Silverado :: All Dash Lights Come From Check Engine To ABS Light - Gas Gauge Goes To Empty
Mar 5, 2014
I have a 2001 Silverado and for some reason all the dash lights on come from check engine to the abs light gas gauge goes to empty then back to normal 9 times out of 10 these lights come on. It has done this for a while and doesn't effect how it drives, I am possibly wanting to sell it and cannot explain hat it runs fine with this problem. Where do I start to figure this problem out .
View 4 Replies
Advertisement
I have a 2000 Silverado Z71 with the fuel gauge swinging from empty to full and all in between. I have heard of others doing this. I guess maybe its time for a new fuel module. It's been doing this for a couple of years, just keep putting it off. Is it easier to move the bed back or drop the gas tank? Also I have developed hard starting problems here lately, It having too crank extra long before it starts up. Could this be a sign the fuel pump is getting ready to go out.
View 8 Replies
I have an 05 silverado 1500 crew cab z71 and i have a little bit of an issue with my Check Engine Light being on. The problem is when I tried to pull the code from the computer it wouldn't even read that it was plugged in at all. I talked to a buddy of mine and he said that could possibly be the reason its on.
What I am trying to figure out is what i have to do to remedy the situation so that i can actually be able to pull codes in the future. My truck inspection is out and need this light fixed.
Also every once in a while my battery light comes on and it says i need to service my charging system also because I have never seen it before.
View 3 Replies
A couple of weeks ago I was driving my 2008 Toyota Yaris and the check engine light came on. Soon after the check engine light came on every dash light started flashing. The Car down shift into second while I was going 55 miles an hour! We took the car into a service center where they said it was the speed sensor which they replaced. We got the car home. I drove it to work the next day and while going to lunch the check engine light came back on! The car seems to be shifting fine though! They mentioned that if the speed sensor didn't fix it, it could be the "cluster"! What the heck is that?
View 4 Replies
I have a 1997 Mitsubishi Galant with 134400 miles. Filled up the gas tank, driving home and the check engine light is on. Checked the fluids and found out that the engine oil is empty. Due for an oil change soon. Last mechanic used an expensive oil. Do expensive oils burn quickly? Mechanic said that cheaper oil change uses cheap oil...
View 8 Replies
recently my check engine light came on, I had the codes read, the tech said that i had air getting into my fuel system, i replaced my gas cap. my light is still on, he also mentioned some kind of emissions sylinoid may need replaced, or a vent valve idk.
I recently drove up to Sandusky OH for the weekend, my light didnt come on til i refuled with gas containing 15% enthenol. the engine is running fine, no miss, has good power. I ran it down to a 1/4 of a tank and filled back up and the light is still on.
View 4 Replies
I have a 2003 silverado 1500 4x4. The check engine was on along with the abs light. I went to advance and let them tell me what was going on. I don't know the specific code but it said the passenger front abs speed sensor was bad so I replaced it along with new brakes, rotors and calipers. Now the abs, check engine and red brake light is on. There is also a message telling me that the brakes need serviced. I went back to advance and let them tell me once again why those lights were on and it was still the passenger speed sensor bad. What could be going on with it? Before it was replaced the red light never came on but now it is.
View 10 Replies
I was driving home and all of a sudden my rpms are at 3.5 4k rpm wont shift to next gear. I put in in tiptronic mode and shift it to 8 it works fine. Then about 10 minutes later check vsc shows on dash traction control light is on check engine light is on and the light next to the check engine i think it is the abs light. I havent pulled the code yet.
View 1 Replies
1996 Silverado 350 engine. When I turn ignition key on, all system check lights come on as they should except "check engine soon". If I connect code reader the light comes on and will come on the next time ignition is turned on but only one time. The second time you try it, it does not. What would cause this?
View 3 Replies
Ok so I just replaced my mass air flow sensor about a week ago. My check engine light just came back on and when I scanned it it said mass air flow sensor. What could be causing this to happen again? The codes are P0102, P0440, P0440.
View 4 Replies
First of all, its 5.7L V8, it's been very well maintained, I've had my fair share of problems but nothing that has been that serious, except for the "check engine" light for the O2 sensor.
For about the last 4 months i've had the problem of the truck sometimes jerking while on the road. Once i started to speed up it seemed to not speed up which when it did, it jerked a bit. That was in the beginning.
AS OF NOW, the jerking has stopped but every now and then when i pull out of the garage and start to turn onto road it turns off, but all the status lights are left on. & when turn the key to turn it off and restart it starts again every time. Ive noticed that i was better off with the "check engine" light on then now because every time it is off it has these problems.
Also, when I barely start to tap the brake, again not all the time, sound skips on the radio. & this always happens when i tap on the brake & this happens more frequently when the "check engine" light is off.
