Silverado :: 2005 - Loud Squeak Coming From General Area Of Torque Converter Or Drive Shaft
Sep 17, 2015
I've got a 2005 Avalanche (basically, a Silverado) which has suddenly developed a possible illness. Whenever I start the truck and begin moving (forward or reverse), I hear one (and only one) loud squeak that seems to be coming from the general area of the torque converter or drive shaft (but who knows exactly). The squeak doesn't happen immediately upon moving but always happens within the first 20-30 feet of movement and then no more. If I put the truck in park, re-engage the automatic transmission and start moving, I cannot recreate the sound.
However, if I turn off the engine altogether, restart the truck and begin moving, it happens again exactly as before. It happens every time the vehicle has been restarted, regardless of whether the engine is hot or cold. Once it's happened, I can drive hundreds of miles and it won't happen again until I turn off the engine and restart it. Further, I've determined recently that if I start the truck on a hill and let it roll while in neutral and without a foot on the brake, the squeak still happens. Therefore, it's not dependent upon the transmission being in gear or the brakes being applied!
View 5 Replies
Advertisement
I have a 2014 4WD Super Duty. It has a squeak that is coming from the drive shaft area. I had someone listen to it as I drove slowly next to them. It is a repetitive: squeak squeak squeak squeak squeak. Not loud. The frequency increases as speed increases. I could believe it may be a U joint based on the frequency, but seems hard to believe with a new truck. I heard this sound when I first got it, but the sound was so slight that I thought it was just some sound associated with a newer engine. But now it is becoming a bit louder.
View 4 Replies
I have just had my transmission rebuilt and torque converter replaced. Now the torque converter will not lock up. It turns 2700rpms @ 55 mph! The shop says it maybe my speedometer causing this because it is stuck at 20 mph. was this way before it went into the shop. I'm replacing the stepper motors next week when the parts get here.
View 14 Replies
After installing the lift on my 6.2 F250 I ran into the well known issue where the front drive shaft hits the catalytic converter. The two options I was told that I had was to weld in a slight jog into the exhaust guts to go around the cat or to get a smaller diameter drive shaft... I had the truck down at my local exhaust shop to have a new cat back system installed and I had the exhaust guy throw in his .02 about what to do.
He came up with a super easy/obvious fix. When the left and right exhaust meet up before the collector there is a welded brace that secures both sides together. He cut about .5" out of it and loosened the flanges and shifted the exhaust over. Welded the brace back up... Works perfect.
View 3 Replies
I have a 2004 Explorer 4.0L with 190,000 miles. My wife was driving it and the vehicle stopped moving. Sounds like the torque converter whining and will not drive in any gear or 4wd.
View 1 Replies
I have a 2005 Avalon Limited. A couple of weeks ago I put the car in reverse and I started hearing this loud buzzing noise coming from the rear window area. I narrow it down to the rear window sunshade. It also makes this noise when pressing the button to lower the shade and maybe sometimes rising it. I know it has something to do with the relay or motor when the signal is sent to it to lower it, because a lower the shade signal is sent when the car is put into reverse or button is pushed. How to find the motor or relay without taking the rear seat out. Right now I would rather just disconnect it to stop the annoying buzzing noise. Where can I find a service/maintence manual to maybe find out how to disconnect it.
View 14 Replies
I am having a minor problem with my 05 F150 Lariat. Under light acceleration going up a slight grade the truck sometimes shudders (vibrates?). If I let off the gas or accelerate slightly it stops. At first I thought it was a feedback loop with the electronic throttle so I had the dealer reflash the computer but that didn't fix it. I've noticed that it happens right about the time the torque converter locks (looking at the tach) and I'm sure it has something to do with torque converter locking up and then disengaging continuously. Funny thing, it seems to happen frequently on the same hill at the same speed. What was done to fix it?
View 14 Replies
I bought this 2010 f150 from the company I work for, front diff was shot, front drive shaft was in the bed, that's all I knew about the truck so I bought a complete front diff from a used place, it only has 58000km on it, good diff... So I installed the diff and the old front drive shaft, which doesn't seem to be in the best condition, now when 4 wheel drive is engaged I'm getting a constant clunk/binding noise from the front driveshaft area. Where to start looking.
View 2 Replies
It sounds like it is coming from the Hybrid Drive. It is really loud. I can hear it as I drive down the road. The best I can figure out from reading forums is it might be some time of coolant pump the drive uses. It starts as soon as I open the door before I start it and it will keep doing it after the car is turned off.
I've posted a video with audio on youtube....
View 19 Replies
Switch out a 5.4 in a F-250 4X4 4 my neighbor now I have a noise like fan blades hitting coming from the torque converter it goes and comes and hits good in reverse...
View 9 Replies
I remember reading on here about why our cars squeak really loud in the drive through and when we go slow etc.. I remember some people saying its the exhaust hanger and some said they were told its because our transmissions use wet clutches or something like that. The past few days I've been driving without my music and I've noticed that is a really loud squeak and its really starting to annoy the hell out of me.
