I have been following some discussions about a vibration at about 40 kms my has this problem also. I removed my drive shaft this morning and ran it on the hoist at that speed the vibration, noise is gone. I checked the center bearing and u-joints , the front u-joint has a tight spot. It appears the u-joints are not serviceable ,whole drive shaft replacement??
View 5 RepliesI recently bought a 08 question Sante fe we just drove it. When it got to 70 to 80 mph i could feel a vibration in the steering wheel. What it could be. I bought it with 56k on it. Put new tires on it cuz the original tires were worn on the inside on the rears.
View 11 Repliesi have a 2.2 crdi 2009 santa fe and when my foots off the gas pedal it has this strange vibrating hum noise that comes and goes - it doesn't matter if its in Park or Neutral.
You can only hear it inside the cab so im thinking maybe its something up against the firewall but i can't see what?
My car santa fe 2009/ 4WD / 2,7 / around 70,000 kms. Around a week ago, I noticed some vibration, that I can feel it mainly on the gas pedal. I can assume that the vibration came from the front of the car and just at low speed, like below the 40km/h. Also I feel that when took my foot of the gas, the vibration gone.
View 7 RepliesI'll try to keep this brief. I bought a 2008 Sante Fe AWD 7 passenger 1st week of Sept 2008 from Jim Pattison Hyundai in Nanaimo BC. Vehicle had a pronounced vibration at various speeds but was most noticeable at around 85 kph which seemed to vibrate frame, not steering. I called service department at the dealership. They said they would look at it during the trailer hitch install in 2 weeks.
After dropping off vehicle for trailer hitch installation I mentioned problem again. Later that day I picked up vehicle and asked about vibration. I was told "mechanic didn't feel anything". Got service manager to take a ride with me, vibration now felt by service manager.
I had this item of concern as a response to another thread but I thought I'd open up a new thread and see if I could get any more attention.
I bought a used GLS and upon initial drives I have noticed a high speed vibration that seems to come from the rear (I don't feel any in the steering). In the colder weather recently I've noticed a pronounced vibration at a lower speed (just before shift points). between 2nd and 3rd. This seems to be worse with short drives or in morning.
Vibration seems to be worse just after a tighter right turns or even some left turns. I notice the most vibration right around 25mph. I also get it with moderate acceleration into a certain torque range. Like driving at 45 and accelerating up to 60. What is going on? It seems like it is linked to acceleration (torque) and possible pressure from turns. CV joint / axle? Wheel bearing? It seems like a tire would be worse as speed increased and more consistent.
Just had new tires mounted and balanced on my 2011 Santa Fe. I purchased Toyo Celsius tires. I purchased the tires on line and had Faulkner Hyundai in Harrisburg PA mount and balance them.
When I drove to work 2 days later, I found that the vehicle starts to vibrate above 65 mph. When I get to 80 mph (typical traffic speed on I83 in the morning), the vehicle vibrates so badly that I shake in my seat.
This shaking leads to a feeling of lack of control. I'm hoping the dealer just screwed up balancing the wheels. Faulkner Hyundai uses a road force balancing machine.
My old near bald tires (the factory original Bridgestones) had a tiny vibration around 65 that went away as speed increased. With the new tires, the faster you go, the worse the shaking gets.
My 2011 Santa Fe still has under 30,000 miles on it!
We purchased a new 2010 Santa Fe Limited in October of last year, and as it stands today, we've put about 19,000km's on the vehicle (about 12,000 miles for my American friends). About 14,000km's in, we started noticing a vibration from the rear under acceleration. When you reached cruising speed (regardless of the speed), the vibration would go away, but would appear under acceleration. What was more alarming was that at slow speeds when making sharp left-hand turns (turning into the driveway, doing a u-turn, pulling into a parking spot, etc), there would occasionally be a loud bang from the rear end. The first time it happened, we thought that we had run over something... actually not but it sure sounded like it!
We took the vehicle into the dealership, and after an inspection they found a rock in one of the rear springs. They removed the rock, applied the TSB to place covers over the springs, test-drove the vehicle, and said the issue was resolved.
The next morning, I was heading out of town to pick up a friend, and experienced a loud bang when I pulled into my buddies driveway. Problem was NOT solved. Called Hyundai again, and made another service appointment. This time with the requirement of having a tech come with me for a test drive.
