Sonata NF (2006-10) :: Check Engine Light Flashing / Stall
Aug 11, 2011
Earlier today i left my car idling for a couple of minutes and when i got back in and started to drive the car was vibrating, almost as if it was going to stall and the check engine light was flashing. drove a bit and stopped, started the car and now the check engine light stays on constantly. I have had the light come on (and remain on) a few times in the last while but it is usually solved by tightening the gas cap. it always seems to happen when i am low on gas (100 mile range-ish) Someone suggested maybe i had dirty gas in the car and needed stabilizer. My boyfriend said its a "misfire" and to change the spark plugs.
View 9 Replies
Advertisement
I have an '07 Sonata and I just recently had an after market HID kit installed. My car has since periodically stalled and the check engine light came on. I ran the codes and they are P0698- Sensor C Reference Voltage CKT low, and P2110- Throttle Actuator Control System forced limited RPM. What does this mean and how can I fix it? I had a second battery installed so I know I have enough to power everything.
View 8 Replies
I have had this issue on and off for a while. happened about 2 years ago just after i bought the car, and just started last week again.
The car will be running fine, then will start to buck while accelerating, shortly after the check engine light will start flashing and the car runs like it is on 1 cylinder. shut of and start again, light remains on( not flashing), car runs smoother, but does not accelerate like it should.
took it to autozone, they said it was giving the code for random mis-fire, and O2 sensor.
2 years ago the dealer said it was loose coils, and they fixed the problem, all the coils feel tight this time.
2007 Sonata ... 3.3 V6, 70k
View 7 Replies
My Sonata has 150k on it and the tensioners have gone bad 3 months now. This AM i got a flashing check eng. light and the car runs rough. Any relation or am I looking at plugs or coil issues?
View 9 Replies
I know it is a random cylinder misfire code however I started my car in the morning and it was fine I moved it and put it back in my driveway. I started it up later and waited for it to heat up i came back outside 10 min later and my check engine light was flashing and my car was shaking like crazy you could tell the engine was misfiring like crazy. I had under a quarter of a tank but not empty yet. I shut it off and turned it back on and it was still doing it. I drove the mile to the gas station the way it was.
Under partial throttle it was revving to 4500 and over 5, had to let of throttle to make the car shift up a gear. I filled up and started the car again performed fine after that however the check engine light was solid now and still on. I went to my local mechanic and he read that code P0300. I changed my spark plugs that day and they were crap the original spark plugs I have 65,xxx on my car now. Car is smooth now. I cleared check engine when i saw him first and it did not come back on all day even before i changed the spark plugs later that night. Why my light was flashing and why my car was acting like that till i filled up?
View 6 Replies
As the title says, my CEL goes on and flashes too.
I've read up a bit on why the CEL comes on/flash and it says it has something to do with the exhaust system and if continue operating will damage the catalyst converter (which I don't understand since I'm a car dummy.
In addition, the engine vibrates like crazy. I can feel the engine vibrating when I'm inside the car as well.
I already got the car tolled to the dealership and they kinda just told me it might be misfirings and then they said they couldn't locate the problem. So my car basically has to stay there until they open again on Monday and hopefully they will figure out the problem/fix it under the warranty and call me back.
The problem arise late Friday night and I just did a 30K maintenance on Thursday. (but the car already has 43,000 miles on it).
View 35 Replies
It happened randomly on the way home from work, the car chugged along with the check engine light flashing at me and then staying on. I was able to limp it home and got a ride to the nearest auto parts store to get some new plugs. I went with the NGK brand. Well, $60 later (including tools on the spot) and it's still running rough.
I know best case it to try and limp it to the autoparts store to let them try and pull the codes. I noticed an old thread where updates were made to the software to correct a running issue. I will note this same chugging randomly happened at 50,000 miles. I shut the car off, let it sit for a moment, restarted and it ran just fine. The engine vibrates noticeably just like it did at 50,000.
2009 Accent running rough 73,000 miles....
View 6 Replies
Kia rio 2006 130461 today I went and got gas right when I pulled out light began to flash and car shaking went to auto zone codes p0302 and p0326. I had knock senor changed 2 months ago . What could be the problem the guy said I just need a tune up . Is this true ? Is my car safe to drive car not shaking now and no changes in function of my car. There no way I can any one to look at it for couple begin tomorrow sunday.
View 19 Replies
I have a 2006 Sonata 6-cyl with 124K miles on it that also has an engine light that stays on but the car runs fine with the solid light. Only on a COLD start, usually first thing in the morning, is when the engine light starts to flash and the car runs very rough. When the engine light flashes and the car is shut off for about 5 seconds and immediately restarted,the engine light again stays solid and the car runs fine. I have had this issue for approx 2 years.
One mechanic says the code that always comes up is "P0306" (cyl 6 misfire) when the engine light stays on solid. When the light flashes and the computer is read,it gives EIGHT separate codes and all are cylinder misfires (P0300-multiple misfires and then P0301 thru P0306 for each cylinder misfire).
One dealer in the Phoenix,AZ area says my #6 cylinder valve is sticking and I need a full valve job because they supposedly did a compression test on all cylinders (which I doubt they did). I have spent upwards of $2000.00 already at both the dealer and 2 other mechanics to try and find the issue. I feel it is an electrical problem (sensor or computer itself) because one would think the car should run rough ALL the time if it was the actual valve sticking,but it runs fine when the engine light stays solid. I am running out of time because my emission test is due in 4 months. I do not trust this dealer to diagnose this issue; they have proven to me they are incompetent and just want me to pay through the nose for possible fixes until they finally just happen to stumble upon the correct problem.
