Sonata NF (2006-10) :: Long Crank Time (8 - 10 Seconds)
Oct 14, 2014
I have a 2006 Sonata GLS with the 3.3L V6 and close to 230,000 miles. A few months ago I noticed that my crank time at starting was longer than typically - it has steadily gotten worse.
Now the crank time is close to 8 - 10 seconds. (Which might not seem like much but trust me, it is).
I suspected that the fuel pump was faulty, however, once started - it runs great.
I put a pressure gauge on the fuel pump outlet and found that it only kicks the pump on when the car is cranking, the fuel pump does not kick on when the key is in the "on" position. Once the vehicle starts, it seems to be drawing fuel.
The pump has all sorts of pressure, I am not worried about that.
I decided to change the Fuel pressure regulator valve thinking that maybe it wasn't holding pressure - That didn't seem to do anything.
Do I need to change the entire Fuel Pump Assembly?
View 5 Replies
Advertisement
I have a 2006 F350. I have long crank times. No Codes. I have Autoenginuity with Enhanced Codes and everything shows fine. I replaces standpipe and dummy plugs. Glow Plugs and harness. I was hoping it not be the STC but I needed to do oil cooler so wanted to eliminate STC. Got truck apart and the STC Fitting is newer style so I'm kinda bummed out. Not sure if I'm missing something and as far as I have it torn down is there anyway to test what could be causing the problem? Or just put it back together and keep my fingers crossed that whoever put the new STC fitting in screwed it up. I'm beginning to not like my truck.
View 8 Replies
Random issue that has progressively been getting worse. I'm assuming it's one of those Sonata quirks that we all deal with.
When you turn the key the starter doesn't try to crank the engine. AC stuff all works properly. I just keep turning and eventually it will turn on.
[URL]...................
View 7 Replies
So ive had a starting issue in the R32 for quite some time now. With waterfest approaching and the new S3 going into production that i ordered, it has come time to finally fix it. I have taken in to many dealerships and very talented techs, and no one has any idea. The car seems to crank for a very long time or start right up and then just completely stall and die. The second time i start it, it starts completely fine like nothing ever happened. This only happens when the car sits for a few hours. It has never done it if the car has sit overnight or during the cold months. It has to be warm and sit for a specific amount of time. Its like it catches the car transferring into a cold start but not fully cold yet, if that makes sense. Also i am now noticing a small squeak each time it starts, like a belt. I have replaced the fuel pump/spark plugs/coil packs. Nothing has changed. We thought maybe a stuck injector but were doubtful as its not constant. Im debating a cam position sensor just to see if thats the issue. There is no CEL or any codes.
View 12 Replies
I own 2013 Mk6 GTI. I am having to over crank the engine for a period of 8 seconds or so before the car starts, especially after it has been sitting for a few hours. My thought was a faulty check valve in the fuel pump. I have heard that our fuel filter has a built in pressure regulator that may get stuck open for whatever reason and that may also cause a long crank time.
View 9 Replies
I have a 1988 Dodge pickup 1500 with a 5,9 gas engine. It used to pop right over all the time. Now, in the morning, I have to crank it forever until it starts, and if it sits for 1 hour or more, same thing (have to crank for a long time). It is my understanding there is a valve called a one day valve that holds pressure on the gas line. Is it possible this valve is not working properly? And if so, do I have to replace fuel pump to fix problem? once started it starts up with no problem until it sits for hour or more then hard to start.
View 15 Replies
So my 2002 ford explorer with the 4.0 L V6, has been cranking along time before it starts. I thought i had this figured out already, i put a brand new fuel pump in it from the ford dealer. That seemed to work, but the problem came back.
Especially when it is cold, it cranks a lot longer than normal to start. and when it does start RMPS go way up briefly and come back down. Seems to only act up when its cold out, say 35 degrees and lower.
So the remote start wont work because it only cranks for a few seconds and then stops. it tries this three times and it gives up. i go out there to start it and cranks for 10 seconds it seems like, sometimes i have to feather the fuel pedal.
