Santa Fe (DM - 2013+) :: Exterior Lighting Activation By Door / Dome
Sep 24, 2014
I got a 2013 awd 2.4 Sport. I am installing a set of running boards and would like to put an LED strip under the boards that is activated when the doors are opened. I am not looking to have glowing neons while driving. I want the feature for lighting up the ground area around the entry doors when someone enters/exits the vehicle. I want the LEDS to remain off otherwise. I figure it would be best to tap into the dome/door circuit but I am lost on how to do it best. My hang up is with getting wire from inside the passenger compartment to under the vehicle (Prefer not to go drilling holes through the floor) I did find a thread about interior lighting upgrades and the OP specified that there is a brown wire inside the A-Pillar that goes -output when the doors are opened. I discerned from that that I would run the LED strip positive lead to the battery and tap the LED strips negative lead to the brown wire.
View 5 Replies
Advertisement
I have a 2013 Santa FE 2.0T Limited with the Smart Key setup. Since new, when I would approach the vehicle and the key was within a yard of the door handle, the small lights in the door handle would come on so we could see the handle. A couple of weeks ago the vehicle battery died (again) and now those lights will only come on once the button is pushed.
The dealer had the vehicle for 90 minutes and could not find any thing wrong other than the Welcome Light was turned off in the center info console from the dead battery episode. I checked it again last night and the proximity lights still do not work. How tp get the proximity lights working again?
View 2 Replies
I admit to being lazy as this is in the manual, but when I need the light, it's dark outside. Which switch goes in what position to enable the dome light to come on when the driver door is opened?
2014 ES350
View 6 Replies
I've been trying to figure out why the dome interior lights are not lighting up when a door is open, etc. The only time those lights come on is when i physically push the light in. I thought it could have been a fuse, however, I replaced the 10 amp room LP fuse, but still nothing.
View 5 Replies
I have a 2012 Santa Fe and the front map light fixture was where my issue started. I believe from what I read that the diode had gone bad because the map lights would work if the light button was pressed, but not if the door button was pressed. At that point, the only issue I had was the light now working when the door opened. So, I ordered a replacement part and tried to install it today. It was harder to get the old one out than last time, but it came out no worse for wear and I unplugged the old map light fixture. I plugged in the new one and it did not work at all. I checked the wire and it looked fine, the prongs and they were fine and tried it again... nothing.
Now, the back seat dome light and trunk dome light don't work either. (with the new map light plugged in or not) Old one back in and still nothing. Checked the manual for the fuse that is supposed to control those lights and it is fine. I got frustrated because it made no sense and gave up for the night. (no light is even plugged in where the map light goes for now) I come in the house and now every hour or two (when I lock the car) the alarm sounds for no reason. The alarm button won't shut it off either, I have to hit unlock and it stops. (3 times in the last 5 hours now) So, I have decided to leave it unlocked for now. So far, so good. BUT, I need to lock my car when I am out without the alarm sounding and I need my dome lights working. Everything else with / in the car seems to be normal.
View 1 Replies
Two Issues....
1.My rear dome lights work when manually turned on. They do not come on when the door is opened. However, the front dome lights do.
2.The lights on my side mirrors turn blink when using the turn signal, and when hitting the lock/unlock/remote start buttons. They do not work when driving around with my head lights on.
View 7 Replies
How I could activate the map lights to turn on when the door opens? Right now it's set for the dome lights to turn on but i dont want that.
View 19 Replies
Is it just as simple as when the wipers activates when it senses water drop on front windshield? the sensor is turned on and it started to not work time to time recently. What's going on?
View 14 Replies
Have the door locks start to lock and unlock while driving / We have a 2015 Santa Fe sport and when the locks start locking and unlocking by themselves the door lock controls are inop until you stop and shut the key off.
View 2 Replies
A couple days ago my wife could not close the fuel door after pumping. What is the official name of the latch that keeps the fuel door closed? Or better yet, a part number?
View 2 Replies
Just noticed the other day that the door handle on my GTI squeaks when pulled, especially when done slowly. The only one that does it is the driver's side. I'm guessing it needs some kind of lubricant?
View 7 Replies
Looking for a DIY about removing exterior door handles? I am referring strictly on the handle, not the mechanism inside the door.
View 1 Replies
2013 SF Sport 2.0T .....
Recently found that trunk area light will not turn ON when you open hatch (in DOOR mode). First I thought bulb is burned out ,but I can manually turn it ON and it will stay ON always or until I switch it to OFF. No recent hits/bump on hatch or any warning lights on dashboard that hatch is not closed. Alarm locks hatch and the rest of the locks OK.
View 5 Replies
I have a 2013 Santa Fe 2.0T Limited. The window (or trim for the window) makes a clicking/ticking noise that gets worse the more uneven the road surface, and also when cornering. If I push on the window it seems to stop.
I worry about taking it in for warranty work because last time I enquired about something different they told me if they can't replicate the problem I'd be liable for the mechanics time.
View 7 Replies
This really ticked me off big time today, whatever I do the gas cap won't open when I tried to at the gas station. Before I noticed that I would have to try this a couple of times before it will open, but today, it just won't open at all.
View 10 Replies
I have the car door apart, how to remove the panel on my camry. I got all the way to where I have to remove the outside handle to completely take out the part that has the actuator built in. Everything is all good until I got to this part. How to finish getting the handle off so the part that goes into the electrical mechanism where the actuator can be removed is done. I got the mechanism basically hanging there. I got the two bolts to what I thought was holding the outside handle on. One bolt is on the side of the door covered by a rubber grommit and the there inside the door in the middle of the handle.
View 3 Replies
Picked up my new sport today and when I got home I noticed the vehicle wouldn't lock correctly with the key fob. After messing around for a few here's what I found. It's the passenger door. If the passenger door is shut the key fob and lock/unlock switch will not lock and unlock the door. I can only unlock the door manually.
Now, if the passenger door is open the key fob and lock/unlock switch will lock and unlock the door. All other doors work as expected.
View 4 Replies
Last week out of the blue, the lock/unlock button the driver's side door stopped working altogether. It's not stuck, as I can definitely feel it click when pressed. Also, the passenger side button works just fine. This is very annoying after spending a year without ever having to use the actual key fob.
View 7 Replies
Just picked up a new to us 2004 GX470 for my wife.
One of the things wrong with the GX470 is the passenger door exterior molding is unclipped at the bottom. I ordered new clips from eBay and they just came in. Now I just need to figure out how to get the molding off without making the problem worse so I can replace all the clips.
View 2 Replies
The right side of my driver side door handle recently came detached, and I can't get in my vehicle unless I crawl in through the passenger seat.
View 7 Replies
How to get the plastic exterior molding on the base of the doors off. I see 2 screws and thats it. Is there a trick to it? I need to replace the passenger side or epoxy one of the clips back on then remount it.
View 2 Replies
