My 2007 3.3l SF timing chain cover is leaking.It has 93,000Kms and is still covered by warranty.The Dealer said it was a 17hr break down job to do.
I am wondering if there are things I should get done/replaced when they open the engine up. I had asked at the dealer if there were other parts that should be replaced at this time, but was told that there was not.
I have a 2011 Limited and I wanted to mention that I brought it in for the ECM service campaign and to have an oil leak looked at. The reflashing went as expected, I am still trying to decide if the car behaves any different. It seems like the engine RPM drops a little bit when slowing down then bounces back up. Nowhere near enough to stall or anything.
While I had it in the shop, I had them look at an oil leak that I have been having. According to the dealer, it is leaking from the timing chain cover. They have ordered some parts and I will be taking it in for the fix next week. I don't have a full list of which parts they will be replacing, but he did mention removing the valve covers and installing a new oil pressure switch while they were in there.
My 2010 Santa Fe is leaking oil. I bought it in April & it has under 8,000 miles. After parking the car, I see oil spots that range in size from a Silver Dollar to a CD after a few hours.
First, the dealer said it was a cracked oil filter cap, so they replaced that...I brought it home and it was still leaking.
Brought it back to the dealer, and now they are saying the Timing Chain Cover Seal is leaking.
My daughter just bought a 2002 Santa Fe LX which is drooling oil all over the alternator and everything else in that area. I found what (I think) is the source (but you have to be a contortionist to see it.) I haven't been able to find any good parts identification photos of that area, but I think that this is the bottom corner of the lower timing belt cover.
I guess the repair will require going through the first several steps used when replacing a timing belt. I don't plan on going any further than needed to fix this leak, though, since the timing belt was reportedly changed about 25K miles ago.
Before I start taking all this apart, I have a couple questions:
1. What might be holding this corner out, away from the block?
2. Is the timing belt cover supposed to snap into place over a lip on the block? Or, should it be sealed with gasket sealer -- or something similar?
I read for a few second at start up ok . Have it checked : [URL] ...
I will be opening up the case in next few days. Chain still on holding by a few teeth. Metal wedge between teeth and chain.
I have a 2011 santa fe limited with the 3.5 and 35k miles that has a noisy timing chain rattle upon start up after sitting for a few hours,it's my understanding that the cause is no oil pressure to the tensioner because the oil drains back into the oil pan after sitting for a while. Is there a solution for this situation like a spring loaded tensioner-it seems to me that replacing the tensioner and chain does not solve the problem.
View 32 RepliesHad 2 valve cover gaskets fixed 2 times on this car. Now I have a timing cover gasket gone. This is real big $$$. Dealer quoted a price of 1400.00 . Contacted Hyundai of America and trying to get some " good will" . It's the 3.3 V6. I know this engine seems to have these problems . This car has 127,000 miles.
View 2 RepliesI have seen this minor oil leak on the left engine side that facing the firewall for sometimes, but just found time to bring to dealer. After some searching on Internet, I suggested to them that it might be leaking from the timing chain cover.
View 19 RepliesI was changing my mom's oil at work today. I noticed her timing chain cover is leaking. Is this just an isolated occurrence? It seems to be right where the FIPG mates the timing cover to the cylinder head. It also seems right below the tensioner. However the tensioner is bone dry.
View 9 RepliesMy truck has had this annoying tendency to drink coolant. I believe I took care of it by replacing the thermostat gasket. Not so, it drinks about a quart every 50 miles - so quite a bit really.
Finally bit the bullet and took it to the dealer so that they could figure out where the coolant was going.
Answer I got back was - timing cover gasket, water pump, lower radiator hose.
The water pump appears to be good, its just the gasket that's bad. So my question is - how significant is the timing chain cover leak? Poking around online it appears to be reasonably common, but sounds very expensive. The dealer indicated it would be 2 days work minimum.
I have a 13 RX350 with 10,000 miles with a side engine oil leak. I looked underneath and I think it's the timing chain cover seal. Took it to the dealer and they put dye in my oil to figure out where the leak is coming from. They suspect it to the timing chain cover as well. I am aware that 07 ES350s had a know oil leak coming from the timing chain cover but haven't heard anything about the RX having this issue. My service rep said they would have to remove the engine to fix the leak.
View 11 RepliesMy 2003' Explorer XLT (4.0L V6) has an oil leak. I tracked it down to the passenger side, rear, bolt head on the valve cover (back by firewall). I took it to a guy who replaced the valve cover gaskets, but it is still leaking. He claimed when he had the cover off he looked for any cracks on it, but did not see any at the time.
