Sonata NF (2006-10) :: 2007 - Loud Valve Tap After Oil Changed
Oct 8, 2012
2007 Sonata GLS 2.4 liter, 145,000 mostly-highway miles.I have a P2187 OBD code, which means an upstream O2 sensor. It's on order, should be arriving in a few days. The sensor has been bad for about a month, but I just recently ordered it.BUT... now I have a fairly loud valve tap; this is tapping whether the engine is cold or hot. A few weeks ago I changed my oil; put in hi-mileage oil (Pennzoil maybe? I remember it was a gold container) and a Fram oil filter (I noticed a number of people on here saying to definitely not use Fram).
I checked the codes again (I was thinking maybe a camshaft position sensor) but I still only have the P2187.This model has a chain, not a belt. So a few questions: Could having a bad O2 sensor (and hence running lean) have caused the tapping?I was thinking of doing an engine flush, then putting in some Lucas along w/synthetic and a new filter.
View 2 Replies
Advertisement
My girlfriends 06 Sonata 4cyl threw a p0011 code a week or so ago. I looked online and saw that it could be dirty oil so I immediately changed it (it was about 400 miles overdue at that point). I also looked on the forums here and was referred to a thread that suggested replacing the oil control valve. My girlfriend drove to work a few times before I fixed it (maybe a 100 miles total) and the car stalled out in the middle of an intersection. I then replaced the OCV and to my discontent the problem was still very present. Very loud knocking or clanking under the valve cover and sluggish idle. Her mechanic now says that it is a job for a hyundai dealership and that it could be something as bad as a head or engine rebuild. What the problem could be?
View 2 Replies
I have a 07 Sonata and having recurring valve cover leak. First time it happened it leaked onto my alternator and had to get car towed and whole bit. About a year later they discovered it again during routine oil change and had it fixed again. Yesterday during a routine oil change, they discovered a leak again!! I know this is an established problem but how many times can the same problem occur?? I'm passed the warranty (103K).
View 3 Replies
I have an 07 Sonata V6 Limited with 65K miles. Recently I've noticed at startup, the valves pinging and blue smoke coming from the tail pipes. Settles down after a few seconds and doesn't do it again if you shut it down and re-start. Last time I experienced this was on a Silverado with well over 100K miles. Back then it was valve seals. Could this be possible with 65K? I noticed in the maintenance log that they request having valve clearance inspected at 60K. Could this be causing my condition? I'm the second owner, so the 100K warranty is out of the question.
View 6 Replies
2009 2.4 Sonata. Replaced the battery. Engine light came on after battery replacement. Engine code P0106 (MAP sensor or vacuum leak). Car drove fine before and after the battery replacement. Engine light after replacing battery?
View 2 Replies
I discovered a few weeks ago that my 2009 Sonata 2.4L SE had a sticking caliper on the rear driver's side. It had gone bad on the passenger side as well, but not as bad. I had the calipers, rotors, and pads replaced on the rear yesterday. As soon as that was done, I started hearing a noise when braking that sounded like a rubbing noise, almost like a long "sigh." It happened at any speed as long as I pressed the pedal far enough to bring the vehicle almost to a complete stop.
I originally thought the calipers weren't the right fit, but the parts I confirmed the parts I ordered (Nastra) through Rock Auto were correct. I've driven about 80 miles since then and nothing has changed. I didn't see anything wrong when I took the tire off, but I don't think this sound is normal. Taking it in to the mechanic tomorrow. Could it be a wheel bearing? Wrong parts?
View 9 Replies
I drive an 06 Sonata with the 2.4L. I have put about 25,000 miles on the car and since then I have changed the tranny fluid 3 times due to it shifting rough. I will change the fluid and it will shift smooth for about 2 or 3 months then it will start to shift roughly again. What I could do or what the problem could be?
View 3 Replies
So I took the pads off and saw pistons that push caliper against rotor were to far out to install new pads. (rear pads were still intact, both front pads were out when i pumped) So im pumped the brakes thinking it would reset them and alls it did was push the fronts out more.. I noticed fluid leaked out of the pistons after fully pushing them out.
After seeing that pushing the pedal only pushed them out and didn't reset them, i pryed them in with a C wrench. Was quite difficult but managed to do it. Note I only did this on the front pads..
Rear was just fine, piston went back in easily. I filled brake fluid fully and still does it - Now pedal hits the floor when i first hit it and seems very light when braking.
View 12 Replies
I recently bought a 2006 Hyundai Sonata 3.3 V6. Had another issue related to the rear wheel, which I fixed. Today, I changed the oil filter on the car (along with the oil). I have heard this engine noise before, but with the cover off it appears a little louder. It's basically a ticking sound.
The engine uses no oil, and has no other leaks. It has some noise on startup for maybe 1-2 seconds (like a loud lifter or something, but it goes away in less than 2 seconds, and at the same time the oil light goes out). I changed the filter today because I was told that a leaky gasket could result in the Filter not retaining oil between starts, causes some minor knock for a few seconds.
But anyway, this other ticking noise seems to be regular, regardless of condition. I have heard some people say that some engine noise is normal for this engine, but how about this?
