Sonata NF (2006-10) :: Leak At Timing Cover Gasket
Jul 9, 2010
Was told my Sonata has a leak at the Timing Cover Gasket by two different service stations. Took it to the Hyundai Dealership and they said they would need to pull the engine out to fix it and it would take a couple of days. I read on a couple of other posts that people were able to replace the timing cover gasket themselves. So, I don't understand why the Dealership said the engine would need to be pulled, but I'm reading others say they fixed it without pulling the engine. Am I missing something...? I'd rather not have the engine pulled out if it doesn't need to be.
2008 Hyundai Sonata 2.4 L 2359 CC L4 DOHC 16 Valve.
View 4 Replies
Advertisement
I'm suspecting a small valve cover gasket leak. I've noticed dirt starting to accumulate near the alternator side of the front valve cover, there is dirt on there stuck to oil, I don't see any wet oil but its so minor the dirt just sticks to it. 107k miles here. Seems to be a common problem. I think Downhiller had a large oil leak, source unknown around his crank pulley area. You wouldn't think a car this young would leak oil. It's not bad, I havn't had to top any off I just like a mildly clean engine.
View 38 Replies
I have 2000 V6 3.0 Ranger and it has sprung a small coolant leak from timing chain cover gasket. I think just few drips after driving a while since I don't see significant drop in coolant level (Took a month to notice level dropped in reservoir) and did not see an active leak while idling. No water in the oil.
The proper repair would be to replace the gasket, but for the age and condition of the truck, I don't think it is worth it. Searching for a cheaper solution, I found K-Seal and see lots of reviews with success. Will it damage the cooling system in anyway? I think it would be worth a try even if it doesn't fix the leak as long as it does not cause any harm.
View 2 Replies
I went in today for a factor recall on my 2006 Toyota Corolla and when I was leaving I was told that my car needs to have the timing cover resealed. Additionally, the Drive belt is cracked and it was recommended to me to get a new belt. My air filter is dirty, I need manual transmission service, Fuel injection service, Fuel induction service and an AC refresh.
Being a college student I wanted to get some feedback on some of the stuff I could do myself. I already change my own motor oil and oil filter and anything I could do myself from the above recommendations from Toyota would really lower the cost.
Also I am not really sure about the timing cover reseal because I have not seen any leaks under my car. It may be that I do not understand what a timing cover leak is. And is this something that I should get fixed right away or can i afford to wait for a while (1 year or longer).
Also what is the difference between a fuel induction service and fuel injection service? Can i do it myself?
View 4 Replies
Changing the valve cover gasket on the 4 cylinder 2.4l. I was going to change mine's. Didn't know if there are any special tips like sealant to be used, loosening bolt sequence or tightening sequence, torque values.
View 9 Replies
Had 2 valve cover gaskets fixed 2 times on this car. Now I have a timing cover gasket gone. This is real big $$$. Dealer quoted a price of 1400.00 . Contacted Hyundai of America and trying to get some " good will" . It's the 3.3 V6. I know this engine seems to have these problems . This car has 127,000 miles.
View 2 Replies
I have a 2003 Eddie Bauer explorer with the 4.0L SOHC . I have a coolant leak from the passenger side that is not a water pump issue.
When removing the timing chain cover with the engine in the car, do I need to remove any accessories ( power steering , alternator etc. ) or their brackets?
View 2 Replies
I have a 07 Sonata and having recurring valve cover leak. First time it happened it leaked onto my alternator and had to get car towed and whole bit. About a year later they discovered it again during routine oil change and had it fixed again. Yesterday during a routine oil change, they discovered a leak again!! I know this is an established problem but how many times can the same problem occur?? I'm passed the warranty (103K).
View 3 Replies
so I have a 2azfe engine
So there's an oil leak coming from the valve cover gasket (just purchased vehicle dirt cheap with 220k)
found this
Notice all the oil sitting on top of the exhaust mani gasket
In the left(lower) part of the picture it appears to be scraped.
the gasket appears to be newer, I did NOT use a screw driver to remove the valve cover, which is what this appears to have been done..
Can this be sanded down then filled with jb weld, and then regasketed?
View 7 Replies
I've got a coolant leak here (I wiped away some of it before taking the picture):
Close up
This is the only place I can find coolant leaking and it's running down all the way to the water pump:
When I wiped away from just below the valve cover gasket it flaked right off and it doesn't appear there is any oil mixed in. I changed the oil today and it didn't appear to have any coolant mixed in either.
