2007 Sonata V6 with 72K miles.
The car has developed a rough idle while in gear (i.e. when stopped at a stop light) and park (i.e. after I start the car).
It's starting to get a little annoying since I'm used to a very smooth idle.
I think this issue started within the last 2-3k miles.
Plugs were allegedly changed at 30k. A full tuneup was done at that time.
Wires are still original.
I have a high milage (210K) '07 2.4L which has a slight engine rattling noise at idle RPM at cold and operating temps, in gear or park. It is a fairly constant noise at idle but does vary a little. Otherwise, engine/tranny operate beautifully with no obvious problems.
I am concerned this could be a timing chain/tensioner related issue although I also wonder if it may be some other component. I have not been able to determine the source or location of the sound.
I have a 2006 Hyundia Sonata. I idles really bad like you pulled 5 of the six plug wires off when you put it in gear. Once you start moving a couple miles an hour it is fine. It is also perfect in park or neutral, not a hint of a problem. Put it in drive or reverse and it almost stalls.
View 13 Replies2006 Sonata V6 with 98K miles. The car has developed a rough idle, sputter/lurch while in gear, but not park or neutral. No CEL/codes. Have already replaced the spark plugs (OE), throttle body/FI cleaned, MAF cleaned, new air filter, coil packs OK... Mechanic said no vac leaks, FI spray pattern good, good fuel pressure, etc. Vibration dampener looks ok, no separation or wobble. Another post mentioned a power steering pressure sensor, which I will have checked, but the mechanic is at a loss.
View 7 Replies2006 Sonata 2.4 (4-cyl)? My Sonnata has rough idle while stopped and in gear feels like it wants to lurch while holding the brake down, runs great at running speed. I did have the problem with it stalling while stopped but cleaning the throttle body remedied that problem. I've changed the spark plugs and one coil,the pcv valve, the front O2 sensor (with a universal spliced in sensor), and the air filter has been changed as well. I keep getting P0304 (cyl. 4 missfire) and P0032 (O2 sensor), I've swapped out both the coil and spark plug with another cylinder and the code still shows for cylinder 4. I've also checked for vacuum leaks and I can't find any.
View 4 Replies1994 Buick LeSabre Custom 3.8 Litre V6 with 103277 miles.
It runs smooth when idling in Park, rough when I put it in gear when I am stopped (either drive or reverse) has hesitation when accelerating, it smooths out again when driving then it starts to drive rough at about 55 MPH.
Mechanic told me it was the plug wires. I replaced those and the plugs. This fixed the hesitation when accelerating issue, but the other issues remain (now even seem a little worse) I thought the plugs and/or wires were bad, so I rechecked the gauge on the plugs and traced to make sure I had the wires hooked up right. Everything seems in order.
I have added fuel injector cleaner, and changed the oil, oil filter, spark plugs, spark plug wires, air filter, flushed the radiator, and changed the thermostat. (For a tune up since it has admittedly been a while)....
As of late, my 06 Camry (I4) idle's real rough @ 600 rpms when in park. It stays the same in drive with the A/C on. However, when I switch the A/C off, for about 2 secs, the idle will be smooth before dropping down in rpms. Some folks have said this is normal, but I've had this happened to my car before. I've got 135K on it so I'm guess a tune up is in order.
I'm new in the game of working on my car myself since a past issue with the dealer on my '06. So if all is needed is a tune up, I can do that myself with the parts of my choice.
My 2009 Sonata, 2. 4 L engine, base model with automatic transmission started up and ran OK, but 20 minutes later when I parked the car and shifted towards Park the gears grinded in neutral, stopped grinding in Reverse, and then grinded again when I made it to Park, and I quickly turned off the engine.
When I restarted, it grinded in Park, OK past Reverse, Grinded in Neutral, and then OK in Drive. How serious this is, or if there is anything I can check out on my own?
2011 accent gs. We purchased the car brand new and it currently has roughly 32k miles on it. About a month ago the car started to misfire at an idle (in park and in gear stopped at a light, etc.). At this time, I purchased a new air filter, and a new set of autolite platinum plugs. Roughly 3 weeks later it started misfiring again. After a few internet searches it seemed as though some people don't like autolite platinum plugs. At this point I purchased a fresh set of NGK iridium ix plugs and figured that'd be the end of it. I test drove the car for almost an hour myself (the same night I repaired it) with no issue. On my wife's commute the very next morning it acted up again.
