently become progressively louder, so that it is noticeable over normal road noise when driving. The noise does not fluctuate in tone or intensity with changes in RPM. However, the tone changes to a higher pitched frequency, almost like a hiss, when the clutch is fully engaged and held to the floor, both when in gear and when not in gear.
What the cause may be? And potentially required maintenance?
View 4 Replies
I have an 06 sonata 4 cyl automatic.Today the transmission was slipping in first gear like the car was revving in neutral.Then after restarting the car it was completely normal. Code P0731 showed up.
View 1 Replies
I have a 09' 4cyl automatic engine with 54k.
About 30min ago when when I parked the shifter would not move past neutral into reverse and go into park. I can go from D into neutral or the next slot over for manual shifting. Naturally this causes a problem as you can't take the key out of the ignition if its not in park.
I took a screw driver and popped open the cap for the shift release button and used that to move it into park. Turned car off, back on, etc etc seemed fine. So when I tried moving it into reverse and it wouldn't budge. It instead would make a electronic click or snap coming form the steering column but more back toward the engine. Like more into the dash area but back in it. It would make this noise every time I attempted to move it but it wasn't a continuous sound. Just once with each jerk to the side to move it out of park.
So the car works fine except for this. I used it with the screw driver/shift release to unlock it and it drives fine. Goes into reverse and back in park but if I move it into neutral or drive it will not go back into reverse or park.
View 1 Replies
I'm having trouble with my a/c clutch not engaging now for about 4 days. I believe I have narrowed it down to the field coil. I checked and I am getting 14 volts at the wire that plugs into the compressor. Auto a/c function will not turn on the a/c compressor light on the dash, but will turn on when manually pushed. When this first started, the radiator fan would kick on but spin slowly and now does not turn on at all when engaging a/c.
Per an older thread I checked the resistance at the a/c relay, though it did not tell me which pin(s). The only readings in ohms I could find from the a/c relay junction in the engine fuse box said 69-76 ohms, but I am unsure whether I am reading the correct wires or the correct way. Facing the front of the car, I am getting the above ohm reading from the bottom right pin to ground. Which pin is the correct one to test?
I am currently thinking the a/c clutch field coil is bad, but it stumps me that the radiator fan will not kick on either now.
Background of car : PO wrecked car, damaging the front end. I bought the car and fixed it up. A/C Pulley was replaced due to bent flange where serpentine belt travels. Also brand new radiator fan and replaced other seemingly non-related items to this issue.
View 8 Replies
Recently, I clutched, the pedal went down, thought I heard something a little crunchy and then the pedal "popped" up. The clutch has been different since. Sometimes difficult to get in and out of gear. Have to double clutch. The first inch and a half of pedal has no resistance. When I release the pedal it pops up. You can hear it. It never stays down. I don't have to bring it up. Local garage thought it was something in the clutch itself. Otherwise clutch is tight. No slippage. Could it be in the hydraulics? Do we have to pull tranny to replace slave? It's not getting better and I want to fix before it gets worse. Car has about 100,000 miles.
View 1 Replies
I have a 09 Sonata which when shifting once, the clutch depressed but did not come back up. While waiting for Hyundai service to come I tried to move the car down the hill to a shady spot on curb for my son and the clutch started working normally and has for 6 months...
View 2 Replies
Just noticed yesterday that the compressor clutch does not disengage while the air conditioner is on. It is 2005 V6 Sonata Elite. All the other cars I have ever owned had compressor clutches that cycle. Internet searches indicate that there might be air conditioners with only a low-pressure switch.
View 2 Replies
M/T 2010 Sonata. I'm just out of warranty at 102,000 mi. No issues before with clutch. I noticed a clicking or crunching sound when pushing the clutch pedal down. I took a gander and noticed the pedal was traveling farther than it used to because there were indentations in the carpet. So this happens for about 3 days. Then I start the car and cant get it into gear. If I shut it off, it easily goes into gear and I can drive. Usually it is ok after that point but is getting worse. Mechanic briefly tried to bleed it but the pedal stayed on the floor. He was able to get it to its original problem but said if he replaces the master & slave cyl then might as well do a new clutch. Because I had no slippage, no pedal issues or anything prior to clicking. Is 102k miles and 6 years usual time for these components to fail?
View 2 Replies
Is it bad shifting from drive to neutral then back to drive going 40mph without pressing on the gas only coasting on a daily bases?
2008 Sonata GLS ... Automatic transmission ...
View 8 Replies
I have a 2007 Elantra with 138,000 miles. I never had any slipping or jerking or reverse issues in the past. I got into the car put it in reverse just fine then put it in drive and nothing happened, I put it in park and the car kept rolling like in neutral and started making a loud grinding noise. When I put the transmission in any other gear the noise stops but will not move and acts as if in neutral.
View 2 Replies
I have an 00 Accent 1.5 liter 5 speed with about 192000 miles on it. I have put about a tank of gas through it since I've owned it, so I can't give a lot of background on it. When I got it the previous owner told me it was popping out of fifth gear and the clutch fluid leaked.
Upon driving it around a while I noticed it would pop out of fifth and third gears almost at random, but seemed to happen more when I applied throttle. I assumed it was an issue with the shifter not fully engaging the gears, and checked out the bushings under the hood and in the console. All looked good, and I didn't see any extra play.
I drove the car for about 30 miles straight and had to downshift and wasn't able to get the car to go into any gear but fifth. I was moving about 20 mph when this occurred. I was able to limp along to a parking lot where I let the car sit for about ten min and I shifted through the gears when stopped. I headed back home with this problem throughout the trip. There is a sound that happens on occasion (that stops when I press the clutch pedal) that sounds like a bad bearing in the clutch area.
When I'm stopped with the car in neutral and I release the clutch the car stalls like it's in gear. I was able to get the car to move some, but it really doesn't want to it acts like there is something jammed in the gears and popped really loud when I backed it up.
There is fluid for the master cylinder, and I can see the slave cylinder moving when the pedal is pressed. I jacked it up and removed the plug to check for gear oil, and it came pouring out, so I think it has fluid in the gearbox. I'm pretty sure it needs a clutch at the least. I think there may be some internal damage in the tranny, and I'm only into the car for the time it took to power wash a house and don't want to get involved in a big mess.
View 5 Replies
