My 06 Sonata runs very rough at start up when the car is cold. It appears that it is missing on several cylinders. This last for about 15 seconds and then the car runs fine. What could be causing this problem? No check engine light.
View 10 RepliesI have 114,00 miles on my car. Plugs changed and decarbonization done at 99,000 as well as ECM reprogram or update ($99). Anyway, when my car sits overnight and starts it is getting a rough high idle until I feather the pedal or give it a minute or 2 and it is fine. It is warm now in the 70's and this just started. I had it to the dealer for oil change and they looked at it. There are no codes, they recommended changing the plugs and doing a decarb again. So I told them if I need plugs there is something wrong, Iridium OEM were installed.
Anyway, they suggested changing the throttle body since it has new sensors. I have have the TPS replaced before when engine was surging. They told me there are 2 sensors and one could be bad in throttle body. I don't get it, I use Hyundai air filter now and change every 15,000 miles and get oil changes regularly and they use Quaker State Synthetic blend. I am wondering if maybe I have a faulty PCV? I don't think that has been changed. Don't even know what the interval is. Previously I was told there was none, but I disagree.
What would cause me to get carbon build up like they keep telling me? I don't want trial and error and throw parts and money at it since there are no codes. I was going to drive it til it throws a code. I do highway driving in suburban area, mostly 65 mph. The car runs good, still the intermittent hard downshift when slowing down but nothing like before the tranny was replaced.
My idle seems to always be somewhat rough whenever I put the heat on in cold weather. While in drive I'll come to a red light, heat will be on and I'll stop. The. my idle will bounce down then back up. I shut heat off to test and it only does it while heats on.
View 5 RepliesIf my car's been sitting - say monday morning after sitting all weekend in the garage- it runs rough for a little while. Sometimes only for a few seconds, sometimes for a little while after the idle drops. The colder the car is, the longer and worse the condition. It feels like a cylinder isn't firing.
After a particularly cold and wet spell (I had the car outside) it ran so badly it threw a code for one of the cam position sensors and #4 misfire. I replaced both of the sensors. That worked a little.
Since I was due for 80k service and saw a misfire when damp, I replaced the ignition coils along with the spark plugs. That worked a little more. But, it still does it. What else could it be if not ignition? Sticky valve? something else?
After scouring through hundreds of threads on this forum (which is Awesome, BTW), it seems as if this misfire / rough idle thing is fairly common (which is scary!!). CEL is on steady. Had the codes pulled; P0301, P0302, P0303. At the recommendation of the mechanic, I had the plugs replaced...no improvement. He then replaced the ignition coils...no improvement. Just finished replacing the MAP sensor. This actually had a VERY temporary positive effect. However, after about 5 miles of driving, the misfiring returned. Took the car to the Hyundai dealership, and they acted as if they didn't want to fool with it. They referred me to a couple of local repair shops...????
View 8 RepliesWhen I start my car it seems like some of the cylinders are missing for like 5 seconds then runs fine. Sometimes its quite violent and this morning it stalled the first time I tried. The colder it is outside the worse this becomes.
The car is still under warranty, but you have to wait a week to get the car into the dealer here and a battery wouldn't be covered anyway. Here is what I have so far.
Bad battery : The car has 45k miles on it and as far as I know the battery is stock. Also, when I did the 40k service I seem to remember something about the battery on the invoice (I will look), but I was too busy worrying about the bald tires. I do generally leave my ipod plugged into my car stereo (which charges it) over night, so that is putting a drain on it. I am going to take it out of the car tonight and see if that makes a difference. I suppose I could take the battery to O'Reilly's and have them test it, but it seems like it would be in their best interest to lie.
Coolant temperature sensor : The car was recently in the shop and they said they found a small coolant leak and fixed it, maybe the sensor became damaged? Most reports I see about this suggest the car runs rough for much longer than mine and must be fed gas.
2006 sonata 3.3L has an engine miss that is most prominent around 30 mph but not detectable at idle or during acceleration. It has new plugs that are properly gapped. Transmission fluid is good and fresh. I even checked the ignition coils and had all about .9. I even changed the fuel filter. What else could it be?
