My 07 is making a clicking noise while pushing on the gas, in cruise mode and while idling but doesn't click when I take my foot off the gas. It sounds like cards in bicycle spokes.
View 4 RepliesI have already concluded I need to replace my OCV on my 2007 2.4L GLS Sonata.
I have also been starting to hear a clicking noise associated with reducing throttle when in the 2500-3100 rpm range. It seems to only make this quiet clicking noise when the throttle is reducing and within the RPM range from above.
I am just wondering if this may be associated with the OCV needing to be replaced. I suppose I will find out for sure when I do finally get around to replacing the OCV sometime this month.
I have a 2010 Sonata GLS that isn't starting. I have full battery and plenty of gas. It doesn't click or anything, but all of the lights and electrical equipment work fine. Is there a common problem with this car that causes it not to start?
View 24 RepliesJust wondering what would cause a clicking type of noise while make a turn? I drive a 06 Sonata GLS.
View 6 RepliesI bought a second hand Sonata NF 2006. Excellent car. At the beginning to me was hard to tell if the car were running or started because of the silence and non-vibration at all.
but, recently I think that I can hear a little click click noise, no the normal one, another and some vibration on the steering wheel that wasn't there before.
My car engine is G4KD 2.0 L 2009, no shift interlocking mechanism installed (I don't have the small button near the gear box to release it) also I am able to shift from P to anything else while the car not turned on, and I can shift without the brake.
2 weeks ago, I started to hear click noise (I am not sure if it was there before, maybe it got louder) when I switch from P to R, and from N to D, my car is on 80000 Km and didn't replace the gear box oil (dealer said oil is fine).
Car run smoothly but I am curious why I have this click.
I just replaced rotors and pads on my 2007 Sonata. I got top of the line premium rotors and ceramic pads from Napa. Cleaned the oil off the rotors and gave them a light sanding before installing, made sure that the caliper bolts moved freely and the caliper pistons were not seized and also used new hardware kit (springs?) that came with the pads.
Everything seems to be ok, except for a clicking sound that occurs on hard breaking as the car is coming to a stop. I think its caused by the pads moving within its mounts (I did notice it was very easy to slide these pads into the mountings, more so than in previous pad replacements).
Reading from other posts I think this is still safe, but the clicking does bother me, should I use pad adhesive to stick the pads to the caliper?
I have a 2010 Sonata GLS and it has a starting issue. When you turn the key I have power to everything like dash, radio, lights etc. but it doesn't start. No crank, no clicking, just dead. I have checked the battery cables, battery posts, ground, starter cable. I kind of got the impression from reading other posts that it may be the starter or maybe ignition switch. I have replaced the starter once before but I'm wondering if you all think it's possible to be the ignition switch? If it was the ignition switch would the symptoms I am having be adding up? I guess what I am trying to say is if it was the ignition switch would you still have power to everything like the dash, lights and so on and the car not start or would there be nothing at all (dash lights, radio, headlights) in addition to the car not starting when you turn the key?
View 14 RepliesSo when I turn and am hard on the gas I get a clicking and slight clunking sound from the front end. Wants to confirm its the CV joints before I rip it apart?
View 6 RepliesThe visor suddenly made a clicking sound while I was lowering it and stays in the lowered position. The mechanism holding the visor up has apparently broken inside the visor. What is needed to remove and replace this under-engineered part?
View 20 RepliesMy B6 only has 1500 miles and I have noticed after I had the dealer replace a defective fuel rail w/only 400 miles on car a click'n noise when I am driving.
For example. When I take off from a stop, and accelerate to lets say 15-20mph and then take my foot off the accelarator, let the the engine(rpms) idle back to normal, and then re-accelarate again, immediately I hear a "CLICK" (only one x, and its not a really loud, its kinda subtle, but still you can hear it from inside the car) coming from under my feet area, very briefly and then the car takes off.
At first I thought this was normal, but of course I could not dismiss this, seeing that this is a brand new car, and figured........"well it shouldn't".
BTW, I just tinted my windows (35%) on my black B6 and it looks fantastic.
Where the flashers are located? I turned my turn signals on to find the clicking sound, but I couldn't see anything under the dash.
View 9 RepliesI have a 2006 hyundai sonata 3.3L V6. Only happens on a cold start. I'll start the car and it won't tick while at idle. But as I drive away ill hear it for maybe about 2 mins only maybe in first gear until the car slightly warms up and then it's gone completely.
View 30 RepliesI have noticed lately, when the car is hot, while pulling into my quiet garage, and even when the car is in park, engine running --- hearing some clicking / ticking coming from, or near the Catalytic Converter.... It sounds as if a small piece of metal is rattling inside with the flow of air... It stops clicking once the engine is turned off.
View 5 RepliesI have clicking noise coming from the accessory drive on my 3.3L 06 sonata. It started off as a squeaky noise upon start up. I have since replaced the belt and the tensioner and now it is a clicking/ticking noise. It seems to be a lot worse when the car is just started and it slowly goes away upon warming up. In addition, when the car is cold the voltage light will turn on around sharp turns and steering will get hard (almost like something is putting drag on the belt). What it could be?
View 2 RepliesWhen I accelerate from stop the left wheel it like makes a "clicking" noise as the car starts accelerating, once in motion there is no "clicking". What might cause it?
View 6 RepliesI recently replaced my starter pin my Hyundai Sonata 06 v6 3.3 gls. Installing it was no real issue, but one (there is only one a single wire not the one that you fix on with a bolt and nut) of the electrical connectors from the car to the starter solenoid. The plastic around the conductor pretty much crumbled around my finger, what this connector is called specifically. Now the contacts will not contact properly so i suspect this the source of the rapid clicking issue, since my battery was fully charged. I plan to go to the junkyard too if i can find a replacement. Looking for specifics on the electrical connector?
View 1 RepliesAC does not work on Sonata 2006. It blows hot air.
1. Freon pressure is high level in red and I didn't add any new freon.
2. Checked fuse 7 A/Con and 19 A/C Relay and both are OK.
When I click on AC on/off green light on AC panel the light is lit but I don't hear any loud clicking sound.
So I just replaced the front rotors and brake pads on my 06 Sonata. Before I replaced them, the front passenger side had a clicking sound coming from it when I turned. So I thought this whole time that I needed a new CV joint. But after I replaced the rotors and pads I took it for a test drive and I noticed that the clicking noise was gone! So I guess my question is, can bad brake pads and rotors cause a clicking sound when turning?
View 4 RepliesM/T 2010 Sonata. I'm just out of warranty at 102,000 mi. No issues before with clutch. I noticed a clicking or crunching sound when pushing the clutch pedal down. I took a gander and noticed the pedal was traveling farther than it used to because there were indentations in the carpet. So this happens for about 3 days. Then I start the car and cant get it into gear. If I shut it off, it easily goes into gear and I can drive. Usually it is ok after that point but is getting worse. Mechanic briefly tried to bleed it but the pedal stayed on the floor. He was able to get it to its original problem but said if he replaces the master & slave cyl then might as well do a new clutch. Because I had no slippage, no pedal issues or anything prior to clicking. Is 102k miles and 6 years usual time for these components to fail?
View 2 RepliesI have this clicking sound from the gear of my car every time i step on the brakes, is it normal or do i have something to worry about...
View 1 Replies