I was able to reproduce the vibration, which really shocked the tech. At the same time, I was also able to duplicate the loud bang when making sharp turns (I had actually caused it to happen twice when driving around the dealership, but I was alone in the vehicle at the time!), when he concluded that there was probably some binding going on in the drive train. They took the vehicle in, and after looking at it, determined that the coupler in the drive train was defective, and needed to be replaced. They didn't have the part in stock, so they had to order it in; my concern was that the vehicle was unsafe, but they assured me it would be fine to drive until the part came in. I went on a weekend trip with the vehicle, and experienced some pretty severe binding when pulling into parking spots (no bangs, but imagine driving through a lake of molasses) - I had to really give it gas to get it moving into the parking spot - not nice, especially considering what might have happened had it 'unbound' while under throttle...it was certainly not safe, but I survived.
After THREE weeks, the part finally arrived, and was installed yesterday. I'm happy to announce that the vibration has ceased, and I can only assume that the loud bang is gone as well (although I couldn't duplicate that on demand, so I'll never know for sure that it's gone). The Tech did mention that it was a new version of the part, so they just didn't install a new part, it was an upgraded new part.
Question about my 2012 Hyundai Santa Fe SE. The car has 25,000 miles on it, and just recently like in the last 1,000 miles I have notice when I use the AC, or even the air without the AC the engine reacts very poorly like it is under extremely heavy load. The car shakes and vibrates.
I completely understand that in AC mode, the compressor kicks in, but this to me seems excessive. The car vibrates and the idle drops substantially. AC on is worse that no AC.
In addition, idle or under 35 is worse that HWY driving. The vibration is so pronounced that I sometimes wont turn the AC or air on as the vehicle feels like it is going to rip itself apart.
This is something new and never vibrated this much before the 25,000 miles. Anything I should look into or have the Hyundai Dealer look into? What I may be over looking? Would more stout battery work?
This afternoon my Santa fe started shaking and light smoke from driver side at around 70 MPH. Continued for about 5 miles then pulled over shook the tire and heard some noise/play. Got back in the car and the issue went away.
How to check ball joint, Axle, and Strut for the cause of the issue? Before pulling over the issue did not worsen applying the brake so not the rotors. Also during idle no vibration.
2011 SF. 52000kms.
A little while ago I noticed a brief vibration (felt through floor and steering) with normal acceleration from stand still... I attrributed this to the cold weather and perhaps oil thickening, as the problem went away after the car was warmed up. Since then I have noticed that it's continually happening on a regular basis, but only for a short period.. I was still thinking that it was the cold, but that wasn't the case because I left the car idle at start up for 20 minutes until well warm.
Now.. If I slowly accelerate (not putting much load on the car) there is no vibration at all. When the car reaches a certain speed, the vibration goes away. There is also no vibration after about 15 minutes of driving.
I had a neighbor test it with me to confirm and he felt it, and initially thought differential oil, but then suggested myriad other things from the CV boot to bearings to etc etc.
I need to take it to the dealership so they can experience the vibration but would certainly need to leave it there over night so they can check it out when "cold".
Problem I have been noticing with my 2010 v6 Santa Fe.
I first noticed a vibration that appears to come from the drive train late last winter and only seems to happen on colder mornings. It comes across like I am driving on a rough road. If I am simply rolling without a lot of acceleration there is no vibration, but once I step on the gas and add power the vibration starts and will continue until I let off the gas. It is not an alignment issue as that has already been checked and eliminated as a cause.
Once the vehicle warms up, the problem goes away. This makes it very tough to demonstrate the problem as by the time I drive to the dealer the problem is gone. Guess Ill need to pick a cold day and leave it there overnight so they can see the problem. Had a very similar issue years ago on my old Nissan Pathfinder which was eventually traced to a the 4 wheel hub system.
I am having with our 2010 Santa Fe GLS (2.4L). Whenever I am stopped and in gear, I have an excessive about of engine vibration IMHO, my wife thinks not, but it just doesn't feel right to me. I can feel it in the seat and people sitting in the passenger side and in the back can also feel it. If I bump into neutral or am accelerating, the vibration goes away. I have no issues with hesitation or loss of power and no other issues/check engine light, etc. This has been happening since we purchased the vehicle, and I mentioned it to the dealer and was given the response that the engine needed sufficient time to be broken in...... I now have 15,000 miles and it still is an issue.