View 21 Replies
So I was pulling out of the parking lot at work in first gear going about 10mph when I heard a loud clang and lost power to the wheels, I just had the car towed home and its dark out so i haven't gotten a chance to really take a good look.
My question is, how did this happen? the car is lowered on coils. I also Installed a B&M short shiftier about 3 weeks ago, i doubt it but could that have anything to do with this?
View 4 Replies
so my r32 recently started making a nasty popping noise. the sound seems to either be coming from something in the rear end or drive shaft. not sure why it happened. i went on a 2 hour trip. got there parked it. aired it down (bags) but then when i came back and when to drive it again. it all of a sudden it started making a horrible popping noise. i thought it was the front wheel bearing going out since i knew it need to be replaced but i did that today and its still making the noise.
The noise sound just like a RWD car with a welded diff when it turns. kinda has that locked rear end hop popping noise. i lifted the whole car off the ground and put it in first to let the tires spin in the air but of course theres no weight on them so it doesn't make any noise. i'm really stumped on what it could be. im going to take the driveshaft off and see if it still dose it. then i know its for sure in the rear end. What it could be?
View 4 Replies
I have Rx 330 2005 AWD, recently we dont have winters, so I don't need 4x4 . Is it possible to drive without the back drive shaft? It very easy to remove it, but is it save for e.g. differential or other mechanisms? By the way I could reduce fuel consumption, I think, 18miles/gallon is really too much for polish realities.
View 2 Replies
My mechanic tells me that the hold up or carrier bearings on the drive shaft of my 2005 Equinox need to be replaced. He says that about half the time this cannot be accomplished and that I might have to replace the entire drive shaft. From the research I have done, it seems that a press (?) and blow torches are needed to replace the bearings. I can't afford the new drive shaft, but I could afford to replace the bearings if I could find someone who was sure they could accomplish this.
View 8 Replies
My wife just bought her first truck, a 2008 F150 about a month ago. We have been driving it around since then and love the truck. The only real problem that I have seemed to encounter on the truck is a squeak coming from the front left wheel area. I can hear it when I cut the steering wheel and when I hit a big bump/pothole in the road. My dad and I have looked into it and he thinks that it is probably the axle joint where it goes into the steering knuckle/spindle. If it is this axle joint, is there a way to service/grease it and go on, or will it just simply need a new axle shaft?
View 1 Replies
For close to 6 months I drove around with a squeak that sounded like a bird chirping coming from my dashboard windshield area. I tried listening everywhere while driving and could never pinpoint the squeak that was driving me crazy. For whatever reason, I adjusted the rubber bumper stops for the hood and the chirp went away. I had to post this just in case there were others with the annoying squeak.
View 2 Replies
Where another 09 owner had what he thought was a cold weather related squeak coming from the passenger side dash / windshield area. Mine does this and it's highly annoying. Here's what I've observed:
- seems to happen in cold temps, though I can't say what "cold" is...<40F perhaps?
- noticeable over bumps or whenever the car frame twists as a result of uneven road surface
- source seems to be the dash / windshield interface on the passenger side
- it's *possible* it may be coming from the top of the windshield as well
- it's very noticeable and highly irritating
Either with an 09 or earlier model? I cut a pool noodle and shoved it down between the glass and dash hoping the pressure would relieve whatever is rubbing. It appeared to work until the temps dropped into the 20s. Then it returned. I have a 2009 GLS, 5MT Sonata.
View 42 Replies
I've been noticing some new noises in my Elantra in the last couple of months.
First, there's a clunking noise that sounds like it's coming from the steering area. It usually happens when I back up and rotate the steering wheel, like when I back out of my parking spot. More often it's in the morning.
Second, when I turn the fan on there is a high pitched squeal. If you turn the fan off you can hear the squeal more clearly for a moment as the fans die down. This one only started happening in the last couple of weeks.
I guess I'll have to take it in and get them to take a look. Last year it was a squeaking in the pano roof which only happened when it was hot out. They seemed to have lessened it but it wasn't gone completely.
View 13 Replies
I have a 2002 Corolla with a 1.8Liter 1zzfe engine.
I can hear a loud "rattle" at 1950 rpm from the drive belt area whether I'm driving down the street or if I rev it up while parked in neutral. It's not a tapping sound, more like a sheet metal rattle but I can't locate an loose sheet metal.
I thought it might have been the drivebelt tensioner. The plastic bushing on the small bolt cracked to pieces and I simply replaced it with a stack of washers. That's the bolt at the top of the piston that screws into the valve cover. I replaced the tension but still hear that rattle. I tried to locate it with a stethoscope but no luck.
View 7 Replies
I have a 2002 Silverado 1500 Z-71. In 4 wheel drive, I can hear a humming/rubbing noise from the front end. Not real loud, but enough to get my attention. It happens at around 25 mph, and just as I'm coming to a stop. This is on the street.....going straight, not while turning. I only engage the 4 HI during street driving on a straight line drive just to "exercise" the gears and transfer case. I don't notice it on the dirt 'cause of trial noise levels. All fluid levels are normal in transfer case and axles. How much noise is normal during 4 wheel drive operations?
View 14 Replies