Anyways, I was searching around and found several explorers leaking in or around the same area of the valve cover. And it turned out that there issue stemmed from bad timing chain guides, causing the valve cover to crack.
I do notice that on a cold start, I hear a rattling when I first start it up. It rattles for maybe that first 1-2 seconds when starting. Is this my timing chain rattling around? If that is the case, how much this could set a guy back on repairs?
I guess I don't know whether to just replace the valve cover, or if I should dig into it to see if the real issue is the timing chain guides/tensioner. Mileage is approximately 121,000....
I have 2000 V6 3.0 Ranger and it has sprung a small coolant leak from timing chain cover gasket. I think just few drips after driving a while since I don't see significant drop in coolant level (Took a month to notice level dropped in reservoir) and did not see an active leak while idling. No water in the oil.
The proper repair would be to replace the gasket, but for the age and condition of the truck, I don't think it is worth it. Searching for a cheaper solution, I found K-Seal and see lots of reviews with success. Will it damage the cooling system in anyway? I think it would be worth a try even if it doesn't fix the leak as long as it does not cause any harm.
I have a 2003 Eddie Bauer explorer with the 4.0L SOHC . I have a coolant leak from the passenger side that is not a water pump issue.
When removing the timing chain cover with the engine in the car, do I need to remove any accessories ( power steering , alternator etc. ) or their brackets?
I had the front timing chain cover replaced, ever since it hasn't started. It would turn over fast a couple times and then drag and then repeat.
Found out the "Tone ring" was warped, it's been replaced and now it just turns over and over and no start but it doesn't drag anymore.
We can smell the fuel, and pulled a plug and can see spark while turning over and I was told fuel came out the plug hole so there is fuel there.
Tried a new cam sensor, crank sensor and battery and no change. Is there something else in the removal and replacement of the front timing chain cover that could be causing this?
I'm not a huge believer in coincidence as the vehicle was running great before this job.
2006 Ford Escape
3.0L v6 w auto tranny.
OK... I know next to nothing about cars. I have a '99 Chevy Lumina I just bought in February. It has been one problem after another. The water pump has been changed and I just got my car back on Monday because there was a leak on the timing chain cover. Now, the car is smoking on the passenger side. Its not a light smoke, but its not heavy yet. I noticed it on the way to work this morning. I opened the hood, it is coming from the left side (looking at it, so the passenger side) of the engine maybe kinda underneath it. I dunno what to do, but I'm ready to push that thing into a lake.
View 1 RepliesI have a 2003 Toyota Corolla with a leaking timing chain tensioner. I was able to locate a procedure for replacing the tensioner but it didn't say whether the no. 1 cylinder had to be @ TDC or not. What is the proper procedure for this repair?
View 1 RepliesMy 2003 Sante Fe has developed a rattling sound in the engine. The oil level has been good. I took it to a dealer for diagnoses and they told me that the engine was gunked up and the timing "chain" tensioner couldn't move to keep it tight and it was rattling. They put some engine cleaner in and changed the oil and wanted me back in 500 to clean it again. I did that again, but the rattle is still there. It gets a little quieter after I have driven it for a while.
My question is doesn't the Sante Fe have a timing belt? If that is the case what do you think the rattle is?
My son's 2007 Hyundai Sonata had an engine noise that was eventually diagnosed as bad timing chain tensioners. However, one Hyundai dealer repeatedly denied the problem, so it was 8 months before another Hyundai dealer admitted it and changed the tensioners. A couple of months later, the engine light and oil light were on and he was told he needed a new oil pump. By this time, the warranty had expired and he had to pay for the new oil pump and eventually a new engine. My question is this: Could the failure of the oil pump have had anything to do with the timing chain tensioner problem?
View 19 RepliesI was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 RepliesI brought my 2004 VW Touareg V6(83k miles) to the dealer for a recall on the ignition call and much to my surprise, was presented with a diagnosis of a $6,000 problem! The dealer told me that the computer read some codes which say that the timing chain is stretched and needs to be replaced. They said it will take 4-5 days and should be done asap so it doesn't "go out", because if it does, it's an even more expensive problem. I took the car to another VW repair shop and they asked me if I heard any noised when I start it cold (like pebbles in a bucket). I have not had any problems like that at all, so they said I shouldn't worry until I start getting symptoms. They also said there is no recommended point (like 90,000 miles) when VW recommends the change, so it really shouldn't be a common problem. I want to do the right thing, but I don't want to rush into an expensive repair if it isn't necessary.
View 1 Replies