Sonata NF (2006-10) :: Intermittent Check Engine Light - Code P0011
Jan 29, 2010
I have a 2006 Sonata with an intermittent check engine light. The light will be on for a few days then goes out for a day or two. This pattern has been going on for about 3 months now. A scan tool was used and showed the code P0011. I know this code has to do with the camshaft timing. My question is should the light be going out on its own if there was a problem with the camshaft timing? Does the engine correct itself and then experience the problem again. Is it normal for check engine lights to go on and off with out being manually reset? Could this be a faulty sensor or loose wire causing the light to go on and off? The car has about 75,000 miles, mostly Hwy, and is driven just about everyday.
View 36 Replies
Advertisement
Check engine light and P0010 code in my Gen III 2010 Prius...
View 2 Replies
I have a 2007 Yaris, 180,000 miles, The check engine light comes on. With a P0011 code. I know that that could mean either:
blocked oil passage
Mechanical timing fault
Camshaft position a timing over advance
Failed OCV
Or VVT controller assembly fault
Since it's been really cold out I figured maybe it was a blocked oil passage, but after an oil change and quick check - I no longer think that's the problem.
The car runs great and it doesn't seem anything is wrong at all ...
View 3 Replies
The check engine light on my 2006 Toyota Camry LE with 95,300 miles came up. The codes that came up on my diagnostic tool were p0011, p0101, and p0113. The code meanings are as follows:
p0011: refers to the VVT (variable valve timing) or VCT (variable camshaft timing) components and the car's power control module
p0101: problem with the Mass Air Flow (MAF) sensor or circuit
p0113: possibly issues with the Intake Air Temperature Sensor
How to solve the issue and get that annoying check engine light off?
View 2 Replies
I have a 2007 GLS. Within the past year I had about 4 or 5 difficult starts. Just recently I got a CEL with cod P0011. I replaced the OCV as that is the usual culprit. Within 6 miles of clearing the CEL, I am still getting the same CEL. I am wondering if the problem is either the wiring harness or the Camshaft Position Sensor.
View 1 Replies
I have a 2009 Sonata (base model) with about 60,400 miles (just out of warranty). My check engine light came on, I drove for about 25 miles or so and it went away. I still took it to a shop to get the code reading, it came back as "P0449 - EVAP Vent Valve Solenoid Circuit". Guy at the shop told me I can continue to drive without any issues but I should get it checked with a dealer. The engine check light is not on anymore.
I took it the dealer and they told me they will charge me $145 to run another diagnostic (they can not use the one I have from Auto Zone). And then on top of that, whatever they need to do, they will charge for that. And since I am out of warranty (barely) I will have to pay out of my pocket.
View 23 Replies
I have check engine light comes on first and after driving a few hundred miles later, light goes off. I drive the car for awhile about a few hundred miles and light comes on again. Basically on an off. AutoZone looked at it and got an error P2273 - it means oxygen sensor stuck rich. They told me to keep fuel tank cap tight. or something else may be defective. I have been driving last two years like this having engine light on and off. I do not see any engine performance difference.
View 1 Replies
My sonata's check engine light came on today. I went to auto zone and they told me it was code p0711. From what I researched it seems to be the transmission fluid senor. Our other car had the check engine light come on last week.
View 22 Replies
I recently bought a 2007 Hyundai Sonata Limited from a private seller. This car has been perfect for the few weeks I've had it. Now, my check engine light came up and the error code "P0660 Intake Manifold Tuning Valve Control Circuit / Open Bank 1" popped up. I'm not really sure what piece to look for, or which connectors to check.
View 3 Replies
I got a 2007 Hyundai Sonata Limited (Platinum Edition), 6 cylinder, 3.3L at 110,000 miles. Got a Check Engine light a month ago, checked it at Autozone and it showed P0171 and P0174 codes (Fuel System Too Lean). The code was cleared and I drew the car for about a month, and the light came back on again recently. Checked it again and now it is showing PO133 code (slow response (heated oxygen sensor bank 1)). What could it be if not the O2 sensor or bad wiring or cracks/leaks in the exhaust?
View 3 Replies
After removing dpf and egr check engine light is blinking. DPF and EGR were turned off in ECU. I rewrited ECU 4 times with different parameters that was working on other Sonatas.
Still after a while p2002 error comes out and check engine flashes.. few times in day Sonata is starting regeneration (I don't understand how because DPF is turned off).
View 2 Replies
I have a 2006 Sonata, 6 cylendar. Today, the Check Engine light came on while driving home from work (note: there was no difference in performance of the car).
I went to the nearest Auto Zone to pull the code. The code reader came back with P0110. The guy at Auto Zone ran it through their computer and Hyundai didn't even come up in the list of code definitions for P0110. However, for all the other makes and models, this code is for the IAT.