View 7 Replies
So how long does one have to crank until it is considered an extended crank? 2 seconds, 5 seconds, 10 seconds.....?
The reason I ask is after all the motor work I did on my truck sometimes she fires up in less than 1 second of cranking and other times it take maybe 2 seconds of cranking. I do not think 2 seconds is considered and extended crank time but was just curious about what is considered extended cranking.
View 12 Replies
Car does not have to get wet, just be in humid air. Problem going on 2 years now, mechanics tried disconnecting a (?) ground/sensor from computer, major tune up, new fuel pump. Until recently, it just took keeping it in crank position for a long time for it to finally start. Recently, in crank position for 30 seconds does nothing and has me worried I'm doing damage. In dry weather, it starts first time every time.
View 12 Replies
I have a 2002 Ford Windstar that only in the fall and winter it has a longer crank time of at least 10 seconds. In the summer it starts as it should within 3-4 seconds. I did notice that the times it did start normally in the colder air is when I turned the key on and listened to the fuel pump prime the system. All other times it doesn't do that and that's when I get the long crank time. Once it is started it runs as normal. Am I looking at a possible fuel filter or pump? I am due to replace the filter as the van has 83,000 miles on it. If this is the possible culprit, is this something that is easily replaced at home?
View 4 Replies
Removed my oil rail to replace standpipes/dummies (04 Wavy rail) and now I have huge crank times to start. This is after the initial Huge crank to get it started. Do I have air in the system, or did I bugger something. I did the whole deal very careful. I lifted the rail up very carefully, pipes removed. I lined up the rail nipples with the injectors and evenly pressed it back in place, and then inserted my dummies/standpipe. Tightened the rail to 120 inch lbs then the dummies/standpipe to 60 ft lb. I did my son's '06 a month ago with no troubles. (didn't remove rails though). Once running it sounds perfect, turn it off and re-start and it's a long crank (30 seconds or more). I have not monitored ICP/IPR while running, will try that today.
View 8 Replies
The past couple of cold starts (not real cold mornings though) I have experienced long crank time to start. Once started she starts normally. No time to read but I'm getting a little worried that I'll get stuck somewhere. I'll check back with my phone when I get into an area with cel service.
View 14 Replies
I have about 3400 miles on my Sonata 2.0T, and I have experienced a long crank with (puttering in between), and does not start, twice occurrence thus far. I have no warning lights, no lamps (SES) that stay on afterward, nothing at all. I have had to press the "start/stop" button again to make it stop, then let it sit for a few seconds press the button again, re-cranks, and starts this time. I know that if take to the dealer they will not find anything wrong since most concerns they have to duplicate in order to diagnose. The SES light is not on, so I know we have no fault codes to go by. Sounds as if the fuel pump is crapping out, or no spark is being generated.
View 8 Replies
1996 GMC Jimmy SLS. I've looked at the "starting issue" threads in this forum but none are quite the same as mine. When you initially try to start the Jimmy (cold or warm), it seems to just crank for 20-30 seconds before it even tries to fire. New plugs, cap, rotor, wires. Battery is 2 months old, and so is the alternator. What about the relays or starter. It's not an intermittent problem either. This happens EVERY time you start the vehicle. The jimmy sat for a good while before we bought it, but would that cause the starting issue? It seems to run fine after it starts, but hesitates (stumbles)a little coming up off idle when its warm.
View 5 Replies
I recently (in the last few months) have noticed my truck (1999 F350 duallie) seeming to be running very rich … I pull a 32' trailer with it and noticed on the art few trips the front and right side of the trailer covered with diesel fuel spots when I got home …. It also smells very rich when idling…. The last couple times I started it in the mornings it seems to crank a very long time before it starts …it still runs but its got issues evidently … it has these 3 codes :
P1280
P0475
P1670
The 1670 will clear , but the other 2 I can't clear, they are right back every time you turn the key on …
View 14 Replies
A/C takes a long time to start cooling, but after it starts it gets as cold as it should. Seems to do okay while highway driving after it starts cooling. Is this a low refrig problem or do I have bigger issues?
