Silverado :: 1999 - Gas Tank Filler Tube Vent Hose Connection Location
Oct 19, 2013
I have a 1999 Chevy Silverado 6.0 Ltr C2500 Auto tran Large Gas tank 120,000 miles. My gas tank filler tube vent hose has come off of its attaching point. It is still connected to the filler tube. I can not see where it connects on the other end. The small hose is long enough to reach the rear bumper on my truck noticed it hanging over the differential on the ground. Where to reconnect it to. I do have a check engine light showing. I fear my truck is falling apart slowly.
View 2 Replies
Advertisement
I recently purchased a used 1999 F250 Super Duty with about 150k miles on it. The truck runs great and I have no complaints but there are a few things that need to be taken care of. It looks like there is a very small fuel leak where the filler neck ties into the rubber hose that runs into the fuel tank. There is a thin film of diesel along the side of the tank, on the leaf spring, the air bag and various other places. Nothing is dripping. I want to drop the tank and replace the hose. The Haynes manual says to depressurize the whole fuel system--is this really necessary if I don't plan on doing anything to the system aside from dropping the tank?
View 2 Replies
Mine was clogged again, and I check it every month.
View 14 Replies
After my accident this summer with the Ex and TT, I have a fuel leak. It appears to be coming from the hoses between the filler neck and tank.
The part # from Ford for the neck and hoses is YC3Z-9034-AA. This part is no longer available! Even NAPA the go to place and pay thru the nose for shows it as obsolete from their vendor.
I am seeing RED at this since I had zero leaks until the body shop dropped the tank to replace the hitch. The BS and INS co told me prove it was not a dry rotted house and they would pay for it. What to do for the hoses?
View 5 Replies
My a/c vents smells musty/moldy when A/C is turned on, searched the FTE site and everyone says to check the A/C drain tube to make sure it is not clogged, I have searched all over top and bottom with a flashlight for the drain tube and swear there isn't one. I think it should be on the bottom of the condenser box but just do not see it. Where it is located? The vent smell is Awful!
2000 F350 Super Cab 7.3 Diesel
View 6 Replies
I got seafoam intake and engine cleaner spray. In order to use it I need to remove the hose which connected to the throttle. How can I remove easily w/o removing any part like grill, bumper etc.?
View 2 Replies
There is a tube/hose going from the air intake duct to the rocker arm cover.
I need to replace it but don't know what it's called to look it up.
View 6 Replies
i have a 1972 fiat abarth and the gas tank has the larger filler hole for the old leaded gas fille nozzles Can i buy an adaptor for the gas tank filler hole to accomodate the new skinnier gas filler nozzles?
View 8 Replies
I was looking around under the hood and noticed a plastic T with two rubber hoses attached, and one end of the T open with no hose. This is on the drivers side in the engine compartment toward the fire wall. Why would this not have a hose on it or at least some type of filter?
View 5 Replies
Been having an oil leak issue and found where it is coming from. Now the only issue is that what this is called. I do note believe its the hose but the connection to the hose. I attached a couple of images so that yall can take a look. This is a VW beetle 2006. 2.5 L 5 cylinder.
View 3 Replies
I have a new hose I need to install because the one on now is cracked... I have pulled the metal clip down, but how do I remove this so I can install the new one? I don't want to break anything else yanking on it too hard.
View 5 Replies
My front differential on my 97 Silverado Z71 sometimes vents some fluid out of the vent tube. I end up smelling it in the interior while driving. The vent tube top is above the top of the radiator and has the little cap on it. The first time it did it, was during a heavy rain. I had it in 4wd on the freeway doing around 60-70 mph. I figured it was because I was in 4wd. It did it yesterday after a 35 mile drive on the freeway again, but I was in 2wd the whole time. Outside air temp was over 100 degrees and I am using Royal Purple fluid. I checked the level a couple of weeks ago and it was below the fill plug about 1/2 inch.
View 5 Replies
I was pulling a motorcycle trailer down the interstate about 75 mph for about 4 hours. When we got home I noticed it looked like there had been an oil leak. I looked underneath and it appears like tranny fluid spewed out of the top vent tube on the tranny. I have a 4x4 with a Automatic overdrive. It was tranny fluid and it does not appear that it was low on the stick when I checked it. We were pulling some hills and it would downshift but it seemed to be working fine. Seems to still work ok. We had the tranny rebuilt about 50,000 miles ago.
View 4 Replies
My 98 mountaineer keeps throwing rear end oil out the vent tube.. Why does it keep doing this?? its been doing this for a while and had to change an axle seal, I think because of this. It stopped doing this for a little while after I changed the seals and put in new oil.. Its not over full.. When it stopped I figured it was because the oil was old and was foaming or something.. But now its back to doing it again... The tube is not plugged.. Why does it keep doing this???
View 3 Replies
I've notice a milky substance on my oil cap and inside the tube where you add the oil, what can be causing this. 2001 Silverado 5.3.
View 4 Replies
New to me 2003 F250 Super Cab 6.8 V10. Great condition inside and out. 68,000 miles. Began smelling fuel (gas) a few days after driving it 250 miles from purchase location. Traced leak down to the top of the gas tank. Staining was visible around the rear vent. Applied about 5 psi to the tank and sprayed soap around until I saw bubbles coming from a hairline crack at the rear vent connection. Its where the fitting for the hose comes out of the tank.
My first choice would be to hot weld the crack. I'm not very comfortable with the idea of a heat source near a gas tank. I'm not sure, but the heat from the plastic welder might be hot enough to ignite fumes? Second option is to try some industrial 2 part epoxy (PIG) and seal it with that. Is there pressure inside the tank, and if so how much? Can try this fix with epoxy or JB Weld?
View 5 Replies
I decided to install a new Optima yellow top battery because I performed the battery check and found the voltage low and therefore believed my 2008 was still running on the original OEM 12v battery. Much to my surprise I found a non-OEM battery installed and the vent tube elbow missing!
View 10 Replies
Ok, I have a 98 F150 XLT, standard cab, 8 ft. bed, 2WD with limited slip - if any of that makes a difference.
The rear axle vent tube is literally blowing oil out the top, where it's loosely connected to the bed. It does this every few weeks. I pulled the hose and ran a rifle cleaning rod down it to make sure it wasn't plugged ... it wasn't.
It seems like it's building up pressure somewhere, then blowing all at once, but why?
View 13 Replies
I own a 2004 F-150 FX4 5.7L V8, I notice this morning that I had gear oil coming out of my rear Axle Vent Tube. What would cause this issue? I'm kinda at a loss as to what would cause it.
View 3 Replies
Having this problem, what to do to correct it? There is no hole in the boot and this just started about a year ago. Does not do it all the time.
View 4 Replies
How to get the boot or hose off the egr delete tube without having to tear everything apart? mines leaking i have new hose to replace just not sure how to get the old one off...
View 7 Replies
