From time to time, the engine lights comes on with error code P0365, it usually disappears within two days (it disappears by itself), but it appears once per month and stays for two days.
The code scanner says :P0365 Camshaft Position Sensor B Circuit Malfunction (Bank 1)
Do I need to change the sensor? and where is it located?
my Sonata is 2009, 2.0L (Korean imported) 4 cylinder ...
I recently bought a 2007 Hyundai Sonata Limited from a private seller. This car has been perfect for the few weeks I've had it. Now, my check engine light came up and the error code "P0660 Intake Manifold Tuning Valve Control Circuit / Open Bank 1" popped up. I'm not really sure what piece to look for, or which connectors to check.
View 3 RepliesA few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.
06 sonata 3.3 L V6. Light has been on for a month or two...took it in to mechanic yesterday and it's a camshaft position sensor error...it makes total sense to me now because my cars been starting hard, seems like it gets hotter then usual...and had a "clicking" noise for about 10 mins, then gradually goes away. it takes a few extra cranks now to start the engine unless it was already fired up.
Also does a jerk once and a while around 40 km/h. I looked online and those seem to all be symptoms of a failed camshaft position sensor (CMP). Would those symptoms seem about right? Am I okay to drive slowly for the weekend before I get the new sensor installed? The mechanic didn't seem to worries about me driving for just the weekend...but it's worrying me a bit...
I have a 2009 Sonata (base model) with about 60,400 miles (just out of warranty). My check engine light came on, I drove for about 25 miles or so and it went away. I still took it to a shop to get the code reading, it came back as "P0449 - EVAP Vent Valve Solenoid Circuit". Guy at the shop told me I can continue to drive without any issues but I should get it checked with a dealer. The engine check light is not on anymore.
I took it the dealer and they told me they will charge me $145 to run another diagnostic (they can not use the one I have from Auto Zone). And then on top of that, whatever they need to do, they will charge for that. And since I am out of warranty (barely) I will have to pay out of my pocket.
I have check engine light comes on first and after driving a few hundred miles later, light goes off. I drive the car for awhile about a few hundred miles and light comes on again. Basically on an off. AutoZone looked at it and got an error P2273 - it means oxygen sensor stuck rich. They told me to keep fuel tank cap tight. or something else may be defective. I have been driving last two years like this having engine light on and off. I do not see any engine performance difference.
View 1 RepliesMy sonata's check engine light came on today. I went to auto zone and they told me it was code p0711. From what I researched it seems to be the transmission fluid senor. Our other car had the check engine light come on last week.
View 22 RepliesI have a 2006 Sonata with an intermittent check engine light. The light will be on for a few days then goes out for a day or two. This pattern has been going on for about 3 months now. A scan tool was used and showed the code P0011. I know this code has to do with the camshaft timing. My question is should the light be going out on its own if there was a problem with the camshaft timing? Does the engine correct itself and then experience the problem again. Is it normal for check engine lights to go on and off with out being manually reset? Could this be a faulty sensor or loose wire causing the light to go on and off? The car has about 75,000 miles, mostly Hwy, and is driven just about everyday.
View 36 RepliesI got a 2007 Hyundai Sonata Limited (Platinum Edition), 6 cylinder, 3.3L at 110,000 miles. Got a Check Engine light a month ago, checked it at Autozone and it showed P0171 and P0174 codes (Fuel System Too Lean). The code was cleared and I drew the car for about a month, and the light came back on again recently. Checked it again and now it is showing PO133 code (slow response (heated oxygen sensor bank 1)). What could it be if not the O2 sensor or bad wiring or cracks/leaks in the exhaust?
View 3 RepliesAfter removing dpf and egr check engine light is blinking. DPF and EGR were turned off in ECU. I rewrited ECU 4 times with different parameters that was working on other Sonatas.
Still after a while p2002 error comes out and check engine flashes.. few times in day Sonata is starting regeneration (I don't understand how because DPF is turned off).
I have a 2006 Sonata, 6 cylendar. Today, the Check Engine light came on while driving home from work (note: there was no difference in performance of the car).
I went to the nearest Auto Zone to pull the code. The code reader came back with P0110. The guy at Auto Zone ran it through their computer and Hyundai didn't even come up in the list of code definitions for P0110. However, for all the other makes and models, this code is for the IAT.
