Santa Fe (CM - 2007-12) :: Transmission Shifting Harshly - Stuck Mid Shift
Mar 18, 2010
We've got a new 2010 Santa Fe AWD LTD with about 2800km on it. About once or twice a week, under normal driving, we've noticed very harsh shifts. It seems to be the 2-3 shift and is around 40km/h. Just normal acceleration from a stop sign. And just recently a new issue. It seemed like it got stuck mid-shift...
I was accelerating slowly from a stop and on the 2-3 shift the engine revved up above 3000 as if it was in neutral. I eased off the gas and then it completed the shift. My wife took it into the dealer today, but I'm worried they'll send it back as "unreproducible" as we've only had about 1 problem for every 10 hours of driving. We'll see what they say. As you can imagine, I'm not very impressed that we're having these issues before our first oil change...
Somebody mentioned that maybe there's something sticking in the transmission and it builds up enough pressure and then finally makes the shift. But I'm not a transmission expert by any means...
View 691 Replies
Advertisement
Having issues with speed sensors on the transmission in their 2012 Elantra? My Elantra has 201K km. Transmission will intermittently shift harshly or sluggishly between all gears. If I turn the vehicle off and restart it it will go back to normal, sometimes for weeks at a time before another occurrence. Also after long periods of driving when the vehicle comes to a stop, say for instance at a red light, when brakes are applied the car will gently lunge forward or flutter. No engine codes.
View 6 Replies
I have a 2005 2.7L Santa Fe that was shifting poorly and getting stuck in limp mode intermittently. I read up on it and found that it was probably an issue with the input/output speed sensors. The codes confirmed my suspicions and I replaced both the input and output sensors. The codes cleared and the tranny shifted like a dream. Unfortunately after 2 days and 100+ miles the car suddenly started down shifting randomly on my way home from work. The CEL came back on and the car went into limp mode. Could the sensor have gone bad again? Or could it be the wiring harness that plugs into one of the sensors? I don't understand why the car would be fine for a few days and then all of a sudden be acting the same way.
View 6 Replies
I have a 2009 Santa Fe and last night, out of the blue, the engine wouldn't start. The shift lever was stuck in park and the brake pedal was very stiff and wouldn't move much. I popped the cap off the shift lock and moved it to neutral at which time the car started without a problem. I could drive but shifting was difficult and the lever didn't really click into a gear. I noticed that when shifting gears. the indicator on the dash would change from N to D and to R in reverse but when I moved up to park, the indicator went blank and the lever locked up again and had be released manually. I also noticed when I got home, since my driveway is a slope, that when the car seemed to be in park is rolled down the driveway, so I had to engage the emergency brake.
View 13 Replies
My 2010 Santa Fe's transmission has been smooth since the TCM update except there's always a clicking sound when the speed first reaches 30 km/h. The sound only happens once during each trip. It seems like it only happens when the fluid is cold. Once it's warmed up, it's fine.
Yesterday all of sudden I feel something is dragging my car. I noticed RPM is over 2000 when the speed is only about 60 km/h. (not mile). And the ECHO light is not ON. So I shift to '+/-' mode and the display shows 4. I guess it means it's in 4th gear. I shift up to 5th gear and RPM drops right away. ECHO light comes back ON. So is this a symptom of 2010 Santa Fe transmission?
I also feel my brake pedal is very stiff when this happens. And the brake pedal has not much travel distance. If the brakes are dragging car down, can this cause the transmission stuck at low gear?
View 2 Replies
Finding a solution to my problem with Santa Fe, the gear gets stuck up on the 3rd gear. I have changed all the solenoid and it is still the same.
View 2 Replies
My transmission got stuck in 3rd gear on the way home recently. I tried disconnecting and re-connecting the battery and that didn't work. Looks like there's fluid around the casing, but I wasn't sure if that was already there or not. What it could be? '07 Santa Fe (3.3L)
View 4 Replies
When I start the car for the first time of the day, the shifting is not as smooth as when the engine is hot. Is this normal ? When I checked the trans fluid, it was between 25 and 75...(the second little mark on the dipstick) but I just drove about 5min so maybe the engine wasn't warm enough..
View 6 Replies
We have a 2010 Santa Fe AWD LTD with about 140, 000km on it. It recently came back from front suspension work. The suspension is fine now, but we notice harder shifts in the transmission. Also, there seems to be a vibration just before shifting gears and when under load (like going up hill) seems to slip (like on ice) about once every second until the shift is made. Once the shift is made it drive smoothly until put under pressure again. Even stepping down a bit on the accelerator will cause this slipping feeling (or maybe its loss of power). Just had new plugs put in and a tuneup so it's not that. Could something from the suspension work cause these symptoms?
View 29 Replies
I just bought a 2007 Santa Fe 3.3ltr with auto trans and all wheel drive. When I purchased it the speedometer did not work. I bought the VSS gear and installed it and now my transmission does not shift properly. Also I had it to the dealership for an ECU update and they said that their computer could not connect to the ECU.
View 2 Replies
When I am driving and I start to slows down to a store my head lights dim when my transmission shift down (A/T). At first it didn't bother me but now since I have noticed it, it is annoying. Although the dimming in not super dangerous but I am worried there might be a bigger issue.
2009 Automatic Santa Fe
View 1 Replies
So I have a issue at hand with a clutch I purchased and fly wheel. I bought a Spec Stg 2+ kit and fidanza lw flywheel. As soon as I installed it the rattle seemed a little harsh and would change noise levels every time I would engage and disengage it. Then the shifting became a issue about 1000 miles in not being able to get it into gear (thats what she said) the clutch felt spongy and not solid. So I just recently pulled it out (real men dont pull out). Everything looked fine...odd.
