Silverado :: 2009 - Occasional Trans Slip When Shifting From 2nd To 3rd Gear
Dec 27, 2011
Have a 2009, 2500HD 4X4 23K miles that has an occaisional/intermittant trans slip when shifting from 2nd to 3rd (I think). It always seems to catch me by surprise so it may be 2-3 or 3rd to 4th. Shift point seems to be around 1800rpm, engine revs to about 2500 during the slip. It's always shortly after starting up and the trans is not necessarily up to full operating temp. I've noticed it happening in the dead of summer as well as the dead of winter.
View 14 Replies
Advertisement
I drive a 91 Silverado, v6, standard transmission.
While I was driving my truck seemed to slip out of gear and wouldn't go back in. About 10 seconds later it shut off. I was able to ride the momentum and pull over. It tries to start when I'm turning the key, but nothing. I've ruled out the distributor and the battery. All I can think now is: transmission ....
I've had problems with my distributor rotor from time to time, but no real indication that my transmission was having troubles.
View 5 Replies
I own a 2002 W8 passat b5.5 that had issues from the used car dealer i had bought it from. I had 2 new motors installed over the period of about 13 months . The first motor had a bad torque converter and seemed to also cause my trans to slip. I am not sure if that is the direct cause of the trans slip going from 2nd to 3rd gear. The second motor dropped 4 valves in the cylinder "3" and cracked the starter. I had all the work done by the VW dealer that i used to work at.
As of today i seem to hear a knocking from idle to 5,000rpms, which is the highest ill push it. Now I know that a lot of of the W8 had issues with the torque converters. my current engine has just about 4k miles on it and I know vw warranties this motor up to 12k miles. That is not my concern, my concern is why do these motors keep failing under normal every day use in my particular vehicle?
View 2 Replies
I got a 2000 ford explorer with 151k on it... Since iv had the truck (5yrs) its always had a slight slip around 3rd going to 4th. The tran is auto!!
I use to be able to jump in and take off but here lately i have to let the truck idl for a few sec or up to a min before i can take off (warm or cold). This just started a month ago...
The trans fluid smells burned and it has be 2yrs since iv changed fluid and filter in the tran...Everything other then that iv kept up to par. What do you think should i start looking for something new or just change filter and fluid????
I know the truck has had a good life so I am starting to think the tran maybe trying to go.... My friend has a 85 dodge ram charger suv not sure the miles but its auto as well....It has a 318. Other then a small dent the thing look good... It has some kinda vacuum leak major but doesn't effect running. He told me the leak is from something he had removed when we left CA that they said he had to have for smog?
View 3 Replies
I have 142k miles on my 2005 RX330 AWD. This week I can feel the transmission slip/shudder when shifting from 2nd to 3rd gear.
My local transmission guy is pretty reasonable but like most salesmen he's going to say rebuild it the entire transmission in lou of something less invasive.
View 6 Replies
Car - 2011 Corolla S - Auto Transmission
My transmission seems to slip when it is shifting from 3rd into 4th. The second that it shifts into 3rd gear the rpm drops and shifts into 4th (This is when i have light to medium pressure on the pedal). If i push the pedal down 3/4 of the way once the transmission shifts into third then the rpm rise for at least 4-5 seconds (which seems more normal). In addition the shifts are a bit rough when the transmission is shifting up or down.I am looking for some insight before having a dealership jerk me around.
View 2 Replies
Started a while back and comes and goes. Only commonality I have found is the truck needs to be warmed up for it to happen and usually after a few hours of driving. The downshift from 5th or 6th into fourth, at times, produces anywhere from a light to violent clunk, feels like a typical tranny slip. It will do it while in cruise and it will do it if I don't have the cruise on. Can't figure out if it is going to be a tune issue or hardware.
It does it only downshifting into 4th from 5th or 6th, no other downshifting is a problem and usually the 6th to 4th produces the worst results. At highway speeds that is usually a shift from around 2Krpm to just over 3K rpm (6th to 4th) if it is from 5th it is about 2500 to 3K. Start from a stop and go WOT and there are no issues.
Having it in Tow/Haul or not makes no difference as far as I can tell. IT can do it on one hill and the next time be just fine or do it 2-3 hills in a row. After this last trip it will do it at 9K feet or at 60 feet elevation, didn't make a difference there either.
Another issue that may be hurting the computer is the truck originally came with the 235 tires, it now has 285's and the rear is only 3.31. I plan on going with 265's and maybe still a gear change to 3.73's in the future. I usually only notice this on long trips, first was a 1500mile hauling an ATV, second was last week during a 2500 mile empty. Although I have had it do it a few times locally. I figure those bigger tires can't be good especially with that high of a rear for the management system.
View 3 Replies
I have a 2001 Chevy half ton 4wd. It has the 5.3L, 4L60E transmission, and a 246 transfer. I am having problems with shifting. if I out the truck in drive, the trans will wind out in 1st gear and not shift. I then pull it down to 2nd and it will shift. When it comes time for third gear, it will not shift at all. It just simply revs until it catches up with the speed at which the truck is rolling. I thought it was a bad tranny as I smoked one and replaced it with a used one so we rebuilt the tranny and it still does the exact same thing. Also the speedo is not working but the odometer is on. Don't know if its registering anything but its on. I have also checked every single fuse and maxi fuse in the engine compartment and the drivers side panel.
View 1 Replies
I Own A 92 Chevy Silverado, 154 K Miles. Runs Great! My Problem? I Experience Rough Shifting At First Take Off, After She Warms Up The Shifting Is Smooth. After Parking And Starting Again, Rough Shifting With A clunking Sound.