View 7 RepliesNeed to determine the noise before I took the vehicle in to be serviced. I don't know if I would necessarily describe this as grinding...to me it doesn't sound like metal on metal..but it's not normal.
Only happens on a cold startup, and even then it hasn't been 100% of the time...probably 80% of the time though.
2007 Hyundai Sonata - Startup Noise - YouTube
I found this thread, Grinding Sound On Statup but not sure it's the same issue. This just started. Vehicle has 150K miles on it.
I have a 2008 Hyundai Sonata 2.4l with ~235,000kms (~147,000 miles). It has been well maintained and has been a great car. It has been developing an engine tick noise at cold startup and it seems to be very gradually getting worse over time. This noise is most evident immediately after strarup and gradually dimishes over a period of about a minute and varies in terms of how noisy it is and how long it lasts. This nopise is never heard when the engine is warm. From what I have read online, this can be caused mainly by two things:
- use of an aftermarket oil filter
- timing chain tension insufficient
Late last week I changed the oil filter out from the Purolator Classic filter that I have been using for years to a genuine Hyundai oil filter. This did not make any noticeable change in the tick noise so I do not believe that this was a contributing factor.
Over the weekend I removed the valve cover and checked the timing chain tension. It was taught as it should be. I could push it down a bit between the camshafts but it would spring right back up. I also used a videoscope to look down inside the cam tunnel and found no evidence of the timing chain contacting any metal or the oil drip line for the lower timing chain sprocket. Everything appeared to be in order.
When I started the engine to confirm no leaks around the valve cover, I used a mechanic's stethoscope to check for the noise. I was unable to isolate it as the engine tick did not occur at that time. The cause of the tick noise continues to elude me, but I have ruled out the two common causes (oil filter and timing chain tension).
I've been chasing a problem all summer. Began with crappy batteries dying intermittently. I replaced the batteries, FICM, finally cleaned EGR valve and replaced ICP with pigtail. The problem is still persistent. Basically a rough idle, puff of whit smoke on cold startup, rough running at around 1500 rpms( driving at 50 mph). The ICP was soaked in oil so i was confident replacing it would finally cure my issues. It actually got worse with the rough idle turning to a surging idle and quite rumbly at 50 mph speed. I guess its time to look to injector issues but i thought id check if after replacing icp/ cleaning egr. I also have a slight exhaust leak at turbo out that i can see. The clamp is not seated properly. This after turbo connection to exhaust.
View 1 Replies2008 SONATA i4. The transmission started to whine a lot when first driven when cold, well transmission was replaced under warranty due to "pump failure"? I noticed that the loaner car I received for tranny replacement had a knock at startup so I called and told the dealership about it, they said it was the timing chain, it was a v6, oddly it didn't sound like timing chain to me, started after fast idle and went away within about 100 feet of driving.
2 days after I got my car back it would knock after I started it up cold when it came down off fast idle, and would knock for about 100 feet of driving or so, then the knock would disappear until the next cold start. exactly like the loaner V6. Well took my car in to have it looked at, got another loaner, 09 sonata I4, same knock, service couldn't replicate problem with my car.
Went ahead and got oil change, drove car home and the next day it had the same knock at startup when cold. Just took it back to dealership to have them look at irregular tap/knock when warm at idle, also car still has startup knock, but just not as loud.
I have a '06 sonata 3.3 v6. Let me first describe what was happening to the car before the noise started. When I first started the car and put the ac, the first time turning the steering wheel in either direction the steering wheel would tighten up and the battery indicator light would come on and the fasten seatbelt light would flash even though I had the belt fastened. It would only happen the first time I would make a turn and after that I could turn with no problem. So in recap, it would only happen on the first turn and only when the ac was on. Now when I start the car up there is a noise coming form the pulley/belt area. I wouldn't classify it as a squeaking noise more like a grinding. I've looked at the belt and it seems to be fine. After I start to drive the car the noise goes away. If I start the car again after a drive within about 2 hours the noise doesn't happen when I start it. What this noise could be? and also could the noise and the steering wheel tightening when the ac is on be connected?
