Santa Fe (DM - 2013+) :: Check Engine Light On Constantly During Cold Startup
Dec 6, 2016
This morning during cold start up I noticed my check engine light was on constantly, I was able to get a OBDII scanner from a friend and perform a scan after work and brings up P0116, google search says HYUNDAI - Engine Coolant Temperature Circuit Range/Performance.
I did notice the radiator fan seemed to be running all the time. I had a look at the coolant level and it's near the full level line (green color if that matters). My questions is it safe to still drive it to the dealer (30 km away)? Would this be part of the powertrain warranty?
Since my wife is out of town i took her car as I did not want to cause any damage.
2013 Hyundai Santa Fe Sport - 2.4 AWD - mileage is at 67,000 km.
View 5 Replies
Advertisement
To start off with I am not car smart! I have a 2008 Santa Fe 3.3L V6. Last year about this time (December) I had problems with the vehicle upon start up would be miss firing and the check engine light would come on. I would turn the vehicle off and restart and it would be fine and not happen again sometimes for a week and sometimes for months. I hooked it up to the computer and found that it was missing on the #6 cylinder. I had the coil pack replaced and that seemed to fix the problem (replaced spring 2011). About a week ago it started doing the same thing (December 1). Upon initial start up when the car is cold and the outside air is very cold it started missing again and having a rough idle. Would turn of the car and restart and would run fine but check engine light would come on.
Hooked it up to the computer once again and it read random misfire. This has happened twice now in two weeks with the same reading each time. Always when it is cold (engine and outside temp) and seems to reset itself when turned off.
I spoke with a mechanic who recently had this same issue with a different vehicle and after trying many things replaced the engine coolant temp sensor and that did the trick. He said it was a cheap start therefore i bought the part and now am looking to replace it. The only problem being i am car dumb and cant find it. I have done many searches and the diagrams i have found don't do me any justice. The past posts on here have given pictures of older models that dont match what i am looking at. It probably is right in front of my face. Any picture of a 2008 that will show the correct area I should be looking at? The vehicle only has about 57,000 miles on it.
View 9 Replies
I had my dealership install a car starter when I purchased my 2014 Santa Fe a year and a half ago. I noticed that this blue flashing light constantly flashes up by the rearview mirror. It looks like an anti theft device which it isn't' and really bothers me especially at night because it lights up the whole dash. How to disable this and still keep the remote functional?
View 2 Replies
I own the 2014 Santa fe turbo 2.0 litre limited which has 4000 km on it. Within 210 km the engine light came on 3 times. I took it into the shop and they ran a code of P0303 which is a misfire, they changed the coils #2 and #3 and cleared the code. The second time it showed the same code but the shop said it was in the history so that is why the same code came up again. They ran an update ECM? and all was good. Now the 3rd time they tell me no code has come up and can't do anything about the engine (they cleared it) but it was like chasing ghosts. My vehicle runs great so not sure why I am constantly having this issue.
View 68 Replies
Twice this week our 2009 SantaFe (3.3l) had a squeal from the engine upon cold startup. The first time it was very cold (-20C or so) and this was louder and longer than the second time (-10C or so). The squeal lasted only a few seconds and trailed off to nothing. Each time the heater controls were set on defrost (fyi). In order of likely suspects, I suspect one of the following:
-compressor engaging and causing sudden increase in resistance on the belt or compressor engagement clutch noisy
-idler pulley for some reason causing belt to slip at first, but don't suspect idler bearing as noise disappears right away
-belt slippage due to resistance somewhere else--e.g. water pump or alternator.
This may not happen when I take the vehicle in for its next scheduled maintenance as by then the weather will likely be warmer. This has 76000 km on the clock.
View 2 Replies
I own a 2011 Hyundai Sonata GLS with 20k+ miles on it. Purchased it about a week ago & had no issues until about now. About an hour ago, my check engine light came on & air from the driver side right vent started blowing even though the fan is off. What the issue might be? Also, my fuel door constantly pops open by itself. While driving, when I close my doors, and when I close my trunk it always pops open. Is there any way to fix this type of issue?
View 2 Replies
Do the check engine lights when you put the switch in the start position or as I know if working properly. I have a 2008 toyota avalon XL,
View 14 Replies
The check engine light on my 1999 1.8T Passat is on. It started with a little miss right after startup. Then in neutral, after revving the engine to say 1,500 rpm and letting off the gas, it would nearly stall. I plugged in an OBDII analyzer and came up with codes P0102 MAF or VAF circuit low input and P0304, Cylinder #2 misfire. I replaced the spark plugs, as they were old anyway. Still the same symptoms. Then I replaced the mass air flow sensor.
