Santa Fe (CM - 2007-12) :: Shuddering When Press On Brakes
Dec 10, 2011
I bought a 2011 Santa Fe in September and now that winter has set in up here, I find that when approaching a stop sign and there is black ice, I noticed that when you press on the brakes, it shudders. Almost jumps if you know what I mean. I've never had this experience and scared the crap out of me the first time. Is it normal? The only time it does this is when the wheels lock and slide on the ice. The brakes? I think then shudder. This is the first Hyundai I've ever owned and love it so far.
View 9 Replies
Advertisement
I have a 2003 Hyundai Sante Fe 2.7 v6. About 2 months ago I started the car and it was kind of a rough start. It usually starts right up. I was driving in the rain and when I would press the brakes the car would shudder like it wanted to turn off but the head lights and dash lights did not flicker. I had it towed to my mechanic. He found a broken vacum hose and replaced it. The car seemed fine.
Today it started up kinda rough and then would shudder and not accelerate no matter how hard I pressed on the gas pedal. It was also idling roughly.
I bought the car from a friend who was the first and only owner. She has ALL of the service records and took good care of it. It has about 120k miles on it. The spark plugs and battery are only about a year old. It has a half tank of gas. I checked all fluids, pulled a few plugs and they look fine too. Air filter is clean too.
I asked the previous owner if she had ever changed the fuel filter and she said she didn't think so. I reviewed the service records (assuming I have them all) and it doesn't look like it was ever done. I have run seafoam through it 3 times since I bought it last August. I change the oil regularly and rarely let the gas get below 1/4 tank.
View 10 Replies
I just bought a used 2007 Santa Fe Limited. It has 78,000 miles on it. I have gone bumper to bumper looking for problems and am pretty happy about the condition. HOWEVER, I have noticed a shuddering/bobbling, fairly faint, when going over slightly rough roads a low speeds. The tires are shot. But they are all exactly the same ... meaning the same wear more so on the outside. I believe they were rotated properly, but something is wearing the outside prematurely. Is the shuddering/bobbling the culprit? What is the most common issue for the Shuddering/bobbling at low speeds on slightly rough roads?
Next, I want a quiet ride. Handling is not a concern. Should I go with a slightly wider tire or slightly taller tire? Lastly, I need new mats. I want them to be the same as what came with the car. Do I have to go to the dealer or are there some vendors with better deals on factory mats.
View 9 Replies
I have a 2007 Odyssey. Honda already recalled it once for brake issues. It has 44000 miles and we already changed brake pads once. Now again beakes are filling soft and have to press hard. what should I do?
View 3 Replies
AC stop working after an alternator replacement ?. I tried crawling under the truck to see if the mechanic didn't plug the compressor back in as he said he had to take it off to get the Alt out, but it looks like the plug is fine. Would the refrigerant have leak all out when he took it off ?. Should I try to re - charge myself with Red - tek kit from Canadian tire ?. The compressor will spin easy enough when I reach down and move it by hand but will not engage when I press in the AC buttons.
View 4 Replies
I have a 2011 Santa Fe. I had to take it in for service in April because the shift lock was not acting correctly. Since I have gotten it back, it will not honk when I press the remote button twice. It did before the service was performed. The lights flash properly and the doors are locked, but I still want it to honk sometimes. Is there something that was turned off that I can turn back on?
View 8 Replies
Just like the title says out of the blue the esc light will come on and it sounds like the front brakes are grinding. This only happens once in a while but more often as of late. Grinding noise does not occur until after the light comes on. Sometimes the light will stay on for a minute and then go out and everything is fine. Other times we need to shut the car off and on for the light to go out. Grinding noise only occurs one time in all instances.
We just had a brake job done 3 months ago so I am at a loss as to the problem. This is an 07 FWD Sante Fe.
View 5 Replies
I have a 2007 Santa Fe, I have been having issues with the power. I tap the brakes and the lights go dim and come back on. Then when the truck is turned off then back on I have nothing like the truck is dead. I replaced the battery and still same issue. I then replaced the alternator and I thought it was good. Just today I decided the use the keyless remote to lock the truck and it locked but not horn sound. I tried to unlock the truck with the remote and nothing. I opened the door and no lights. Turn the key and nothing. The battery still has power to hit. What it could be?
View 6 Replies
On my Santa fe 2009 , Just noticed that I can shift from PARK to R, N, D or anything else without pressing on the brake. I checked the gear sticky by the mechanic , and we found that the lock on the gear sticky not exists. So I am worry if that normal and it's like safety option that not exists on my car? Also , is it something that may case damage to the transmission , or just Safety option .
View 8 Replies
In cold weather (10-15 deg.) the brakes in my 2009 Santa Fe are very soft/spongy. I had to depress the brake pedal nearly to the floor before it would stop on dry pavement. Once it's warmed up, the brakes seem fine. Pumping them seems to work but they are not back to their normal condition.
View 14 Replies
I have a Santa Fe 2010 2.4 awd 6AT with 20000km, I live in Ushuaia, Argentina, here the use of salt is normal in winter (a lot of salt). I have one winter and the second is coming with this SUV. Today I was in a road at 120km/h (75mph) and I had to apply brakes. In that moment I noted a little vibration on the steering wheel. After release brake pedal, the vibration disappeared. I checked again with same results, is been posible that my brake discs could be damaged or something is wrong with the brake system? I didn't have any light of malfunction. What is the normal life of brakes discs and pads in a santa fe with normal use?