SO I contacted Spec and they told me after inspecting the pictures that the self adjusting pressure plate was mis-adjusted and stuck and needed to be put into a vice to release the springs to put it back to normal. Hence why I had bad shifting eventually etc. Had less than 10,000 miles on the set up...fml. Spec has been extremely useful but I do not have the funds to buy another clutch from them. So im debating on putting it back into my car after resetting the pressure plate or just getting another clutch kit from a different company. I was also told to just go back to the stock clutch and pressure plate with the fidanza flywheel
View 4 Replies
My parents are having trouble with there 2008 Santa fe 3.3 L. The transmission won't shift and the rpm's climb really high. Does that mean the transmission is going or is it something else.
View 15 Replies
Bought a 2009 Chevy HHR with 35,000 miles in July, 2010. In the summer of 2011 the ignition was replaced, as the key would not turn. (The engine was running at the time. It was necessary to disconnect the battery to turn off the engine.) At 55,000 miles the transmission suffered "catastrophic failure" and the entire transmission assembly was replaced. (The engine light never came on, although the transmission was slipping frequently.) After driving the car with the new transmission between 100 and 200 miles, the engine light came on. The error code indicated a faulty transmission fluid pressure switch. The transmission changed gears harshly at times and the automatic door locks stopped working properly. Sometimes they would lock when the car was taken out of "park" and sometimes not. Likewise, they would not always unlock when the transmission was put in "park." After replacing the switch, the technician said that for no reason the security light came on briefly as did the passenger airbag "on" indicator light. Once again, after having driven between 100 and 200 miles, the engine light is on again, and gears are sometimes changing harshly. No diagnosis yet. Do I need an exorcist?
View 7 Replies
2007 V6 Mustang Manual Transmission. I recently got stuck in my drive way due to a poor plowing job by the plow guy. I had to turn the traction control off and aggressively shift transmission between reverse and 1st to rock the car and spin the tires. I eventually got unstuck but now the transmission doesn't feel right.
I thought it was the clutch but the issue seems to occur only shifting from 1st to 2nd. The higher gears all seem relatively fine. There is just a catch between 1st and 2nd now that sometimes causes me to not be able to shift into second gear without forcing the shifter down roughly.
Is it possible that I just threw something out of alignment inside the transmission itself? It doesn't make the car undriveable but i get ticked every time i drive it knowing that it was fine before the poor plowing job.
Should I even bother having it looked at? I know transmission repairs are expensive.
View 1 Replies
As I was entering a highway onramp today, the transmission stuck and didn't shift between what I'm guessing was 3rd and 4th gear. It was revving at about 5000 RPM and stayed there.
After what felt like about 10 seconds, it got its act together and shifted and the revving stopped.
View 3 Replies
I have a 2002 Chevy S10 ZR2 4x4, the transmission will shift through 1st and 2nd gear up to 30mph then will not shift anymore. I have notice if you are easy on the gas you make get lucky to shift into 3rd, but the transmission downshifts to 2nd and only 30mph. I've tried shifting into 3rd manually, if the rpm is high it will not shift into 3rd but if they're low it will shift and if you press the accelerator just a little harder it will shift back to second and speed will drop to 30mph. I've changed transmission fluid and filter. The fluid was dark. I put DEX VI transmission fluid back in. Problem still exist.
I just have so much to explain and not sure how. I bought this truck from a person who bought this truck brand new in 2002. He was always kept the truck maintenance but he said he has never changed the transmission fluid. The truck has 276,000 miles but they are mostly highway miles from driving from NC to DC and back. I can assure you guys this truck hasn't been "dogged". I read one forum and someone said to changed the ignition switch wire harness. I'm not sure if that has anything to do with it, but I only seen one person say that and I'm not sure if it works.
View 19 Replies
I have a BMW 523i SE AUTO (1997) 2494 Petrol. In auto transmission the gears will shift from 1st to 2nd and 2nd to 3rd but won't shift any higher. In steptronic/manual transmission the gears will shift from 1st to 5th without any problems therefore suggesting that the problem isn't the gearbox itself. Only very occasionally does the shift electronics telltale light appear on the dash, yet the problem with the auto transmission is continuous. A local garage specializing in automatics suggested that it was the gearbox inhibitor. I've today had this changed but the problem still exists.
View 5 Replies
I have a 2001 Hyundai Accent with 120,000 miles on it. Up until a few months ago, its been a great little car. The transmission started acting funny by shifting irregularly and then getting stuck in 3rd gear occasionally. I took it to the dealer and they told me that the tranny is shot. The estimate for the repair is $2000.00.
I just can't see putting that much money into this car. It needs Struts, Shocks and a timing belt. Basically what it needs is what its worth if it were running well.
How hard it is to replace the transmission in this car? I have the 1.6L DOHC with the Automatic transmission.
View 12 Replies
My 2001 Santa Fe 2,4l - Have suddenly lost the abillity to shift gear. Its stuck in 2 and the shift stick is very loose in the "front to back and back to front" motion.. in other words there are resistance sideways.
I suspect it to be a broken shift cable. So my question is : changing shift cable on a santa fe easy? Is the best approach to start from inside the vehicle or from transmission side?
View 6 Replies
I just recently bought a 95 F150 with a 351. The truck has high mileage, about 190k, and I am not sure how long the transmission has left. It rides smooth down the road, but when I put the truck into reverse it hesitates for a moment then makes a loud clunking sound(as if a door is being slammed) and then jerks into gear. The reverse works great at the moment though. Should I be worried, is there anything I can do to fix this?
View 11 Replies
