My Sonata 2008 2.4 produces a single click as I press brake pedal, somewhere half way through. You can hear it and feel it with your foot. I think it clicks somewhere inside the hydraulic system of the brake.
View 13 RepliesWe have a new 2015 Prius with 6k on it and we are noticing one solid brief single click when the brake pedal is pressed and/or released. It doesn't happen every time (just some of the time) but it is only noticeable at slow speeds.
View 19 RepliesNoticed when I press brake pedal brake lights does not work even the center one. Checked all fused in the car and the small ones under the hood. All fine. I have a long trip tomorrow. Where else i can look. Everything seems working. Reverse light is fine. Is that related to latest brake light switch recall? Cant think of anything else.
View 4 RepliesOk, did an intake manifold cleaning on my 99 Accord the other day, and now I have problems...
Long story short, some time ago my car started to have a very rough idle. Took me awhile to find the problem. Turned out the air hose, between the filter and throttle body, had developed a big hole on the underside. So I replaced it and while I was at it used some throttle body cleaner, spraying into the intake manifold chamber. Lot of junk blew out the tailpipe. The car ran much better, but the idle could still be a little rough. I ran it that way for awhile, and finally the other day decided there was probably still some junk in there and it was time to really clean it out. So I took ff the throttle body and intake manifold housing. There was a lot of junk in there! The small intake on the passenger side was completely clogged shut. (I understand this isn't surprising on these cars.) I used a bunch of rags and 2 cans of Valvoline throttle body cleaner and a lot of elbow grease and cleaned it out. I was thinking to myself that whatever I didn't get with the rags flushed through OK, but I didn't want to take the whole intake manifold out.
So I put it all back together. (I took a video before I started, so I'm pretty sure it's all back together right.) But now I have problems. The car starts. It idles fine mostly, but can be a bit rough. But the trouble starts when I put the pedal down. If I do it in Park, well, if I push it quick the engine just dies. If I push it slow, the engine revs then quits, revs and quits, over and over. Similar if it's in gear. If I push it hard, the engine stalls. If I push it gentle, it revs up, but chugs along a bit.
I've run some seafoam through it, thinking it was clogged up with all that junk, and sure enough, lots of smoke comes out, but nothing is improving so far. What have I done wrong?
I own a 04 Grand Cherokee and have recently had problems with my passenger side brake light. Now the light itself does work under normal running light conditions, but when I go to press the brake pedal it doesn't engage the bright brake light. Drivers side works fine and so do all my other lights, I replaced the bulb to no avail, and am now currently looking into replacing the bulb socket.
View 1 RepliesWhen I press the brake pedal, the car will stop. But if I keep pressing it while the car is stopped, the pedal wants to keep going towards the floor. I have to press hard for it to do this. I have bled the brakes. I've checked the calipers and the hoses for leaks and don't see anything. The master cylinder is topped up and I don't see any fluid underneath it. It doesn't appear to be leaking. The funny thing is, when I turn the engine off and press the pedal, the pedal comes to a stop and doesn't want to move after I pressed on it as hard as I can.
View 2 RepliesMy dad drives an '06 Sonata. And he recently broke a brake line and had gotten it fixed. His current problem is that his brake pedal hasn't returned after getting the line fixed. What can he do to fix that? The pedal is really low and is spongy. And his ABS and ESC lights are also on.
View 4 RepliesI have a 2007 Sonata GLS 4cyl. Anyhow lately my brake pedal is going right to the floor. The brakes seem to work fine, but if I keep constant pressure on the pedal it will slowly go all the way to the floor. My rear rotors and pads have been changed a couple of months ago and I'm pretty sure my front brakes are good. What could be causing this? I also checked underneath the car for leaks and there doesn't seem to be anything leaking underneath.
View 6 RepliesI drive almost all the time in stop and go traffic and my knee hurts because the brake pedal is too high. My wife also noticed that the brake pedal is unusually high. Is there any adjustment I can make to lower the brake pedal?
