Sonata NF (2006-10) :: 2009 2.4l - Location Of Knock Sensor?
Jul 12, 2016
Replacing the knock sensor on a 2009-2010 Sonata with a 2.4l? Where exactly is it located and what has to be removed?
View 2 Replies
Jul 12, 2016
Advertisement
Accent MC (2006-11) :: 2009 - Location Of Knock Sensor
I'm looking for the location of the knock sensor I can't find it?
View 4 RepliesAccent MC (2006-11) :: Location Of Knock Sensor
I need to change the knock sensor of 2011 Accent, don't know where it is.
View 7 RepliesSonata NF (2006-10) :: Can Oil Temp Sensor Knock Out Airbags?
I went to Jiffy Lube and got an oil change, fuel system cleaning and cabin air filter replacement & sanitizing. I drive an '09 Sonata with 112K miles. When the car came out, I pulled away and noticed that the airbag symbol on my dashboard was lit and the center console was flashing that my passenger did not buckle their seat belt (I didn't have a passenger or anything on the seat). I went back in and after they looked at it, they said they couldn't find anything that could've happened at anytime and was a "horrible coincidence."
Hyundai ran a diagnostic tests and one of the 4 things that came back was B1389 (in addition to B1516, B1324 and B1515). B1389 signifies "Oil Temperature Sensor Circuit Failure." If the guy changing the oil damaged this (does this even get touched on an oil change), could that have offset the sensors for the airbags?
I just don't see how they done the above listed work and coincidentally my airbags are all deactivated afterwards. I'm reading a lot of bad reviews online, including quite a few for NOT putting oil back in the engine after the change.
Sonata NF (2006-10) :: Camshaft Position Sensor Location On 2007 GLS
I have been getting a P0011 error code. Changed the OCV but the code continues. I'm going to try replacing the CMPS but am not quite sure of the location on the 2007 Sonata GLS. Looking for any pics of the location or a description?
View 1 RepliesAccent RB (2012+) :: Knock Sensor Location
I cannot find the location of the knock sensor in my 2012 Accent. I just replaced the radiator and had everything off up front unobstructed and couldn't find it. Looked in back, sides, but am completely stumped. I have found information on earlier models but not 2012+.
View 37 RepliesAurora :: Location Of Knock Sensor On 1997 Vehicle
Where the knock sensor is located on my 1997 Aurora. what does it do?
View 2 RepliesSonata NF (2006-10) :: 2009 - Evap Purge Valve Location
Where are the canister and solenoid valve located, above the tank? 2009 Sonata 2.4L ....
View 1 RepliesFord F-150 (2009-2014) :: 2010 5.4L - CEL Came On Knock Sensor Replacement
Recently, my CEL came on. I had the guys at Autozone read the code and they said it was the knock sensor on bank 2. I disconnected the battery to clear it but after 100 miles or so it came back on. Idling, my engine runs as quietly as it ever has (can't tell it's running if the windows are up) so I'm hoping that the sensor has gone bad. I can't hear any knock at any speed but the re-appearance of the light has noticeably affected the engine performance. Any link that even shows where the sensor is located? If I can find it, I can replace it.
View 1 RepliesSonata I45 (YF - 2011+) :: 2.4L - Temperature Sensor Location?
Have no Fan on Rad running. Cant seem to locate the temp sensor to test it? What is the location?
View 1 RepliesSonata I45 (YF - 2011+) :: Mass Air Flow Sensor Location?
Oil leak.... I can not locate the MAF sensor in my 2012 gls 2.4l sonata. I followed from the front tube intake through the air box to the throttle body and i do not see one. I also have the service manual and no mention of said sensor!
View 14 RepliesSonata I45 (YF - 2011+) :: Crankshaft Position Sensor Location?
Looking for a picture or description where this sensor is located? I assume very close to the crank pulley, but I'm hoping I will not need to remove the crank pulley to gain access to this sensor. I have a 2011 Sonata, 2.4L engine.
View 3 RepliesFord F-150 (2009-2014) :: Location Of Oil Pressure Sensor
Where the oil pressure sensor is located on a 2013 F150 with the V8 is located?
View 3 RepliesLexus GS 2006-11 :: Check Engine / VSC Lights On - P0333 Knock Sensor Code
I just purchased a 2006 GS300 AWD w/115k. Started car on lunch hour to find check engine / check VSC lights on. Ran codes to find P0333 Knock Sensor code. Vehicle seem to run perfectly fine, but now that the light is on, it is definity spark knocking under acceleration. This is my first Lexus / Toyota product, so I am unfamiliar with the common problems or fixes. Are knock sensor replacements common?
