Sonata NF (2006-10) :: Clunking Noise Around Front Suspension / Wheel Arch
Oct 12, 2012
I have a 2005 NF V6 Sonata Elite - for some time now there has been a sporadic clunking noise in and around the suspension or front drivers side wheel of my car. It got a lot worse a week ago when I took the car off sealed roads for a short distance, almost sounding like a CV that had gone. However a mechanic checked the car over a few days ago and found the CV was fine, as was the driveline. It seems to clunk more when turning, and when I put the power on or off. I also detect a slight vibration or hum coming from the area concerned when taking gentle bends at moderate speed on smooth roads. I can assume the wheel bearings are fine, although the mechanic I went to perhaps isn't very familiar with the make/model of car. They went around the suspension and tightened some of the struts, which made a small improvement I think, but the car is still making the noise. What was the cause of the noise if known?
View 4 Replies
Advertisement
3 days ago I noticed a whirring noise coming from inside the front nearside wheel arch . I thought that it would stop when the engine cooled down but on checking at various times over the Easter weekend it runs continuously . It is not the radiator fan , more like a motor or relay that won't shut off .
View 14 Replies
I have an 06 Sonata GLS with a clunking noise coming from the front end somewhere. I hear it when I drive over small cracks or bumps in the road, and when I jerk the car from side to side. I have just replaced the front struts, bearing plates, and sway bar links. I've checked the tie rods, ball joints, control arm bushings, etc.. Yet the noise still exists. After a recommendation from a Hyundai Tech, I even re-tighten the subframe bolts using loctite. I am completely lost at this point and do not know what to do to eliminate this annoying noise.
View 17 Replies
I have a 2006 sonata and I have a noise in the front end. On the link below you can hear it. I need to know where the noise is coming front.
Hyundai Sonata 2006 front suspension noise.wmv - YouTube
View 2 Replies
So I have the creaking noise on my front suspension. I'm going to replace, but I'm leaning toward not doing OEM ...
View 1 Replies
Front Suspension - 2006 Sonata GLS 3.3. McPhersons make noise when going over a washboard road. It's as if the top bushing on the strut is not large enough. Quite annoying.
View 5 Replies
Ok so I replaced my upper strut mount and my struts in the front along with the shocks in the rear.......... the squeak is still present when i go over a rougher bump and it is cold ..................SO i went on hma service and saw this...................
Symptom "Squeak or grunt-noise from the front suspension, occurs more in cold ambient temperatures-more noticeable over rough roads or when turning"
Suspect Area "Front stabilizer bar"
Remedy "Under these conditions, the noise is acceptable."
Wow so not acceptable i am going to try and lubricate this piece... Will report back
[URL] ....
View 33 Replies
Looking for a suspension diagram that can be shared for this model? I need to fix the squeaking noise from front passenger side and would like to have an overview pic of the suspension system.
View 6 Replies
I have a 2007 Sonata Ltd (63000 miles) and had a clunk in the front suspension. I had the front upper control arms replaced (which were visually badly worn) and that fixed the problem. But now, a several months later another similar clunking noise has developed when I go over those small speed bumps in parking lots.
View 18 Replies
My front passenger wheel began creaking when driving over uneven surfaces after work was done on 12/29/14 to replace the wheel bearing, stud, and nut for the right front. I've been dealing with this noise for 1.5 years, but to my luck, when I take a test drive with a mechanic, it does not reveal itself, so they will not take a detailed look at it and open it up. It is more prominent in cold weather. Pushing down on the front of the car for a strut test does not produce the noise.
View 9 Replies
So I got a steering problem and it's got me going crazy. I have a 06 g35 sedan lowered about an 1.5 inches. It's been about 5 months since I lowered it, lately I've been herring clunking noise in front suspension, not all the time but only sometimes when I turn. The other day my steering got really stiff and when I turn the steering won't return to the center. My Power steering isn't making any noise and I'm good on fluid. A lot of people say my ball joints but don't they usually make a lot of noise when they go bad ?
View 18 Replies
I am trying to find origin of clunking noise, but it is difficult to do as there is no visual signs and no excessive movements in any components.
Little bit of details and video. Noise occurs when moving rapidly steering wheel on stationary car with running engine. Not noticeable when at speed. Wheel is not vibrating and cv joints not clicking. Very tiny free movement in steering wheel about 1mm, but I am not sure if that is related maybe a completely different issue there. Mot tester make an advisory note that steering system slightly rough, but its not that useful to find an issue.
[URL] ....
View 8 Replies
My 2002 Passat Wagon (2.8L, FWD) has started developing a clunking noise at 67,000 miles in the front right suspension. Based on forum search here, it sounds like a common problem with the control rods, tie rod ends, ...