View 2 RepliesThis afternoon while I was driving home from work I heard a minor squeak so I put the windows up and the radio off. t I heard my brake pedals chirp. It's a small minor squeak, but I hear it and it's bothering me. Am I over thinking this?
View 20 RepliesI was wondering if this problem is the "Barking" noise that keeps coming up the search or is it another problem. I will include a link to the video down below.
To start off, the Prius is 2010 Prius II and has 120k miles on it. Great Car. Only other problem was AC compressor dying at 90k.
The chirping noise happens when the brake pedal is pressed and does not go away until the release the pedal. It makes the noise regardless of whether the car is on or off.
It makes the noise when the car is stopped and or when the mechanical brake engage at between 0 and 6 mph.
Noise does not occur when the brake switch is removed. Not valid solution since the brake lights will stay on. It does not affect the performance of braking.
Here is the link to the video .... .... ....
Today I faced another problem i just try to start my car but, due the dead 12v battery it didn't start so i pressed the BRAKE PEDAL until it reach the bottom, again i tried to press but its not going to the bottom why was that, is it due to dead battery? And last time i called an automobile expertise to jump start my car. They check the voltage with a digital multi-meter and he said me if you jump start even you will get this problem again until u replace the new battery. but i said him it doesn't matter do a jump start and finally it was ok . Now again I faced the same problem and this time i am going to change the battery.
View 1 RepliesWhen I press the pedal down the pedal vibrates and make an odd sound like errrrrrrrrrrrr best way I can explain it...
View 5 RepliesSo I took the pads off and saw pistons that push caliper against rotor were to far out to install new pads. (rear pads were still intact, both front pads were out when i pumped) So im pumped the brakes thinking it would reset them and alls it did was push the fronts out more.. I noticed fluid leaked out of the pistons after fully pushing them out.
After seeing that pushing the pedal only pushed them out and didn't reset them, i pryed them in with a C wrench. Was quite difficult but managed to do it. Note I only did this on the front pads..
Rear was just fine, piston went back in easily. I filled brake fluid fully and still does it - Now pedal hits the floor when i first hit it and seems very light when braking.
I have only 42k km or 26 k miles. Brake stops but soft. The brake pedal sink if you apply pressure after a stop. Feels like someone open a valve. The pedal go to very low. I am find the stopping power is poor. Brake fluid is brownish. I hope it is not the master cylinder.
View 20 RepliesRequiring that the brake pedal be depressed in order to start the engine can be a nuisance, say if the driver is out of the vehicle and the passenger wants to start the engine to run the A/C, etc.
There is a workaround though. Press the engine start switch once to go into ACC mode, then press and hold it for 15 seconds and the engine will start without the brake pedal having to be pressed.
When brake pedal is fully pressed and my car is in drive the pedal vibrates. The only thing I thought of is that my intake is touching something, but I don't see anything.
View 8 RepliesSometimes my 96 Subaru Legacy will not turnover unless the brake pedal is pressed. Other times starts without my foot on the pedal. It seems to need the brake pedal addition more often if it has sat a couple hours or more without being started.
View 5 RepliesI just noticed it this morning. When I step on my brake pedal, all 3 brake lights activate, then they start to sporadically blink, I don't think it's a fuse problem, since the 3rd brake light also blinks, and I believe it runs independent of the regular brake lights.
What to check.. No codes are being listed, checked that with my Scangauge II already. (2006 GLS)
I have 2013 Elantra ( 20,000 miles) and when I put the brake lights on without the headlights on everything works ok but when the headlights are on the driver's side brake light does not come on when the brake pedal is pressed. I thought it was a bulb problem so I replaced it but I am still having the same issue. What is going on? I know it is still under warranty but I figured I could handle a burnt bulb issue but that was not it. I noticed that the drivers side bulb is not as bright either when brake is pressed without headlights
View 11 RepliesTo all 2014 and 2015 GX 460 owners, does brake pedal have a slight modulation or vibration while press it. Feels like ABS but not as strong pumping action.
When I step on the brakes the first time feels normal and then I let go of the brakes, then I press it the second time that is when I feel a slight modulation or vibration of the brake pedal.