View 6 RepliesJetta - Volkswagen :: 2006 - CEL Code P0332 / Knock Sensor 2 In Bank 2 Faulty
I have a 2006 VW Jetta with 92K miles and just a couple of days ago my check engine late came on and when i took to an auto store to check the code, it came as P0332, Knock sensor 2 in bank 2 is faulty. Three things have happened all around the same time and I am not sure if they are related and are just coincidence.1.Check engine light came on.2. I have noticed after that, my car RPM has dropped, idles at about 600-700RPM and when trying to accelerate, it tops at 3000 RPM and feels like the motor cuts off at that point and I have to step off the gas and the car runs ok again, but cant go over 3000.
Had trouble getting on the interstate due to this and thought the car was going to stall, but it didn't. just had to back off the gas and let it run, It did go up to the speed that I wanted, but seems like it wont go past the 3000 RPM point.3. My fuel gauge, drops to empty when it reaches the half way mark on the meter. It stays at the correct level when I start and keep the car in idle, but when I start moving, it drops to empty. When I fill up the tank, it goes all the way to F, and after the car goes the usually of about 190-210 miles, when It reaches the half full level, the meter drops to zero, so have been using my trip odometer to drive after that.
Elantra HD (2006-10) :: DTC P1100 / Location Of The MAP Sensor?
Don't know the location of the MAP sensor for a 2008 Elantra 4-dr (HD)? I'm reading a DTC P1100, which indicates a manifold absolute pressure (MAP) sensor malfunction. The Haynes manual refers to this only being necessary for the previous model Elantra.
View 3 RepliesAccent MC (2006-11) :: Mass Flow Air Sensor Location
2009 accent, cant find its location. Picture would be nice...
View 4 RepliesAccent MC (2006-11) :: Misfire On 2 Cylinders - Location Of MAF Sensor?
I have a 2009 Hyundai accent. 2 cylinders misfire. I changed out the spark plugs after the misfiring began and the 2 cylinders that misfire don't follow any specific ignition coil, it's just 2 random ones.
Looking at the data with a reader points to fuel injector number 1 not working properly. The first few seconds the car is on the check engine light blinks and fuel injector 1 spray duration (fluctuates based on gas applied) changes just like all the others. However, when the check engine light goes solid (then the misfire code is thrown) fuel injector 1's spray duration is stuck (usually around 3.5 ms)
The cable going into the fuel injector powers those little troubleshooting lights like it should until you plug the cable into the fuel injector OR remove and replace the light a few times.
I don't know much about cars but someone told me to try cleaning out the Mass AirFlow sensor as they had the problem above and the MAF sensor was the cause. I can't find anything on where the MAF sensor is located though.
Sonata NF (2006-10) :: Slight Knock When The Car Shifts Into Third Gear
I bought my sonata with about 48,XXX miles about 2 months ago, and now it has 52,500 (im a student - dont drive much). Anyways, whenever i start my car up and drive down the road, when the car shifts in to third, i hear a slight knock. almost like a little gong - metal on metal.
Once it does it the first time, it doesnt do it anymore. Im guessing temperature could have a factor?
Sonata NF (2006-10) :: Transmission Knock When Shifting Into 2nd Gear
I noticed that recently my 2007 Sonata (108k Miles) is making a knocking sound when it shifts into second gear. It happens only when I back out of my garage and drive down the street and the car is cold. After that there is no more noise, and the transmission is shifting through the gears smoothly.
I recently replaced the transmission fluid, about 5k miles ago and I used the recommended type.
I read other postings with people having the same problem, and in those cases they pointed to the ABS self-check which occurs when you first start out. But this is definitely not my case as the noise is coincidental with shifting into 2nd gear and it only does it when the transmission is cold.
Could this be caused by the fluid temperature or maybe because the fluid has not had a chance to circulate through the transmission and fill all the cavities? Its rather strange thought that I just noticed it in the last month or so, if that were the case I should have had this problem before.
Accent MC (2006-11) :: 2008 - Coolant Temp Sensor Location?
Where the ECT sensor is located? I would really like to have a diagram of the engine. Where I can find an engine diagram for a 2008 accent gls?
View 3 Replies