We took it to the dealer this morning, and I honestly don't believe what they're telling me. They are insisting the problem is with spark plugs. They say that the manufacturer recommends copper plugs only, and that would be step 1 of their diagnosis/repair which they want $130 for. At this point I declined their service, and they'll let me put copper plugs back in. They said that if it continues to act up to bring it back in after that. Ah yes, and during this whole time there has never been a check engine light.
My 09 Sonata GLS has 50k miles on it. I bought it as a demo model with 9k on it (regret that) as new ... who knows how it was treated.
at 40k miles I noticed that in the morning when I was braking the car would feel like it was slipping out of gear momentarily and it was pretty rough. After a few minutes it would stop and I could continue on my way. The car is an automatic. I noticed it if I let the car decelerate enough that it dropped into first on its own, or if I used the brakes. I figured it must be due to the cold weather or something and was hoping it would clear up. This was only happening after 8 hours of non-use, overnight in the cold.
In idle and driving the car sounds rough as if a pulley was loose, after checking no pulley was loose but problem still persists. Tried turning wheel left n right n noise didn't go away or get worse its a constant noise, what it may be? Crankshaft pulley? Idler pulley?
View 2 Replies2007 Sonata V6. He's spent many hours and a good chunk of change at the dealership trying to get it fixed and nothing has worked yet. They honestly have no clue whats wrong which kinda scares me.
First off here is his problem. Occasionally when he starts the car it will idle very rough and struggles to accelerate to 30-40mph. When this happens he pulls over and shuts the car off for a few minutes then it will run fine again. When all of this happens there is no CEL or any light at all that flashes or comes on the dash.
Here is a list of things that have been replaced
Fuel pump
Throttle position sensor
Crank sensor
Plugs, wires and coil pack
I have 114,00 miles on my car. Plugs changed and decarbonization done at 99,000 as well as ECM reprogram or update ($99). Anyway, when my car sits overnight and starts it is getting a rough high idle until I feather the pedal or give it a minute or 2 and it is fine. It is warm now in the 70's and this just started. I had it to the dealer for oil change and they looked at it. There are no codes, they recommended changing the plugs and doing a decarb again. So I told them if I need plugs there is something wrong, Iridium OEM were installed.
Anyway, they suggested changing the throttle body since it has new sensors. I have have the TPS replaced before when engine was surging. They told me there are 2 sensors and one could be bad in throttle body. I don't get it, I use Hyundai air filter now and change every 15,000 miles and get oil changes regularly and they use Quaker State Synthetic blend. I am wondering if maybe I have a faulty PCV? I don't think that has been changed. Don't even know what the interval is. Previously I was told there was none, but I disagree.
What would cause me to get carbon build up like they keep telling me? I don't want trial and error and throw parts and money at it since there are no codes. I was going to drive it til it throws a code. I do highway driving in suburban area, mostly 65 mph. The car runs good, still the intermittent hard downshift when slowing down but nothing like before the tranny was replaced.
I've got a troublesome misfire in a 2007 Sonata V6, 70k miles, which I have been trying and failing to track down for a long time.
More than a year ago, the owner of the car complained of rough idle. When this was first mentioned, I looked at the car, she and I talked, and I concluded that she hadn't changed the oil in some 20k miles. ...... Nothing else seemed wrong. I changed the oil, thinking that what she needed was an oil change.
Some time later, I was in the car myself and all of a sudden felt a strong bucking. Must've been a misfire. I recommended taking it to the Hyundai dealer, thinking the so-called 100k mile powertrain warranty would cover whatever it was (it didn't but whatever).
We drove it to the dealer. The dealer firstly informed us that the CEL had burned out, so we had missed some codes. The dealer further us the car needed new plugs and replacement of both upstream O2 sensors. Here was what the mechanic wrote:
"BETWEEN 35-40 PUT CRUISE ON AND WILL FEEL. CHECK AND ADVISE COMES AND GOES. MULTIPLE CODES STORED IN SYSTEM. ... P0300 RANDOM MISFIRE (ACTIVE), P0140 O2 SENSOR CIRCUIT NO ACTIVITY, P0154 O2 BS S1 NO ACTIVITY. WATCHED O2 VALUES AND FOUND ERRATIC READINGS. FOUND TSB 10-FL-012 SUGGESTING REPLACEMENT OF BOTH UPSTREAM O2 SENSORS. RECOMMEND COMPLETE SYSTEM TUNE UP FOR RANDOM MISFIRE. HOWEVER MISFIRE COULD BE RELATED TO O2 ACTIVITY.