The check engine light still went on after it was cleared, except this time it was P0302, Cylinder #2 misfire, P0102, P1613, Auxiliary inputs aux. outputs control, and P1426 Mfg. Control/auxiliary emission controls. Soon after, the car started running fine on it's own and I again cleared the codes.
Then a day later, the check engine light is on. This time, it is only the P1426 - Manufacturer control auxiliary emission controls. The Bentley manual calls it Tank Vent. Valve Open, which doesn't mean anything to me and the Bentley manual is of no luck. (The error code almost implies that it is the famous loose gas cap, but I have checked that - unless the gasket is bad). FYI: I have 99K miles on the car.
View 5 Replies
Experiencing the Nav system freezing on startup? I tap "Agree" to the legal and it doesn't respond. I literally had to turn the car off at an intersection - open the door and re-start to get it to work. (twice) The problem has since disappeared again but guaranteed it will return again...
View 15 Replies
Bought 2009 santa fe new [3.3]. after cold start up tac is moving up and down and it seems to be missing. After temp is reached tac is steady but there still seem to be a hesitation when driving. 21,000 miles on vehicle. could it be a bad tbs?
View 4 Replies
I have had the new Santa Fe for about a 45 days now. It is a 2.0T model with awd and no nav. So the basic radio.
Three times I have now had the issue with the radio. Right after the vehicle is started the radio shows it being in a diagnostic mode and loud static coming over the speakers.
Turn the vehicle off and back on and it is gone. I have asked my wife to take a picture if it happens again.
View 14 Replies
I am considering buying a used 2013 Audi Q5 with 25K miles. The day I was supposed to see the SUV the check engine light came on-. The catalytic converter had to be replaced. The dealership could not give a good reason why this happened. During the winter, the owner backed into a pile of snow--and dented the under panel in the rear that has since been replaced.
View 19 Replies
I got one this morning and the thing never went away. and yes, i checked my fuel cap. How to remedy this issue or do I need to take it to the dealers.
View 3 Replies
Its been getting quite cold here lately at night and in the morning when i go to the santa fe it makes a ticking noise for about 2-3 seconds and everything is fine again. I was thinking of dropping a quart of transmission fluid in the crankcase run it for a bit and change the oil?
View 14 Replies
I just purchased a 2013 Elantra GT, 3 days ago. I was driving down the highway and my check engine light came on. There is only 480 miles on my car! I know it's not a gas cap. I haven't even put gas in it since I drove it off the lot. Is there a way to check for the code thrown without a scanner? I use to have a jeep liberty and I could click the key over 3 times an the code would pop up.
View 24 Replies
I have a 2013 Elantra GLS with almost 200k on it. I am the original owner. I have only had a few small problems with it just replacing lights and had to replace the passengers side wheel bearing twice. the rest has just m=been replacing wear and tear parts. the check engine light is on because it needs 02 sensors. They are back ordered. The car started idling roughly and driving horribly on the way from Rhode Island to New York on Christmas day. A friend had a diagnostic machine and the code read misfire cylinder 3 p0303..I am assuming it damaged the catalytic converter and that I now need both the sensors and the convertor. I live about 7 miles from my garage. should I tow it ? or drive a t a low speed? Have to bring it in first thing in the morning. What else could be wrong?
View 3 Replies
Its strange this code came up 02 sensor circuit low voltage bank 2 sensor what does that mean? what causes that?
View 6 Replies
Yesterday from the smart center of Rochester, MN I bought a 2013 Smart fortwo Pure with 19k miles. This evening the Check Engine Light came on and it is code P0455.
No other dash lights are on and I have not even touched the gas cap yet. Should I clear the code? Take it to the dealer? Tow it to the dealer?
View 7 Replies
2011 Santa Fe 3.5 L
I've isolated this rattle down to the cam phaser( CVVT) in the right cylinder head. It rattles bad for 2-3 secs on cold start or after it sits for 3 hours.
I've put in 5w20 synthetic oil and synthetic Lucas additive and it cleared up the noise for short interval start ups.
I changed the cam phaser in the right head with a used one ( 40k ) but it didn't make a difference. I should change out the attaching cam as well.
View 21 Replies
My '04 santa fe 3.5 v6 gls/lx, 79k miles, gas, auto, check light has just come on while I was driving a less than 10 mile journey. How can I check what is wrong. Do I need some sort of diagnostic code checker. Do any national outlets check it for free (Pep Boys or Auto Zone, etc).
Just 5 days ago (about 50 miles only) I had timing belt, water pump, plugs and leads replaced, brakes checked and lubes flushed; BUT not at above dealers. I would rather know what the code is saying before I go back to the shop who carried out the work.
View 12 Replies
How can i turn off check engine light (hyundai santa fe 2003 3.5) by fuse ? I do not have any code scanner.
View 10 Replies
