Santa Fe (DM - 2013+) :: Engine Stumble Or Possibly Misfire When Came To A Normal Stop For Red Light
Mar 23, 2016
So I was driving along at about 50 MPH and came to a normal stop for a red light. Sitting at the light for approximately 10 seconds and feel the engine stumble or possibly misfire.
I immediately look for any idiot lights and see none, however above the mileage range instead of the pages that are normally shown I see:
LIMIT --- MPH
I drove for about a mile and everything seemed fine, I pulled off into a lot and rebooted the car and now everything is back to normal.
View 6 Replies
Advertisement
Once warmed up, while sitting at a stop in Drive, there is what feels like an engine stumble every so often. Good guess is every 45-60 seconds, so it only happens once, maybe twice at long stops. There is a sudden change in pitch the engine, and the car - for lack of a better term - shudders. The thing I have noticed is that when it does this there is no indication anything has happened with the tachometer - RPMs hold perfectly steady. Additionally, there is no shudder when sitting in park or neutral, only drive.
I initially thought it might be an ignition fault, so when I replaced the balance shaft belt I also replaced the crank sensor. No change in behavior. I did some googling, which suggested the issue might be related to the EGR not closing properly. I changed all the vacuum hoses and removed the switching solenoid to test - it seems to be doing its job. I have not removed or inspected the EGR valve itself. However, because there is no symptom in engine speed and the sensation doesn't happen in park or neutral and only happens when warm, I am starting to suspect the transmission itself is the culprit - I can imagine if the torque converter quickly engaged and disengaged - and a little power made it to the wheels - the same result would happen.
There is nothing else odd about the engine or transmission. No codes. Runs like a top. Transmission always shifts perfectly. Fluid was changed two years ago, about 15,000 miles. What came out looked good as well. I'm okay with replacing EGR components, but I don't want to throw money at the problem unnecessarily. Maybe try driving around with the EGR vacuum hose pinched off or disconnected?
View 5 Replies
I own the 2014 Santa fe turbo 2.0 litre limited which has 4000 km on it. Within 210 km the engine light came on 3 times. I took it into the shop and they ran a code of P0303 which is a misfire, they changed the coils #2 and #3 and cleared the code. The second time it showed the same code but the shop said it was in the history so that is why the same code came up again. They ran an update ECM? and all was good. Now the 3rd time they tell me no code has come up and can't do anything about the engine (they cleared it) but it was like chasing ghosts. My vehicle runs great so not sure why I am constantly having this issue.
View 68 Replies
I recently noticed while driving my Santa fe the car started to stumble.Then a little while later the check engine light came on. Pulled the code came up with p300. It's a random misfire related code.
View 3 Replies
We got our latest Santa Fe computer email and it warned of an engine fault. The car itself was not flashing any warnings though. Took it to the dealer and they said OBD was throwing a P0303 cylinder 3 misfire code. They shifted the ignition coil, and replaced the injector and seal before resetting the code. They had the car for 3 days though. Car was not running rough or anything else you would expect from this type of issue. Still trying to figure out why we got the email with no indication of trouble from the car itself.
View 3 Replies
I've got a 96 Aero with 128k miles. It's AWD with the 4.0L. It's developed an annoying "stumble" on startup. The engine seems to misfire a bit and the car shakes. It goes away when I give it some gas and/or start driving. This started out being very occasional but eventually started happening at least once a day. It doesn't seem to happen with the engine very cold or very warm. It mostly happens when the engine is "lukewarm" (having sat for about an hour). So far, it hasn't died on me. I ran some fuel injector cleaner through and it went away for about a week, but then returned (but not as bad). No stored codes. Within the last 10k miles I have had done:
Compression test (passed) about 10k ago
New plugs, wires
New fuel pump
New water pump
New fuel filter
Tranny rebuild
View 9 Replies
I just posted on here a few weeks ago about a flashing engine light possibly caused by low compression getting worse. And it was determined that a used engine would be the way to go because the rings were so bad. Since then I did some research and found that low compression can also be caused by coked rings. I did have a wet compression test done that pointed to the rings as the culprit. But is it possible that the low compression is not bad rings but coked rings instead and that something like Auto-RX might might be worth a try? Is there any way to test for coked rings or are the results from the wet compression test enough proof that the rings are bad without a doubt?