The coolant doesn't appear to have any oil in it's nice and pink as it should be. I started the car from a cold start and sat and watched the area waiting for it to leak but nothing ever came out, of course.
I know there shouldn't be coolant leaking from this area anyways but I don't know how else to explain the trail pictured. I definitely have a small leak somewhere as I've found coolant on the floor of the garage before.
Do I just replace the valve cover gasket and move on or is there something else I should be concerned with here?
View 11 Replies
I had a very slow oil leak that dripped onto the garage floor and i brought it into the dealership. They said it was a leaking left valve cover gasket; I searched and came up with nothing? The engine has just over 30K miles on it.
View 20 Replies
I just noticed what appeared to be an oil leak around the valve cover gasket, which the VW dealer has determined to be a defective cam sensor. Apparently the VW parts distribution center in Wisconsin has 530 of these in stock, so it may be a common failure. This is on a 2010 GTI with 28,xxx miles. Thought the community would like to know.
View 2 Replies
I understand the TSB for this issue relates to 2005 and 2006 model Avalons. what's your best guess in terms of how common the timing cover oil leak problem is on '05s and '06s? 20%? 80%?
View 11 Replies
Had our dealer service (non oil change interval) today at 46k miles. Was informed that there is an oil leak from the timing cover seal.
I was told it's not a minor job to remove the timing cover and reseal due to the many labor hours involved. 2 days of work required.
View 19 Replies
I have seen this minor oil leak on the left engine side that facing the firewall for sometimes, but just found time to bring to dealer. After some searching on Internet, I suggested to them that it might be leaking from the timing chain cover.
View 19 Replies
I had my 2011 on the lift tonight for a quick oil change and tire rotation. The current mileage is 115k. During the inspection, I discovered that I had a small timing cover oil leak.
View 1 Replies
So, when I bought my truck, it leaked oil.....bad. It goes through around 2-3 quarts a week. I needed a vehicle, this one was cheap, so...I run it. Every other day, I put half a tank of gas and a couple quarts of oil in it. It leaks on the passenger side, right above the starter. I figured it was the valve cover gasket, and planned on changing it today. I saw a post about the "typical" head gasket oil leak, which sound suspiciously like what mine is doing. I have no oil in the coolant,or vice-versa.....
View 9 Replies
I have a 97 Honda Accord with V Tec engine, 2.2L. I have an oil leak that is coming from BEHIND the timing belt cover. I removed the cover and the belts to expose several seals. The oil leak is quite extensive and leaves a good puddle after running the engine, however, it will not leak once I clean up the mess, put the car up on jack stands and disassemble the engine. I cannot tell which seal is leaking and am wondering how to tell which seal is leaking. Is there a way to apply pressure to the engine with air, possibly through the oil dipstick hole to possibly expose the leaking seal?
View 9 Replies
I was changing my mom's oil at work today. I noticed her timing chain cover is leaking. Is this just an isolated occurrence? It seems to be right where the FIPG mates the timing cover to the cylinder head. It also seems right below the tensioner. However the tensioner is bone dry.
View 9 Replies
My truck has had this annoying tendency to drink coolant. I believe I took care of it by replacing the thermostat gasket. Not so, it drinks about a quart every 50 miles - so quite a bit really.
Finally bit the bullet and took it to the dealer so that they could figure out where the coolant was going.
Answer I got back was - timing cover gasket, water pump, lower radiator hose.
The water pump appears to be good, its just the gasket that's bad. So my question is - how significant is the timing chain cover leak? Poking around online it appears to be reasonably common, but sounds very expensive. The dealer indicated it would be 2 days work minimum.
View 9 Replies
Looking for some insight into the state of the motor in a 2002 XD. Short story is that it appears to be leaking oil from the valve cover gasket (common, I know) and sometimes winds up running extremely low on oil before it gets changed. When draining the minimal oil in these conditions, non insignificant amounts of water can be found along with the drained oil.
Car is at 155k miles, has exhibited this behavior for more than a year, and has no noticeable knocking issues, power loss, mpg loss, heating/cooling issues, or any other ill effects other than apparently making a mess in the engine bay, on the ground where it parks, and scaring people when draining the oil.
Logically this is going to not be the case forever.... Thoughts? Prognosis? Treatment?
View 7 Replies