The guy at Auto Zone, just for fun, tried to look up an air intake sensor for a Hyundai Sonata, 2006, and was told that this car does not come equipped with an IAT sensor. What caused the Check Engine light to come on and what do I need to have repaired?
View 2 Replies
I do not feel any difference in the transmission performance but the code has been cleared twice and keeps returning so the symptom is persistent. Can't find the 08 sub-code on the internet anywhere so guess I will have to visit the dealer.
View 6 Replies
From time to time, the engine lights comes on with error code P0365, it usually disappears within two days (it disappears by itself), but it appears once per month and stays for two days.
The code scanner says :P0365 Camshaft Position Sensor B Circuit Malfunction (Bank 1)
Do I need to change the sensor? and where is it located?
my Sonata is 2009, 2.0L (Korean imported) 4 cylinder ...
View 8 Replies
Show 2 error P0011 and P0014.
Sonata YF 2010 2.0 80.000kms ....
View 1 Replies
I know it is a random cylinder misfire code however I started my car in the morning and it was fine I moved it and put it back in my driveway. I started it up later and waited for it to heat up i came back outside 10 min later and my check engine light was flashing and my car was shaking like crazy you could tell the engine was misfiring like crazy. I had under a quarter of a tank but not empty yet. I shut it off and turned it back on and it was still doing it. I drove the mile to the gas station the way it was.
Under partial throttle it was revving to 4500 and over 5, had to let of throttle to make the car shift up a gear. I filled up and started the car again performed fine after that however the check engine light was solid now and still on. I went to my local mechanic and he read that code P0300. I changed my spark plugs that day and they were crap the original spark plugs I have 65,xxx on my car now. Car is smooth now. I cleared check engine when i saw him first and it did not come back on all day even before i changed the spark plugs later that night. Why my light was flashing and why my car was acting like that till i filled up?
View 6 Replies
I have already concluded I need to replace my OCV on my 2007 2.4L GLS Sonata.
I have also been starting to hear a clicking noise associated with reducing throttle when in the 2500-3100 rpm range. It seems to only make this quiet clicking noise when the throttle is reducing and within the RPM range from above.
I am just wondering if this may be associated with the OCV needing to be replaced. I suppose I will find out for sure when I do finally get around to replacing the OCV sometime this month.
View 2 Replies
My check engine light came on the other day, and I went to Autozone to have the code read. Of course, that indicated the camshaft position sensor was detecting a fault. I read through all the posts relating to the fault, headed up to my local Hyundai dealer, and picked up the oil flow control valve for about $50 plus tax. While I was there, I figured I might as well have them do an oil change, since it was way past due. No point in putting in a new part with dirty oil..right? They did the oil change, washed the car and I was ready to roll. My plan was to replace the part myself, but magically, the check engine light has not come back on since.
View 8 Replies
Check engine light on and off. Code shows turbo boost throttle position sensor is the problem. I can't find a part with that name.
View 10 Replies
I recently bought a 08 Sonata V6, with 94K mileage. The oil pressure light comes on when the engine is idle (around 700-800 rpm). The seller told me that this problem started a few months ago, but the car has not been used much since then. He also said that he has changed the oil after that, but the problem still persists.
The engine light has shown up more recently, like in a week or two. I took the car to a mechanic and he could not guess what the problem might be. But he gave me the error codes: P0011, and P0051. There are no other obvious symptoms (e.g. oil leakage, low oil level, unusual sound from the engine).
I could not find any thread regarding both of these issues (Oil Pressure, and the error codes) together. Any connection between these two?
So far, I have realized that the oil pressure can be due to a bad sensor, and P0011 has something to do with CVVT, and Oil Control Valve (OCV). But I would like to make sure I don't just waste money by replacing the sensor and OCV.
View 2 Replies
2008 Toyota Prius Touring. I got a Check Engine Light while at a drive-thru, and my "Automatic" adapter reports this:
I drove the remaining ~60 miles home without incident, and the engine seems to be running smoothly and I don't notice any loss of power or rough idling or anything along those lines.
Going by the first few Google results, a P0011 error could indicate a few things:
-Incorrect camshaft timing
-Wiring problems (harness/wiring) in intake timing control valve control solenoid system
-Continuous oil flow to VCT piston chamber
-Failed timing valve control solenoid (stuck open)
I've had this car for ~3 years and have always been super careful about regular oil changes and maintenance, including dropping an ungodly amount of money getting the "full 100,000 mile service package" at the dealership ~6 months ago.
Suddenly getting a P0011 error code and Check Engine light on a well-maintained 2008 Prius w/ 112,000 miles.
View 7 Replies