View 19 Replies
I have had some slight rough running with a cold engine and stumble <2000rpm. Finally it tripped a CEL which was read as a misfire code.
The mechanic swapped the coil and plug(recent) and no change. He did a compression test and air blew out the exhaust. So.......the car needs a valve job which entails motor removal and fixing the head and reinstall. He rough estimates this at $2000 and rate is $65/hr.
He mentioned looking at pistons and may be a bit more if rough.
This car well maintained (170,000 miles 2005 Legacy turbo wagon with manual)...
View 19 Replies
On light acceleration, it has a light stumble or surge and is very slow. On hard acceleration it makes a lot of noise, but isn't even fast enough. I can feel it shift through the gears, and can feel the converter lock up when it's supposed to. Any attempt to climb a slight hill or pass a car, it downshifts to what seems like 2 gears down, and has a loud roaring noise, but I don't feel the acceleration. At steady speed, it feels like it's hunting for a steady RPM, but can't find it.
I just had a timing belt replaced. Had the mech double check to make sure marks are correct. He did a cranking compression test and said they were all between 165-170 psi (is that a little high for a 150K mile car?). He smoke tested the intake system and found no leaks.
It does have codes stored for cat converter and a lean code-bank 1.
View 5 Replies
I have a 2005 Santa Fe with the 3.5 with 112000 miles on it. I had the engine light come on with the code P0302 cyl #2 misfire, I got spark plugs, plug wires to do a tune up on it. I changed all of it and got it back together, started it up and it still had a miss to it. I then took the front spark plugs out and did a compression test on it. #2 was at 85, #4 was at 120, and #6 was at 160. I couldn't check the back cyls because I had already put the intake back on. I then did a wet test, and all the cyls came up to 160. So this tell me that the piston rings are bad in #2 and going bad in #4. I have kept all the oil changes up and up to this point I haven't had any trouble with it. Having this problem with there 3.5?
View 1 Replies
My wife was rear shunted badly in her 2016 SantaFe - she is puzzled that the airbags did not deploy. I told her they only deploy front or side if collision hard enough in those areas - am I right ?
View 9 Replies
I have a 2004 santa fe with a 2.7 v6. I have had a little misfire issue lately. I had a major power loss with a check engine light on it lasted for just a minute before it settled itself out. Had the code pulled at a local parts store. P0301 so I checked the plugs and they looked worn out. I pulled the upper intake and replaced the plugs and wires plus the upper intake gasket. I cleared the code and that seemed to correct the problem. Two days later, same thing happened. The engine seems to be running fine now. I wiggled the wiring harness to the injector and to the coil, no change in the way it runs. I was thinking it could be an injector or a coil pack.
View 6 Replies
I just started to have some idle problems with my 2013 Elantra GLS auto 1.8 that has 10k miles.
I went to the gas station to fill up the tank since the gas was very low (30 mile range). I filled up the tank, started the car and the engine began to stumble and idle poorly like it was about to stall. I put the car in drive and the engine stalled. I restarted the car and it ran normally.
The car will now briefly idle poorly when I'm at a stop light. The car will be at a stop light idling and running normally. Suddenly, the tach will go down to 200 rpm and then up to 1200 rpm, like it is about the stall. Then it will idle steadily and be back to normal. This has happened about three times over the past two weeks.
What may be causing this intermittent idle problem?
View 9 Replies
Santa Fe 2013. I bought it a few months ago and soon after a strange issue appeared from time to time. When I push the start/stop button it spins the engine but it wont start no matter how much I wait. Usually it start fine for the second time. This happens sometimes and sometimes not. About 2 months ago it didn't want to start for about 5-10 minutes no matter what I tried (push the button with the tip of the key), so I decided to go to a service station.
There they connected the car to a computer to check if there were any error codes logged. But they haven't find anything, after the second time I visited the station they replaced the battery in the key, told that maybe that was the problem.
