Santa Fe (CM - 2007-12) :: Significant Judder When Setting Off In 1st At Low Revs And Worse When Reverses
Nov 22, 2011
I have a 2.2 CRDI Manual - new 2010 model - bought from new approx 16 months ago. Live in UK. Quite a few problems, which is a shame as I love the car. Tonight's question is about the clutch. Became increasingly difficult/impossible to get into 1st when cold, and wasn't clearing so car would slightly jolt forwards. Dealer had it in and replaced ?Slave cylinder. No better. Went in yet again for a week. This time ?replaced Clutch ?wheel (staff not that communicative, or apologetic, and ps had to also replace both front drive shafts too as clicking ++). Now at least the car is easier to get into gear, but pedal rather sponge like and significant "judder" when setting off in 1st at lowish revs, and worse when reverses. Surely this can't be normal - it's a new car after all. Back to the dealer later in the week, but what do I do if I become unhappy with the dealer?
View 4 Replies
Advertisement
its the auto with triptronic with flappy paddles, when driving in auto its perfect but when using triptronic from 4th to 5th there a terrible judder, it gets worse the faster i go
View 5 Replies
I have 120K miles on my 07 Santa Fe Limited AWD. I have a significant buzz/hum coming from the rear. It varies in pitch with the speed of the vehicle, and the intensity seems to be less when when veering right. I'm guessing that's a bad bearing, which of course means a hub assembly. Prices seem to be all over the place, but I also see that some have a sensor and others do not. I'm assuming that's an ABS sensor.
View 8 Replies
I have 3000 songs in folders on a USB stick. I understand how to get random play both within the folder, and for the entire USB. (Pushing and holding the button) What my frustration is is that everytime i take a phone call, or everytime i turn off the car, the random setting gets erased and it is back to sequential play. Is there a way to get this to a default permanent setting of "all random".
View 3 Replies
I have a 2009 Santa Fe Limited. Dual climate control issue. The passenger side blows cold air regardless of the temperature setting or mode. How to remedy this?
View 7 Replies
I own a 2010 AWD Santa Fe. It gets factory scheduled maintenance at the dealership. Since owning ( i bought it used from Dealer, it was driven by dealer) it has periodically revved while driving. Often at lower speeds while accelerating from a stop. The engine will rev and the car will act as if it is in neutral. Then, after a few seconds there will be a sharp jerk as the transmission(?) engages and the car lurches forward. My dealer told me it is normal. This does not seem normal.
View 1 Replies
Over the last few months I've noticed that there was a small 'Jerk' from the car when pulling away at low revs. It seemed to happen around 1200 RPM/20 MPH put only when pulling away very gently. It has been getting worse in the past two weeks. The car needs a service and I was going to get the fault looked at when in for service. Last night the 'ESP OFF' and the 4WD fault indicator came on (4WD lamp flashing). Since the fault lamps have illuminated, the car has stopped 'Jerking'.
View 3 Replies
Finally got my Auto Santa Fe on the road after buying at Auction and changing engine. If you drive reasonably gears change quietly but it you rev over 2k revs before you get to 5th gear there is a screeching noise (like a belt slipping) from the gearbox region of the car. Once in 5th gear or in Neutral there is no screech. Have it booked in with a gearbox specialist next week but have a 300 mile trip on Friday. Is there anything obvious I could have a look at before then?
View 10 Replies
My 2.2 crtd is the first ever diesel car i have bought, but i have noticed a whine especially when cold, pitch bieng raised as engine revs. Is this a characteristic of this car or am i in for a bill further down the line.
View 3 Replies
Occasionally, when braking at lower speeds (i.e. coming to junction) I get feedback through the pedal almost as if the ABS has kicked in....braking is not very effective when it happens. I can also hear a pump type noise going. If I lift my foot and re-apply it clears and normal braking returns. In fact, sometimes I can hear the pump noise going even before I brake....always at low speed (sub 15-20 mph) doesn't happen when driving at higher speeds.
View 17 Replies
I have a santa fe 2002 diesel the abs lights stop on all the time the brake pedal has a bad judder on it when braking. I have taken the fuses out and it will still judder. The only thing that is when i disconnect each sensor the red brake light stops on but not with the osf front sensor. All the rings look ok but when i had a problem with 1 of them the abs light would go out then return on...
View 1 Replies
We have a 2006 CM later model Santa Fe 2.2 CDX+ 7 seater. Engine light came on last week and since then car does not shift into 4th gear. It revs very high upto 5000rpm with no increase in speed, it's limited to 30-35mph.
I had this problem back in 2010 where the Hyundai franchise identified a fault with the EGR which was replaced under warranty, and then a year later a problem with the fuel sensor which was also replaced.
I had the local garage check the EGR and give it a clean based on the steps provided by a member here - no change. So I took it to Hyundai but this time, they are reporting fault codes P0733 and P0744 which point to transmission problems. I just had a call from the garage who say they believe the gear synchromesh is jamming thus not allowing the change of gears. He said that the diagnostics report that the car is sending the gear change command correctly (pulse generator ok) so does not believe it is an electrical fault.