View 3 Replies
Noticing that my drivers seat is taking a long time to heat up. I usually warm up the car in the winter, and turn on the seat heater. The seat is still cold when I get in, and does not heat up until I go a few miles. Have to check and see if the passenger is doing the same thing.
View 2 Replies
I wrote about the problem I was having back in Jan 2014 (engine would crank too long if I left the car parked for 30 mins to 4 hrs) ..... well, I finally brought it o a good diagnosis tics place and some of the guys that replied to me we're correct ..... they told me that the crankshaft position sensor (1of 2 sensors) was faulty and replaced it.
View 3 Replies
My 06 currently has 296k miles. 3 years ago I put a lot into her. Dummy plugs, stand pipes, STC, hg,studs, oil cooler, bpd egr cooler. Cleaned spool valves and fresh o rings in injectors. (Alliant) plus a lot more that I can't remember. Ran very very well after all that.
Fast forward to a few weeks ago. Driving down road and truck died as I let off pedal to slow down for turn onto my road. Took about 7-8 tries to get started back up. Icp was reading in the 300's until it finally started. Made it home. Shut it off. And started right back up.
Few days later truck died again same way. Let off to make a turn. Several attempts to restart icp was in the 300's again. Once it started building 420ish it sounded like it was firing a few injectors and slowly started running. The next time it happened the same way but when I got it back running I eased to my inlaws like less than a mile. When I got to their house and pulled in and went to back up to turn around the display on dash said low oil pressure and started missing a little. So once I got home started researching.
A few days ago I pulled out the low pressure oil regulator to check it out. It was clean but did have some mild scaring. I used some fine scotch rite and smooth it out a a little. It moved freely in the bore so I put it back together. Then pulled the oil filter cap off to check the little black valve. I noticed the filter was not dripping with oil like normally when I change the oil. And yes it's motor craft filter and cap. It checked out ok. Press it down and turned engine over and it filled and held. Let off of it and it drained.
Next I air checked the high pressure side. Applied air and waited until I could hear the air (IPR still open) then closed the IPR. Couldn't hear any leaks. Just a very very minor his and couldn't pin point where. So I went ahead and went to dealer and got new stand pipes and plugs. And ordered new print set for injectors. Pulled injectors and didn't see any smoking guns. Replaced prongs, stand pipe and dummy plugs and put it all back together. Cleaned the injector cups and hold down bolt holes. Torqued injectors to spec.
Got it all done and rotate motor by wire next to heater blower to assist prime system. Tried to start it up and it took two tries but fired right up and sounded smooth as hell. After it idled a few minutes I saw a haze from exhaust. It smelt just like fuel. A few minutes later started idle a little rough. Gave it some go pedel and it was rougher at about 1600-1800rpms and couldn't feel it above 2k. Got my laptop out with AE and done balance test. Did not show anything. No codes either.
View 14 Replies
This applies to a 2001 F-350 with 73,000 miles on the engine. Engine oil level is good, batteries charged, HPOP reservoir is full and passes Cody test with flying colors. Fuel pump runs for 20 seconds at key on. Start takes about 6 seconds. If I shut the key off and restart immediately it starts in under 2 seconds but if I wait about 30 seconds it's a 6 second start. Here is an AE that I ran on it, it has me stumped. FWIW it seems to start quicker when AE is hooked up. ?? An odd whir type of noise comes out from somewhere under the hood when I first turn the key on and when I clear the codes with AE.
View 14 Replies
I'm driving a 2006 4cyl LX Sonata. Just started past 3 months. Intermittently and usually after long freeway driving, the pwr steering locks-up as I come to a stop. Example is driving off the freeway via a ramp and stopping . Steering breaks loose if I apply pressure and goes back to normal. Fluid has been checked for level but not replaced.
View 3 Replies