I really don't know much about cars but it was a strange idea as I would expect the same behaviour when the battery is low than when the key is not present: Car not doing anything but displaying a message that the key is not present.
Anyway, it kinda worked, or I was lucky. For more than a month everything was fine, not a single issue. And today morning it started again. I brought my car to a hand washing, and after they cleaned the outside with steam they wanted to park the car inside the building to clean the interior, and the same issue occurred. And after that it happened with me as well several times this day.
View 21 Replies
I noticed this past weekend that when I stopped at a stop light for a long period of time, the engine would misfire for a split second, random, just miss for a moment, then do the same after 15 or so, sometimes less. Other times, no issue.
View 1 Replies
My 93 with 210K miles threw a new one at me the other day. Not 1 mile from work with AC running, it started stumbling a bit at around 40MPH. I just assumed it was the AC cycling and the Van was in OD. Dropped into D and drove her on home.
Well this morning was round 2.... got about 2 miles from home and it started stumbling again (no AC this time). Just happened to look down at my digital dash and the speed was jumping all over, finally settling on 0 MPH. I got about a mile down the interstate and it suddenly reactivated and displayed 70mph.... smooth as silk.
OK, so I know that the rear diff. has a sensor for ABS, and obviously a pulse wheel on the diff. Is this sensor the input for speed? From other makes, I understand the pulse train input is "conditioned" in another device ( hardware) which then outputs to the dash display.
Based on these assumptions, I'm going to assume the crazy speed variation was playing hell with the ECU. When it settled on 0 mph it was happy again. Can't just be a display issue as there would have been no stumble. Getting ready to drive her about 3.5 hours this weekend to go trout fishing.... obviously the cruise won't work but otherwise it appears to function WITHOUT the speed input.
View 6 Replies
Bought a 2001 from a used car dealership about 2 months ago. A week later it started acting funny. It would often race the rpm's about 2000 when at at stop light and then others times would act like I was out of gas when I would take off. Sputtered and then finally run normally. Then other times it wouldn't start and just crank over and over. After 10-15 times it would fire up and then act like nothing was wrong. It was a total crap shoot whether it would start or not each time.
Took it back to dealership and supposedly their mechanic installed a new fuel pump. Ran like a champ for about another two weeks and then exact same symptoms started showing up.
View 7 Replies
This morning during cold start up I noticed my check engine light was on constantly, I was able to get a OBDII scanner from a friend and perform a scan after work and brings up P0116, google search says HYUNDAI - Engine Coolant Temperature Circuit Range/Performance.
I did notice the radiator fan seemed to be running all the time. I had a look at the coolant level and it's near the full level line (green color if that matters). My questions is it safe to still drive it to the dealer (30 km away)? Would this be part of the powertrain warranty?
Since my wife is out of town i took her car as I did not want to cause any damage.
2013 Hyundai Santa Fe Sport - 2.4 AWD - mileage is at 67,000 km.
View 5 Replies
Well I drove the wife to work in her Prius this morning. I noticed in heavy stop go traffic, the engine was idling more than normal. Normally the EV light is on when I am stationary ( idle) in traffic, but for some reason today almost more than 70% of the stop go traffic the RPM was felt via the brake pedal and EV light was off, but the battery had at least 3 bars or more I think.
The load on the vehicle was the usual, AC on at 65 in ECO mode and radio. I guess this question might be more a hybrid newbie question than anything else. So, just curious what "drives" the vehicle to be in EV mode when stationary in traffic or in my case earlier this morning what prevented it?
View 19 Replies
Im getting an intermittent stumble with a check engine light. I have a 1990 Ranger XLT with a 2.3L 5spd. I pulled the codes 32 41 88. I looked them up but Im not sure what to check next. I have done much searching on several sites but havent found much. OBD-1 eludes me.
32(R)EVP - EGR not responding properly during test - EVP
41System Indicates Lean
88 Loss Of Dual Plug Input Control c ..
What does it all mean??? What would you check next?
View 7 Replies
I have a 2002 Santa fe that will not stop running. When the key is turned off the engine keeps running like normal. I changed the ignition switch yesterday. still have same problem.
View 21 Replies