View 9 Replies
1999 Jetta MK4 with only 124k miles on it. Everything is fine with the car except when the car shifts from 2nd to 3rd it is jerky/violent/forceful everything else is good with car except check engine light is on but I don't really care about that and I'll go check with autozone to see what the code is. I am able to feather the gas when I know its going to shift and I can make the shift pretty smooth. My question to all the experts is does this mean that this tranny is on its last leg or does it still have a lot of life left in it. My old Cabriolet did it for years and never was a problem.
View 5 Replies
After car warms and while driving trans moves to 3rd gear and stays ??
View 2 Replies
1993 Transport 3.8 L
Starting out from stop it seemed to get noisy and was very late shifting to 2nd. Slowed down and tried again; this time it did not want to shift to 2nd at all. Brought it home slowly.
Trans fluid was right up. I did another road test, running it manually through the gears so I could easily hear and feels the shifting. 1-2-D-OD perfect; did this twice of thrice. Starting out from stop on the highway a couple times, it shifted up perfectly. I did some kick-downs and manual shifting; everything is working fine.
Could this have been a linkage problem? Could running it manually through all the gears smarted up the linkage or something? Could it be related to the 'modulator valve'?
View 4 Replies
My friend has just brought a truck and has lost 3-4 gear in the auto trans. We have the PO782 code coming up. Is there something in particular we should look at first.
View 2 Replies
A couple months back I purchased a 2010 F150 XL with the 4.6 2V engine. It has about 112,500 miles on it as of today. The problem I am seeing is in the trans. Normally around town there is no issue other than it seems to shift from 1st to 2nd kinda quickly. That is of course you get on it harder, and then no issue at all. The real issue comes after driving for more than 30 to 40 mins. My wife and I took a little day trip that required about 45 mins of highway driving. The truck performed perfectly. Cruising at 75 to 80 there was no issue at all. When we reached our destination it was more stop and go type driving.
It was then I noticed that when pulling away from a light the trans was not shifting from 1st to 2nd smoothly, but rather with a jerk, or bump. Not horrible, but definitely noticeable. Again if I really put my foot in it it did not do it. All other shifts seem fine just 1st to 2nd. The trans temp gauge was steady in the normal range, and this was on a pretty hot day, in the 80s. Since I bought the truck used I cannot say with any certainty what servicing it has had, but judging from the condition it is in I would guess it was well taken care of.
View 1 Replies
My car recently started running overtemp not much, but enough to bother me. I flushed the system with no change. after about a week with continued symptoms, my trans started shifting hard between 1st to 2nd and 2nd to 3rd, and running rough in general, sputtering lightly in high gear. I assumed it was running over temp with the rest of the car, so I replaced the radiator and the radiator cap, yet still am having the same problem. Is it still related to the cooling system? if I replace the water pump will i solve my problems, or is it really a hidden trans problem? I'm fairly certain the trans has never been serviced, and I'm reluctant to do so given the high milage, 174,000. The fluid is full, but its very thin, and no longer red, its sort of a pale yellow.
View 19 Replies
My 2011 F150 limited started great bout 3 blocks away from home. The truck glitch. Then it wouldn't shift out of 3rd gear even at take off it was in 3rd. There was also a delay going from fwd to rev. With a clunk as it when in gear. I took it to the dealer ship. EVS Ford Random Lake WI. They were great fast and explained the prob to me. They had to reprogram the tranny. The temp sensor was wigged out n didn't know its own temp so it went into a fail safe mode.
View 1 Replies
I have a 09 f 150 4wd that i took in for a trans flush, the electrical bulkhead connector on the rear of the trans appeared to be leaking so i got the replacement part and asked the service shop to throw that in if possible. Two valve bodies were partially removed and the said part was still not accessible. i said No!!! put it back together and do the flush! s
So the flush was done (by a ford tech) and now the back up lights, rear parking aid, and rear view camera are all out of commission!
It has been in the shop for 2 days now and the flush was done a second time for whatever reason, now it wont come out of third gear. the shop owner called me to say i bought the wrong filter... I don't have the part number handy but i got it from oreilly. they say it is the filter for the 6r80 trans with the 21 bolt pan. does that sound right?
View 9 Replies
2009 corolla le won't shift into park. Disconnected linkage and works good. Lever at trans moves smooth in every gear except park.
View 12 Replies
I purchased my 2013 Ford F150 3.5L Ecoboost screw in December 28th 2013. I now have 12,000 miles on my truck. My transmission occasionally clunks in and out of gear. Mostly in stop and go rush hour traffic around 20mph. Dealer applied a PCM/TCM software update in July. Still clunks... possible 'slip bump fix' required?
When I 'punch it', I see what looks like blue smoke blowing out of the tailpipe. Tailpipe has soot buildup. I've also noticed a slight drop in MPG. I have NOT noticed a loss of power. Wondering if my truck needs induction cleaning?
View 12 Replies
2011 Corolla S 1.8L 4 speed a/t
I have noticed that when my car shifts from second into third gear at around 50 km/hr that the rpm drops twice. It shifts (almost seemingly to a 2.5 gear) and the rpm drops and then a second later it's like it shifts again and the rpm drops again, is this torque converter lock up I am experiencing?
This also usually happens when I give it light throttle and not when I am heavily accelerating.
View 4 Replies
For the last few months my truck shifts rough between 2e and 3e gear. However it only does this first thing in the morning, when I leave the house I speed up until the end of the street, then when I let go of the gas it'll rev up a bit and shift from 2e to 3e while making a big clunking noise which I can definitely feel ...
It does it sometimes very rough and sometimes just a little bit. I used to not worry about it but i'm starting to wonder if something is wrong with my trans. Could it have something to do with the slip yoke?
Truck: f150 2009 xlt 4x4 supercab 6,5' box.....
View 14 Replies
