Silverado :: 1999 - Stuck In 4hi - 4wd Light Comes On?
Jun 29, 2014
My truck is stuck in 4hi when I turn the key on service 4wd light comes on. A when I push 2 hi it flashes. tccm clicks then I hear a humming/buzzing coming from the to shift motor an stays in 4hi I can push 4 auto an It goes into that but no 2 hi or 4 low I have two 99s so part are easy to get so I swapped out the dash switch with a working one from my other one. No change . Swapped out them (transfer case control module) no change. I believe my actuator is working as it should I hear it just like my other working 99 4wd system so I thought it's gotta be a bad shift motor but after reading lots of posts here I'm thinking a bad wire? Any input welcomed to have an appointment at the shop the 7th of July if I can fix it before then I'll save 200 bucks what colors are the problem wires that every one has? An is there a way to get it into 2wd if i cant fix it myself?
I haven't check my fluid yet I haven't run it for codes I tried but the checker didn't have the stuff to get to transfer case data
View 14 Replies
Advertisement
I have a 1999 Silverado. I have noticed the AC stays on even if the light is off. Is this normal?
View 5 Replies
I have an old base model 2001 Silverado, so manual everything. Here's my problem-- the air direction control knob (feet, defrost, face, etc.) is stuck on defrost. Literally stuck. Obviously, the knob attaches to and is supposed to turn a metal rod that then changes the direction of the air flow, but the rod will not turn at all...I even detached the knob and tried to turn it with a pliers! The climate control and fan speed knobs both work. What might be causing this?
View 6 Replies
Like the title says, my 99 ranger has the door ajar light stuck on, which in turn is making the dome light stay on. It's kinda been acting up lately, but would go out eventually. Today I washed it and had the doors open for a while. After I shut the doors and started it the light stayed on and hasn't gone off since. I pulled the negative cable tonight. And no, the doors aren't open! FWIW I cant pull the doors any tighter closed and make the light go out..
View 6 Replies
My question is my abs light came on so I stuck my computer on it. Said right rear , we'll we all know on a 2007 6.0 f350 4X4, the there's only one sensor on the pumpkin, so I replaced it and cleared the code. Abs light came back on once I started driving, week ago my right front caliper stuck and got very hot, could that read bad for the rear of the front went bad? Will pull plug and make sure I didn't bend any pins.
View 2 Replies
I recently had my fuel gauge stuck on full and at around the same time, my left rear brake light doesn't work. I do have LED brake lights in the rear so I am not sure if that changes anything. I thinking something with a ground or is it possible that these aren't even related.
View 2 Replies
I have a 99' silverado and last night the ABS light came on and will not go out. Also the emergency brake is way out of adjustment. I can put the emergency brake on and it goes to the floor, however it doesn't really hold. I'm really concerned about the ABS light.
It is a 1500 5.3liter ....
View 14 Replies
This is on my g/f's 04 silverado 2x2 started about a month ago. Light comes on after rolling a few feet and right after hearing the abs pump run for a second. Then the light pops on, but the brakes feel fine. Only thing I tried so far is to clean the ground wires under the drivers seat but it's still doing it. I know when my sensor(s) went bad on my 00 the abs pump would kick on when stopping! not fun at all, but like I said it stops fine, just the little pump hum then the light.
View 4 Replies
recently my check engine light came on, I had the codes read, the tech said that i had air getting into my fuel system, i replaced my gas cap. my light is still on, he also mentioned some kind of emissions sylinoid may need replaced, or a vent valve idk.
I recently drove up to Sandusky OH for the weekend, my light didnt come on til i refuled with gas containing 15% enthenol. the engine is running fine, no miss, has good power. I ran it down to a 1/4 of a tank and filled back up and the light is still on.
View 4 Replies
I have a 2003 silverado 1500 4x4. The check engine was on along with the abs light. I went to advance and let them tell me what was going on. I don't know the specific code but it said the passenger front abs speed sensor was bad so I replaced it along with new brakes, rotors and calipers. Now the abs, check engine and red brake light is on. There is also a message telling me that the brakes need serviced. I went back to advance and let them tell me once again why those lights were on and it was still the passenger speed sensor bad. What could be going on with it? Before it was replaced the red light never came on but now it is.
View 10 Replies
I purchased the vapor canister vent valve and purge valve as the service engine light has been on and this are the contributors. I want to know the location of these and how to access. It appears that they may be by the fuel tank and I don't know if I need to lift the box or something to access them. It is the 5.3L V8.
View 5 Replies
I have a 2000 Silverado 1500 4.8 liter v8. On my drive to work this morning the headlights and the cluster light shut off and the security light illuminated and has been on ever since . The truck will crank and run fine I have brake lights and turn signals and reverse lights. I have read that this problem can usually be traced back to the body control module. I located the TBC fuse under the hood and it was blown. so I replaced it with another 10 amp fuse and it blew immediately after I inserted it. So I am thinking if I am able to rule out a ground or bare wire somewhere then the module itself may just have to be replaced.