I looked at the control arm kits available at ECS Tuning. Is this a DIY job for someone with only moderate mechanical skills? I have never performed front end suspension work before. How difficult is it? Special tools needed?
If I had it done (both sides, upper and lower) at an independent repair shop, how much might I expect to pay?
Lastly, is it best to replace all the parts (as provided in these kits), rather than isolating the part that is currently causing the clunk and just replacing what needs to be replaced?
View 14 Replies
I have been frustrated with my Elantra's handling from the time I purchased. I feel that the car is setup poorly and has design/OEM part issues.
I have improved the rear-end "hop" issue by replacing the OEM rear shocks with the KYB Gas-A-Just's -- a big improvement in handling the bumps. But the rear-end solid axle on such a light car is just crap...
I have developed quite a bit of 'clunking' noise in the front suspension.
I am considering replacing the front-end shock-strut assemblies with KYBs -- I'd love to hear if it made a big difference. Also wondering if I should change-out the 'sway bar link' while replacing the shock/struts.
I'm just so frustrated with the way this car handles (I've driven Subaru's, Honda's, and VW's) compared to other cars. I feel it's a combination of low-quality OEM suspension parts, rear solid axle, light weight, crappy electric steering settings, and tires that are too wide and too low-profile for such a light car. (I have the limited with 17 wheels).
View 2 Replies
I have a noise in the front end that is only happening during suspension travel. It is really bad on bumpy roads. I thought it was my sway-bar end links but they are a year old and tight. I have checked the shocks and they are tight. It sounds like a clunking noise. Could the front drive axles be making this noise while not locked in?
View 14 Replies
We have a 1999 Passat GLX 2.8 auto. I recently put on a new inner and outer tie rod as well as a lower forward control arm. The issue that we are experiencing is that when accelerating or braking hard there is a popping/clunking noise coming from the driver front area. When accelerating or braking normally/ smoothly it is fine. But, as I said accelerate or brake hard it will make a single pop or clunk and that is it, just once when braking hard or accelerating quickly.
View 2 Replies
I just purchased my first VW, a 2012 Tiguan SE in Night Blue Metallic. The level of fit and finish, handling, and general feel are miles ahead of my old '04 Jeep Liberty.
Anyway, I've had the car for about 250 miles and have noticed a clunking/rattling noise coming from what sounds like the front passenger side suspension arm. The noise is fairly quiet but seems to consistently happen when turning left over uneven pavement.
I plan on taking it to the dealer this weekend and it is only a minor annoyance, but a shame since the rest of the vehicle is so quiet and refined.
View 3 Replies
So when I turn and am hard on the gas I get a clicking and slight clunking sound from the front end. Wants to confirm its the CV joints before I rip it apart?
View 6 Replies
2012 truck, started making a noise today. I cannot tell what it is, but seems to be coming from the passenger front suspension, its a crunching/light clunking sound, happens when going over bumps, when the truck pitches one way or the other turning, and coming to a stop....
Truck has 6k miles, I did a quick visual inspection this afternoon, didn't notice much, but the sway bar endlink looked a bit odd though, not sure if normal, its gota little bend too it and seems to just contact the vac line mounted behind it, seemed unusual...
Maybe its its just one of the crappy rancho branded shocks is junk?
View 6 Replies
I just have a couple questions. First one I have a creaking in my front suspension when I go over bumps if I'm doing 50+mph it isn't heard anything slower you can hear it especially over speed bumps in parking lots. What could that be exactly? And also I'm looking to upgrade my headunit already got a single din but I'm wanting to replace the factory subwoofer. Can I replace it with a low power 8" aftermarket sub for better sound?
View 7 Replies
I'm considering buying a used '06 Sonata LX with 137k miles, and the front suspension squeaks badly. I read the entire thread about replacing upper control arms to see what I might get into if I purchase as-is, and while it honestly doesn't seem too bad I know other problems may lurk. Would you buy this car with a squeaky suspension, or would you expect the seller to fix it first? Would you insist on them replacing all front UCA + LCA + struts + mounts + alignment at the same time? Any issues to worry about with the rear?
The car was amazingly clean and well-cared for overall. It was parked outside and the interior and exterior look better than my '05 Magnum that was garaged! I did notice rust on the wiper arms, one screw that was out of the passenger rear grab handle (above door). Also the seller told me the front passenger door lock won't work electronically 98% of the time, and the drivers rear lock won't work 70% of the time. I'm assuming the solenoids are bad or something is stuck - I can see the locks twitch a little bit when I depress the lock/unlock switch, but not enough to actuate the locks.
View 10 Replies
