Silverado :: 1996 Will Not Shift Out Of First Gear - 4l60e Transmission
Dec 27, 2013
I have a 1996 Silverado and it will not shift out of first gear. I have had the pickup for about 6 months and when I got it, it would shift if I accelerated to about 30 and let off but then I went though some mud and got stuck, I kept shifting from reverse to forward and I got out of the mud and it would not come out of first but reverse works fine and it will not shift manually at all the pickup has a 4l60e transmission.
View 5 Replies
Advertisement
97 Silverado - 5.7 with 4l60e trans. truck will not shift into 2nd gear while driving. stays in first gear until rpm are high and shifts into 3rd. under hard acceleration will stay in 1st until let off gas then shift into 3rd. manual shifting results in same, no 2nd gear until selector is moved into 3rd then shifts into 3rd. Haven't got any trans codes, fluid change netted no change in performance, fluid was pretty dirty but didn't smell burned, and there were no metal shavings in pan.
View 9 Replies
I have a 98 Chevy truck with a 4L60E. It has no second gear. I was sitting in park for about 10 minutes with the engine running, then put it in drive and it never shifted into second. It felt like it went straight to 3rd. I played with it manually until I figured out I had reverse, 1st, 3rd, 4th and torque converter lockup, just no second gear. My acceleration rate was medium and when I reach about 27-28 mph it would shift from 1st into 3rd. It has 230K on it so I rebuilt it with all the typical parts - frictions, steels, band, sun shell etc., still no second. I then pulled the pan back off and replaced the spacer plate and put in a shift kit. While I had it down I put a corvette servo in and did an air check. It worked fine. I could feel the band tighten.
Both the 1-2 and 2-3 solenoids checked good at 23 ohms. I swapped their positions to see if it would make a difference. I also checked to make sure the 1-2 accumulator piston wasn't stuck in its bore, the spring was new from the shift kit. It was fine. Put it back together...still no second gear. When I originally pulled the pan off for the rebuild, the pan was free of any debris and was very clean. I then drove it a couple of miles to a local transmission shop. They put their scan tool on it and drove it around the block. There were no codes and the ECM was calling for second gear. It doesn't sound mechanical since almost all the parts have been replaced, rebuilt or inspected that affect the 1-2 shift. It sounds electrical. Is there anything I have missed?
View 14 Replies
i am having problems shifting. it wont shift into reverse all the way and when its in drive it has a hard time shifting from first to second gear and wont shift into third.
View 1 Replies
My dad's 1996 Chevy Silverado will not shift into hi gear. The truck starts up fine and he can drive it but for some reason it won't shift into hi gear. Him and I are clueless as to why it won't. He has a 1996 Chevy Silverado, 6.5 liter V-8 automatic transmission, and its a diesel. We really want to fix the truck ourselves so we are trying to avoid taking it to a shop.
View 2 Replies
[URL].....................
If I accelerate gently and keep the rpm down to about 2500 or less, I get a normal shift from 2 to 3 and I can then accelerate with vigor without any apparent problem.
If I accelerate the way I normally drive, at the 2 to 3 shift point the transmission misses the shift and I have to let off the throttle for a few seconds and wait for 3rd to engage. I usually see no codes, but once in a while P0758 reappears.
Both solenoids A and B have been replaced, as described in the thread referenced above.
More symptoms, and maybe this is a vital clue: the 3 to 4 shift is fine, but I've noticed that lockup takes a while to occur. When locked up, I normally see almost exactly 2000 rpm at 70 mph. I am seeing about 2150 rpm at 70 mph until lockup finally takes place, but I can't say exactly when it does happen---I have to watch the road now and again.
I understand there are a 3-2 solenoid and a pressure control solenoid, but I don't know enough about their purposes to decide that either needs to be replaced.
View 12 Replies
I have a 1994 C-1500 4.3L with a 4L60E transmission. After driving for 30-40 minutes it loses 1st gear and you have to manually shift between gears. R, 2, D and OD can be manually selected but there is no automatic up or down shifting. There isn't any gear slipping prior to this. After sitting for 25-30 minutes everything works fine. I have noticed that sometimes before the problem occurs that if i manually select 1st gear it will stay in 1st & sometimes it will automatically shift to 2nd even though the gear selector is in 1st. Also it usually shifts into D at about 30 mph but sometimes it stays in 2nd until I manually shift down to 2nd and back up to D. It isn't giving any relevant codes (use jumper & flash codes). I'm thinking possibly faulty solenoid(s), but not sure.
View 2 Replies
On my 96' F-250 4x4, The tranny will shift to 3rd gear and that's it. If I put it in Neutral and then back into drive it will stay in 4th gear for about 15 seconds then go back to 3rd. What could be causing that?