View 4 Replies
Changed my oil today and check the air filter. I noticed that there is oil on the air filter, so I'm thinking the PCV valve is bad (car has 136,000 miles). I want to check it but I'm not sure where it's located. Where it's located (pictures would be great) and how involved it is to replace?
View 4 Replies
Changing the valve cover gasket on the 4 cylinder 2.4l. I was going to change mine's. Didn't know if there are any special tips like sealant to be used, loosening bolt sequence or tightening sequence, torque values.
View 9 Replies
Where are the canister and solenoid valve located, above the tank? 2009 Sonata 2.4L ....
View 1 Replies
I changed my leaky valve cover gasket today, along with my spark plugs and PCV valve. Now after driving a few minutes my CEL and oil light come on.
the car was/is low on oil from the leak. I was going to change the oil but it has been pouring rain today and it was all I could do to get the valve cover gasket done.
I put two quarts in after the oil light came on, I haven't had a chance to check the level since then.
I don't see oil leaking anywhere on the engine. I cleaned it up pretty well around the valve cover and should see any new oil easily.
How low does it have to be for the oil light to come on?
View 1 Replies
Got Engine Code P0022. Listed several things, Cam Position Indicator (replaced it) and CVVT Oil Control Valve Bank 2. Dealer calls them "front" and "rear". Is Bank 2 the rear (Black or gray also).
View 1 Replies
So, I changed my spark plugs a couple of months ago and did the pcv valve swap as well. Now I have this high pitched rattling noise, like a tiny chain rattling. It is coming from the engine bay - in the area between the throttle body and the firewall. At least that's where I can hear it.
It does it quickly right after I start the engine (though I am certain it is not a timing chain issue)...I had that fixed a while back. Also it doesn't sound like the timing chain tensioner noise.
I am thinking maybe the pcv valve that I swapped out. I remember reading that a new one should make some noise when you shake it...an old, gunked one would not rattle if you shook it in your hands. Consequently, this noise sounds a lot like if I would shake the pvc valve back and forth very fast.
It happens intermittently on idle....and when I rev the engine, it will also make the noise while the RPM falls back down. Since this happened literally right after I did the spark plug change and the pcv valve, my guess is it's that. Maybe I didn't install it correctly.
View 3 Replies
I'm suspecting a small valve cover gasket leak. I've noticed dirt starting to accumulate near the alternator side of the front valve cover, there is dirt on there stuck to oil, I don't see any wet oil but its so minor the dirt just sticks to it. 107k miles here. Seems to be a common problem. I think Downhiller had a large oil leak, source unknown around his crank pulley area. You wouldn't think a car this young would leak oil. It's not bad, I havn't had to top any off I just like a mildly clean engine.
View 38 Replies
I have a 06 Elantra having a problem with a p0441 code flow fault I changed purge valve and canister purge valve I don't know what else to do what else can I do to get it to go away permanent so I can get car inspected no codes for my car can be on but only 1 i/m
View 3 Replies
I recently got a check engine light. I went and got it checked, the person said its the canister purge valve that needs to be replaced. Where it is located and the difficulty replacing it. The part is cheap and I want to replace it this weekend. 2007 elantra
View 2 Replies
We have a 2009 Sonata with barely 50k miles - always garaged. It has been a great car but recently has come up with a couple of quirks.
I was driving last week and heard a loud "pop" behind me. Really loud..... I pulled over and found that the left rear window was missing!
I took the car to a local auto glass place and they found the missing window down in the door, I really though that it had fallen out and actually went back to the spot on the road where the noise happened and looked for it.
Anyway, the glass shop lifted the window back in place but had little interest in making the power part work again.
Now, I have had power windows fail on other cars before but they always got stuck, I have never had one "disappear". Would this be a safety issue that Hyundai might cover?
View 1 Replies
Ever since I bought my 06 LX in November last year, it's either the transmission or possibly the engine that makes a whining sound. It's a very noticeable sound, every passenger I have mentions the sound. It starts as soon as I step on the gas.
I'm finally getting annoyed with the sound, and I'm wondering what I could possibly do. It's just out of warranty, 71000. I'll try to have a video recording of the sound by tomorrow.
View 7 Replies
I have a 2006 Hyundai Sonata that is making a loud clunking noise when I first put the car in gear. I start the car, put my foot on the brake, put the car in R and I hear a creeeeaakkk, clunk! noise coming from the front, passenger side of the car. I back up out of the driveway/parking spot, put the car in D and get a slight clunk! noise out of the same area again.
At first, I thought this was maybe a ball joint or a tie rod failure, but a friend of mine and I took the front wheels off of the car this past weekend and I gotta say, everything was found to be in solid shape. Nothing loose, bushings are in good shape, boots are in fantastic shape, no loose wheels that can be moved in ways they shouldn't move. After getting the noises and clunks to happen again, my buddy's opinion is that it's my transmission having a tough go of it and that I should take it to a transmission shop. Is it a transmission thing?
2006 Sonata, 6 Cylinders, 141,000 miles (227,000 km)
Never did anything with the transmission fluid since I've owned the car. I bought it in 2010 when it had 80,000 miles (129,000 km) on it.
View 1 Replies
