Silverado :: 2000 - Brake Lights Staying On All The Time
Jan 1, 2013
I have a 2000 Silverado 1500 4X4 extended cab with short box with a 5.3L. A couple weeks ago I noticed that my brake lights were staying on all the time. I removed the fuses for the trailer left and right lights and the brake lights went out. due to the holidays I haven't had time to find out why the lights were staying on.
Today I noticed that my 3rd brake light was staying on all the time, even with the truck off, and no one in the truck, and my electric brake controller inside the cab was on. I unplugged the controller from the fuse panel and the controller light went out but the 3rd brake light was still on. I couldn't find a fuse, so I removed the bulbs. Where I would start to find the problem.
View 8 Replies
Advertisement
My son's 08 1500 2WD truck has had problems with the cruise control not working correctly. Think I found out why, was following him today, and his brake lights came on. He was on an open road, no traffic, so I called him and asked if he was riding the brake with his left foot. He said No. Told him what I saw, and when he came to a red light, I told him to stab the brake 2 or 3 times, then let up. No change, brake lights stayed lit. He pulled into a lot, and unplugged the connector on the brake pedal arm. Then he turned on the key, brake lights were still on. Connector has 4 wires, I guessed one circuit for brake lights, one for cruise? Or is one for the transmission interlock solenoid that prevents shifting out of Park until you press the brake pedal? Getting ready to go check things with a voltmeter.
View 6 Replies
My brake lights are staying on all the time. I changed my brake light switch. This did not work. I took it to the dealer and they could not figure out what was causing this. They felt it could be a wire which might take them 10 hours to trace down @ $95 an hour. I don't understand how a wire could do this.
View 2 Replies
I have a 2000 Silverado 1500 4.8 liter v8. On my drive to work this morning the headlights and the cluster light shut off and the security light illuminated and has been on ever since . The truck will crank and run fine I have brake lights and turn signals and reverse lights. I have read that this problem can usually be traced back to the body control module. I located the TBC fuse under the hood and it was blown. so I replaced it with another 10 amp fuse and it blew immediately after I inserted it. So I am thinking if I am able to rule out a ground or bare wire somewhere then the module itself may just have to be replaced.
The next question I have is due to the security light staying on in the cluster all of the time. Assuming that I can continue to drive the truck while waiting to have the BCM replaced I would only need to ensure that I did not drive after dark as I have no headlights. But I am concerned that the security light being on all of the time will drain my battery. Do the security light remaining on will in fact drain the battery? And if so, is there a way to disable the cluster and door security light so that I may continue to drive it and not have to come home and disconnect the negative cable every
View 4 Replies
My interior lights are staying on all the time, What is the part number for the switch that I need?
View 1 Replies
I have a ES 300 H that I am loving so far. I have a question about the footwell lights. Are they suppose to go out after you close the door? Mine have been staying on the entire time while I am driving. If they are suppose to go off or not.
View 14 Replies
Happened to pop into my garage tonight and notice my brake lights on my 04 GLX won't turn off. I checked to make sure I didn't leave the main lights on or anything else I can think of. The only way I could get the lights to stay of was to pull fuse 13.
View 8 Replies
The car is off yet the brake lights stay on.
View 6 Replies
I have a 2012 Sonata for 4 years. In the past year I've experienced the ABS, Brake, TC lights staying on. Then had a bad battery and a headlight go out. Got all that done but after 4 months on new battery, it failed, and the 3 lights came on again. According to codes, dealer says the issue is a valve and they cannot give an estimate for repair but to tear down the valve and probe to find it, will cost me $132. That doesn't set well with me so I elected to drive on with lights on. They did say the battery & headlight issues were not related to the 3 lights staying on.
View 1 Replies
2000 Mercury Villager tail lights stay on: This car is supposed to have a tail light relay. But I don't know where it is,accept 'main junction box' but I don't know where that is and which component would be the tail light relay.
View 13 Replies
2000 Excursion 2WD 6.8L V-10. Dashboard brake light has come on and is staying on. Fluid is up in reservoir visual on lines and calipers appear in standard nick. Bad brake light switch?
View 2 Replies
I have a 2000 Silverado 1500 replaced calipers, master cylinder, and ABS Pump/Modulator. Bled all four calipers. Brake pedal spongy and has very little pressure and travels all the way to the floor. What am I missing here?
View 8 Replies
I broke my emergency brake cable on my 2000 chevy silverado. It broke before the cable splits to two wires to go to the two rear tires. I would like to know if this is something I can handle myself. My biggest question is how I get access where the wire attaches to the pedal itself.
View 2 Replies
I've got a 98 Silverado. Break lights and rear turn signals won't work but tail lights and reverse lights work. Also the brake light on the cab does work.
View 6 Replies
I have a 1999 Silverado. I have noticed the AC stays on even if the light is off. Is this normal?
View 5 Replies
All dash lights and gauges went crazy with a picture of battery in screen and then stopped working for a few miles before working again. I was cruising @65 and this happened and downshifted to 2nd then quickly to 3rd and wouldn't shift again. Stuck in 3rd gear.
Had it scanned and got
P0740
P0753
P0758
P0785
All shift solenoids. Would I just buy a new valve body with new solenoids?
I would occasionally have the gauges go crazy and battery light go on but would go away and not have any codes stored. It would only do it towing and always thought it was a ground issue with th
View 10 Replies
my 99 durango's brake light and abs light came on at the same time could these have anything to do with each other?
View 14 Replies
My B5 has all three brake lights coming on (including top highline brake light in estate model) when the headlights are turned on. When the brake is pressed, they all stay on and glow a bit brighter.. Is this normal?
When the headlights are not turned on, the brakes work ok with all three rear red lights only coming on when the brake pedal is pressed.
View 2 Replies
I start the car and everything looks good. I drive 10 feet and the ABS and Brake light come on at the same time. I replaced the "ABS CONTROL MODULE UNIT COMPUTER" that was under the dash by the steering column but that didn't work. Brakes feel firm and strong. Breaks well. What next?
View 19 Replies
I changed the bulb in my driver side brake light - routine -done a zillion bulb changes on my car. This time however the dashboard lights up every time I brake!! What gives? Something to do with the brake pedal triggering the brake light button in the footwell area under the dash? Its a 2000 Passat 1.8T sedan - manual tranny.
View 5 Replies
A couple years ago my car got stuck in Park, in which I had discovered my brake lights and a few other electrical fuses blew at the same time. It has happened randomly about 4-5 other times since, in which I take it back to the dealership and they "fix it" temporarily. After about a 1 1/2 years of no trouble, it happened again, and the dealership traced it back to the GEM module, which they replaced for me. Electrical components I forgot I had (like automatic locking doors) came back- for about a week. I got stuck in Park again, lost my break lights, as well as some other functions. I haven't noticed this problem on the focus with other discussions. Now it has added to much time in the shop, multiple FORD dealerships unable to fix it properly, and lots of wasted money. Shouldn't a new electrical unit fix the problem?
View 6 Replies
