Sierra :: 1991 GMC 1500 Won't Start - Not Making A Clicking Noise
Jul 8, 2011
I'm working on getting my GMC seirra 1500 5.0 L running. Last fall When I was making a trip to another town, it broke down. When it broke down it smelt like plastic was burning, I was unable to figure out what the smell was.
First I though it was a bad battery connection, or that the starter had went.
I changed the Battery, made sure the cables were good. changed the starter and it still doesn't work.
I know the battery is working for sure because There is power to the lights so I can turn on the brights. There is no power to anywhere else on the dash though other then the icon that shows the brights are on.
When I try to turn the engine over, nothing happens at all. Doesn't even make a clicking noise.
View 1 Replies
Advertisement
2001 sierra 2wd ext. cab. over 300 km. 5.3 motor auto .... Battery charged, everything is working when key is on, but nothing happens when key is turned to start. Clicking noise can be heard in 5 pin fuse relay located on left side dash fuse panel.. How do I check it? Could have something to do with anti theft system?
View 3 Replies
I have a 91 Nissan pick up that is just making a clicking noise upon trying to start it. I replaced the battery. The inside light works, radio works, dash clock works, but still just clicking upon trying to start. Is there a clutch safety switch that could cause this, or starter, or ???
View 8 Replies
I just purchased a 91 sierra sle with the short bed. I am interested in buying a cap for it because the snap on tonneu cover is falling apart and id like a cap. Would caps from other full size short bed pickups work or does it have to be from a sierra/silverado?
Also i notice the oil pressure fluctuates from around 20 to 80 depending on if I am idle (20) to acceleration at 80, when driving it seems to go up and down to depending on the accelerator position. is this normal??
View 3 Replies
I have a 1991 gmc 1/2 ton with 200K on it. Its a 350 engine. The engine has been stumbling for a long time. I've tried many things ...new fuel pump and filter...complete tune up.....checked all vacuum lines..replaced a couple lines...EGR valve.....changed head gasket and intake gasket. Checked the warm up flap inside the air cleaner. I am now very very frustrated.
This stumbling happens often but intermittent also....sometimes worse than other times like the truck is about to stall. The truck seems like its being held back like a loss of power. The truck will begin to stumble so i will pull over and rev it up and it seems to clear itself for a short while then right back to stumbling.
Upon warmup in the morning she seems to run fine until hot. No codes being thrown ...service engine light NOT on. Even while at a stop i will hold the throttle part way and revs at different rpms. I am now at a loss and feel defeated.
View 7 Replies
My belt was making a screaming squeaky noise to wake up the dead. I used dish soap on it and it got quiet as long as I remember to bring the dish soap. My mechanic looked at my AC and told me I need a new compressor (he is a friend I trust) Now the AC comp turns but the belt seems to go on and off. And, the weird thing is-the AC feels great! Am I to expect any moment for it to just stop working? So, what to expect from my dead or dying compressor?
View 18 Replies
1985 GMC Sierra 2 wheel drive. Truck sets lower on drivers side about 1 or 1.5 inches. Very noticable. Put new coil springs in front and 4 new shocks on. Back springs are original heavy duty with six leafs. Nothing noticable. don't know what to do. This truck is all factory original.
View 2 Replies
This truck has 180km on it and runs fine except as of lately i have developed a surge while at constant speed. When i step on the gas it does not seem to happen.....it only happens when I reach a constant speed. The odd time it will surge at idle and the engine will rev up and down on its own also. When at highway speed it seems to not do this. The truck never dies completely....just surges slightly.
View 9 Replies
I just bought this nicely used 1991 GMC Sierra 1500 series pickup truck for $650. It started up and ran fine when I gave the seller the money - the few leaks in the break lines.
Easy fix right!
So my son (19 that knows it all) and I went and changed all the brake lines (made everything one size 3/8 line.) Filled it up with break fluid and started the truck. I had my so pumping the breaks and holding them (his first time) I bled the far rear (passenger side) then I had him turn the steering wheel to the right so I could bleed the front driver side.
He turned, and turned and turned until the engine died.
Now the truck only runs when the steering wheel is turned all the way to the right or all the way to the left.
Going to pull the codes to see what the heck is going on....
View 9 Replies
I've got a '96 Sierra manual transmission with 215K that's been running fine. I just ran it 400 miles without a problem. Recently I downshifted into fourth to go up a hill and I had a sudden loss of power and a rough ride like I had a flat tire. The harder I press the gas the rougher the ride and it idles almost normally. The check engine light came on and blinks 12 times.
View 1 Replies
I have a mazda 3 and i just tried to start it but its just making a clicking noise. The radio works so does that rule battery out....
View 4 Replies
Accidently ejected my map dvd...located just under my Nav screen under a piece that has Lexus on it. It slides right up and the dvd came out. Cant get it to stay in now. Only makes clicking sound! So frustrated. How do I get the dvd player out? Removing the dashboard? My dvd player isn't in the dashboard though!