So the owner went to a different mechanic and had the plugs, upstream O2 sensors, and one of the downstream sensors replaced. All OEM, I believe. ($$$!) (O2 sensor parts 39210-3C100, -3C200, and -3C400) Dunno why the downstream one was replaced, not my doing.
Following this, there was no real improvement. No codes either. The problem comes and goes, so maybe I thought it was fixed, but it has come back. Sometimes, it can be felt just slightly when the car starts cold. Other times, it can be felt just barely when driving at a consistent speed. Sometimes, the problem becomes really bad and jerks the car around. Other times, nothing.
What to check next? Coil packs? Intake manifold gasket? She never gets "top tier gasoline," but I would be skeptical that that's the problem. These are the top three suggestions I've heard.
So my sonata 2.4L has been freaking me out lately. Once it has been driven and warmed up good, it starts to idle rough at rest at lights and in traffic. Now the crazy thing is it idles even more rough if I switch it into neutral during those stops. One more thing is it idles the worst after I fill up with gas and get stopped at lights.
So what I have done:
Cleaned the MAF sensor with MAF spray
Changed spark plugs (I4 so it comes with coils not plugs)
Put Lucas Gas treatment in
So I'm getting no check engine light. So all I can think of is fuel filter. Or some other sensor. I mean I know it could be a coil so that would be the next thing I check. What this could be?
My idle seems to always be somewhat rough whenever I put the heat on in cold weather. While in drive I'll come to a red light, heat will be on and I'll stop. The. my idle will bounce down then back up. I shut heat off to test and it only does it while heats on.
View 5 RepliesI have a 06 sonata 3.3L v6. I have been having misfire problems and lack of power under 2000 rpms and at idle when I am either a stop or just warming the car. What is happening I feel it shake and feel the misfire but after it gets up after 2000 rpm at highway speeds its completely fine. It struggles getting up to speed if i press on the accelerator. I have changed the spark plugs and all the ignition coils maybe about 2 months ago, I have also have changed the camshaft position sensor for the rear bank. I believe that it could be the crankshaft position sensor but I want to make sure....
Obd2 codes: p300,301, 303, p0012, p0011, p0014,
My 06 Sonata runs very rough at start up when the car is cold. It appears that it is missing on several cylinders. This last for about 15 seconds and then the car runs fine. What could be causing this problem? No check engine light.
View 10 RepliesI just bought an 2006 f150 4x4 with a 5.4l 3valve, and this morning when I pulled into work it was idling Rough as I let off the gas and rolled into my parking spot. No check engine light or nothing, just when it's in gear Rpm is at 600-700 and vibrating. When I shifted it into neutral or park it went away and the engine ran smooth. According to the oil pressure gauge I've got good flow. I was told from the dealer that they replaced the cam phasers, timing chain and put new spark plugs in it. What the issue is here?
View 1 RepliesMy car has had a rough idle (no MIL). Scanned for codes and got the following:
P0552 - Power Steering Pressure Sensor - Low
P0553 - Power Steering Pressure Sensor - High
I'm picking up the part at the dealer this afternoon. I printed out a diagram of the component location, and it looks to be easily accessible.
I have a 2006 Hyundai Sonata with a 2.4 liter 4-cylinder engine. After filling the gas tank, the car idles roughly, but accelerates and performs fine at higher speeds. The rough idle lasts about 5-10 miles and then goes away.
Six days ago, I changed the spark plugs and air filter. Four days ago, I filled up with gas (and had the same issue with the rough idle). This morning, I started the car and idled it for 2 minutes while I scraped ice off the windows. I drove the car about 5 minutes and the check engine light came on. I took it to Autozone and the code given was P2187, System too lean at idle bank #1. "
Autozone suggested that it could be an air intake fault (MAF sensor), fuel pressure, or vacuum leak. They also said they have a MAF sensor cleaner to try. I am not sure if the rough idle after fill-up and check engine are related. Also, I don't know if the spark plugs or air filter could be related to the check engine. I was planning on making some easier checks first such as hoses near where I worked last weekend, especially near the air filter. Cleaning the MAF sensor is easy too. I was also going to check for vacuum leaks (incl. intake manifold) and recheck the spark plugs.