View 3 RepliesI have a Santa Fe 2010 2.4 awd 6AT with 20000km, I live in Ushuaia, Argentina, here the use of salt is normal in winter (a lot of salt). I have one winter and the second is coming with this SUV. Today I was in a road at 120km/h (75mph) and I had to apply brakes. In that moment I noted a little vibration on the steering wheel. After release brake pedal, the vibration disappeared. I checked again with same results, is been posible that my brake discs could be damaged or something is wrong with the brake system? I didn't have any light of malfunction. What is the normal life of brakes discs and pads in a santa fe with normal use?
View 13 RepliesMy 2012 Santa fe crdi2.2 has 150000km. At the speed of 90km/H and faster there is a vibration coming from the back (passenger side I think).
There is no play on that wheel when it’s in the air, but it doesn’t turn smoothly. It turns smoothly until a point where there is obviously friction, once past that point it turns smoothly again for 3 quarters of the way until it reaches the same point…
The back wheel on the passenger’s side is the same story. Although the vibrations seem to come mainly from the driver’s side (at the back). Is this a wheel bearings problem or can it be something else?
I put a winter wheel at the back (driver’s side) to see if the problem was caused by the wheel. There is less vibration when driving, but it also starts at 90km/H. This winter tyre is higher, so probably it absorbs the vibrations better.
It's not a 4x4.
Our FWD Santa Fe Limited had a very noticeable vibration that started around 60mph. Oddly, the vibration will sometimes come and go while cruising at a constant speed on the highway. We went about 30k miles before we had time to get it into the shop.
I asked them to rotate and balance the tires and the vibration was noticeably reduced...initially. Now it's back!
The car has ~65k miles. All 4 Kumho tires match and I believe are original from the factory. I have kept all tires inflated properly.
Our car has the optional 18" wheels. Is it common for these to bend? What else could be the cause here?
I am having problems with vibration on my 2011 Santa Fe 2.2 CRDi Premium, 95% of the time the car is fine, but twice now in the last month, out of nowhere, I can be driving along as standard and all the sudden a vibration will hit the whole car out of nowhere, it almost feels as if there is a bleb or defect on one of the tyres, the whole car shakes, but the shake is not coming through the steering wheel, it is the car body that seems to be shaking, if that makes any sense... However, if I pull over, turn off the engine, restart it, and pull away the vibration immediately disappears???
I am totally lost, as it is a occasional occurrence I can not replicate it for the dealer to inspect as it is still under warranty...
2007 Santa Fe GLS 2.7 V6. T belt replaced by dealer at 62K. Noticed engine vibration when picked up vehicle. RPM is steady, engine runs smooth, no error codes, no strange noises. Mechanic who did the work confirmed vibration problem and recommended bringing it back - had no answer on the cause but mentioned lose motor mounts which I doubt - the car ran perfect until the dealer did the work.
View 3 RepliesI have a 2007 CRDi Santa Fe with 135k on the clock. Regularly serviced however in the past year we've heard a rumble / vibration coming from the vehicle.
Location feels / sounds underneath driver / front passenger footwells and only occurs on strenuous acceleration i.e off a round about going up hill. It doesn't occur at any other time.
It's been in and out of the Dealership but they haven't been able to replicate the problem.
Just recently I went to overtake another vehicle at around 100kmh when I lost all drive to the wheels. The engine was running normally, there were no warning lights on the dash but no matter how hard I pressed the accelerator i had no forward drive other than coasting.
I wondered if the exhaust was loose or an exhaust or other supporting bracket had failed but as previously mentioned the Dealership can't find the problem?
I have santafe 3.5 2012 4WD , it's 51K on odometer, the problem when cold startup , Noise and small vibrate form front side , its look like from gears
When put to reverse (R) sound is louder and strong vibration from front side, all this problem gone when drive about 15 minutes.
I have visit 3 local shop they check the engine, gear box, everything normal, no check indicator appears.
ok, I had quite bit of work done, prob over yr ago All oem parts, timing belt, crank sensor, idler pulley, some other things while in that area. So when he was done I got this vibration when it goes into gear never in park only in rev. or drive but only in cold weather and after it warmed up it was go away. No Trans service was done. He kept it overnight outside, had the timing cover off rolled it in the garage, started it and seen that the belt was flapping crazy. So he thought it was that. well every cold morning I have to wait till it is warm to not hear that sound. it only happens during cold mornings never in summer. He had back in his shop 3 times after parts were installed. and its to this day isn't the same. its unfortunate that I didn't have many cold mornings when he had worked on it. but after I had it and the next cold morning it was there.
View 7 Replies