View 3 Replies
I just bought this used truck, 2005 Chevrolet Silverado 1500 extended cab. I noticed some shaking while in idle when I got it back home. The check engine light came on a day or two later, and I recently had a diagnostic test ran on it at the local AutoZone. It came up that I had a P0135 o2 sensor (bank 1 sensor 1) malfunction and a P0101 Mass Air Flow Sensor signal performance issue. The check engine light comes and goes. I stopped by Walmart for about 10 or 15 minutes and when I got back into the truck, the issues reoccurred. For about a minute, the check engine light actually started blinking! And then went away and started running normal again. Its upper confusing. I bought some MAF cleaner to use on it tomorrow and figured that wouldn't definitely clear up my issues, but I'm still wondering if the MAF sensor is enough to warrant the CEL to blink like that?!
View 6 Replies
I have a 2003 Excursion 6.0. I didn't post this in the 6.0 section because it may not be just a 6.0 issue. (See what I get) On cold starts, anything under 150 degree water temp reading on the SGII. I get a CHECK GAGE light on accompanied by the check engine light. No codes read on the SGII pending or stored. Just some of the time I get a water in fuel light too. This tends to go out fairly soon after driving. (Even after I just drain the fuel pump it still happens.) other issues that accompany the lights are as follows.
The trans temp does not give a reading to the dash. The oil temp does not give a reading the dash. Both show proper temp on the SGII. When in reverse the back up alarm beeps as if something is behind me. And the auto door locks will not activate after 10 mph. The tach also will not show a reading in the dash. SGII shows the numbers. Now the kicker, this ALL gets resolved the instant the water temp hits 150 degrees. The only lingering issue is the that the tach will surge or drop every now and then. The tow/haul light does not come on when this is going on. I've checked the battery terminals all are clean. Both batteries are brand new.
View 9 Replies
I have a 2001 chevy silverado 3500 6L gasoline engine.
I have been getting a P0307 random multiple misfire #7 on and off for a few months now, occasionally the P0300. Check engine light comes on when I am going up hills, often under heavy load and sometimes when the truck is cold in the morning and the truck starts to run rough until the code clears, which it does pretty quickly usually. I have replaced coil, crank sensor, cam sensor, fuel injectors. If I unplug the battery overnight the code will be cleared and the truck will be running just fine the next day.
View 6 Replies
I have a 1998 chevy silverado z/71 4x4. I had a water leak and had the intake manifold gaskets replaced. Ever since then, the check engine light comes on and it soots up the o2 sensors and the 4 plugs on the right bank. It may run good for a month or so and then it starts all over again.
View 1 Replies
I've been fighting this for weeks with no success. Gas gauge always reads empty and the light is on. I checked the resistance of both sending units sitting in the tank 28 ohms on the right and 50 ohms on left. That should be within spec right? And when I pulled them out the ohms change at a steady rate with the arm down to 4 or 5 ohms.
I've checked all the fuse, all good. And I do have a for fuel level sensor A. Is there supply voltage checks I can do, or ground something to try to get some reading?
View 1 Replies
2 weeks ago, I noticed the fuel gauge doesn't return to EMPTY when the engine is off. I didn't worry much as the actual movement of the gauge seemed accurate as I was using up the fuel. I figured it might fix itself during my next fuel fill up. Nope....continued staying at the fuel level and not returning to EMPTY. A few days ago, I noticed it went back to EMPTY when the engine was off, but it took approx. 5 minutes. Now it doesn't go back to EMPTY.
View 9 Replies
So yesterday I was driving home from work.. I know my tank was 3/4 full. All of a sudden, my low fuel light came on and my gas gauge needle went to empty.
The needle sits at E, but it still says about 20 miles till empty on the MFD. When I left the house this morning, it said 5miles till empty.. by the time I got to work, it said 20. Kinda odd..
I will hook up the vagcom when I get home tonight, any area I should scan for? or just a complete scan? There is no CEL error on the dash though. What I could look at to fix this?
View 4 Replies
All dash lights and gauges went crazy with a picture of battery in screen and then stopped working for a few miles before working again. I was cruising @65 and this happened and downshifted to 2nd then quickly to 3rd and wouldn't shift again. Stuck in 3rd gear.
Had it scanned and got
P0740
P0753
P0758
P0785
All shift solenoids. Would I just buy a new valve body with new solenoids?
I would occasionally have the gauges go crazy and battery light go on but would go away and not have any codes stored. It would only do it towing and always thought it was a ground issue with th
View 10 Replies
I have an 08 Hyundai Santa Fe. Check engine light comes on, fuel gauge goes from empty to full, to half, to 1/4, just all over the place. Even ran out of gas a few times on the side of the road not knowing how much fuel I have.
What exactly causes this problem? I've heard "fuel sender" I've heard "fuel pressure sensor" etc. All are different parts. Need to get this repaired asap.
View 8 Replies
I have a 1999 Jeep Cherokee Sport with 140K + and recently had an oil change. I went on a 8 hr road trip split up between 2 days (there and back). On the way home I noticed my oil pressure gauge acting funny, going up and down but not past 40. Today, I drove home from work (10 miles or so) and the check engine light came on and the oil pressure gauge was very low, almost 0. I made it home but was very nervous and noticed both today and this weekend there was smell, burning or burned type smell. What should I do? I don't really trust the garage that changed the oil and was skeptical taking it there but was in a pinch.
View 12 Replies