View 13 Replies
I did lube my brakes 2 weeks ago (2nd I am doing it) and since then for the first couple of kms, the brakes are making a squeak noise. I think I put a little too much grease. Could it be the reason why its making noise ?
View 10 Replies
We have a 2009 GLS AWD 3.3l and recently discovered that the parking brake was not fully releasing. We watch our mileage quite closely with the obc and it wasn't seeming quite right. A quick check of the rear parking brake drums showed that they were hot..as in not red hot but too hot to touch. The cure seems to be to work the parking brake pedal up and down fast and many times to 'free up' the mechanisms....this we now do after each time we use that brake. Sadly it is necessary to use it from time to time or like all parking brakes, it would become dysfunctional. Just a tip for those who may wonder why their good mileage suddenly went bad.
View 4 Replies
We bought a used 2009 Nissan Rogue about a year ago. According to the previous owner, all services were done at the local Nissan dealer.
About 4000 km after we bought it, my wife noticed that it was shuddering after she applied the brakes. So I took it to the dealer... and they said that the front calipers were seized and needed to be replaced. It only had 82,000 km or so (51,000 miles) on it then. The previous owners paid for the repair, which included new calipers, pads and rotors.
Fast forward to yesterday, and I was told by the independent garage that we take all of our vehicles to that one of the rear calipers had seized and needed to be replaced. The vehicle only has 104,000 km on it (about 65,000 miles). Again, the caliper had to be replaced, along with all pads and rotors on the rear end. When I commented to him that we've replaced 3 out of 4 calipers, he said that the other rear caliper looked like it had been replaced too.
My question to the group is - should calipers that have been serviced properly seize like that? I'm of the opinion that they shouldn't if they're being checked regularly and serviced properly.
Am I correct? Or not? I've owned a lot of cars in my lifetime, and this is the first time I've had seized calipers on any of them.
View 8 Replies
I just installed new brake pads in my 2WD 2009 Santa Fe. I bought the cheapest AutoZone pads. Now I have a loud squeal sound when I apply the brakes. If I apply a hard brake the squeal goes away. Until I apply the brakes again. Now, after install...I have been researching and noticed that the stock pads are ceramic. I did apply (Not once but twice) break grease on the pads. What the problem might be? Oh yeah, I did see that after 2007, oiling the caliper springs is required and might be the problem too. But I do not know where the spring in question is and how to oil it.
View 4 Replies
A week ago my brakes started squealing badly. This past weekend I pulled off the offending tire to take a look and sure enough the squeeler is riding on the rotor so it looks like I need to replace the brakes at 53,000km.
The rotors look good so I plan to only replace the front pads. While I am working on it, I am going to disassemble and preform the TSB on the rears as they have been neglected lately.
What pad material should I go for, metallic or ceramic? Ideally I would like something that has good performance, yet had a good life span. I occasionally pull a 2500lbs (dry weight) braked tent trailer, but that is not very often.
View 33 Replies
My 1963 Holden has drum brakes all round. The fronts had always been a problem pulling and shuddering. I have had the drums machined and fitted new shoes and adjusted them up correctly. The shoes are the correct fit in the machined drums.
They are now working really well when cold. Once they heat up I am getting a bit of shudder, nowhere as bad as before but still annoying. No longer pulling to any great extent. My question is, why would the shudder only happen after driving for a while and the brakes warm up?
View 15 Replies
I have a really weird problem with my car. Every time that I apply the brakes, I get a bit of a shudder. It just started a couple of weeks ago and we checked the brake pads which were fine and the bearings were good as well. What could be causing this problem?
View 2 Replies
My 2002 2.4lt Santa Fe started shuddering under braking just after I brought it, so I got the front disc's skimmed, fixed it but 6 months later it come back, so on went a new OEM set, fixed it but 6 months later it's back again...
I'm about to skim this new set and see what happens.
Part number 81230-26000 and 81230A from partmaster
View 1 Replies
Lately I've been noticing on my 07 camry when i step on the brakes i have to press a lot of more than normal and when i'm stopped and still have my foot on the brake pedal i hear a hissing sound or hissing air with my foot still on the brakes.
View 10 Replies
I have a 2007 Sante Fe Limited that has 93k on it. Within the last year I have noticed the steering wheel will shimmy when you apply the brakes at high speeds, it's slowly came to the point now that anything above 40mph will cause the steering wheel to shake while applying the brakes. I am guessing I have warped or unevenly worn front rotors. The car supposedly had a break job done at 74k and this started happening at about the 90k mark.
I was looking at these : Front Performance Brake Rotors Posi Quiet Ceramic Pads for Santa FE 07 09
Second question, any tool list or required sockets sizes to complete a front rotor and pad replacement? I have a floor jack, jack stands, a set of 3/8 deep metric sockets. I also have a breaker bar. This is my only car so I want to make sure I have everything I need before I start taking stuff apart.
View 15 Replies