View 14 Replies
Truck has 222000 miles on it. With gentle acceleration not noticeable, with maybe half throttle rpms increase for say one second or two and then shifts smoothly into third, However at full throttle with the shift coming at 55 mph or so, it shifts perfectly with no slip. It also acts the same manually. I had asked my mechanic about changing the fluid and if it could fix the problem, he said, "well it could work or hurt it." After thinking about it, we decided to change the fluid. He did a full flush and cleaned out the pan which had lots of sludge in it but no pieces of metal in it that would seem to indicate a major internal problem. It doesn't seem to have made it much worse if at all, but did not fix it.
View 1 Replies
I hve a 89 Chevy Silverado Z71. Transmission will not shift out. It's only a little over a year old. Got it from Advance Auto Parts.
View 8 Replies
1996 dakota v8 automatic 4x4. tranny rebuilt 3 years ago got stuck in the mud and every since then it is stuck in first. wont shift no matter what i tried to adjust the tv cable and it didn't work at all. don't know much about dodge transmissions iv always worked on 4l60e in chevys. I don't know were to start. Where to start. iv been reading about the governor valve and shift selnoids are there any way to test any of this? first pulls strong and reverse works
View 1 Replies
When I shift the car to drive it revs up to 3 or 4 rpms but only goes about 10 to 15 mph. It doesn't produce power like it should.
View 1 Replies
I have a 2001 Chevy half ton 4wd. It has the 5.3L, 4L60E transmission, and a 246 transfer. I am having problems with shifting. if I out the truck in drive, the trans will wind out in 1st gear and not shift. I then pull it down to 2nd and it will shift. When it comes time for third gear, it will not shift at all. It just simply revs until it catches up with the speed at which the truck is rolling. I thought it was a bad tranny as I smoked one and replaced it with a used one so we rebuilt the tranny and it still does the exact same thing. Also the speedo is not working but the odometer is on. Don't know if its registering anything but its on. I have also checked every single fuse and maxi fuse in the engine compartment and the drivers side panel.
View 1 Replies
Replaced Troque Converter, Truck runs engine runs fine transmission won't shift out of 1st gear.
View 2 Replies
I have a Ranger that I have put a 302 engine with an FMX transmission in...everything seems to be working correct except the transmission will not shift in to 3rd gear... don't know alot about transmission.. could this be a linkage adjustment issue?
View 6 Replies
I get a hard shift into second gear, it jerks into 2nd but not all the time. I only notice it after driving on the freeway for several miles. It has 60,000 original miles. Service Engine Soon light come on after the hard shifts with a transmission fault code. I reset the Engine light and let it set 20 or so minutes and it shifts like new.
1997 CHEVROLET TRUCK S10 2WD
6 Cylinders 262 X 4.3L SFI
Automatic
View 13 Replies
My 2002 Camry has an automatic transmission that works fine except when it is about 20 degrees or colder. The problem is that the transmission does not want to shift from first to second gear. After about ten minutes things shift normally. Other than that I have had no issues with the transmission.
View 3 Replies
My 1997 Saturn SL2 with 5 speed manual transmission won't shift into first or second gear. When I shift into the location where first would be the car is in third gear. It shifts into 4th, 5th and reverse just fine, though the shifter is in the wrong position for those gears. I can wiggle the shifter in neutral and get it to move into the position where 5th and reverse are normally found, but it is stiff and makes a clunking noise when I move the shifter over to the far right side.
I have removed the center console and the bushing appears to be intact. Both cables are in their proper positions inside the vehicle and at the engine. One of the cables (the top one in the engine) has some wear and tear on the boot, but does not appear to be binding. Other than the stiffness and the clunking noise, the shifter seems to be working fine too.
View 8 Replies
I have a 36 foot motor home on a 2000 Ford F53 chassis. (similar to single axle freight trucks and school busses) After getting one set of the rear wheels partially stuck, which resulted in some spinning of that side, the overdrive off light on the shift lever began to blink and the service engine soon light came on. The fault code said, "speed sensor showing more than one mile per hour". Now the automatic transmission sometimes will not shift into first gear after stopping and has to be manually downshifted, after which, it works fine.
View 1 Replies
when the jeep warms up the transmission wont shift out of second gear.it is an automatic.had solenoid packs replaced and no mechanic has an idea.external cooler has been mentioned along with replacing pcm.
View 2 Replies
I have a 99 passat wagon - it hasn't been shifting right - sometimes it won't shift out of park, other times it won't sift out of 1st... we are wondering if it is worth fixing or if we should find a different car...
View 3 Replies