View 29 Replies
Just bought a 2001 santa fe, 2.7 v-6, automatic trans, 2 wheel drive, new tires, 120,000mi. Got a great deal, don't want to negate that by nickle and dimming. 3 weeks ago noticed a howling from drivers front at speed, pitch changes with wheel speed not rpm so i figured wheel bearing. Took both front tires off with vehicle firmly supported and put vehicle in drive and increased rpm. The noise is not at hub but at other end where the shaft attaches to transaxle. I figured there would be an "axle bearing" or some such i could replace but I can find no reference of one, and my book doesn't have break down of the transaxle. Where can i find more information, schematics, etc? I hope I don't have to remove transaxle to have one pressed in.
View 2 Replies
i have a 2014 Santa Fe 2.0t awd. When I first bought it it was getting 320-340 miles a tank after having it for 6 months now we are down to 250-260. The engine feels sluggish, however no codes, no change in driving habits.
View 11 Replies
I have a Hyundai Santa fe 2004 6cyl 2.7 L , AWD. I am having problem of slow acceleration which is worse after a stop sign or red light. Sometimes while taking turns I feels like that I will not move and I was lucky to be not hit by a Car coming from opposite direction while taking a left turn today.
The Truck’s exhaust pipe broke recently and a auto garage welded it. But I am facing the above problem immediately after the repair of exhaust pipe. If I put more pressure on gas pedal then a mal function indicator comes and today I took it to another mechanic and he gets the error code of P0303 –engine misfire and wants to charge me ~ $600 $ to replace spark plugs and wires. The malfunction indicator goes off also while I am driving and can comes back after a while or a day. With the indicator on, the car drives erratic (minor jolts ) for few meters and then its fine. Since when I am driving on highways then I can go higher speeds without any problem. Is it still misfire issue???
View 11 Replies
So my sonata 2.4L has been freaking me out lately. Once it has been driven and warmed up good, it starts to idle rough at rest at lights and in traffic. Now the crazy thing is it idles even more rough if I switch it into neutral during those stops. One more thing is it idles the worst after I fill up with gas and get stopped at lights.
So what I have done:
Cleaned the MAF sensor with MAF spray
Changed spark plugs (I4 so it comes with coils not plugs)
Put Lucas Gas treatment in
So I'm getting no check engine light. So all I can think of is fuel filter. Or some other sensor. I mean I know it could be a coil so that would be the next thing I check. What this could be?
View 10 Replies
Owned my 2009 for 6 months now. Ever since purchasing it, car will vibrate significantly at highway speeds when first driving it, then decrease by 90% after a few miles. At first, since I purchased in winter, thought it was cold flat spots on tires. Dealer changed tires 3 times, finally with a new set of Turanza OEM tires. Still does it.
Service manager said he drove new 460's and they all do the same thing for a few miles. I have seen other comments on internet from other owners who report the same phenomenon. Don't think it is the tires since we went through 3 sets and it still does it in the summer. What else could cause a vibration until the car is warmed up?
View 14 Replies
My cruise control has been acting very funny lately. The light comes on normal all the time when I press on/off. However about half the time the cruise does not set when I press set. By this I mean, on Monday this week my cruise refused to set on my way to work, but on my way home it worked just fine. On Tuesday, the cruise worked perfect all day. Today, it did not work going to work or coming home.
View 6 Replies
2006 Sonata. I had to remount the drivers window glass which had slipped out of the clamps and fell inside the door.
Afterwards, if using the window auto-up feature, the window reaches the top and reverse back down to about the one-third closed point. Using the normal (non-auto up) it remains properly closed at the top.
My first thought was it needed to be reset by the well documented hold the switch up for at least .2 seconds method. I've done that and it hasn't solved the issue.
There doesn't appear to be any unusual resistance to movement which might activate any 'arm in the window' type safety feature. (if it even exists)
I would also expect that type of thing to work regardless if using auto-up or not anyways.
View 1 Replies
i have just replaced the clutch in my 2002 santa fe all went well but on the test drive i noticed the revs jumping up and down while idling at a set off lights . it was not in gear and the clutch was out. Have checked all hoses and connections. problem still there.
View 1 Replies
05 Santa Fe, 2.7 liter, 71,000 miles
Prior to today it had revved high, up to 3000 RPM, once or twice upon start-up but then settled down once I started driving it with no issues at stop lights.
Today, however, no issues upon start-up but within 1 mile it started acting badly. Pulls strong under load, i.e, accelerating. Once cruising speed is achieved and the right foot is relaxed, it loses power, slows and bucks.
At stop lights revs are down to below 800 while in drive and is slow out of the gate. When put in neutral at stop lights, it revs to 3000 then falls to 2000 then back up to 3000. It does not stall.
Replaced the IAC and it ran fine in park for exactly 2 minutes then began revving again.
View 3 Replies