The guy at Auto Zone, just for fun, tried to look up an air intake sensor for a Hyundai Sonata, 2006, and was told that this car does not come equipped with an IAT sensor. What caused the Check Engine light to come on and what do I need to have repaired?
Is there a replaceable bulb for the check engine light? Mines stop coming on when starting the car. I think that's why I failed the emissions test. I didn't check with the attendant in the office to get an explanation.
View 1 RepliesI do not feel any difference in the transmission performance but the code has been cleared twice and keeps returning so the symptom is persistent. Can't find the 08 sub-code on the internet anywhere so guess I will have to visit the dealer.
View 6 RepliesI know it is a random cylinder misfire code however I started my car in the morning and it was fine I moved it and put it back in my driveway. I started it up later and waited for it to heat up i came back outside 10 min later and my check engine light was flashing and my car was shaking like crazy you could tell the engine was misfiring like crazy. I had under a quarter of a tank but not empty yet. I shut it off and turned it back on and it was still doing it. I drove the mile to the gas station the way it was.
Under partial throttle it was revving to 4500 and over 5, had to let of throttle to make the car shift up a gear. I filled up and started the car again performed fine after that however the check engine light was solid now and still on. I went to my local mechanic and he read that code P0300. I changed my spark plugs that day and they were crap the original spark plugs I have 65,xxx on my car now. Car is smooth now. I cleared check engine when i saw him first and it did not come back on all day even before i changed the spark plugs later that night. Why my light was flashing and why my car was acting like that till i filled up?
2003 1.8t passat wagon. 50k miles... The check engine light came on today. Oil and engine temp are fine. Can most shops plug in and diagnose? Can I get one of those code readers at Advanced Auto parts to read the error code?
View 5 RepliesWhat is the meaning or the fault concerning 4608. The above error code was reported on the computer diagnose machine and it referred me to look into the vehicle ownership manual book BUT its rather unfortunate that i could not find that book. So, what to tackle or replace on the engine to enable the check engine lite go off.
View 17 RepliesI got a P0118 error code on my car. Looked up some things and most people were saying change coolant temperature sensor. I changed it 2 days ago and have not had a chance to clear the CEL. Its still on now, guy at Autozone would not clear it, said it was against company policy.
Will this turn off automatically once problem corrects itself? I went to Autozone and had them rescan the error, this time another code poped up P0444, EVAP(Evaporative Emission System)Evaporative Emission Control System Purge Control Valve Circuit Open. What this can be?
I have a CEL on my 2007 Avalon so I decided to take it to Autozone to get a scan. Error code P0015 was returned. This code has to do with B Camshaft Position, Timing Over Retarded (Bank 1). I've done a little research and I've read that this could possibly from a dirty screen on the Oil Control Valve, the OCV itself, or the Cam Position Sensor. Before replacing parts, what I would like to do first is to check/clean the screen on the OCV. Secondly, I would like to swap the Cam Position Sensor to a different bank and see if the other bank throws an error. If the other bank throws an error, then I know the sensor is bad and needs to be replaced. With this said, I am having trouble locating the OCV and CPS. Where the valve and sensor is located. A diagram would be useful.
View 14 RepliesI got a 2012 Hyundai Accent SE manual 112000 mostly highway miles. For a month now I am getting the MIL on and P2191 code (System too lean at higher load bank1) after erasing the code it appeared again in 3-4 days. I replaced air filter check all valves and vacuum in air flow, changed to premium gas. Pipe that connected to the valve from EVAP system looks not damaged and valve works as intended. While changing spark plugs I noticed that all of them were quite charred. I am thinking to replace both O2 up/down stream sensors. Which not OEM sensors would be the best match for my Accent?
View 11 RepliesI am far from home. Taking a road trip. Day 2 out of 6. My check engine light came on, so I just pulled over. All fluids were fine. Found some place to read the code:
P2757 TCC pressure control Sol Ckt Perf / Stuck off
The guy said it was something to do with trans.
I was driving along today and my Check Engine light came on. I stopped at the nearest Advance Auto to have them pull the code and it came up with the P0420, Catalyst Efficiency Below Threshold (Bank 1). I asked what could cause this and they mentioned that the fuel that was put in could be causing it. They didn't mention any other possible causes. Any others? I'm thinking it could be the fuel because the last gas station that I stopped at and filled up at is one that I never go to, and maybe just got a bad batch of fuel.
View 14 Replies