View 1 RepliesI recently purchased my first Ford pickup. I bought a 2006 F-150 with the 5.4L 3V engine. I have only driven it for about 300 miles so far and am having problems. The engine has 146,000 miles on it. I have read several posts on here about the cam phasers which I believe that I may have some issues with. The engine will run well when cold, on the road, etc. The engine does have a slight ticking after it warms up (cam phasers?). When I come to a stop after the engine is operating temperature, the engine will start to miss and shudder and all 4 above codes come active and are also pending (8 codes in total).
All 4 codes are logged at the same time. I have replaced both cam position sensors, both sensor ends and terminals for cam position sensors, checked wiring around the rear of engine (does not appear to be rubbed through), all plugs were replaced, and all COP boots are good. Is there anything that can cause these codes that may not be the actual cam position sensors, ie. VTC, COPs, cam phasers? What pins the cam position sensors come on the ECU (so I can ohm the entire wire harness)?
Also, if the engine is missing with the codes active and I rev the engine up it will come back to idle and run great. The engine never dies out, just runs horribly. I have also unplugged each sensor with the engine running which has no effect on the way it runs.
I feel my 2009 Sonata with 25k miles has a fast startup idle.
It goes upto 2200 RPMs. It runs fine otherwise.
I will keep an eye on it to get more RPMs and timing.
1998 4.0 ... She only misses about 30 seconds during stone cold startup. I figure it's probably the plug thats hardest to reach ? Isn't that the way it always is? From the hood I can see only one spark plug, so I figure I'll do all the plugs. Is there any right or wrong approach to the plugs? I did the thermostat today, but this plug job looks like it's gonna be a bitch. Time for some skinned knuckles Next is the right side O2 sensor, that looks like fun too. But I gotta say, this little truck is sweet. Great visibility and easy to park in the city. I really like her. She's a keeper. She needs some new sway bar bushings too, but no surprise with 127 K on the clock.
View 5 RepliesI have a 2006 Hyundia Sonata. I idles really bad like you pulled 5 of the six plug wires off when you put it in gear. Once you start moving a couple miles an hour it is fine. It is also perfect in park or neutral, not a hint of a problem. Put it in drive or reverse and it almost stalls.
View 13 Replies2007 Sonata V6 with 72K miles.
The car has developed a rough idle while in gear (i.e. when stopped at a stop light) and park (i.e. after I start the car).
It's starting to get a little annoying since I'm used to a very smooth idle.
I think this issue started within the last 2-3k miles.
Plugs were allegedly changed at 30k. A full tuneup was done at that time.
Wires are still original.
In idle and driving the car sounds rough as if a pulley was loose, after checking no pulley was loose but problem still persists. Tried turning wheel left n right n noise didn't go away or get worse its a constant noise, what it may be? Crankshaft pulley? Idler pulley?
View 2 Replies2007 Sonata V6. He's spent many hours and a good chunk of change at the dealership trying to get it fixed and nothing has worked yet. They honestly have no clue whats wrong which kinda scares me.
First off here is his problem. Occasionally when he starts the car it will idle very rough and struggles to accelerate to 30-40mph. When this happens he pulls over and shuts the car off for a few minutes then it will run fine again. When all of this happens there is no CEL or any light at all that flashes or comes on the dash.
Here is a list of things that have been replaced
Fuel pump
Throttle position sensor
Crank sensor
Plugs, wires and coil pack
My moms has a 2010 Elantra with 30,000kms on the clock, and we have noticed since new when the vehicle is started cold in the morning it seems to run rough for about 30-60 seconds then stabilizes.
It's almost like it has a slight misfire, or slight fuel flooded from sitting overnight. Now if course we have taken it to the dealership twice for this issue and dropped it off overnight for a cold start, and both times they cannot re-produce the problem.......surprise.
2006 Sonata V6 with 98K miles. The car has developed a rough idle, sputter/lurch while in gear, but not park or neutral. No CEL/codes. Have already replaced the spark plugs (OE), throttle body/FI cleaned, MAF cleaned, new air filter, coil packs OK... Mechanic said no vac leaks, FI spray pattern good, good fuel pressure, etc. Vibration dampener looks ok, no separation or wobble. Another post mentioned a power steering pressure sensor, which I will have checked, but the mechanic is at a loss.
View 7 Replies