View 1 Replies
I have a 1995 volvo 850 t5. Basically, the engine is making a clicking sound. Immediately on start up, which continues when i drive. In saying that, I've been only doing 5 minute drives so perhaps its not running long enough to go away.
So today, i started it. Car starts ticking. The ticking is like 3 or 4 seconds apart between clicks, and the idle seems to change slightly each time it clicks.
I checked the oil and it was a little low. So i put 2 litres in, and then i ran the car (idling) to see if it would go away. Just for a few minutes. It did seem to go away, but then i gave it a little rev and it came back.
So in summary, clicks on start, idle and while driving. Idle changes slightly between clicks. And there is a few seconds between clicks.
Just checked it again. If i leave it idling the click stops but as soon as there are more revs, it comes back. And the noise is almost like the click of a switch (like when your kettle finishes boiling and the switch flicks off. Not the best comparison but similar).
View 5 Replies
I recently did all new suspension on my caprice...new springs all around...new shocks all around....all new ball joints and all the tie rods brand new too and new sway bar... after installing everything i took the car to the shop and they did alignment and said they checked everything out and said i was good to go. The reason i did all new suspension in the first place was because a noise i was getting which i believed to be a bad ball joint so i just went ahead and did everything since i had to pull the control arms and what not. after everything is said and done the car is still making the same noise....its like a clicking noise which only happens when i apply the brake and the car lurches forward it sounds like a popping like something isn't tight and the car is moving forward on the frame or something....it doesn't happen in reverse and happens at all speeds sometimes one click sometimes 3 consecutive...
View 14 Replies
The other day I had my windows open while backing up and noticed that the brakes make a clicking noise when I initially apply them while in reverse.
This happens every time I'm in reverse and I apply the brakes.
The clicking is only when I first step on the brake, but it happens every time I first step on the brake in reverse.
Maybe this is unique to the LS600hL (2008)? Are brakes on my LS different from brakes on LS460 / LS460L?
View 2 Replies
So I was driving my wife to dinner the other night, it was about 30* F out and the mirror started making a clicking noise (of course, I had no clue it was the mirror until I stopped and looked around). Sure enough, the mirror was clicking and the display was going back and forth between the "188" (the start-up display) and "NW" or "W" or whatever direction we were traveling in.
Obviously the clicking noise is a relay.
View 2 Replies
My daughter has bought a 2003 4 door accent and on the way to work she lost most of the brakes. I could not see any fluid leaking and the level was ok. I did try pushing on the brake pedal with my hand and it was making a noise like a clicking? I was thinking it was just the brake light switch but not sure. The place she bought it from put new brakes on it when the driver side was getting really hot. I am thinking maybe air in the system? It sounded like a caliper was sticking when I test drove it but only a couple of times. You would have some brakes but you had to pump the peddle.It is in a parking lot right now but I can work on it unless it is some sort of different? I am going to try to bleed it in a little bit but was thinking I should ask around. I read that the piston could be sticking but can you just rebuild the master cylinder to fix it if that is what it is? I could pull the pedal back a little bit. I only looked at for 4 or 5 minutes kinda dark and no tools with me.
View 10 Replies
1991 chevy silverado 1500 4.3 ... Cruising at 55 down highway truck died for 2-3 seconds only to refire itself. After doing so for a few days it wouldn't start at all. Changed fuel pump,fuel filter and all spark plugs. Now runs fine until I shut it off briefly. Then it stalls on me on 3rd,4th and 5th gears. Bucks badly. Is it a fuel issue or something to do with starting it while it's warm. Also it runs good with the check light ON. Soon as it goes off it starts shutting off and refiring itself when I give it gas.
View 1 Replies
My 05 Malibu classic is making the turn signal clicking noise constantly which then causes the warning chime to start going off. I have replaced the turn signal assembly three times and each time it fixes it for a short time then it starts again.
View 4 Replies
The other night I was going up the mountain and while going it started making a clicking noise..probably from no oil..We had been told from the dealership there was a small leak but nothing to worry about at the moment.We tested it and it wasn't leaking visibly but I guess with it getting cold out the hole got bigger and we didn't notice so all the oil leaked out as we were powering the lil car through the mountains..Needless to say on the cruise down it started shaking i saw some sparks and I think the rod went through my engine block and we broke down. It's completely dead. The car has right around 200,000 miles on it and has always been very well taken care of.I just traded my dad the car about 7 months ago for my 4-runner cause of gas prices..I moved across the country and of course have had NOTHING BUT PROBLEMS since day one.
View 8 Replies
I have a 2012 Azera and when I enter and exit the vehicle, the driver seat will automatically move forward and backward. I have noticed that it just started making a loud clicking noise when moving forward and backward. Is this a motor issue, something under the seat, or maybe just a lubricant issue?
View 21 Replies