View 4 Replies
I just bought a 2006 Subaru forester with 130K miles. Recently, the check engine light came and at the same time the cruise control started flashing. I brought it to the mechanic who said I had a bad catalytic converter. The car seems to be running just fine and now a day later the engine light is off.
View 3 Replies
I have been experiencing some issues with my '06 rio5 (same engine as your hyundais). this forum is way more active than the kia forums, so figured id give it a shot here.
I am experiencing a rough idle at start up while the car is low on fuel (<1/4 tank). it idles rough for a few seconds, the check engine light flashes a bit, and then it runs fine.
The car is an '06 rio5 with approx 19k miles on it, five speed manual. Also, sometimes after refueling and it will just shut off while waiting at an intersection. Not sure whether these two issues are related, but thought i would mention it just in case they were.
View 14 Replies
2006 F150 Triton 5.4 Motor... It's been over a months journey with fixing this truck....
How it started: had an oil change, a while back, on long drive after, check engine light started flashing as I accelerated up hill so I pulled over and in a while it was ok, but couldn't get on the gas too much, or it would cause that flashy light thing.
So fast forward to now, after driving it with an intermittent miss for a while, was driving it to work and the miss became a shudder, and she stopped going over 30-40, and runs extremely rough.
Steady but loud idle.
Replaced all plugs with motocraft plugs and new coils all around. No change.
Finally hooked it up to a computer and got random misfires, now it's saying
P0174 bank 2 too lean,
But it's bank ONE that's the only side misfiring.
Here are the freeze frame details:
Frame 1 Mod $00
MIL Status Off
Troub Code P0174
Abslt TPS 24.3%
Eng speed 1665
Baro PRS 71 kpa
Calc Load 100%
[Code].....
View 3 Replies
I unplugged the battery and left it over night. Started her up and there was no check engine light. I'm thinking it could be because of the CAI I have installed? Took it to autozone and he said it showing no codes.
View 9 Replies
I just changed out the spark plugs in my 06 Sonata and now the check engine light is on. The car runs fine but I can't find out why the light is on. Is there some reset switch?
View 7 Replies
Just went and got my check engine light looked at.
This is what code I'm getting P0174
It's also listing ignition misfire condition
Fuel injector problem
and engine mechanical condition.
I don't know if this is listing probable causes of the P0174 or if it's saying those are also problems.
First time dealing with autozone and there check engine light look up.
View 3 Replies
My 06 Sonata 120k 3.3L Does not go into reverse. (automatic) Took it for a short (1/4 mile) ride. Shifted fine at first then check engine light came on and it seems to be stuck in 3rd? What this may be, I don't want to get ripped off on a repair I don't need.
View 4 Replies
I recently installed HID lights in both the low beam and fog/driving lights on my 2008 Sonata Limited. I used relay wiring kits so the HID's pull power straight from the battery. When I turn on the HID's after starting the car, the engine stalls and throws a check engine light with codes P0698 & P2110. Took the car to the dealer and all they really did was verify the codes and clear them claiming it was fixed...NOT!!
If I restart the engine 2-3 times with the HID's off, the check engine light clears itself and if I rev the engine RPM's while turning on the HID's then it's no problem. The HID's otherwise work great..and again the only power they pull from the car's electrical wiring is the signal from the headlight switch wiring that trips the relay to turn the HID's on!! The HID relay wiring kits have inline 20amp fuses between the battery and relays and they are fine, so the HID's can't be pulling that much current.
View 5 Replies
I have a 2007 Sonata Platinum Edition with a V6. I changed the battery in December 2015 and the car has been sitting since then waiting for my niece to buy it. I haven't driven it since the battery install until today. The problem is although the car started easily I noticed the Check Engine Lite is now on and so is the ESC Off light. No matter what I do the ESC on off button it still says ESC Off. So I thought I'd take it for a ride only to find out that the engine won't run much faster than an idle. Floor the gas pedal in drive or reverse and nothing happens except the car moves very slowly. Just a little faster than it would if you put your car in gear but didn't give it any gas.
View 3 Replies
so I bought a 2008 Sonata with 70K miles about a month ago...
about a week ago, I noticed the oil pressure light was not going off immediately, it would stay on for like 5-10 seconds after the engine would start, usually it would fade away, sometimes flicker..
anyway, the time it stayed on and took to turn off got progressively longer every day (as long as 30-45 seconds) but it eventually goes away... well today the check engine light came on, and now the oil pressure light will flicker occasionally, and seems to do so based on actual pressure, not like a loose wire or something...
whats weird is if i'm acclerating, or maintaining steady RPMS, there is no light, but if i let off the gas, it will come on real quick, like a fraction of a second and go away, but when the car shifts (the same type of RPM drop) it doesn't happen...
anyway, I'm pretty chapped about it as I just got the car less than a month ago and bought it as is, but now i'm freaking out..
oh also the car doesn't leak, the oil change is less than 1K miles old and the oil is showing full on dipstick.
View 14 Replies
The light just came on in my 06 Sonata 3.3L, showing many codes... P0171B, P0172B, P2187, P2188, P0174B, P0175B, P2189, and P2190. All of these just came on at once, within the last hour. Everything that is stated is regarding Too Lean or Too Rich on Bank's 1 & 2. Where to start on this...
View 9 Replies
I recently got a Sonata from my parents when they moved to Pennsylvania. It's a 2007 with the 2.7 liter engine. It has had low oil for some time, so when I got it (last week) I put more in, up to but not above the full line.
It has had now for just a couple of days a very bad rattle, which is barely audible (but still IS audible) at idle and gets very severe during and after acceleration. It remains for some time even after the gas is no longer being pressed, then subsides a bit. I diagnosed it as knocking, but just today the check engine light came on and the rattle got louder.
I don't have another car to drive and I have class in five hours. Should I drive it or call a cab?
View 4 Replies