The next question I have is due to the security light staying on in the cluster all of the time. Assuming that I can continue to drive the truck while waiting to have the BCM replaced I would only need to ensure that I did not drive after dark as I have no headlights. But I am concerned that the security light being on all of the time will drain my battery. Do the security light remaining on will in fact drain the battery? And if so, is there a way to disable the cluster and door security light so that I may continue to drive it and not have to come home and disconnect the negative cable every
View 4 Replies
I have a 2000 Chevy silverado. I recently was having problems with the transmittion not switching correctly. Long story short the shop told me to fix the problem I had to put in
A new transmition as well as a new computer which I did, from another Chevy. It worked for a few days then The truck was not starting and had security light on. Had alarm specialist take look and he said the computer had to be reprogrammed. It was reprogrammed at merles. And was still not working. Its unable to start, starts at random once in a long while. ignition switch was changed and still gave same problem. Took to another shop they had a specialist take a look and he said the computer had to be reprogrammed again.
Also would it be possible to bypass the anti theft system by adding a remote start, or cutting some wires. I just really need to get this truck running.
View 14 Replies
Ok so I just replaced my mass air flow sensor about a week ago. My check engine light just came back on and when I scanned it it said mass air flow sensor. What could be causing this to happen again? The codes are P0102, P0440, P0440.
View 4 Replies
First of all, its 5.7L V8, it's been very well maintained, I've had my fair share of problems but nothing that has been that serious, except for the "check engine" light for the O2 sensor.
For about the last 4 months i've had the problem of the truck sometimes jerking while on the road. Once i started to speed up it seemed to not speed up which when it did, it jerked a bit. That was in the beginning.
AS OF NOW, the jerking has stopped but every now and then when i pull out of the garage and start to turn onto road it turns off, but all the status lights are left on. & when turn the key to turn it off and restart it starts again every time. Ive noticed that i was better off with the "check engine" light on then now because every time it is off it has these problems.
Also, when I barely start to tap the brake, again not all the time, sound skips on the radio. & this always happens when i tap on the brake & this happens more frequently when the "check engine" light is off.
View 3 Replies
I just bought this used truck, 2005 Chevrolet Silverado 1500 extended cab. I noticed some shaking while in idle when I got it back home. The check engine light came on a day or two later, and I recently had a diagnostic test ran on it at the local AutoZone. It came up that I had a P0135 o2 sensor (bank 1 sensor 1) malfunction and a P0101 Mass Air Flow Sensor signal performance issue. The check engine light comes and goes. I stopped by Walmart for about 10 or 15 minutes and when I got back into the truck, the issues reoccurred. For about a minute, the check engine light actually started blinking! And then went away and started running normal again. Its upper confusing. I bought some MAF cleaner to use on it tomorrow and figured that wouldn't definitely clear up my issues, but I'm still wondering if the MAF sensor is enough to warrant the CEL to blink like that?!
View 6 Replies
What the fuel pressure range should be for a 1999 5.3L?
View 10 Replies
I have a 99 silverado 4x4 with a 5.3l that has 118,000 miles. I just noticed the other day that my tow/ haul button is not working....I really do not tow much, but i would like to get it fixed. where does to go from the lever??? is there a sensor or motor to engage this on the tranny somewhere or is it built in the tranny???... is this a major deal or should i leave it alone and deal with it being broken???
View 14 Replies
I have a 2001 chevy silverado 3500 6L gasoline engine.
I have been getting a P0307 random multiple misfire #7 on and off for a few months now, occasionally the P0300. Check engine light comes on when I am going up hills, often under heavy load and sometimes when the truck is cold in the morning and the truck starts to run rough until the code clears, which it does pretty quickly usually. I have replaced coil, crank sensor, cam sensor, fuel injectors. If I unplug the battery overnight the code will be cleared and the truck will be running just fine the next day.
View 6 Replies
I have a 2001 Silverado and for some reason all the dash lights on come from check engine to the abs light gas gauge goes to empty then back to normal 9 times out of 10 these lights come on. It has done this for a while and doesn't effect how it drives, I am possibly wanting to sell it and cannot explain hat it runs fine with this problem. Where do I start to figure this problem out .
View 4 Replies
I was driving my Chevrolet Silverado 1500 4 wheel drive single cab when it sputtered a couple of times I came to a stop light and the car stopped I tried starting it to no avail. I also noticed I did not hear the fuel pump run as normal when truck is in accessory position . When my buddy showed up I had him try and start the truck as I banged on the gas tank and it would run when I stopped so did the truck...
View 2 Replies
